IPhone 5 stuck on iTunes connect logo then shows error 9 when trying to restore
my dad came home with his iphone today and today and said how something had happened and it shut off and didnt want to turn back on it just stays on the itunes logo screen when i go to restore it on my computer itunes does recognize it but when it comes down to finally restoring it it goes pretty much all the way through then gives me an error when it gets to verifying with apple part on itunes please help im on windows 8
What is the error, including the error number? You can look it up here:Get help with iOS update and restore errors - Apple Support
Similar Messages
-
I am getting error (-1) while updating my iPhone 4 to iOS 5.1. The phone has gone into a recovery mode. Restore fails every time at "restoring the firmware" stage. Striped bar remains for a long time, then shows "error (-1)" and the restore fails. I have been doing it for last 12 hours. Help!
Thanks for your reply Michalo. I am in India and here Apple care does not work on Sundays. I have been without my phone for the entire day. Perhaps tomorrow will bring some respite. There is not solution to "error (-1)" on any forum it seems. I found one forum which suggested use of Tiny Umbrella. Any idea about that?
-
My iPod is stuck on apple logo and I get a 1434 Error when trying to restore it.
Hello, I hope somebody can help me. I have a 120 gb ipod classic (6th generation). I purchased it a long time ago. It was working fine for a few years and then suddenly it's been stuck on the apple logo ever since.
I tried to restore it by putting in on disk mode and connecting it to my Mac. My iTunes recognizes the device (But my Mac doesn't!). On iTunes, I tried to restore it, but I get an error message 1434, stating that the restoration could not be completed.
I read that I should try to erase the drive with Disk Utility, but when I get there, the button to erase the drive is unclickable. I tried to partition as well, but it also did not work (maybe I am doing it wrong? Could somebody direct me with better instructions?)
I'm wondering if the hard drive is dying, or if I have a bad ribbon, or if the logic board itself is broken. Not sure what method of action I should take. I can't even get into the diagnostic screen.
PLEASE HELP!Hello E1777,
You can try this link to download iTunes from the Apple website. It should resolve the issue for you.
iTunes 11.0.4
http://support.apple.com/kb/dl1614
Thanks for using Apple Support Communities.
Regards,
-Norm G. -
Error When Trying to Restore from iTunes Backup
I had to erase and re-install the operating system. I thought I had iTunes covered by burning an iTunes backup to a CD, but when trying to restore iTunes from the CD it will restore a few songs and then give an error message that it was unable to read or write to my hard drive. I looks as though it restored the music that I owned and put on the computer but not the tunes I had purchased from the iTunes store and not the playlists. I did not know enough to burn the /music file. Is there anything I can do to get the burned CD to restore?
Contacts are not part of the backup. They are seperate and either you need to sync them with an email program such as outlook or use icloud mail,contacts, and calendars on the phone. Unless you did that then the contacts are gone.
-
HT201210 phone screen is stuck on itunes connection help what is error 3194
my phone sceen is stuck on itunes connection cant get calls or get to main screen tryed to up date but keep saying that its a error 3194
See your other post on this Topic...
https://discussions.apple.com/message/23362244#23362244 -
Hello,
I need help before i go to the apple store for help.
My problem is that I have an Ipod touch which it was working fine but now it will not boot all the way.
It will not show the red bar when is ready to be turn off or reboot when using both buttons to reset it it will only come to the apple logo then goes blank.
I tried to restore via Itunes but same result, it will start showing is doing the extract then it will go blank and get a message saying that It can not find the device.
What do i need to do.
Thank you for your help.
regards,
Mario
PS. The OS I am not sure do not remember exactly.- Reboot the computer
- Try another USB port
- Try another cable try another cable
- Inspect the dock connector for bend or missing contacts, corroded contacts, broken, missing or cracked plastic.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
Recently updated my iPhone 4 to iOS 6.1.3 and lost all of my contacts after doing so. Tried to restore phone to latest backup performed in iTunes but I get an error message that tells me there's not enough space on my iPhone to perform the restoration. The ultimate problem I'm trying to solve is the loss of my contacts so if there's another way to solve that please let me know. If restoring my phone is a proper solution please help me do so.
1. How do I get my contacts back?
2. How do I restore my iPhone from latest backup when getting "not enough space" error?
Please help!Contacts are not part of the backup. They are seperate and either you need to sync them with an email program such as outlook or use icloud mail,contacts, and calendars on the phone. Unless you did that then the contacts are gone.
-
So I got an iPhone 4 and tried to restore it with my back up from my 3GS but it's not showing up in the drop down menu. The funny thing is my wife got one too and we restored hers just fine. Also when I look in the preferences I can see the backup from my 3GS! Really confused....
Your Powerbook 6,8 (the 1.5GHz 12" model, correct?) was never shipped with OS X 10.4.6 discs, so you were sold installer discs with it that are specific to a different Powerbook model and can't be used on yours. Contact the seller and ask for the correct discs, but don't hold out too much hope of getting them at this point. The seller probably has no idea how to identify them even if he has them — it's really very hard to do.
What you will probably need is a retail (universal) installer DVD of OS X v. 10.4.3 through 10.4.11 or any version of 10.5.x. Don't buy any disc that has a gray label, nor one that says "Upgrade" or mentions the name of any Mac model on its label. -
HT201210 why do i get an unknown error when trying to restore my Iphone 3GS,
i was informed (by app store icon i had apps that needed to be updated ,
i said ok to the 2 updates ,
the phine then asked me (as usual) to insert my pass word
it said i had used wrong pass word and re-enter it which i did
this then set my phone to keep switching itself on and off repetedly
i tried to switch off the phone using the power button butg at first this did not work,
i then pressed reset (power button and home button, as requested in the user guide
my phone then came back on with the itunes and usb logo tgelling me to connect to itunes to do a restore ,
after the phone tries to update itself with the download
although the phone trys to reboot and use the down load it just keeps disconnecting fron my computer
and itunes come back with an error message telling me it cannot make contact with the phone
there are no other fixes on your site
so now my phone is out of warranty it is now useless
i had though of upgrading to an iphone 4S but am now thinking do i want to do that now this has happened
maybe its time to go back to android also recently bought an IPAD touch which up to now is fine
but not sure if i should keep this as ive never had this happen to me before and the phones are so expensive
my old galaxy android phone still works fine , so ive now put my sim card in there and works fine after 5 years continuous use
what would you suggest i do now
what will you do to make me stay with apple ????
Mr walter DicksonHave you tried to download anything else?
-
"Unable to continue with activation" error when trying to restore iPhone 3G?
So here's the sticky.
My friends from the Middle East bought me an iPhone 3G. They had taken the SIM out of it.
I connected it to my computer, and backed up all the photos. It was running 4.2.1 (the final version of iOS for 3G). I then downloaded 4.2.1 again from getiOS.net, hoping to rejuvenate the bogged down iPhone with a fresh restore. I connected it to iTunes, selected my downloaded iOS file, and proceeded with the restore.
So it extracts the software fine, the progress bar also shows the restoration and verification going fine, but then when the iPhone reboots it shows a screen which sort of looks like the iTunes recovery mode screen (the wire connected with the iTunes icon) but it also has a popup saying "NO SIM CARD INSTALLED", and on my computer iTunes says, "We are unable to continue with your activation at this time. Please try again later."
So where's my iOS gone?! What happened to my phone? How do I get it back to normal?
Someone suggested putting the phone in actual recovery mode by holding down the home button and connecting it to the computer with iTunes on, but it just showed the restore option again and when I tried the restore again, the same problem happened.
Please think of a solution guys. Is it because there is no SIM inside? Or maybe it's from a different region? Or what?https://discussions.apple.com/servlet/JiveServlet/showImage/2-20596803-190597/Sc reen+shot+2012-12-15+at+15.49.30.png
-
Iphone 3GS error when trying to restore and update
I took my old Iphone 3GS and tried to run an update on a new Itunes acct so I could use like a ipod since my other acct is tied to my current phone. Itunes did a restore and then errored when it tried to update with the latest software. Now it is only showing the image of a USB cord to be plugged into Itunes and my Itunes is not seeing the phone anymore.
Please help if there is a way...I did the troubleshoot on the device before and updated drivers. They were current before the restore and my computer still sees the iphone under upspecified - Apple Mobile USB Device Driver.
Thank you very much for any advice you can offer.Thank you for the quick response and I went throught the step shown but iTunes is still not seeing my device in itunes menu when i do this action. The phone is also still showing the connect to itunes screen and no pop-up to restore has happened. I tried the steps 3 times.
Also, I tried to troubleshoot the device and see if that would correct the computer seeing as it did before but it says there is no problem with the device.
any other thoughts? -
TS3694 Keep getting a 1015 error when trying to restore Iphone 3g
Hi, I have a problem with my old Iphone 3G, I upgraded to a Iphone 4 ages ago and just kept my old phone in a drawer, now I want to give it to my niece, so decided to plug into Itunes to reset it ready for her, it said it needed to update and download, it did that, but failed and said to restore it, but I keep getting 1015 error when it goes through the restore.
Any ideas and options other than going to Genious Bar ?http://support.apple.com/kb/TS3694
error usually means you have a jailbroken or a modified iphone. -
TS4036 could not sign in server error when trying to restore iphone from icloud
I am trying to restore my iPhone from an iCloud backup. I deleted everything on the phone per restore instructions. Connected to wireless on iPhone. Logged on to my iCloud account. Told the iPhone to restore from iCloud backup. I keep getting ""could not sign in" server error OK. I get this messge over and over.
I actually noticed when I had this problem just now that my iPhone 4 wasn't on wif. Only connected to 3G even though I entered my network info and clicked connect. So I backed up a few steps and re selected to connect to wifi and it fixed my issue!
-
ITunes giving error when trying to restore iPhone 4
When I try to restore iPhone 4 it gives an error saying that the resource for the request was not found.
Help, as I have sold my iPhone and need to send it.
And I am not using my own pchttp://support.apple.com/kb/TS3694
-
HT4623 My iPhone 4 shows error when trying to install iOS 6
My phone show a error message that it can't install iOS 6, why?
Maybe try searching the forums for similar issues, specifically those with the exact error message that is being displayed and you'll get a resolution much faster.
At the very least, post the actual error message that is displaying.
Maybe you are looking for
-
Win 7 & FF 28/29. Beta feed. I noticed the Icon first time only two days before. It is square shaped , about the size of the menu icon; with a flag with a five pt. star in the center. Always at the very last place on the toolbar. Rt clk: the remove f
-
Hello Experts, I have a requirement of generating Night Shift Premium Hours. My Night Shift is from 18:30 to 6:30. Where as Hours needs to consider for Night Premium is only between 21:00 to 5:00. We are having Positive Time scenerio & Clock in/out i
-
Date selection in a program variant
Hi, I would to like to set a variant for a program under ECC6. The date selection has to be dynamic, and i would like to put in the selection from a fix date (e.g 1.1.2009) to (today's date + 5 days). It is possible? min
-
Failed to retrieve data from the database using Crystal Reports XI R2
I am using Crystal reports XI R2 and using the Universal Web Connector (connecting to Coghead). When I put some some of the fields from the database and run Preview I get "Failed to retrieve data from the database." . Where is this message coming
-
Thanks!