IPod froze when I connected it to my mac
I was trying to upload songs as I normally do, but when I plugged the USB cord into the computer, the iPod screen froze on "do not disconnect" I tried restarting it by holding the center and play buttons but that did nothing. I tried disconnecting and reconnecting, but that did nothing. It's only four months old, so I don't understand what the problem is.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar
Similar Messages
-
My IPod froze when I connected it to the computer
When I connected my Ipod to the computer it froze and the computer is not regognizing it either... HELP! I don't know what to do.
I've only had it for just over two weeks, I hope it isn't broken.Have you tried reseting your ipod? (hold center button and menu down for 6-10 seconds. this may have to be repeated a few times.) also try making sure your itunes is up to date.
-
please help. ive bought a second hand ipod nano, when i connect it to my pc, it does not recognise it in itunes,yet it comes up as a sigma mass usb device. its an ipod nano 8gb?. im running on windows vista,my own ipod classic runs fine.
there is a good chance that this can be related to bad contact in USB lead.. e.g not enough power from IPOD to PC so that pc cannot recognise it. Where I work I get alot of USB devices on pc's that are not recognised and most of the time it is the connection to the device that is not good enough because the flat end of the USB adapter has been gradually bent over time just slightly and now contact is not good. It can also be todo with drivers or If you are using it through a USB hub.
so if it is not working through USB hub try direct. also try in back of PC as these Ports or direct access to main board to pc and would be less trouble some if there was a voltage loss from mainboard in pc to front of unit. -
Sync problem - earlier today I updated both iTunes and my iPod Touch. Since then, I have tried syncing the two. The iPod Touch claims that there is no music on the iPod, however, when I connect it to my computer it says my full library is on there. At present, I am unable to listen to songs on the iPod when not connected to the computer. What can I do to fix this?
Thanks for any help!- Have you reset your iPod:
Press and hold the On/Off Sleep/Wake button and the Home
button at the same time for at least ten seconds, until the Apple logo appears.
- Next would be to backup your iPod and then restore you iPod from backup via iTunes. -
Old ipod nano - when i connect it to my imac - error message
I have an old iPod Nano - when i connect it to my iMac, I get an error message that says I can't have more than 5 computers authorized with my account - My account only shows 4, but that's really beside the point since this iMac is already authorized and I sync other devices from it. Any suggestions? It won't let me add any new content to this iPod.
See Recover your iTunes library from your iPod or iOS device.
tt2 -
Neither my iphone nor my ipad would appear in itunes when i connect them to my mac. I have already upgraded my itunes to the latest version. I have no problem synching my ipod to itunes using the same mac though. Could it be because I am using an older mac? (Mac OS X version 10.4.11)?
You need to be using a Mac OS X version at least as new as the one given in the device's original system requirements.
(74595) -
hi - i have an ipod and when i connect to my pc and try to update the software, its says that cannot update as im not connected to the internet even though i am. what can i do?
Update Server
Try:
- Powering off and then back on your router.
- iTunes for Windows: iTunes cannot contact the iPhone, iPad, or iPod software update server
- Change the DNS to either Google's or Open DNS servers
Public DNS — Google Developers
OpenDNS IP Addresses
- For one user uninstalling/reinstalling iTunes resolved the problem
- Try on another computer/network
- Wait if it is an Apple problem -
I can not recharge my Ipod Touch, when I connect it to the computer or the power cord. What do I do next to recharge the battery?
See the not-charging topic of:
iPod touch: Hardware troubleshooting -
I can't remove or add any songs to my ipod shuffle when I connect it to my laptop
I can't add or remove any songs from my ipod shuffle when I connect it to my laptop. I've never had any problems with it before last night and it is driving me insane. Can anyone help?
Hey sunj313!
I have a link here for you to a troubleshooting assistant for your iPod shuffle. You will need to choose the shuffle that most closely resembles yours, and then follow the troubleshooting steps that will be provided for you:
Apple - Support - iPod Troubleshooting Assistants
http://www.apple.com/support/ipod/five_rs/
Take care, and thanks for visiting the Apple Support Communities.
Cheers,
Braden -
i've got a vodsaphone payg sim: i've been given an iphone 3g, and when i connected it to my mac and itunes, a message told me that the sim was :not compatible" with the iphone. is this because, as i've been told, my card is an old style sim and i need the newer style that works In smart phones? if so, how do i go about getting the right card.
Contact your carrier & get a new sim...they should give you one for free.
-
Why can´t I find my 5d Mark ii in the finder when I connect it with my mac?
Why can´t I find my 5d Mark ii in the finder when I connect it with my mac?
Because it is not a mass storage device that would appear in the Finder. It uses the Picture Transfer Protocol (PTP) to interface with a computer. It can be accessed using an application that uses PTP, such as Image Capture, iPhoto, Aperture, or Canon's software. These applications also support more camera-specific features than the Finder would, such as tethered shooting and possibly camera clock synchronization.
-
I have the CANON REBEL T5 1200D, and when i connect it to my mac which is 10.10 the new OS X YOSEMITE it says that it "Cannot be used with this version of the operating system" why does it say that if my camera is listed under the supported digital cameras for OS X YOSEMITE?
Put simply, the minimum system requirements for iTunes have changed. You need a Mac running at least OS X 10.6.8.
It's best you look online to see if your model of Mac can be upgraded to at least 10.6.8 "Snow Leopard". It should still be possible to order a copy of Snow Leopard if so. -
my problem started when i connected my iphone5 into mac book and i started restoring data, by that i lost my recent photo's ,i tryed a program but it was recovering the previous photo's not the recent once ... need ur help what to do plz....thank u
Not much you can do. You overwrote your current data with older data when you restored the phone from that backup. Your data's gone.
-
I want to make my external HDD my backup disc but how to? Nothing pops up when I connect it to my Mac...
https://discussions.apple.com/docs/DOC-3003
-
i have an iPhone 4 and when i connect it to my mac i cannot back up device and the bar is for the phone is only showing "Other" as the memory , Help ?
Make sure you have the Latest Version of iTunes (v11) Installed on your computer
iTunes free download from www.itunes.com/download
Then...
Connect to iTunes on the computer you usually Sync with and Restore
http://support.apple.com/kb/HT1414
Maybe you are looking for
-
Can We send data from SAP to non SAP using ALE !
In this case what will be the receiver side configuaration ! What will be our receiver client !
-
Running FCP HD 4 on Intel Mac?
Hello Not sure where I should post this.... I recently acquired FCP HD 4 (retail) for a screamin' deal. I was hoping it would run on my Mac Pro. It installed fine but when I try to open it, I get configuration error with hardware/software is missing
-
Acrobat Pro 9.2 problem printing to from IE8
I have been having a pretty consistant problem since doing a clean install of Win7 Pro and Acrobat Pro 9.2. If I print preview a webpage and then try to print from it to a .PDF, the screen comes up asking where to file the printout and just hangs.
-
BI7 Business Explorer Installation Problem
I am new to BI, after install SAPGUI Front End and SAPBIGUI and then install BI7.10 Business Explorer 1000 patch. However when I go to Program -> Business Explorer -> Analyzer, an Excel pop up, click on the Bex Toolbox ("xxxBEx Analysis Toolboxxxx")
-
Compatibility Check of SOA Suite 10.1.3.5. Over WebLogic 10.1.3.3
Hi, I am seeking one clarification regarding SOA Suite 10.1.3.5. installation over Weblogic 10.1.3.3. As per installation note available over the internet at various site I came to know that for SOA Suite 10.1.3.5 u need to install Weblogic 10.1.3.1.