Iphone stuck in headphone mode - swapped cables, still the same problem!
The silent switch on my iPhone had stopped working so I bought a new housing from ebay and decided to swap the back around at the same time.
I noticed the little switch on the silent button had broken on the old one, so bought a new jack cable.
Put it all back together and the silent switch and everything is working fine apart from the phone thinking it's in headphone mode when it isn't
I've tried all of the fixes and nothing works. I was hoping it was a faulty cable, so asked the guy to send a new one. That arrives this morning and it is exactly the same 'Headphone Mode'
I've just plugged the old cable in and it's saying the same thing, even though it didn't before.
Does anyone have ANY idea what else I could try? It doesn't seem like it's a problem with the actual cable so I'm hoping it's nothing too drastic.
Please help!
Cheers
Does anyone have any other ideas? I've just installed 3.1 on the phone and no difference. Really don't know what else to try.
Somebody else mentioned the two different types of jack cable for the 2g iPhone one that was the reverse, but why would my original cable still think the headphones are in when they're not
Any help would be much appreciated!
Similar Messages
-
Itunes will not launch, it shows message of "itunes library .itl" can not be read because it was created by a newer version of itunes. I tried opene it in save mode but I had the same problem.
If you still have an issue you may have to see about using the iTunes version (application) included with Snow Leopard 10.6 from the installer or an another one if available online, and see if that will install.
Sometimes you may have uninstall the bits left in your system by the earlier (or later) iTunes installers; as they all leave a trace and these can stop a different version of iTunes from being installed.
Not sure if the following site/link will tell the method...
•Apple - Support - iTunes - install & update:
http://www.apple.com/support/itunes/install/
•Troubleshooting iTunes installation on Mac OS X:
http://support.apple.com/kb/HT2311
Good luck & happy computing!
ps: i see you resolved this issue. it's magic! -
i have ipad 2 16gb wifi, since 3 months it started to autorestart and crash out of games and apps, more than 20 times aday- tried to restore-install as new ipad- soft and hard reset-, updated to the latest 7.0.4 but still the same problem
plz help....Vinayaka-
After all you've tried, Dah*veed is probably right about needing warranty assistance.
But first check to be sure Settings-Airplane Mode is set to OFF, and Settings-WiFi-WiFi is set to ON.
Try unplugging your WiFi router for a few seconds. Then reset the iPad's network. Go to Settings-General-Reset-Reset Network Settings. You will need to reconnect to your WiFi.
Fred -
Hey, I'm trying to install Adobe Flash on my Macbook Air. At a certain point it asks for my password but it doesn't take it. So I cannot continue installment. I have reset my password already. Still the same problem. How can I continue to install when it keeps asking for a password it doesn't recognize over and over again? How many times do I have to reset it then? Advice please
You have to provide your computer's administrator password in order to install Flash Player.
-
My iPod Nano 7th Generation couldn't be detected by iTunes when I plugged in. I tried resolving the issue by uninstalling the iTunes and then install it back again but yet still the same problem exist. Can you please help me to solve this issue? I have already updated to the latest version of iTunes on my Windows 8 and I cannot synchronize my iPod for the time being. Please do help me to solve this problem. Thank You.
uninstall all iTunes,5 programes,this worked for me after reinstall them
-
i upgraded my firefox to 3.6.4 but when i add some add-ons it tell me that i have 3.5.8 & i have to upgrade it ... i reinstall 3.6.4 several times but still the same problem ...
== 2-3 days agoLook at the highlighted copy of your Help > About Mozilla Firefox image attached below this message.
<u>'''Reset general user-agent'''</u>
-In Firefox, type '''about:config''' in the URL bar and press the Enter key.
-If you see the warning, accept it (promise to be careful).
-Filter = general.useragent.extra.firefox
-Right-click that preference and select Reset
-Then restart Firefox (File > Restart Firefox) -
Fife days App Store not give it to me the verify code, I made I lot email adress, changed and created the new, still the same problem, and this is second iPad that I bought this month, if not help me I don't know how to deal, thank you in advance, maybe I will go to shop and want my money back
Do you have a technical question for us volunteer users?
-
IBooks application is not working properly!! It shuts down immediately after opening .I tried installing the app. Again and still the same problem!!
Will I lose my emails I have on there? I have numerous client email files and can't afford to lose any of them. I do have everything backed up but I'm fearful of losing important client info. What if something happened during the back up and it doesn't have my files?
-
I'm having some problems wiht Firefox, for example; Youtube isn't loading right, Facebook won't let me send messages, search up people, and this website i made wont load right also. I've re-installed and updated it but still the same problems. Any help?
Because I know enough to be dangerous... I was trying to extend the two outside columns down.... Instead of just using faux columns which I have fixed since I posted the question.
The other link problem is the left sidebar links. When you go to the event photos page I have a repeat of the sidebar links that are on the newsletter page. I used named anchors on the newsletter page to link to the particular article. From the Event Photos page the links look like this:
<a href="1112Visions_Iss1.html/#puzzle" target="_self">[Puzzle]</a>
The problem I am having is that some of these go to the newsletter page and the anchor and some do not (I get an error message saying it can't find the page). To add to the problem is that when we choose say the President's Message, when it goes to the newsletter page and the correct anchor, the newsletter page is missing all the links to the graphics... the photos are missing the graphic for the faux columns is missing. It makes no sense. When I preview the newsletter page from Dreamweaver everything shows up fine.
I do not know if all of this is being caused because I haven't posted this stuff to the site or what. I've tried re-booting both the browser and Dreamweaver, dumping the cache and still the same nonsense.
Got any ideas? -
Upgraded this morning. All worked fine for about 30min then "no service". Still the same problem and a reset of the device only fixes the problem for 15min. then we are back to no service?? When will apple fix this???
Tried to reset network settings ...only fixes it for 15min. Did a firmware restore and a clean new phone setup. no settings restore. still have network service after around 60min. still running 6.1. i do get a prompt that i have to update settings to LTE. Have not excepted the settings as yet. Cellular data is still set to 3G....
-
i tried to restore my new ipad in my itunes but it keeping restore it to my old ipad. I did delete also all my backups in the iTunes, still the same problem is showing??? please I need a huge help to have my new iPad as I bought it???
pleeeeeeeeeeeeeeeeeeeeeeese I need an URGENT help,,, someone answer me back
-
I receive a message indicating that my Apple ID is disabled . Although I've changed my password still the same problem exists.
Mehrak88 wrote:
I receive a message indicating that my Apple ID is disabled . Although I've changed my password still the same problem exists.
Mehrak,
Messages like that are almost always phishing, and are not actually from Apple. Changing password does not affect it, since they can still send you the same email.
See this document:
Identifying fraudulent "phishing" email
Does it fit the description, or is it something else? -
IPhone stuck in "headphones" mode....
My iPhone appears to be stuck in "headphones" mode. Sound works fine through headphones when they're plugged in, but when headphones aren't plugged in, I get no sound at all from the phone. When I adjust the volume with the buttons on the side, the display says "Ringer (headphones)." Help!
I had exactly the same experience as Spartan95. My iPhone got stuck in headphones mode just before a business trip, and stayed that way for 2 weeks before I could get to the Genius Bar. I tried resetting, compressed air, restoring... and nothing worked. The Genius attempted a restore in the store, and when that didn't solve the issue, handed me a new phone. Too bad there isn't a manual software "switch" available in the phone's options panel. Oh, well....
-
Iphone stuck in headphone mode- speaker not working
They keep saying not many people are reporting this, so I thought I'd throw my two cents in:
I'm on the phone- suddenly silence, but the call continues. If I hit speakerphone, that works and they're still there. I turn off speaker phone, they're gone. BUT if I turn the volume up, it says "headphones" AHH it thinks there are headphones plugged in.
On the newer macs, there's a switch that can tell if a jack is plugged in and it can stick- you can have to insert a jack pointing down to hit that switch (to make the laser stop coming out of the jack)
On the phone, they tell you to jam a phone jack in and out several times before giving up and resetting the phone. I get that to work sometimes, but it shouldn't happen...Okay, I had a similar issue with my phone about a month and a half ago. If you're like me and explore every aspect of the iPhone, then you're taking the headphones out and putting them back in a lot. I found that my higher brain can still in fact control the iPhone, although incredibly sophisticated. If you take your headphones or any other TTY jack and put it in and out of the iPhone jack rapidly over and over again it should solve the issue. I had only to put it in and out about 6-10 times, but I'm sure I overkilled it =)...I have never had the same problem with my phone...That should work, but if not then it might be a more serious issue.
-
I can't open my fb,games in my iphone 4s i already reset my phone still the same help!
I can't open my fb,games etc. in my iphone4s i already reset my phone still the same help!
Most FaceBook games require Flash, which is not available on iOS devices. Check the App Store to see if the games you play are available as iOS apps. Many are.
Maybe you are looking for
-
I got a macbook pro i want to wath it on my hdtv
my macbook don't display anything on my hd tv
-
Hi All, I have a problem where I have just updated to SP 18 and now the BEx Query Designer comes up with a problem, I can open the Query Desinger but when I go to open a query from my history the Query Designer shuts down immediatly. Has anybody got
-
CRM ICWEB "END CALL" tab getting truncated in IE8
Hi, We have CRM 6.0 (2007) running on IE6 and planning to upgrade the browser to IE8. During testing, found that "EndCall" tab on Identification screen is getting truncated after clicking on it. Upon click the tab moves up into the header area and ge
-
How is skill weighting handled?
We use skill weighting for our workgroups as sometimes we need backup from one to the other. It works okay, but sometimes not as well as we would hope. I have two problems in troubleshooting this. For one, our Agent Skills Report doesn't run right. W
-
Printing JList - font problems
i am using a class that takes a Component and prints it. in windows: when i send a JList, it prints using the standard java font. if i set the LookAndFeel to the DefaultOS, then if i set font that is what I am assuming to be the System default (in wi