Ipod loses battery when im not useing it! 40 ha more like 2

ok my 160gig ipod dies when im not useing it i went to school today full charge at school used it for an hour and a half and on the bus home it dies. i dont get it. this has happend a few times now and i know somethings up PLEASE HELP. i didn't pay 350$ for a 2 hour battery life.

There a several posts about the battery dying quickly with firmware 1.0.2. Check here (http://discussions.apple.com/thread.jspa?messageID=5610235&#5610235) for a fairly succinct explanation and workaround until Apple hopefully fixes the issue with the next firmware update.

Similar Messages

My iPod show that my battery is receiving energy and that it is "charging," but it doesn't actually charge. The battery never increases; it only decreases. Even when I have it physically plugged in and charging, it loses battery whenever I am using an APp

My iPod shows that my battery is receiving energy and that it is "charging," but it doesn't actually charge. The battery never increases; it only decreases. Even when I have it physically plugged in and charging, it loses battery whenever I am using an APP or anything. I'm thinking that the chip that receives the energy is damaged or worn out. Is there anyway to fix it without going to the store? My USB chords is fine. It charges other iPods fine. Including a second generation iPod which means my 4th generation iPod should not have an physical battery problem. Any suggestions? Thank you so much!

- See:
iPod touch: Hardware troubleshooting
- Try another cable. Some 5G iPods were shipped with Lightning cable that were either initially defective or failed after short use.
- Try another charging source
- Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar

My iPod Touch keeps displaying the message 'This accessory not supported by iPod touch.' When I've used it w/this device multiple times, it's happening more and more frequently now. Anyway to dismiss this message for good? Because the iPod still plays .

My iPod Touch keeps displaying the message 'This accessory not supported by iPod touch.' When I've used it w/this device multiple times, it's happening more and more frequently now. Anyway to dismiss this message for good? Because the iPod still plays thru my radio and system.

That message is usually due to a bad cable.
Not Charge
- See:
iPod touch: Hardware troubleshooting
iPhone and iPod touch: Charging the battery
If you can’t charge your iPhone, iPad, or iPod touch
- Try another cable. The cable for 5G iPod (lightning connector) seems to be more prone to failure than the older cable.
- If a 5G iPod
Iphone 5 lightning port charging problem - SOLUTION!
- Try another charging source
- Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar
or send it in to Apple. See:
Service Answer Center - iPod

Ipod loses power when turned off?

My ipod loses power when its turned off - when i turn it back on its battery is nearly alwasy dead - am i doin something wrong? Please help - new user -

May be time for a new battery.

HT201365 I just updated to ios 7 on my iPhone 4 how do you turn the apps off when your not using them? The old way of double clicking and then pressing the app until a red minus button comes doesn't work it opens it back up!?

I just updated to ios 7 on my iPhone 4 how do you turn the apps off when your not using them? The old way of double clicking and then pressing the app until a red minus button comes doesn't work it opens it back up!?

Double click home button, then swipe up on app picture (not the icon itself)

I have an iPod mini that I have not used for mover 3 years. I am trying to download music and it is giving me a warning sign. How can I fix this issue.

I have an iPod mini that I have not used for more than 3 years. I am trying to download music and it is giving me a warning sign. How can I fix this issue?
patrishafrombrooklyn

Try:
http://snapguide.com/guides/calibrate-your-home-button/?utm_expid=69945963-15
fix for Home button
iPhone Home Button Not Working or Unresponsive? Try This Fix
- If you have iOS 5 and later you can turn on Assistive Touch it add the Home and other buttons to the iPods screen. Settings>General>Accessibility>Assistive Touch
- If not under warranty Apple will exchange your iPod for a refurbished one for:
Apple - Support - iPod - Repair pricing
You can do it an an Apple store by:
Apple Retail Store - Genius Bar
or sent it in to Apple. See:
Apple - Support - iPod - Service FAQ
- There are third-party places like the following that will repair the Home button. Google for more.
iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens

HT4436 We changed the iCloud account on the Mac Book and now we can not use some part of iCloud like Documents, etc on the Mac book to sync to iPad.

Hi,
We changed the iCloud account on the Mac Book and now we can not use some part of iCloud like Documents, etc on the Mac book to sync to iPad.
It says it is not the principal account.
Regards,
JG

The iPad and the Mac need to be signed into the same account, 2 different accounts won't work

HT1476 My ipod touch only charges when im not using it, when i use it, it doesnt bring up the charging symbol

My ipod touch only charges when its not in use and doesn't come up with the charging symbol. Please help cheers

First try another charging source. Maybe the source yo are using is not putting out enough pwere when the screen is on.
Next try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.

Does iphone lose battery when powered/turned off??

So my lock button at the top of the iphone 4 doesn't work and i used the assistive touch button to lock screen when needed. The reason i didn't go to apple store is that i have past my warranty and didn't buy apple care.
Anyway, the other day, the iphone shut down unexpectedly at around 40%.
Now, normally, if it shuts down, it'll only be because of the battery being lower than 4%, and so all i had to do was to it in to power adaptor.
BUT, because i know that the percentage left is closer to 40%, then i was wondering whether the iphone would lose battery. Because if that happens, i can just wait for a couple of hours before plugging it in....

All devices use power when in sleep mode.
Locking the screen does not turn the device off, never has.

IPod mini battery bar status not accurate

I just bought an iPod mini but I am not sure if my battery is working properly. When I have fully charged the iPod mini and disconnected from my iBook, the battery status doesn't show full charge. Is something wrong with my battery?

- reset, several times
- calibrate the battery and the battery meter

I want to store my ibook. Can I take out the battery and simply not use it for months?

Just bought a new imac and want to mothball the laptop. Can I simply remove the battery and not use it?
Do I have to recharge the battery every few months?
Can't see the point in leaving it plugged in as its not being used, yet in case I need it as a back up would like to keep it.
Any comments on proper procedure?
thanks.

From Apple:
Storing Your MacBook Pro
If you are going to store your MacBook Pro for an extended period of time, keep it in a cool location (ideally, 22° C or about 71° F) and do one of the following to preserve your MacBook Pro battery life:
Discharge the battery 50 percent before storing your MacBook Pro.
When storing your computer for longer than five months, discharge the battery to approximately 50 percent and then remove it from the MacBook Pro. If you are storing your computer for an extended period, recharge your battery to 50 percent every six months or so.

Generating SOAP Envelope when DO NOT USE ENVELOPE option is marked

My scenario: SPROXY => XI => 3rdParty WebService. Communication is synchronous. I've a problem with soap envelope. It is required by webservice, but when I use standard soap envelope generated by SAP I've a problem with receiving response from webservice.
So I want to create my own envelope. For this reason I've used DO NOT USE SOAP ENVELOPE option. Now the challenge comes. How can I create my own soap envelope?
Do you have any working example? Soap envelope should be added to message send from XI to 3rdParty WebService.
Helping answers => a lot of points

I'm talking about HTTP header.
When I'm sending SOAP request from SAP my whole message looks like when I use soap envelope
POST / HTTP/1.0
Accept: */*
Host: 192.168.132.179:54000
User-Agent: SAP-Messaging-com.sap.aii.messaging/1.0505
Content-ID: <soap-02cce7702b1a11dd9902000c29ee261e[at]sap.com>
Content-Type: text/xml; charset=utf-8
Content-Disposition: attachment;filename="soap-02cce7702b1a11dd9902000c29ee261e[at]sap.com.xml"
Content-Description: SOAP
Content-Length: 259
SOAPACTION:
<SOAP:Envelope xmlns:SOAP='http://schemas.xmlsoap.org/soap/envelope/'><SOAP:Header/><SOAP:Body><ns0:Sd2Ids_SzfExport xmlns:ns0='http://www.dat.de/sdii/ids/Sd2SOAP.wsdl'><arg1>1234567899-0</arg1><arg2>1</arg2></ns0:Sd2Ids_SzfExport></SOAP:Body></SOAP:Envelope>
Always after such request I got and HTTP 411 error.
In opposite, when I'm sending request from e.g. Altova or SoapUI, my message looks:
POST / HTTP/1.1
Content-Type: text/xml; Charset=UTF-8
User-Agent: XML Spy
Host: 192.168.132.179:54000
Content-Length: 489
Connection: Keep-Alive
Cache-Control: no-cache
<SOAP-ENV:Envelope xmlns:SOAP-ENV="http://schemas.xmlsoap.org/soap/envelope/" xmlns:SOAP-ENC="http://schemas.xmlsoap.org/soap/encoding/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xmlns:xsd="http://www.w3.org/2001/XMLSchema">
     <SOAP-ENV:Body>
          <m:Sd2Ids_SzfExport xmlns:m="http://www.dat.de/sdii/ids/Sd2SOAP.wsdl">
               <arg1 xsi:type="xsd:string">1234567899-0</arg1>
               <arg2 xsi:type="xsd:string">1</arg2>
          </m:Sd2Ids_SzfExport>
     </SOAP-ENV:Body>
</SOAP-ENV:Envelope>
After that request WebService response is correct.
You can find such differences (except Content-length which is a result of XML message formatting) in those two headers:
- for first is used HTTP 1.0 protocol for later 1.1
- in SAP header an info about attachment is added
After a lot of test I thing that those attachment info in header of HTTP is causing a problem. So I want to use DO NOT USE SOAP ENVELOPE option to generate HTTP header without Content-Disposition and generate SOAP Envelope manually.

How to make VM to suspend when it not use , VDI3.0 with SGD 4.5

Hi All,
We are using SunVDI3.0 with VBox 2.0.10 and connecting via SGD 4.5.
i konw that we can do suspending vm on vmware esx, however i couldn't find it in VirtualBox provider.
how to make VM to suspend when vm is not using for some period time.
thanks in advance
-kevin-
Edited by: kevin on Sep 27, 2009 5:44 PM

Hi All,
We are using SunVDI3.0 with VBox 2.0.10 and connecting via SGD 4.5.
i konw that we can do suspending vm on vmware esx, however i couldn't find it in VirtualBox provider.
how to make VM to suspend when vm is not using for some period time.
thanks in advance
-kevin-
Edited by: kevin on Sep 27, 2009 5:44 PM

Error when applying Note using SNOTE and Manually

Hi Gurus,
I get the following message when i try to download a note using SNOTE
Error: Format of correction Instructions 0120061532 1 0000771620 0002; unable to read corr.instruct
I tried downloading the note to my local machine and then uploading it locally but got the same result.
Any thoughts on how to procede?

Hi ,
Are you trying to download directly on to server? then you need to connect your server to SAP router and connected to Service market place. If you want to do it off line? get the note by Download manager and apply from Snote.
Regards,
Hari.
PS: Points are welcome.

Main iPod got renamed when trying to use a new shuffle

I just got a new iPod Shuffle and in setting it up and loading music in iTunes, I didn't realize that two pods cannot be used simultaneously, and now my main (original) iPod has been renamed with the new iPod Shuffle's name.
When I use my iPod with headphones or in the car, my full songlist is available and works fine. However, when I plug it into my computer at work, iTunes shows it with the new name and only shows the Shuffle's songs and playlists.
My iPod has a different songlist than my iTunes library, so I can't just re-load the songs.
I have since found the links to discussions on these forums for how to use two pods on one computer, but for now I just need to be able to see my iPod's songs when in iTunes.
HELP!

#Click the Firefox button, go to Bookmarks, Show All Bookmarks.<br><br>
#Go to the Unsorted folder, click the bookmark to highlight it, then click ''Organize ''(top left), then Move.
If you just want to rename the folder, hit CTRL+I to open the sidebar, right click the folder, go to Properties and then rename it in the dialog box which appears.

Ipod loses battery when im not useing it! 40 ha more like 2

Similar Messages

Maybe you are looking for