Ipod Classic 80G Diagnostics SDRAM BackLight off : Fail

Run a diagnostics test and got the result BackLight Off ; Fail. Is this maybe the source of my apparent battery problems. Replaced battery but still running out in 3 hours.
What can I do about this result?

found the answer! - posted in 2010 from Bryan: hold the centre and menu buttons down at the same time for about 15 seconds. Had to do it about 3 times until the apple icon comes up and then its ok. Thank you.
Now to update my 'stuff'. I love this board! Thanks.

Similar Messages

  • IPod Classic 80g..message 'Delayed write failed?? Will not sync to itunes!

    This message appears when I try to connect to my pc...
    'Delayed write failed. Windows is unable to save all the data for the file J:\ipod_control. The data has been lost. This error may be caused by a failiure of your computer hardware or network connection. Please try to save this file elsewhere'
    Ok..
    A: I know the 'J' is the drive it is assigned too...I have been to admin and changed it....No luck
    B: I have found the actual file in the hidden folders but cannot move it or save it elsewhere as it suggests....
    C: I have reset and at one point factory restored through itunes.....
    D: I have even been into the system start up sequence and set it up for ipod and itunes only.....
    Am I being silly or is there a solution???
    Please can somebody shed some light as to what to do...
    Ta muchly
    Chris

    My husband's 80GB iPod had the same problem a few months ago...turned out it was due to corrupted album artwork. Try unchecking the box "Display artwork on this iPod", close iTunes, reconnect iPod to iTunes and then recheck the box "Display album artwork on this iPod". Once I did that, the iPod loaded perfectly and no more error messages.
    Hope this helps!

  • I've got a iPod classic 80g I've got loads of pictures on there and I want to get them off. I've tried something where the files I get off come up as thumbnails which I can't open. Is there any way of getting them off and viewing them as a normal photo?

    I've got a iPod classic 80g I've got loads of pictures on there and I want to get them off. I've tried something where the files I get off come up as thumbnails which I can't open. Is there any way of getting them off and viewing them as a normal photo?

    Oh no... NOT THE 99-PAGER!!! Anything but THAT!!!

  • I have an ipod classic 80G and i been trying to restore it but it doesn't let me help!!

    i have an ipod classic 80G and i been trying to restore it but it doesn't let me help!!

    Add a valid payment method to your account. That is required even for free apps and app updates. If yo think the payment method is valid contact iTunes:
    Apple - Support - iTunes - Contact Us

  • Podcasts Ipod Classic 80G

    Hello Folks,
    I am new to this forum, having just purchased a new Ipod Classic 80G yesterday. I tried so far to sync some golf lesson podcasts that I had subscribed to in Itunes, and they did sync with my Ipod, but are all in a single file, not in single lessons that I can access one at a time. I tried to create my own playlist of all of the in a list and sync'd that but they show up as music and will only play the sound on them. Can someone help me to get them on my Ipod in selectable order so I can play each one separately, with the video and sound?
    Many thanks,
    Jim

    I discovered after working with my unit more, I had the lessons on it just the way I wanted them to be.
    Jim

  • Will apple repair my ipod classic 80g with video?

    I got my ipod classic 80g in 2006.  I used it for a couple years and was very satisfied.  It was in a backpack that was tossed carelessly, and then stopped working.  The screen does not display anything except for some black lines.  The physical casing is not broken however.  When I plug it into a computer, I can hear the harddrive spinning, but itunes won't recognize it, and it won't show up as a device on my computer.  I have waited so long to inquire about a repair because I have replaced it a couple of times with other ipods.  I would really like to have this one repaired as I don't have an ipod curretently. And, instead of buying a new ipod classic, I would like to have this one repaired.  I read that it would cost $129 to repair this ipod.
    I would like to know however, if I spend $129 will apple repair my ipod for sure?  If it is deemed unrepairable, will I get a replacement?  Or will they refund my money? 
    Thanks for reading and giving your time.
    -Madison Albert

    Apple doesn't actually repair iPod, but does an out of warranty exchange of it for a refurbished model of the same generation and capacity.
    And it will cost $129 according to this page: http://support.apple.com/kb/index?page=servicefaq&viewlocale=en_US&geo=United_St ates&product=ipod&select=REPAIR_PRICING
    B-rock

  • Loading cd collection onto ipod classic 80g

    ihave 700cds to load onto ipod classic 80G via itunes but my computer only has room for approx250.Can i delete those 250 from my itunes folder and start again?how do i load them all?

    To load them all you would have to buy an external hard drive to move some other things over from your computer or just have the music files on the hard drive. If you can only have 250 of them then here is what to try.
    Import the first 250, then have the ipod on manually manage music etc... Drag and drop all the 250 CDs content to the iPod.
    After done copying delete the files for the first 250 and then put the next set on and repeat copying them to the ipod, repeat this until all 700 CDs are on iPod.

  • Can iPod Classic 80G use coverflow view?

    I bought a used iPod Classic 80G, and I restored it to its original settings, and i have the latest softwere version, wich is 1.3. I have basicaly 2 questions:
    1) When i'm using my iPod can i search my musics with coverflow view? I know that the new ones can, so i would like to know too if apple intends to distribute the new softwere for iPod classics that would include feutures like genius playlist and coverflow view.
    2) I got used to coverflow on my iTunes library, but i can't use it when i'm looking at my musics on the iPod in the computer. I can't even view as grid, and i'm stuck with view as list. The question is, am i really stucked as view or is there a way to view it sorted by albuns?
    Tanks for the help

    It's not a "Classic" - the latest firmware for the 80/16Gb iPod Classic (i.e. 6th gen.) is v 1.1.2. You have a 5th generation iPod. Menu options are what you've already seen. There are no prospects for Cover Flow or any other graphically enhanced menus on your iPod.
    tt2

  • I have a white screen on my ipod classic 80g need some help to try and resolve it . HELP PLEASE

    I have a white screen on my ipod classic 80g need some help to try and resolve it . HELP PLEASE

    iOS: Importing personal photos and videos from iOS devices to your computer
    iOS: Unable to import photos or device not recognized as a camera

  • My ipod classic 80G is displaying the error message "this accessory is not supported" when placed on my Altec Lansing dock

    Ipod is 80G Classic and displaying no other unusal or faulty behaviour. In the couple of days between the dock working fine and the error message appearing, there were no software updates. The ipod is actually a couple of years older than the dock- what's going on?

    So the iPod worked previously on this particular dock? Does Altec's support website state that it supports your particular model iPod Classic?
    Have you tried a hard reset of the device with it still connected to the dock?  To do this, first make sure the hold switch is in the Off position, then press and hold both the Select (Center) and Menu buttons together long enough for the Apple logo to appear.
    It wouldn't hurt to also check the dock connector on the iPod for any signs of debrisa and bent or corroded pins that could be blocking the connection between the dock and iPod.
    B-rock

  • IPod Classic 80G wont take movie rentals ???

    Just downloaded three rental movies ok to my PC. They ar ein my library ok now but Classic 80g iPod did not synch them nor could i manually drop them anywhere. Any ideas ??? It claims lates revsw of iTunes and firmware. Everythung else synchs fine but this is my first rental movie try.

    The 5th gen iPod "classic" was the first "video" iPod.  It's video capability is more limited, and supported video resolution is lower, typically only 320x240.  Even if the video is standard def (SD), and not HD, it is probably at least 640x480.
    Also, current iTunes Store video content (such as TV shows and movies) uses DRM (copy protection).  The 5th gen iPod was designed before the iTunes Store started selling video content (as it does now); I don't think it supports the DRM technology. 
    If you have video content that is not DRM'd and plays in iTunes (such as video podcasts), you may be able to use the convert command in iTunes.  Select the item on a list in iTunes.  From the iTunes menu bar
    File -> Create New Version -> Create iPod or iPhone Version
    That version may play on your iPod, so iTunes will sync it.

  • IPod classic 80gig won't turn off

    My iPod classic 80 gig (2007) won't turn off. It seems to me the whole Play/Pause switch is non-functional. How to fix? Everything else seems all right.
    Also, when I do 'reset', and get the apple logo, is that signifying 'turned off'? (I've just bought the iPod 2nd hand, so am not familiar with it.)
    Replies appreciated.
    blaggie

    For what it's worth:
    My iPod Photo (60G, purchased June 2005) wouldn't turn off either. I nearly always play the iPod docked to a Bose SoundDock external speaker. Yesterday, I lifted it off the speaker dock without turning it off first to take it on a trip. Discovered it wouldn't turn off by holding down pause/play, even for a full minute. No choice but to let it drain until the next day. Back home, I placed it in the dock, let it charge for about 15 minutes, turned it on (it turned on OK), turned it off *while still docked* (it turned off OK), took it out of the dock, turned it on out of the dock (OK), turned it off out of the dock (OK).
    Not sure what, if anything, this means.

  • Windows 7 and iTunes doens't recognise iPod Classic 80g after wipe clean hard drive and format fat32.

    My iPod Classic 80gb every now-and-then goes funny, and eventually iTunes doesn't recognise it. In the past I could put it on disk mode, and do a reset, but some times I would have to format (FAT32), uninstall and reinstall iTunes, so it would work. Now it happened again, this time wiped clean the hard drive and formatted. However windows 7 and iTunes still doesn't recognise it. Tried many tips online but nothing works. All software I have used don't see the hard drive, so can't format it again.
    I can get it on disk mode but even then windows and iTunes don't recognise it. When connecting to laptop my machine goes boiling hot. Left it connected with iTunes on for  few hours but still no luck.
    Any suggestions?

    Hello @turingtest2.
    Following your threat I realized it was time to have my hard drive changed. My iPod classic has a Samsung Model: HS081HA, 80gb/3600 rpm (real hard to get it open and check out!!!).
    My question is if I DO HAVE to buy exactly the same hard drive, or I could get away with another manufacturer and model, such as Toshiba (80 GB MK8009GAH FOR iPod Video 5th 5.5th iPod Classic 6.5th 7th Gen Hard Drive - Ebay listing)?
    I ask you that as these Toshiba hard drives are considerably cheaper.
    Help much appreciated.

  • Background Cover Flow Ipod Classic 80G

    Hello,
    I've got a question about de background of the Cover Flow on my Black Ipod Classic 80 G. Now i see the covers on a white background. On promotion stuff of Apple is see a black backround and that's much better
    Does anyone know if I can change the colour of the Cover FLow background?
    Thanks!

    The Cover Flow background is black in iTunes, on iPod touch and on iPhone, but white on iPod classic. There is no setting that would allow changing the background color.

  • IPod Classic 80G isn't picked up buy windows

    Right so have got my iPod classsic 80G back from apple repair but it dosn't seem to work. I'ved plugged it into my computer (Windows XP Home SP2.I get the sound to say that it has picked up a USB device but niether iTunes or windows picks it up. I have tried resetting the iPod dosn't work i have done the five 'R's and no joy.

    Have you had a chance to look at these troubleshooting pages? They may be of some help:
    iPod missing in My Computer and in iTunes
    iPod is not recognized properly by computer when USB drivers are not installed properly or are out of date
    If you are using a laptop, this page might help: iPod not recognized when connected to Windows laptop over USB

Maybe you are looking for

  • Technical Upgrade from R/3 4.6 to ECC 6.0

    Hi all i have a query regaring system upgrade: Currently i have 2 systems R/3 4.6: Development(D1), Quality(Q1). Now this systems needs to be upgraded to ECC 6.0. First the D1 is going to be copied to a new development(D2). Then D2 will be upgraded t

  • Equivalent of %s/string1/tring2/g

    Hello, I would like to replace some string with SQL, but I do not know how to. I have this in one field: <status xsi:nil="true" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" /> <creation_date>2008-01-07 12:15:11</creation_date> <creator>creat

  • SQL Developer 2.1.1.64 Reset Password Issues

    I have a user with the version identified in the subject that cannot reset their password by right clicking on a connection and selecting "Reset Password." With the same version on my workstation I can carry out this task with no problems. The user a

  • Export Quicktime with leading header out of AE CS4

    Hi everyone, I have to get a workflow with the Rosendahl bonsaiDRIVE (portable video and audio multitrack recorder) and After Effects up and running. Unfortunately the only files that server accepts via Ethernet are Uncompressed 8-bit 4:2:2 Quicktime

  • Cisco Works LMS 4.x NetShow Jobs URL

    Hi I have upgraded our LMS 3.x to the new LMS 4.x Version. I have installed the new 4.x on an new server and importet the backup. I have importet a Certificate and have enabled the Browser-Server Security Mode:               Enabled I added some new