IPod Nano 7th gen wont turn on after a restore

I tried holding down the top and middle buttons and it wont work, this is a replacement one for an iPod Nano 7th gen with corrupted software, could it be the same problem?
During the restore it says it's restored and not to disconnect my iPod but then can't seem to find it so it repeats the restore again and again
Starting to get really annoyed with it now

Hi Sherbetpips201,
If your iPod won't turn on, the following troubleshooting steps may be helpful.
iPod troubleshooting basics and service FAQ
http://support.apple.com/kb/TS1382
I hope this helps ....
- Judy

Similar Messages

My ipod nano 5th gen. wont turn on and is not being recognized on my mac or itunes

my ipod nano 5th gen. wont turn on and is not being recognized on my mac or itunes

What have you tried so far in terms of troubleshooting? After leaving the Nano to sit and charge for at least 30 minutes, try resetting it by pressing and holding both the Select/Center and Menu buttons together long enough for the Apple logo to appear. You'll want to make sure the Hold Switch is not in the On position as well.
B-rock

Ipod nano 7th gen not turning on or connecting to laptop??

My son's ipod nano 7th gen won't turn on and when I connect it to the lap top a message comes up saying device driver not recognised - he was listening to it just last night, can anyone help? He's only had it since his birthday in November.

I reset the ipod by holding down the power button and the menu button and the apple screen came up after a few moments - this seems to have done the trick!

IPod Nano 7th gen not turning on but recognized by iTunes and Windows

My two-month old 7th gen iPod Nano is not turning on. I've reset and restored it using both Windows (My Computer) and iTunes and have downloaded the and installed the latest version of iTunes. It was working fine and now just will not turn on. It is being recognized by Windows as a removable disc and by iTunes as an iPod that I can sync data onto.
I've tried the 'hold the power button for 5 seconds' trick to try to manually reset it, as well as other variations with pressing down on the power and menu keys simultaneously. The iPod is new, ordered online and the nearest Apple Store is over 2 hours away from where I live.
Please help?

Hello, M.Ram.
Thank you for visiting Apple Support Communities.
I understand that the screen on your iPod nano is black, but is recognized by iTunes. Take a look at the troubleshooting article below as it may provide some troubleshooting steps that may help. However, if the issue persists, see the section labeled Issue not resolved.
iPod nano (7th generation): Hardware troubleshooting
-Jason H.

Ipod Nano 6th Gen not turning on after lcd change

again, Hello People,
=D
I changed the lcd and flex cable over on a ipod nano but the new buttons didnt seem to work (power did, volume didnt). i took it out of the body and connected the touchscreen and flex cable to see if there was a kink in the flex . i did try turning it on and then realised it could be abad idea as the earth points wernt connected. anyway, i put it all back in the body and it doenst turn on at all. i did read somewhere it could be the circuit board shutting down and there are ways of waking it up......eg. draining the batt, short curcuit etc......wondering if anyone has any ideas......

Hello, M.Ram.
Thank you for visiting Apple Support Communities.
I understand that the screen on your iPod nano is black, but is recognized by iTunes. Take a look at the troubleshooting article below as it may provide some troubleshooting steps that may help. However, if the issue persists, see the section labeled Issue not resolved.
iPod nano (7th generation): Hardware troubleshooting
-Jason H.

My ipod nano 4th gen wont turn on ! help me !

okay i got this ipod nano off one of my friends. I plugged it into my own computer and the apple logo came onto the screen, then after a few seconds the main menu screen came on, but while doing this i accidently knocked the cord connecting my ipod to the computer, then my ipods screen went black and said "please eject before disonnecting " but as it slightly came out it was "disconnected" so i tried putting it back it but the ipod wouldnt turn on, only a blank black screen. I have tried all the steps from apple but none of them are working, please tell me whats wrong with the ipod and how i can fix it !!! i really need this ipod !!

Hey WarriorFelip,
Thanks for the question. After reviewing your post, it sounds like the iPod wont turn on. I would recommend that you read this article, it may be able to help you resolve or isolate the issue.
iPod won't turn on
Thanks for using Apple Support Communities.
Have a nice day,
Mario

Ipod Nano 4th Gen wont turn on.

My Ipod Nano 4th Generation will not turn on. I plug it into my computer and get nothing, i tried resetting it and that did nothing. I then plugged it back into my computer and i got an error message on Itunes saying that my Ipod was corrupt. I know can not get Itunes to recognize my Ipod, even for a 'corrupt' message. I have had my Ipod for over a year now and wondered if anyone els had had this problem and even better knew a way of fixing it. I cant afford a new Ipod and need one for work. If anyone could help me i would be very grateful. Thanks.

I have the same problem. I've had mine since Christmas and when I went to listen to it today the screen just shut down and it's unresponsive to anything. Even being plugged in to my computer. The only thing it does it make a clicking sound when I take it off hold.
I've also done the Five R's and none of them worked.

Ipod nano 1st gen wont turn off

i have a ipod 1st gen that will not turn off when holding the play/pause button. my only options right now are to just let it die. someone please help . i want to be able to turn off my ipod

Try restore your iPod. If didn't solve the problem you need an repair center.

My ipod nano 6th gen wont charge, turn on or respond to anything i have done i have tried the troubleshooting and nothing works. I have droped it once but it work for about a month after and i havent wet it any tips would be much apriciated! thanks

My ipod nano 6th gen wont charge, turn on or respond to anything i have done. I have tried the troubleshooting and nothing works. I have droped it once but it work for about a month after and i havent wet it. any tips would be much apriciated! thanks

Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar

My ipod nano 7th gen has suddenly gone black and it wont turn on or connect to a power source.

I was listening to my ipod nano 7th gen when it went black and the music stopped playing. It wont turn on when i press the power button and when i connect it up to charge the screen doesn't turn on. Can anyone tell me how to turn it on again or give me suggestions.
Much appriciated,
MissC@t

Hey MissC@t,
Although the following article says 6th generation, most of the troubleshooting steps should still apply to your 7th generation nano. I'd go through the troubleshooting steps and see if that resolves the issue:
iPod nano (6th generation): Hardware troubleshooting
http://support.apple.com/kb/TS3474
Have a good one,
Delgadoh

My ipod nano (7th gen) seems to be stuck in a loop of turning itself on and off, tried rebooting but keeps doing it?

My ipod nano (7th gen) seems to be stuck in a loop of turning itself on and off, tried rebooting it but after a while it just starts it again?

Hi altofts,
Thanks for using Apple Support Communities. You can try resetting and restoring your iPod nano to see if that helps with the restart loop:
How to reset iPod
http://support.apple.com/kb/HT1320
Restoring iPod to factory settings
http://support.apple.com/kb/HT1339
Cheers,
- Ari

My ipod nano 7th gen is stuck on a loop of turning on and off.

My ipod nano 7th gen is stuck on a loop of turning on and off, I've already done the reset, and everything that was recommended on other similar questions. it isn't recognized by iTunes except in recovery mode where it allows me to restore but then goes right back to turning on and off once i'm back to normal play mode. Once on recovery mode it works fine and doesn't turn on and off. I've also uninstalled and reinstalled itunes to avail. I'm super frustrated and am hoping that I won't need to buy a new one. Is there anything else I can do before i just toss it out? i'm getting a bit frustrated just watching my ipod turn on to the apple and then turn right back off.

Hi there tksunrise,
You may find the troubleshooting steps in the article below helpful.
iPod nano (7th generation): Hardware troubleshooting
http://support.apple.com/kb/TS4433
Will not turn on or screen remains dark
Connect iPod to power for at least ten minutes to ensure that the battery has enough charge to allow iPod to turn on.
If iPod does not turn on after ten minutes, try resetting it while it is still connected to power. Reset the iPod by holding down the Sleep/Wake button and the Home button for at least six seconds or until you see the Apple logo appear.
If the Apple logo appears on the display, connect iPod to a computer and verify that it appears in iTunes and can play music. If iPod appears in iTunes and can play music, no further troubleshooting is needed.
If the screen remains dark and will not turn on, then your iPod may need service.
Issue not resolved
If the issue is still not resolved, please read this information on servicing your iPod.
-Griff W.

What is up with the iPod nano 7th gen. I just had a second one die. with both after only 3 weeks of useage?

what is up with the iPod nano 7th gen. I just had a second one die. both after only 3 weeks of useage... both dead since Jan 10th 2013.

this is an answer I just gave to someone else.
i'm going to ask you to try something I just did to fix a maybe simular problem that worked..... but I don't know why yet........make sure your iPod in plugged into your computer (mine is a Mac) and iTunes is turned on. My iPod was also "dead" but had been plugged into my computer for a couple of hours (but not lit up in any way). Then (in desperation) I held down all the buttons, the on/off (on top right), the small Home botton at the bottom of the face, and the volume/pause buttons (left side). For whatever reasons my iPod came back to life in a needs restoring mode ....and asked me to restore it in the itunes like "new' iPod connected mode. Since I have a Mac I also had to give permission to do a download by entering my computer password. If you have to do the same have that password ready. Then it did a restore software download. Everything previously on the iPod was erased and had to be re-synced, but I was just thankful to get it up and restored again.
Give this a shot and I hope it works for you.....but why? I don't know yet, I need more questions answered.

After upgrade to Windows 8.1, ipod nano 7th gen not recognized

/after upgrading to Windows 8.1, ITunes does not recognize my ipod nano 7th gen. I have uninstalled and reinstalled ITunes but no luck. I have gone through all steps in troubleshooting, but it still doesn't recognize it. Help!

Hi cindywindy,
If your iPod Nano is no longer recognized in iTunes after a recent system upgrade, you may find the following article helpful (apologies if you have already seen it):
Apple Support: iPod not recognized in My Computer and in iTunes for Windows
http://support.apple.com/kb/ts1369
Regards,
- Brenden

I have a bright white screen when turning on my ipod nano 7th gen. Have tried resetting etc etc. Any further ideas?

I have a bright white screen when turning on my nano 7th gen. Have tried resetting and restoring settings - no change. Any ideas please?

Hello pipworms,
I would be concerned too if my iPod nano's was just showing a white screen. I recommend following the steps below:
Display shows a white screen
Try putting the iPod into disk mode:
Reset the device (Reset the device by pressing the Sleep and Home buttons simultaneously until the display shows the Apple logo. This should take about eight seconds).
When the Apple logo appears, press and hold the Volume Down and Volume Up buttons simultaneously until the device enters Disk Mode.
While the device is in disk mode, sync it to iTunes and try to restore.
I got this information from the following article for the 6th generation iPod nano. The steps are the same, except I updated the reset steps with the reset for the 7th generation iPod nano:
iPod nano (6th generation): Hardware troubleshooting
http://support.apple.com/kb/ts3474
How to reset iPod
http://support.apple.com/kb/ht1320
Putting iPod into Disk Mode
http://support.apple.com/kb/HT1363
Thank you for using Apple Support Communities.
Best,
Sheila M.

IPod Nano 7th gen wont turn on after a restore

Similar Messages

Maybe you are looking for