Ipod 2g will start and shut down after 10 secs on logo

i will hold power button then it will start loading with the logo then after 10 secs it just shuts down and wont let me get to slider

Try a hard reset. If that does not work, put it in Recovery or DFU mode and restore it.
Basic troubleshooting steps 
17" 2.2GHz i7 Quad-Core MacBook Pro  8G RAM  750G HD + OCZ Vertex 3 SSD Boot HD 
Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101
 In Memory of Steve Jobs 

Similar Messages

  • IMac starting and shuts down after less than one minute...

    Hi !
    I hope someone could help me with this problem...
    I think I've tried everything... CMD+Alt+P+R / CMD+R / ... SMC...
    I'm a little lost because I can't access to the computer (it shuts down before arriving on the desktop). I've also tried to access just to the hard drive by connecting 2 Mac with Firewire cable... And the same problem appears. The iMac is also shutting down to soon to backup anything...
    Is there someone who has experienced the same problem ?
    Thanks !
    Best regards,
    Jonathan.

    Hi Jonathan..
    Just to rule out any hardware issues, might be a good time to run the OS X Lion: Use Apple Hardware Test

  • G4 MDD FW800 starts up and shuts down after several seconds

    Hi all,
    My G4 MDD FW800 DP.1,48 starts up and shuts down after about 20 seconds. I Have reset PMU and checked battery voltage, witch was OK. (also had it out for 30 minutes with no power connected etc.) I have video and also tried with NOTHING connected. But still it just powers down and failes to enter start up procedure.
    Last time I had it running I pulled my iPod, beacause the computer did't see it, the next thing I saw on screen was the message to hold the power button for 5 to restart, after that I got the problem described above.
    Anybody?
    Thanks,
    G4 MDD FW800 DP1,48 Mac OS X (10.4.2)

    Hi, I don't know how fast it shuts down, but...
    How to reset the SMU/PMU on a Power Mac earlier G3, G4, G5 models...
    http://support.apple.com/kb/HT1939
    Have you done a PRAM reset, CMD+Option+p+r...
    http://support.apple.com/kb/ht1379
    In fact, do 3 in a row, takes a bit of time.
    Does it boot into Open  Firmware with CMD+Option+o+f ?
    http://docs.info.apple.com/article.html?artnum=42642
    reset-nvram (press Enter)
    set-defaults (press Enter)
    reset-all (press Enter)

  • Slow start up and shut down after Zenworks installation

    I hope someone can help me out on this one. Not sure if I am posting the
    right forum or not but here we go. After I installed Zenworks on our PC's
    here at work, we have a noticed a distinct difference in how long it takes
    for the PC's to start up and shut down. Before installation, everything
    was very quick, like it should be. Now it seems to take some users 3-5
    minutes to start and shut down their PC's. The machines are running
    several different OS'es. Windows 98SE, Windows XP Pro SP1 and Windows XP
    SP2. No one OS has more problems than the other. Has anyone heard of
    Zenworks causing this issue or heard of a way to prevent this? I would
    really appreciate any help you can provide.
    Thanks!
    Jami Benson

    On Thu, 20 Dec 2007 09:12:26 GMT, Rolf Lidvall wrote:
    > See this article by Shaun Pond:
    > "Using Search Policies Effectively in ZENworks"
    > http://www.novell.com/coolsolutions/feature/15294.html
    I would also suggest to get either some training or self study material or
    read the online documentation
    Marcus Breiden
    If you are asked to email me information please remove the - in my e-mail
    address.
    The content of this mail is my private and personal opinion.
    http://www.didas.de

  • My itunes will stop working and shuts down after 5 to 10 minutes playing. I have the most recent updates. How can I repair or correct this from crashing?

    My itunes will stop working and shuts down after 5 to 10 minutes playing. I have the most recent updates. How can I repair or correct this from crashing?

    Hello there, jbenjaminii.
    The following Knowledge Base article offers up some great recommendations for troubleshooting the issue you're describing:
    iTunes for Windows XP: Troubleshooting unexpected quits, freezes, or launch issues
    http://support.apple.com/kb/ts1421
    Thanks for reaching out to Apple Support Communities.
    Cheers,
    Pedro.

  • Hi my desktop starts and then shuts down after the apple logo and an oblong box appear.thanks

    hi my mac
    desktop starts then shuts down after displaying the apple logo and an oblong box.
    thanks

    Sounds like something is badly wrong with your system.  First step would be to start up from your Mac OS X install disk, by inserting the disk and holding down 'c' at startup.  Select your language, then choose Disk Utility from the Utilities menu.  In Disk Utility, choose your hard drive and click the Repair Disk button.
    If problems are repaired, try restarting and see if the problems are gone.
    If problems couldn't be repaired, you can try DiskWarrior, which can sometimes repair problems that Disk Utility cannot.  However, if nothing works, you probably are going to have to erase the hard drive and reinstall the system from scratch.  Hopefully you have backups!
    If there were no errors, or they were repaired successfully but that didn't fix the problem, then you should try booting into safe mode by holding down the shift key at startup.  If that works, you may have some bad third-party software.  What that might be is hard to say, though.
    If nothing works, try rebooting from the Mac OS X install disk again and install Snow Leopard right on top of your current system.  That shouldn't disturb your apps or data, but of course, if you don't have backups, you're in trouble if something goes wrong.

  • Hi my iMAc 27 inch starts up to the grey screen with apple logo and loading bar underneath it loads halfway then freezes up and shut down after a while please help

    Hi my iMAc 27 inch starts up to the grey screen with apple logo and loading bar underneath it loads halfway then freezes up and shut down after a while please help

    Try the tips listed here Mac OS X: Gray screen appears during startup - Apple Support

  • MacBook is starting to shut down after 5 minutes.

    My MacBook has just started to shut down after 5-10 minutes. The computer still holds a charge, and the battery Percentage says that it's full, so I dont know what's going on.

    If it's under AppleCare take it in immediately.
    It is possible that a fan might not be working, and causing it to overheat & shutdown as a safety measure.
    The other reason could be RAM.
    But that's just my guess.

  • My MacBook Pro starts and shuts off after loading for sometime

    My MacBook Pro starts and shuts off after loading for sometime

    Try starting in Safe mode by holding down the Shift key while booting. Safe mode takes a while to load the OS. After that, restart the computer normally.
    If that does not work, start up in Recovery by holding down the Command and R keys. In the window that opens, choose Disk Utility at the bottom and verify and repair your disk. Repair permissions while you are there.

  • Starting up and shuts down after 30 seconds

    My powerbook started doing this. It's starting up, you hear the chime , then the spinning thing with the gray screen, then it shuts down after about 30 seconds.
    I did try a few things that I've read in different threads. I can do the single user mode and the black screen comes I can type the things from this thread but it doesn't look it works.. https://discussions.apple.com/thread/1801027?threadID=1801027 . I did type those commands w/wo the "+" signs.
    Please help

    The plus signs were remnant discussion formatting keys and are not part of the commands.
    OK, here goes on what to do.  Boot into single user mode.  Then try the following  command
    /sbin/mount   -uw   / <enter>
    which mounts the boot volume as write-enabled (it normally comes up read-only to begin with) then this command:
    /sbin/fsck   -fy   / <enter>
    And let it attempt the repair of the boot volume.  It will either report that the volume is OK or that it has been repaired.  If it has been repaired, then repeat the second command until it just says things are OK.  Please post the results.
    Note that usually, in single-user mode, those commands will appear as an advisory just before the first terminal prompt.

  • SL takes longer time to start up and shut down after "IceClean".

    Greetings,
    After "IceClean" (both maintenance and cleanup), SL seems (obviously) to take longer time to start up and shut down.
    Any idea why and how can I resolve it?
    Thank you so much.
    Cheers.

    Hi,
    I've finally able to solve the problem. The problem was due to start up item. There were 2 trial application (expired long ago) in the folder. After clearing the application, start up and shut down are fast as light.
    I think I've "awaken" the start up application after "IceClean" as IceClean has deleted their log file or something like that and therefore the applications have to run again.
    In order to be fair to IceClean, it is my fault to be blamed.
    Thanks again.
    Cheers

  • Satellite Pro A300D gets to warm and shuts down after short time. HELP!!!

    Hallo together,
    i bought the Satellite Pro A300D notebook 3 weeks ago. Since the beginning I have the problem that the notebook gets to warm and shuts down within an hour!
    I dont run any high performance application and I keep the left side of the notebook free so that the warm air can get away! I already cleaned the heatpipe by using a hoover.
    That couldnt be! I need the notebook for work and thats impossible...
    What can I do? Do I have it to send in?
    For help I am thankfull
    Frank
    Message was edited by: DerVogel

    Hi there DerVogel ,
    Sounds like a Heat related issue ????????
    Whenever it shutdown automatically does it turn on right away ? One symptom of a heat related issue is, it takes about several minutes before you can turn it back on again.
    Here is how you can isolate the issue since it could also be a software related problem.
    1) Turn on the system Tap F2 and boot on the system setup screen ( BIOS )
    2) Just stay on the Bios , If it doest shutdown on the bios then you might need to reinstall windows. or check if system is infected with spyware or a virus.
    But if it does the same thing then the best thing to so is to bring it to a Repair Center or Call Tech support for a depot service repair.
    Cheers ! hope this will help.
    Message was edited by: iSkO

  • Why does starting and shutting down iTunes on my Mac stop movie from playing?

    Every time I start or shut down iTunes on my Mac, the movie I'm watching on my Apple TV stops playing and goes back to the menu.  It also loses the spot in the movie, so I have to fast forward to my spot.  Extremely annoying.  EVERY TIME.

    Unless it is actually associated with something not working, it isn't a problem. I've always seen it on my machine, which works perfectly and has done so for 2.5 years now.

  • Macbook turns on to gray startup screen but will not load and shuts down after about 45sec -1 min

    Hi There,
    My Macbook pro has been experiencing some craziness the last couple of days.
    Yesterday it was sort of slow and I was experiencing the rainbow spinning wheel between all applications.
    The battery was very low so I charged it and attempted to turn it on today.
    Now, when I turn it on I am experiencing the gray startup screen with the spinning geat and what sounds like
    the CD drive going ( I believe I have a disk in there). After less than 45 sec to 1 minute the machine just shuts off.
    I have tried the safety start and a few other startup methods, but always the same result.
    Any ideas or should I go strait to Apple hospital?
    Thanks-

    Did you find any help to this? I have the same problem!

  • Macintosh HD greyed out and shut down after progress bar complets

    Hello everyone, after i manually closed my macbook by holding the shut down button for 5secs due to an application crush, my macbook pro doesnt seem to be able to boot anymore. It executes the progress bar under the apple  icon on the screen (trying to repair my hd) and after it completes the process, it shuts down. When i press cmd+R, i can see from disk utilities the 500GB hard drive and the macintosh hd. The 500GB total hard drive is normal (even with no problems to fix after running verify and repair) but the Macintosh HD-part is greyed out and verify/repair fail with an error when i click on them. What should i do? i dont think its a hard drive failure. At least, how can i back up my system or some files? from disk utilities the new image function should be executed for the macintosh hd partition and not for the parent 500GB hard disk in order to make a backup, right?

    1) In a Finder window, select the Macintosh HD. Can you see the contents? If yes, you can select to drag over files.
    2) Download SuperDuper (free) When it opens does it recognize the internal drive in the popup? If yes, you will need to make a second portion on your external drive for the clone of your internal drive.
    3) If you can't see the contents or the drive in Finder or SuperDuper then you will need to download and run Mavericks over the internal drive.

Maybe you are looking for