IPhone 5s goes black screen after the Apple logo is displayed

Recently, my iPhone 5s keep restarting when I am using it and a blue screen appeared before the restart process. But worse, this time, my iPhone stays on the black screen after the apple logo is displayed and it is turned off automatically after a couple seconds, what happened and what should I do?

Hi CarltonKwok,
If the screen on your iPhone turning on completely, you may find the following article helpful:
iOS: Not responding or does not turn on
http://support.apple.com/kb/ts3281
Regards,
- Brenden

Similar Messages

  • Iphone is a black screen and the apple logo won't show on screen

    My iPhone has a black screen and the apple logo does not appear. it keeps saying voice overb run or mute on mute off.

    Hey there Maggie,
    Welcome to Apple Support Communities.
    The article linked below provides troubleshooting tips that can help you resolve the blank black screen issue with your iPhone 6 Plus.
    Get help with the screen on your iPhone, iPad, or iPod touch - Apple Support
    If you see a solid color screen (black, white or blue)
    Plug in your device to a power source. If you see the low-battery screen when you plug in, let your device charge for at least 10 minutes (20 minutes for iPad) before using it.
    Reset your device while it's plugged in.
    If resetting doesn’t fix the issue, restore your device.
    If you still see the issue after you restore, contact Apple Support.
    Cheers,
    -Jason

  • Ipod touch wont turn on i tried restoring it but every time i do it just says its waiting for the ipod to respond. meanwhile my ipod is no longer a black screen but the apple logo with a loading bar underneath that after leaving for 8 hours hasnt moved.

    my ipod touch wont turn on ive tried restoring it but every time i do it just says its waiting for the ipod to respond. meanwhile my ipod is no longer a black screen but the apple logo with a loading bar underneath that after leaving for 8 hours hasnt moved.

    Try:
    - Another cable
    - Another USB port
    - Reboot the computer
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • HT4623 After installing the above mentioned update, my ipad will no longer turn on. I have just a black screen with the apple logo when I attach it to a power source.  Anyone else having this problem, please advise on how to fix.

    After installing the above mentioned update, my ipad will no longer turn on. I have just a black screen with the apple logo when I attach it to a power source.  Anyone else having this problem, please advise on how to fix.

    IF RESET DOESN'T WORK, FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port. Do not release button until you see picture of iTunes and plug (very important)
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note: Data will be lost

  • Hello, I can't turn my iphone 4s on, it just broke down and now there's just the black screen with the apple logo on it. So I connected it to itunes and tried to restore it, but than always the errors 1603

    Hello, I can't turn my iphone 4s on, it just broke down and now there's just the black screen with the apple logo on it. So I connected it to itunes and tried to restore it, but than always the errors 1603 & 1611 appeared! please help me!!

    You may have a faulty USB cable. Try another.
    Make sure you are following the instructions in this procedure to the letter. Here they are, with emphasis on some easily overlooked requirements:
    Disconnect the USB cable from the iPhone, but leave the other end of the cable connected to your computer's USB port.
    Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release only the Sleep/Wake button.
    Continue pressing and holding the Home button while you reconnect the USB cable to the device. The device should turn on.Note: If you see the "low battery" screen, let the device charge for at least ten minutes to ensure that the battery has some charge, and then start with step 2 again.
    Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears (iTunes icon and USB connector) release the Home button.
    If necessary, open iTunes. You should see the "recovery mode" alert ("iTunes has detected a phone in recovery mode").
    Use iTunes to restore the iPhone.
    If you do not see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
    Select the device in iTunes and choose "restore from backup".
    If you still can't get it to work, you have done all you can and only Apple will be able to help.

  • My iPhone 3gs is stuck on black screen with the apple logo, help

    my iPhone 3gs is stuck on black screen with the apple logo, help

    then get it replaced if that doesnt work or try to le tthe battery die and recharge

  • My 5th generation iPod (bought in April of 2013) will quit unexpectedly. It will take for ever to load what I write while texting. It also just goes to the black screen with the Apple logo. I'm not sure what to do.

    My 5th generation iPod (bought in April of 2013) will quit unexpectedly. I can't do app store apps (like snapchat or facebook, ect.) or apple apps (like Camera, Safari, ect.)It will take for ever to load what I write while texting. It also just goes to the black screen with the Apple logo. I'm not sure what to do.

    Try This...
    Close All Open Apps... Sign Out of your Account... Perform a Reset... Try again...
    Reset  ( No Data will be Lost )
    Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
    Wait for the Apple logo to Appear...
    Usually takes about 15 - 20 Seconds... ( But can take Longer...)
    Release the Buttons...
    If no joy...
    Reset all settings
    Settings > General > Reset > Reset all Settings.
    This will return all iDevice settings to factory defaults... you will not lose any data.... But you will have to re-enter all of the device settings.
    If the issue persists...
    Connect to iTunes on the computer you usually Sync with and Restore
    http://support.apple.com/kb/HT1414
    Make sure you have the Latest Version of iTunes (v11) Installed on your computer
    iTunes free download from www.itunes.com/download
    More Tips here...
    http://osxdaily.com/2013/09/23/ios-7-slow-speed-it-up/
    http://osxdaily.com/2013/09/19/ios-7-battery-life-fix/
    Note:
    Also consider Deleting any Apps you have Purchased / Downloaded but you now never use.

  • Today, randomly my iPhone 5 stopped working. It has been on this black screen with the apple logo and some small white writing at the top of the screen for many hours. I've tried rebooting it and connecting to iTunes but nothing has worked.PLEASEHELP

    It has been on this black screen with the apple logo and some small white writing at the top of the screen for many hours. I've tried rebooting it and connecting to iTunes but nothing has worked.
    PLEASE HELP!!!!!!!!

    It likely means there was still water inside it and something has now shorted out and permanently damaged one or more components.  THE very worst thing you can do with wet electronics is energize them - even a small drop of water inside on any of the circuitry or electrical contacts can cause catastrophic damage.
    Take it to Apple for a free evaluation, but most likely you will need to replace it.  For the out of warranty fee ($269.00 USD) you will get a refurbished replacement (like new, with a factory new screen and battery).  An out of warranty replacement will also re-instate your remaining warranty, or 90 days warranty, whichever is longer.

  • I turned off my iPod touch and when I tried to turn it back on, it won't load and just sits on the black screen with the Apple logo.... HELP!!!):

    I turned off my iPod touch and when I tried to turn it back on, it won't load and just sits on the black screen with the Apple logo.... HELP!!!):

    Try a Reset...
    Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
    Restart / Reset
    http://support.apple.com/kb/ht1430

  • Just upgraded my iPad to IOS5 and when the download was completed, a window said that there was an error and it could not restore.  Now I have a black screen with the Apple logo and the circle lines.  None of the buttons respond. Help, please!!

    Just upgraded my iPad to IOS5 and when the download was completed, a window said that there was an error and it could not restore.  Now I have a black screen with the Apple logo and the circle lines.  None of the buttons respond. Help, please!!

    Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. Maybe this will let the iPad reboot and then you may need to restore again but see if this helps to start the iPad first.

  • TS3274 my ipad has a black screen and the apple logo and won't do anything else. I have tried to reset it but to no avail.

    My ipad has a black screen and the apple logo and won't do anything else. I have tried to reset to no avail.

    Try and force iPad into Recovery Mode
    1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
    2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
    3.While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
    4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
    Note: Data will be lost. You may have to repeat the above many times.

  • My touch is frozen on a black screen with the apple logo and a load bar, nothing works, tried resetting and everything, any suggestions?

    My touch is frozen on a black screen with the apple logo and a load bar, nothing works, tried resetting and everything, any suggestions?

    In that case....if you have Apple Care, give support a call - otherwise, walk it into the nearest Apple Store.
    Good luck.

  • HT201412 my iphone is not turning on its freeze on the black screen with the apple logo.Please help me guys iam fed up please its a humble request

    my iphone is not turning on its freeze on the black screen with the apple

    - Try a reset.
    Reset iPod touch:  Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Then connect to your computer and try to restore.
    - See if placing the iPod in recovery mode will allow a restore. For recovery mode see:
    iPhone and iPod touch: Unable to update or restore
    - If the logo still show all the time, let the battery fully drain. After charging for an hour try the above again.

  • I updated my ipad last night. It's got a black screen w/ the apple logo

    I updated my ipad last night. It's got a black screen w/ the apple logo

    Did the update ever complete? Presumably the update was too iOS 8.1.1.
    Have you tried resetting your iPad?
    Reset: Press the Home and On/Off buttons at the same time and hold them until the Apple logo appears (about 10-15 seconds)
    No data will be lost.

  • My Macbook will not boot the operating system.  It just goes to a blue screen after the apple logo and the spinning wheel goes off.  I took the battery out and held the on/off button for five seconds and reset the PRAM.  I have the old mac os disk.

    My macbook will not boot.  It goes to a blue screen after the logo and wheel goes off.  I have taken the battery out and held the on/off button for five seconds and reset the PRAM.  I have the the original os disk but have not put it in for fear of losing un backed op data.
    Thanks
    Rich

    You won't lose any data unless you erase your hard drive.
    Put your install DVD into the optical drive and reboot. As soon as you hear the boot chime, hold down the "c"key on your keyboard (or the Option key until the Install Disk shows up). That will force your MacBook to boot from the install DVD in the optical drive.
    When it does start up, you'll see a panel asking you to choose your language. Choose your language and press the Return key on your keyboard once. It will then present you with an Installation window. Completely ignore this window and click on Utilities in the top menu and scroll down to Disk Utility and click it.When it comes up is your Hard Drive in the list on the left?
    If it is then click on the Mac OS partition of your hard drive in the left hand list. Then select the First Aid Tab and run Repair Disk. The Repair Disk button won't be available until you've selected the Mac OS partition on your hard drive. If that repairs any problems run it again until the green OK appears and then run Repair Permissions.

Maybe you are looking for

  • I want standard report to get material MATNR for Which PO isn't created

    hi i want standard report to get material no for which Purchase Order is not created. only those Material no for Which PO is not generated. thanks.

  • G460 Disk Read Error

    Can someone help me, i'm figuring out what caaused this problem and i have so many files in my computer. When i turn it on it doesn't go through the LENOVO screen, then after 2 or 3 minutes it displays Disk Read Error, please press ctrl + alt the del

  • Flex SWC Library in Flash CS3

    I have created a few SWC libraries in Flex and I would like to distribute them so that they can be used in Flash CS3. Is this possible at all? None of the classes in my libraries contain any Flex-only classes ( i.e. anything in the mx.* packages ). T

  • Does Developer2000 work with AS400/DB2

    Hi Folks, Has anyone worked on Oracle Developer 2000 using an AS/400 DB2 as database server? Is it feasible using Oracle Open Client Adapter? Appreciate if you could detail the issues you faced during implementation. Thanks Ramesh

  • Shop for education

    I noticed on the Apple website that if you're currently enrolled in college you can "shop for education" and get products for a cheaper price. Does this also take place if you visit an apple store? Or is it strictly an online offer?