Iphone updated by syncing. Now battery is completely dead and phone will not turn on.
I synced my phone using Itunes and afterward it appeared "dead".....would not open, would not charge, would not do anything.
There's only one thing you can do: make an appointment with Apple genius at the Apple retail store for a out of warranty replacement.
Similar Messages
-
Did the new ISO update and phone will not turn on at all. what do i do?
My fiance went to do the newest update, His phone will not turn on. I plugged it into my MAC and its saying that it is in recovery mode. We have tried holding the power and home button, as well as fliping the mute switch. What else can we do?
Hi denise mfrompalatine,
If your iPhone won't turn on, try the steps in the resource below:
If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support
https://support.apple.com/en-us/HT201412
Hope that helps ...
- Judy -
I have just updated my iPhones 5s with and my phone will not turn on one now please help
I have just updated my iPhones 5s with las test update ios 7.0.5 and my phone will not turn on one now please help
Try a Hard Reset,
press and hold both the Sleep/Wake and Home buttons for at least 10 seconds, until you see the Apple logo.
if that doesnt work you may need to do a restore
http://support.apple.com/kb/ht1808 -
Just updated my iPhone 5s and it will not turn on now
I have just updated my iPhones 5s with las test update ios 7.0.5 and my phone will not turn on one now please help
Do a reset, hold down the home/sleep button together until you see the apple logo and then release.
-
My iPhone 4 is completely dead and won't charge, turn on, no signs of life!
My iPhone 4 is completely dead and won't charge, turn on, no signs of life! What to do???
Was late to work because my alarm didn't go off on my iPhone this morning! (4 w/ IOS 5) When I woke up, I went to check my phone and it wouldn't turn on; so I plugged it in to the charger and no response. I left it plugged in while I was getting ready...came back a shortwhile later...still no signs of life. At that point, I held both buttons for several seconds and the apple logo appeared and the lock screen displayed shortly thereafter. And what's odd, is that it showed that I had about 80% of battery life left. So it seems like something else caused it to shutdown completely. One note though...I updated to IOS 5 on Sunday...and I've used my phone ever since with no problems. So this is the first time this has happened since the update.
In looking at a thread on another site, I found this excerpt from an alleged beta tester back in June...and it was in reference to the iPad 2 with IOS 5, but seemed plausible enough to share here:
Issue: "Hey guys, whenever my iPad 2 is locked for a while, it wont wake from sleep. I have to give it a hard reset. Is anyone else having this issue?"
Response: "I think I isolated the issue....make sure banner notifications are turned off for mail app. If the screen is locked and you get a mail it freezes up causing you to reboot. hope it gets fixed in the next beta!"
Follow-up: "Did it help you at all? I tried recreating every way I could think of with mail and never could. I'll turn of mail notifications for the rest of the night and see what happens."
"Hey Rick, yes it helped, my iPad no longer shuts off. I turned off mail banner notifications like Defender2010 said, and at least for now, it doesn't turn off anymore." -
I have a n IPhone 4S. I upgraded to IOS7 and then tried tp go back to my prevous IOS and now my phone will not turn on at all.
I tried to do the same, but couldn't find ios 6. I even tried the APPstore, to download the last IOS6 version.
The most problem is the running out of the battery.
I've checked each app who is "eating" the most power.
The battery stoped runaway, when I closed the weather service....
So for now, I will use regular internet service, and probbaly will do to more app.
Until, finaly, I will find my self with all the applications closed....:-)
That will be the sign, to replace my phone to anderoid....:-)
Till now, there is no any sign from Apple to have a glance to our complanes. -
My IPOD Touch initially had a white screen. I tried correcting this by restoring default settings via ITunes. The Restore Failed with error 1602 and now the IPOD touch is completely dead. It will not power on or respond when I plug it into my PC via USB. I get an error on my PC stating that device attached to USB port is not recognizable. Can anyone help?
Error 1602: Try the following steps to resolve this error:
Ensure proper USB isolation troubleshooting has been performed, and test with a known-good cable.
Follow the steps listed for Error 1604.
This error may be resolved by disabling, deactivating, or uninstalling third-party security, antivirus, and firewall software. See steps in this article for details on troubleshooting security software.
Above from:
http://support.apple.com/kb/TS3694 -
My wife spilled a gas of wine on her MacBook Air . Now it's completely dead, and doesn't even show it's being charged.... Any advice is welcome .
Liquids and electricity don't mix. Any hope of surviving a spill is based on immediately turning the device off, getting it as dry as possible, and then letting it have a lengthy drying period. Some people recommend putting it in rice to absorb moisture though I think that has its own danger. At this point your only solution is to take it to an Apple repair center and see what it will cost to replace the logic board - and to hope that was the only damage.
Sorry I couldn't provide better news. Check your home owners policy to see if this is covered (and if it is worth using). I have a specific rider on my policy for electronic equipment which includes full replacement value with no deductible. -
I was trying to update my phone to ios 7. There was an error and it stopped. Now my phone will not turn on.
Try recovery mode as described here. You may have to try to enter recovery mode more than once to succeed.
http://support.apple.com/kb/ht1808 -
I just did a restore to my new iPhone 6 from iTunes and now my phone will not turn on at all. How do I get it to re-start?
Hi denise mfrompalatine,
If your iPhone won't turn on, try the steps in the resource below:
If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support
https://support.apple.com/en-us/HT201412
Hope that helps ...
- Judy -
HT4528 I installed the update on my phone and now my phone will not turn on
I installed the update on my phone and now my phone will not turn on
I installed the update on my phone and now my phone will not turn on
-
Phone will NOT turn on after synching & updating (or trying) to ios 6. ? ..... Is it REQUIRED to "restore" to factory setting? When researching, I read that you will get an option to restore from back up. I am not receiving any options on iTunes.... restore only & basically it is telling me I will lose everything.
I am reading on this site about the error I am getting and it wants me to change some files that I am not comfortable messing with. Mainly because it is like a foreign language. Will the store do this for me or tell me if it is neccessary?
-
My iPhone 4s is stuck on a black screen that shows a USB cable connecting to iTunes. The phone will not turn on and the iTunes logo as I described only shows up when I plug the phone into the charger or my computer. I have tried the reset in restore mode as well as the DFU? mode and it still will not work. I have the latest version of iTunes on my Mac. My error code was 2002. I also tried it on my laptop (windows 8.1) and none of the above worked. My error code on my laptop was 02. The phone is through Verizon and it has absolutely no damage. It was working fine up until this and I have been trying to fix it for 2 days. Please help! I am unsure of what version the phone was currently running on before this because I have another iphone that's my primary phone and have not used this one in about a month. I do not believe it was updated to IOS 7.
Your iPhone is in recoverty mode at the moment so to possibly get it back up and running you would need to do a restore as you have been trying. Follow the steps in the article below for the specific error messages you have been receiving. If after following all steps the issue remains book an appointment at a local Apple Retail Store to have the iPhone evaluated.
Resolve specific iTunes update and restore errors -
i need help my iphone 5c has been on charge for 5 hours and still has not turned on past the charging symbol, what can i do? (baring in mind i got this phone 2 days ago brand new.)
Do you see a lightning bolt near the battery , Battery is charging (supposedly( IF not return to where you purchased it (also make sure that the charger is on) if still not charging with lighting bolt bring it back
-
I have an iPhone 4 and it will not turn on. I plug in and says connect to iTunes. I connect it and it won't restore. What can I do? Please help
http://support.apple.com/kb/TS3694#error21
These errors typically occur when security software interferes with the restore and update process. FollowTroubleshooting security software issues to resolve this issue. In rare cases, these errors may be a hardware issue. If the errors persist on another computer, the device may need service.
Also, check your hosts file to verify that it's not blocking iTunes from communicating with the update server. See iTunes: Advanced iTunes Store troubleshooting—follow steps under the heading Blocked by configuration (Mac OS X / Windows) > Rebuild network information > Mac OS X > The hosts file may also be blocking the iTunes Store. If you have software used to perform unauthorized modifications to the iOS device, uninstall this software prior to editing the hosts file to prevent that software from automatically modifying the hosts file again on restart.
Maybe you are looking for
-
Windows 8.1 Capture through MDT Get Error -217217406 in MDT 2013
zti error unhandled error returned by lti apply not found 217217406 0x80041002
-
How to delete pic and docu from iPad desktop
-
Keep getting JBO-35007: Row currency errors on all pages if the user doesn't press the submit button within a certain amount of time. Thanks
-
hi evrybdy can we use MAX aggregate function to pick a field of type char from database table ...if yes thn how ..? plzzz ans soon . thank u .
-
Hello everybody! I'm trying to insert new nodes into existing BW hierarchy. I've found appropriate class CL_RSSH_HIERMAINTAIN_BASE and method INSERT_NODE_HIERARCHY. Unfortunately, there is no mention about this method on the internet. Can anybody giv