IPod Nano keeps skipping, static noises?

Hey Everyone, wanted to get your thoughts on my problem. My 2gb white iPod Nano (got it refurbished via Apple) has been skipping a few seconds proceeded and followed by some static noise. I thought perhaps it was some electrical charge from it rubbing against fabric but it's happened when I've had it sit on my desk as well. It does seem to happen often in podcasts.
I've listen to the same songs/podcasts on iTunes and my older iPod (20gb 3gen) and it sounds just fine.
Thanks in advance.

Try going through the Five Rs.
btabz

Similar Messages

  • My brand new 6th gen ipod nano keeps shutting down after about 30 seconds?

    My new 6th generation ipod nano keeps shutting down after 30 seconds. It has been registered with itunes and has about 200+ songs on it. I have not tried to reset it because i was not sure what this would do. Please help!

    This is usually a sign that your headphones are not plugged all the way in.  Make sure you cannot see any silver still showing from the headphone's plug.  It may require a little extra force to get the headphones to become fully inserted.  You should hear a sort of clicking noise indicating that they have been fully seated.
    Also check the headphone port from a damage or debris.
    B-rock

  • Ipod nano keeps turning on and off

    My ipod nano keeps turning off and on automatically and when I push a button once its on then it freezes, and when I reset it then it starts turning on and off again....what do I do someone please help me

    Hello Mo0nangel,
    Welcome to Apple Discussions.
    First, try updating the iPod software. Follow the steps in this article:
    Updating iPod software
    If the problem persists, you may have to restore your iPod:
    Restoring iPod to factory settings
    Unfortunately, restoring will wipe your nano clean of all songs and photos.
    Gary

  • Ipod nano keeps turning off mid song unless plugged into a power source

    ipod nano keeps turning off mid song unless plugged into a power source

    Hi,
    I got the same problem, I just got it last night and charged it for more than 3 hours but with the same problem

  • 2nd Gen. iPod nano keeps disconnecting

    My 2nd Generation iPod Nano keeps disconnecting.  It was working fine until I tried to delete everything, which did not work, so I resorted to clicking "Restore".  The problem is that I am trying to sync podcasts only I keep getting a message:  "The iPod...cannot be synced.  The required file cannot be found".  This is very bizzare because I also realized the iPod Nano itself keeps giving a message also:  "OK to disconnect" and goes into sleep mode.  I am not sure if this is a settings issue...Help!
    Note:  The iPod is charged.

    Ummm.. didn't you read the box or Apple website BEFORE you bought it?
    You've made it through almost 3 large OS updates without complaint so I don't see how Apple wronged you.
    This is your fault for not looking into this beforehand. There were major changes in OSX starting with X.3 that made it so that some software would not be compatible with the operating systems below that version. iTunes is such software.
    * Your nano needs iTunes 7 to sync.
    * iTunes 7 does not work is OS9, OSX.1, or OSX.2
    Just like it won't work in Windows 98 or ME
    An operating system made FOUR and a HALF YEARS ago can not be expected to support into perpetuity hardware that did not exist back then.
    Your laptop works just fine, you have no problems upgrading cheaply to X.3 (you don't NEED X.4 despite your claims) and you can cut the pathetic comparisons to how "simple" windows makes it with anything.
    He11, their own Zune isn't even supported by Vista.
    I for one am glad the OS is updated in approximately 12-18 month intervals instead of allowing it to languish on its laurels. The gains in features are a good thing not a curse. If you want them people are free to upgrade at their discretion. No one is forcing you to upgrade the OS and no one made you buy the Nano. The requirements are all over the place and it was your job to look into it before buying it.

  • Why does my ipod nano keep shutting off?

    My new Ipod nano keeps shutting off after about a minute when playing music. It is fully charged.

    Hi, I had the same problem  googled the problem & it said to make sure ear piece  is in as far as possible , make sure no silver is showing on the jack, check out ifixit.com. mine now working ok.

  • What do I do if my iPod nano keeps syncing, resetting, and syncing and i cant add music to it? I've tried syncing my other iPod and that works just fine.

    What do I do if my iPod nano keeps syncing, resetting, and syncing and I cant add music to it? I've tried syncing my other iPod and that works just fine.

    If it is a lightning to 30 pin adaptor, and you have a 7th Generation Nano it has to fit the Nano.
    This is lightning to 30 pin adapter: http://www.bestbuy.com/site/Apple%26%23174%3B---Lightning-to-30-Pin-Adapter/6651 936.p?id=1218803450821&skuId=6651936#tab=overview
    Is this what you bought?
    You need to contact Sony and see if they model you have is compatible with the docking adapter. It may not be.

  • My ipod 4 keeps skipping when i watch videos

    my ipod 4 keeps skipping when i watch videos

    - Reset the iOS device. Nothing will be lost      
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    -Go to Settings>Message>Send and Receive and sign out and then sign back into Messages. Note that all old messages on the iPod will be deleted.
    - Reset all settings                            
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                               
    iOS: Back up and restore your iOS device with iCloud or iTunes
    - Restore to factory settings/new iOS device.                       
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
      Apple Retail Store - Genius Bar                                              

  • My iPod just keeps skipping songs

    My iPod just keeps skipping through songs and won't play anything.

    It skips on my ipod directly not my computer. It would play one song then just keep skipping through and wouldn't play anymore. I figured out how to fix it though. You need to push the menu button and the circle in the middle at the same time until the apple comes onto the screen, this should reset it. It worked for mine. Thanks

  • Ipod nano keeps randomly pausing.

    Ipod nano keeps pausing mid song and it's not the headphones... I've tried different sets of headphones & even held them in so they were flush. Still keeps happening. Been listening with no issue for about 2 hours before it started happrning all of a sudden. sometimes it will play 10 second sometimes it will [lay a few minuts but it always eventually pauses itself. Any ideas?

    I just received my brand new 7th Gen iPod Nano today, ordered directly from the Apple website, and I am experiencing the exact same issue. I have tried several diffent pairs of headphones and regardless, the iPod randomly pauses. I also noticed that on occasion if I press play the iPod will indicate that it is playing music however no sound comes out of the headphones. It seems pretty clear to me the headphone jack is faulty... I suppose I'll need to get on the phone and deal with the highly inconvenient process of exchanging it. Very disappointed.

  • My 4th gen Ipod nano keeps getting stuck on the apple logo.

    My 4th gen Ipod Nano keeps getting stuck on the Apple logo screen, this happens everytime I plug it in to charge. I plug it in, an apple logo comes up, and it stays like that the entire time its plugged in. To get it to unfreeze, i have to press random buttons and unplug and re plug in earbuds. After 20-25min of doing this it unfreezes and I come to find it has gotten little to no charge after being plugged in for hours at a time. Any one else have this problem, and if so what do you do?

    This can be a corrupted software/firmware on your iPod touch. If the recovery mode you did was not forced, then try to force it into recovery mode. This is how:
    1. Force it to shut down (note: this sort of shut down should not be preformed unless you are in a situation like this because it is a hardware shutdown and will not attempt to unload software, save unsaved files, safely stop system processes, etc.) to do this, hold down the power/sleep button and home button for about 7 or 10 secs. Also I might be incorrect but I heard that you can just hold down the sleep and home button until the screen goes blank and then immediately let go.
    2. Have iTunes running. Hold down the home button and plug the USB cable that came with your iPod into it. Keep on holding on the home button until a picture of a USB cable going into the iTunes logo appears. You are now in a forced recovery mode. (In case your not so tech-savvy forced recovery is the same as a normal recovery mode that an iPod might do if it knows an update or restore failed.)
    3. iTunes should have shown a pop-up message about it found a iPod in recovery mode. Click OK, click your iPod from the sidebar and click restore. The iPod will show the apple logo for a while and iTunes will say "preparing iPod for restore" and then "waiting for iPod" this was the longest part of updates for me.
    4. iPod will reboot when restore is completed. When I update my iPod it one time showed the apple logo for one whole sync until it showed the slide to unlock screen, so do not worry. P.S if that does not work do a DFU mode restore ( I've been told DFU mode stands for device firmware update mode) I'm running out of room, so google it. Hope this helped ;)

  • Why is my iPod touch making a static noise?

    My iPod touch (2 gen) is making a static noise from the internal speaker. Anytime that I play my iPod from the speaker or headphones, it makes a static and crackling noise. However, it does work when I connect it to my iPod dock. I have tried the five R's and none of them work. What can I do to fix this?

    Make an appointment at the Genius Bar of an Apple store.
    Apple Retail Store - Genius Bar

  • Does the iPod nano keep changing songs if I keep it in my pocket?

    I'm not going to be running or gymming with the iPod nano in my pocket. It is mostly for home use. I just wanted to know that since there is no HOLD/LOCK button, it may keep changing songs if put in a tight pocket while walking or travelling. Is that the case?
    Also, should I buy it for home use? (With the occasional outdoor trip? Or do you think I just stick to my laptop)

    If you have Shake to Shuffle turned off and you push the sleep button it shouldn't change songs in your pocket. Mine doesn't.

  • IPod Nano 4G Skips During Playback with Apple Lossless Songs

    My iPod Nano 4th Generation has been consistently skipping a brief portion of music about every 5th Apple Lossless song during playback. I've been working unsuccessfully to resolve this issue with tech support and fixed the problem when I disabled the energy level setting in the playback menu. While this is a hit to battery life, the skipping no longer occurs. Hoping that this issue is permanently resolved in an upcoming software update.

    Hi,
    I brought my ipod yesterday and had the exact same issue. it would skip certain songs frequently and was extremely frustrating. Im not sure if this is the case for all ipods (i have an ipod nano 16Gb 4th gen, with firmware 1.0.4), but i fixed my issue in a series of steps. Im not sure which exact part of my method did the job, but here it is:
    1. plugged it into iTunes and clicked "restore" under the tab "summary". WARNING: This will delete everything, and restore factory settings. im not sure if this is necessary, but youll need to delete the songs which skip anyway.
    2. pressed the eject button IN ITUNES (under "devices", and next to your ipod icon), ejecting the ipod. wait for the ipod to specify when it is ready for it to be unplugged. proceed to unplug said ipod.
    3. Choose the language of your ipod, and go into playback settings and (settings/playback or something) and turn OFF "shake" and "energy saver"
    4. Plug your ipod into your computer again and drag all the songs onto your ipod using itunes.
    5. after it has finished copying, WAIT until the ipod no longer says "synching", and until it says "connected"
    6. Press the eject button IN ITUNES (again, under devices, and next to your ipod icon)
    7. Eject when the ipod says it is ok to do so.
    As i said, im not sure which part of the method did it for me, but i think it might be the way in which i was ejecting it. Before i was ejecting the ipod on my desktop. I think it is important to eject it using itunes. Anyway this fixed my ipod. Im not sure if it will do the same to yours, but if its making you very angry (to say the least) like it made me, its worth a try i guess. I would appreciate it if people let me know if this works.

  • Ipod nano keeps speaking song title, how do i stop this?

    my ipod nano 6th gen keeps speaking the song title despite the hints being switched to off, any help would be appreciated.

    First, double check and make sure that VoiceOver is off. Check in itunes by clicking the "Configue Universal Access" button and making sure all checkboxes are unchecked.
    Then, on the Nano, navigate to the accessibility settings menu and make sure it is off there.
    Finally, at the bottom of the settings menu is the "reset settings" option. Do that, then check again.
    If after all this it is still doing it, restore the Nano in itunes.
    If it is still doing it after that, it is likely that there is some moisture either in your buttons on the device or in the buttons on your headset (if it has them).
    i

Maybe you are looking for

  • Itunes doesn't open after 10.4.7 upgrade

    I just did the 10.4.7 upgrade after receiving a message from Apple that the upgrade was avalable and recomended for all users. I quit all applications excpet the finder and did the install... All went well and I restarted my Power Book G4 1.6Ghz. I c

  • How do you set up excel form in sharepoint server?

    Dear all, I am trying to setup an excel form in sharepoint list, basically something that will do a bit of calculation and it has to be in form format. Just like the excel form. Will it be easier to set it up in a web page or in a list? I will need t

  • Inter-company Sale

    Hi i want to create Purchase order directly from Sale Order. i have created this scenario Document Flow ----Sale order ------OutBound delivery --------PGI ----------Invoice -------------Inter company invoice i have to include PO in this Document flow

  • Oracle apex select list display

    hi all: i have 2 select list ,1. select list1 and 2.select list 2 ok .in select list1 have items like A,B,C,D,E,F LIKE THAT AND select list2 aslo have item's like X,Y in select list1 i am trying to select B ..in select list2 it should be display only

  • Why can't i decline an update on iphone 4s?

    i have recieved an update for IOS7 on my 4S. It is to fix a security issue for the 5S and something about Greek. I do not require it. Why can't I decline to download it?