Ipod frozen with sync screen even after battery has died and been recharged

My wifes ipod nano 3rd generation is stuck on the sync screen even after it has been unplugged, the battery has died, and it has been recharged again.

Hi buddy,
In my opinion the only the only one that you can do is updating the BIOS as Akuma suggested. This problem is not software related so thats the only option you have I think. You can download the newest BIOS version here:
http://eu.computers.toshiba-europe.com > Support & Downloads > Download Drivers
If not, contact an authorized service provider please. The guys can fix all hardware related problems can diagnose this problem. Maybe the mainboard or something else must be exchanged.
Good luck! :)

Similar Messages

I purchased Adobe Acrobat XI Pro - Student and Teacher Edition but cannot activate it even after it has deactivated and replaced my old Acrobat 8. How do I get a serial number and activate the product?

I purchased Adobe Acrobat XI Pro - Student and Teacher Edition but cannot activate it even after it has deactivated and replaced my old Acrobat 8. How do I get a serial number and activate the product?

I have the same problem. Have paid. Messages say I have downloaded it but the file is inaccessible apparently download is somewhere on my hard disk. How do I find it?? Is there not help at an Adobe phone service. If so what is the number to call??
Roger Broughton

Ipod frozen with white screen

My ipod has stuck and frozen with a white screen when i go to start it up. It will not shut off and will not respond to any touch movements. When plugged in to the computer, I-Tunes does not recognize it. Please help!

I have had it two years and this is the first issue. My main concern is that the computer does not recognize it in order to reinitialize it. It wont shut off, it wornt do anything, I am just loking for a guide before I have to send it in for repair/replace... I am not feeling much good from the boards, but I am gonna be patient and see if someone stumbles across my please for help-- this cant be the first time someone has had and fixed this problem....

TS1538 iPod Touch with blank screen that doesn't shut off and not recognized by iTunes?

I opened the app "MyTown 2", and it stayed on the opening screen for about 5 minutes - WAYYY too long! So I tried to close the app. A slight grayscale sort of film "slid" down over the opening screen, and then it went to this light gray, completely blank screen. It's been that way for over an hour - no matter what I do, can't do a hard shut down, and the device is not recognized by iTunes at all. It's completely DEAD!!!! Is there any hope? Anyone have a clue?

Following the instructions in this procedure to the letter. Here they are, with emphasis on some easily overlooked requirements:
Disconnect the USB cable from the iPod Touch, but leave the other end of the cable connected to your computer's USB port.
Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release only the Sleep/Wake button.
Continue pressing and holding the Home button while you reconnect the USB cable to the device. The device should turn on.Note: If you see the "low battery" screen, let the device charge for at least ten minutes to ensure that the battery has some charge, and then start with step 2 again.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears (iTunes icon and USB connector) release the Home button.
If necessary, open iTunes. You should see the "recovery mode" alert ("iTunes has detected a phone in recovery mode").
Use iTunes to restore the device.
If you do not see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Select the device in iTunes and choose "restore from backup".
If you still can't get it to work, you have done all you can and only Apple will be able to help.

Battery has died and am not sure why

Hi, my macbook battery has completely died and I cant work out why, I accidently let it run to empty and now when it only works when connected to the adaptor and the battery icon in the top right simply has a X in it and it doesnt register that theres a battery there. The battery is securly fastened and wasnt removed at all before this happened, Ive taken it off and wiped the connectors, but there was no obstruction of anykind and its not been near water or anything. Can any one help, will I need to take it to an apple store or is there something else I can do? Many thanks
PS in the 'power' section of the 'more info' bit it simply reads:
Battery Information:
Charge Information:
Charge remaining (mAh): 0
Fully charged: No
Charging: No
Full charge capacity (mAh): 0
Health Information:
Cycle count: 0
Battery Installed: No
Amperage (mA): 0

weird. I don't know what to say.
it doesn't matter if you leave it to die because no matter what it should work.
I'm a student with a low health battery caused from constant use so my laptop dies completely 5 times a day and the battery still works for 4 years.
leaving the battery to die should be a problem.
the X definitely means your battery is dead. this could have been caused by a sudden electric shock, maybe while you were away. since you already cleaned your battery it means it is still dead. get a new one.
p.s. Merry Christmas to you all!!!

Reloading photoshop elements after it has crashed and been removed

How do I reload Photoshop elements 11 after it has crashed? I have uninstalled elements 11 because it crashed. I now need to reload it. I have my product number. I cannot find where or how I download on the adobe.com site.

Download Photoshop Elements products | 13, 12, 11, 10
Mylenium

IPod Touch won't reset even after holding down power and home button

My kid was playing the Very Hungry Cat App and all of a sudden the screen went white on my iPod Touch 4th Gen 32gb.
I tried holding down the Sleep/Wake button + the Home button for ten seconds and it just stayed white. I tried plugging it into my computer and the computer doesn't recognize it was plugged in. Lastly I tried doing the 3 second sleep hold, add 10 second hold on the home button, then release sleep and hold the home for another 20 seconds and it didn't work.
I'm currently letting it sit there hoping the battery dies and that works.
Anyone else have any ideas?
Thanks for your help.

You are doing the ony thing you can. That let the battry fully drain. After charging for an hour try the reset, conncting to computer and placing in recovery mode. If still white then you very likely have a hardware problem and an appointment at the gensiur bar of an Apple store is in order.

Error printing with Windows 7 even after unistalling old and installing new driver

I recently updated to 64-bit Windows 7 and cannot get my HP OfficeJetJ4580 working after the upgrade. I uninstalled all prior printer drivers and ran the recommended software from the HP site to ensure there were no remaining drivers on my system, then installed the updated drivers for use with WIndows 7. The driver isntallation said it was successfula dn that my printer was ready for use.
When I try to print, the job is sent to the print que. The print que immedialtely notes "Error printing" and deletes the job from the que. The printer never responds or tries to print. This happens with anything I try to print, including a test page. No error message is dispalyed on my screen. The only way I can see the error is by opening up the print que and looking at the pending jobs. I went to the HP support center and downloaded and ran the printer diagnostic sofware they had on there. It could not detect any problems with the printer.
I am at a complete loss as to what to try next.

Hello PPN, and welcome to the HP Forums, I hope you enjoy your experience!
I see you are running into installation issues. I would like to help.
I would suggest Uninstalling the Printer Software.
Once it is uninstalled, I'd recommend putting your system into clean boot mode within the Microsoft configuration. You can do so by following this document: How to perform a clean boot in Windows.
After the computer has been put in clean boot mode, I would suggest reinstalling the HP Printer Install Wizard for Windows.
Good luck and please let me know the results of your troubleshooting steps. Thank you for posting on the HP Forums!
Please click “Accept as Solution " if you feel my post solved your issue, it will help others find the solution.
Click the “Kudos, Thumbs Up" on the right to say “Thanks" for helping!
Jamieson
I work on behalf of HP
"Remember, I'm pulling for you, we're all in this together!" - Red Green.

Use nano with battery charger after battery has died?

Hello
I am wondering if it is possible to use the nano with the battery charger plugged into it after the battery in it has been used up? Because the battery seems to decay pretty fast and my primary reason to have the nano is as an input to my amp...
Thank you.

yes this ok to do. I do this all the time when I am listening to tunes at home. It saves the battery from discharging as quick
jid

Hello. Today, I was updating my iPod Touch 4th Generation to iOS 6. I unplugged the iPod when it was during the installation because it appeared to be frozen. Now the iPod is stuck at a light blue screen even after I reset it. How do I fix it?

Hello. Today, I was updating my iPod Touch 4th Generation to iOS 6. I unplugged the iPod when it was during the installation because it appeared to be frozen. Now the iPod is stuck at a light blue screen even after I reset it. How do I fix it?

You will need to do a DFU restore by holding the home and power buttons down (while the device is plugged in to your computer) until the device's screen goes black and as soon as the screen goes black, count down from 3 and release the power/sleep button, but keep holding down the home button. Then, iTunes will say the iPod needs to be restored. The restore process will take some time and even though the iPod may appear to be frozen, don't interrupt the restore.

TS1373 my 5th generation ipod acts like it is going to sync and then "ejects" itself before even 1 song can be synced. It then doesnt recognize that it has been ejected and keeps the"do not disconnect" icon on the screen even after unplugging. What do I

my 5th generation ipod acts like it is going to sync and then "ejects" itself before even 1 song can be synced. It then doesnt recognize that it has been ejected and keeps the"do not disconnect" icon on the screen even after unplugging. What do I do? it also makes a lot of noise while connected to the computer.

Is the camera damaged? Could be a hardware problem.
Try:
Close the Camera app in the multitasking bar, then try again.
Restart/Reset/Restore your iPod. In that order.

My ipod was in recovery mode and fixed it. i can use it. but the problem is whenever am i connect it with itunes it says IPOD is in recovery mode even after recover is done. i cant sync ipod rite now. it showing same msg again. nyone knows wat to do plz??

my ipod was in recovery mode and fixed it. i can use it. but the problem is whenever am i connect it with itunes it says IPOD is in recovery mode even after recover is done. i cant sync ipod rite now. it showing same msg again. nyone knows wat to do plz??

I did the restore and it cleared and reset the iPod but after it finished the same error came up. I tried this 3 times. Also it no longer shows up as a drine in My Computer.
if it's relentlessly doing that to you, it's plausible that the message is being caused by a Windows drive letter confusion. (that's consistent with the disappearance for My Computer, too.)
see the following article for troubleshooting information on that possibility:
"iTunes has detected an iPod in recovery mode - Use iTunes to restore"

Ipod Touch completely frozen with white screen

My ipod touch is completley frozen with a grey/white screen. it will not respond to reset or restore, neither my pc or itunes recognise it when i plug it in. Anybody have any ideas other than contact apple directly? All software on ipod touch and itunes is up to date.

- If the reset does not work, connct to comuer and if iTunes sees the iPod restore the iPod via iTunes.
- Next let the battery fully draind and charge for an hour.. The try the reset:
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
and connecting to iTunes to try to restore.
- If the iPod still has the white screen then it is time make an appointment at the Genius Bar of an Apple store.
- If the iPod is off se if placing the iPod in recovery mode will allow iTunes to se the iPod so tha you can restore the iPod. For recovery mode:
iPhone and iPod touch: Unable to update or restore

My iPod nano 6G stop working suddenly; After i reset it and even afetr put it in "stand by" mode by accessing deagnostic mode, it is still not working; Now i can access it sometimes (the main screen), but is not playing and is too slow. How can i fix it

My iPod nano 6G stop working suddenly; After i reset it and even afetr put it in "stand by" mode by accessing deagnostic mode, it is still not working; Now i can access it sometimes (the main screen), but is not playing and is too slow. How can i fix it

If you do not find a solution in the iPod nano (6th generation) - User Guide, suggest that you call AppleCare if still under warranty or take a trip to your local Apple Store or AASP.

Unable to sync with MacBook Pro even after installing Po...

Unable to sync with MacBook Pro even after installing PocketMac

why don't you post the same thing again (since you posted it 3 times already)?
perhaps whole you're at it you could post some useful information to get advice like Mac OS, Device, Device OS, other sync software installed...
4.6.1.305 hybrid
Mac Pro 2X2.8 Quad SL

Ipod frozen with sync screen even after battery has died and been recharged

Similar Messages

Maybe you are looking for