Ipod touch hacked everytime headphones are plugged in

ipod touch is hacked every time apple headphones are plugged in.  For example songs will start, stop, fast forward, rewind, and voice control menu is sometimes activated, all without touching anything on the screen or headphone buttons.  Apple headphones act as antenna so this seems the likely reason, when heaphones unplugged hacking stops.  Ipod using 7.0.3

First try another pair of headphones. If still problem
- Try cleaning out/blowing out the headphone jack. Try inserting/removing the plug a dozen times or so. There is a little switch in the headphone jack that disconnects the speaker when the headphone jack is inserted.
Try the following to rule out a software problem
- Reset the iPod. Nothing will be lost
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup
- Restore to factory settings/new iPod.
- Make an appointment at the Genius Bar of an Apple store. Seems you have a bad headphone jack.
Apple Retail Store - Genius Bar

Similar Messages

  • My iPod 5 says that headphones are plugged in but they're not. Help?

    So today I was just using my iPod 5 to play music and then it suddenly wouldn't play anything. Even when it was on full volume there were no sounds. I tried to find out what was going on and I found out that it says that the headphones are plugged in, when I pressed the volume buttons. If I plugged in actual headphones it would play music/sounds but if I plugged the actual headphones out it wouldn't play. Please help me!

    - Try cleaning out/blowing out the headphone jack. Try inserting/removing the plug a dozen times or so. There is a little switch in the headphone jack that disconnects the speaker when the headphone jack is inserted.
    Try the following to rule out a software problem
    - Reset the iPod. Nothing will be lost
    Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup
    - Restore to factory settings/new iPod.
    - Make an appointment at the Genius Bar of an Apple store. Seems you have a bad headphone jack.
    Apple Retail Store - Genius Bar
    If not under warranty Apple will exchange your iPod for a refurbished one for this price. They do not fix yours.
    Apple - iPod Repair price                  
    A third-party place like the following will replace the jack for less. Google for more.
    iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens
    Replace the jack yourself
    iPod Touch Repair – iFixit

  • Ipod Touch 4th gen has no sound except when headphones are plugged in

    I have checked sound settings, reset the ipod, powered off, and synced it.  Still no sound except when the headphones are plugged in.  Any ideas?

    - Try cleaning out/blowing out the headphone jack. Try inserting/removing the plug a dozen times or so.
    Try the following to rule out a software problem
    - Check also Settings > General > Accessibility > Hearing. Make sure that the sound balance is not set all the way to "R".
    - Reset the iPod. Nothing will be lost
    Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup
    - Restore to factory settings/new iPod.
    - Make an appointment at the Genius Bar of an Apple store. Seems you have a bad headphone jack.
    Apple Retail Store - Genius Bar
    Apple will exchange your iPod for a refurbished one for this price. They do not fix yours.
    Apple - iPod Repair price                  
    A third-party place like the following will replace the jack for less. Google for more.
    iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens
    Replace the jack yourself
    iPod Touch Repair – iFixit

  • My 2nd gen iPod touch's music app will crash as soon as a song is selected while headphones are plugged in.

    It will crash as soon as a song is selected while headphones are plugged in. It won't even go to the Now Playing screen; it will just hang on the highlighted song for a few seconds and then crash. Works fine when nothing is plugged in, though. Sometimes it will work completely fine, but after restoring the iPod, the problem seems to have worsened after a day of perfect operation.
    The iPod was a gift from a friend, and he had it for a while, so I don't think there's a warranty on it anymore. Help please??

    If you only restored from backup try restoring to factory defaults/new iPod. If you still have the problem then an appointment at the Genius Bar of ab Apple store is in order since you appear to have a hardware problem. The apointment is free.

  • My ipod 5th gen won't change volume when headphones are plugged in, but when they are not I can change the volume on the speaker.  How do I fix this?

    My ipod 5th gen won't let me adjust volume when headphones are plugged in, but when they are not I can adjust the volume on the speaker.  How do I fix this?

    Try a hard reset of the Nano. To do this, press and hold both the Select (Center) and Menu buttons together long enough for the Apple logo to appear.
    I assume you have double checked to make sure you are plugging the headset all the way in meaning the white part of the headset is flush with the body of the Nano?
    B-rock

  • IPod nano 6th gen (brand new) doesn't recognize when headphones are plugged in

    I have a brand new iPod nano (6th gen), and it doesn't detect when headphones are plugged in. I have read that the problem can ocurr because the headphones are not correctly inserted (which is not the case.. i'm absolutely sure about this) or that the headphone jack has dust inside (which is also not the case, since it is brand new).
    This is what happens:
    When i play a song, and then press the sleep/wake button to turn off the display, the music stops. Or if i let the music play, it stops when the screen times out and turns off. These two things occur because the ipod "thinks" that there are no headphones inserted.
    When i try to activate the FM radio, the radio won't start because it says that there is no radio signal (which occurs when no headphones are connected).
    Needless to say, the microphone and volume controls of the iphone headset, don´t work at all (they even work on the ipod shuffle!).. and because of this, no voice recording for me!
    It's a shame, because the FM radio is completely useless, and music playing only works by activating the "double click to play" option in the settings menu.. but it is somewhat cumbersome the process of "play music - turn off the screen - double click to resume playing" every time I select a song.
    The headphone detection has only worked randomly when the ipod is connected to the computer, but i haven't been able to figure out under what conditions this occurs. I have read about this issue, and I only would like to know if this is a firmware bug of the 1.2 version. I tried unsuccesfully to downgrade the firmware to the 1.1 version (maybe because the ipod shipped with the 1.2 version).
    I have also restored the device in itunes, with no luck.....
    Thanks in advance for any useful answer!

    Thanks for your answer...
    The headphones that i'm using, are the ones that were included with the iphone 4 (so, they are original).. however this shouldn't be a problem, as the ipod should work fine with whatever headphones i choose to use (sound quality will vary, of course).
    The ipod does the same with the headphones that were included in the box, and with every pair of headphones i have used to test, so i'm certain that the ipod has an issue.
    I hope that the picture is clear enough.. here you can see that the headphones are fully inserted, and the ipod is not recognizing them.

  • Hi, I have a 4th generation's iPod Touch, and everytime I try to plut, Hi, I have a 4th generation's iPod Touch, and everytime I try to plug it in my Sony dock,

    Hi, I have a 4th generation iPod Touch, and everytime I try to plug it in my Sony dock, for the 2 first seconds, on it's screen, the iPod would display the
    image of the battery, but it would automatically turn into a yellow triangle with an exclamation point in it, and wrote
    under it that the accessory is not working with the iPod Touch... Please help me!!! P.S : i have my dock since 2 years, and it recently started showing this message) ...

    Disabling the computer's security software (firewall and antivirus) usually resolves that error.

  • Gen 5 has lost volume control of headphones and also radio does not recognize headphones are plugged in.

    gen 5 has lost volume control of headphones and also radio does not recognize headphones are plugged in.  Any Ideas on a fix?

    The earphones must be pushed very hard into the iPod. So hard, that the white part of the plug must touch the iPod in order for the external speakers to turn off. You will hear a click.
    If you do a forum search, you will find this same solution. If it does not work, you will need to take your iPod to an apple store or call the Apple iPod tech support if still under warranty or you have Apple Care.

  • My ipod touch screen broke and i am replacing. i backed up my apps to the computer and they now sit in itunes apps.  how do i add them back to my replaced ipod touch? everytime i try to move them, i get a red circle w/ a line thru it?? thanks

    I am replacing my ipod touch today.  I backed up the apps into itunes and they now sit in itunes>library>apps.  How can I transfer them to the new ipod touch?  Everytime I attempt to move the apps, i get a red circle w/ line thru it and I can't do anything.  They were purchased by the same user ID as the computer uses, although the computer is new also? any thoughts? Thanks

    Sync the apps to the iPod via iTunes. Make sure that the apps are chaec to syc and the proler boxes checked in the Apps pane for the iPod in iTunes.

  • Can i exchange my appe ipod touch cable and headphone for new one

    can i exchange my appe ipod touch cable and headphone for new one

    Only if they are in warranty and have factory defects.

  • I have an ipod touch and everytime i connect to my home wirless network it asks for a wep key. It never did that before?

    i have an ipod touch and everytime i try to connect to my home network it asks for a wep key. It never did that before . Now everytime i take it out of the house and come home it asks for it .no one elses in the family asks for the wep key. What can i do about this?

    Can no one help?

  • My Ipod touch will only work when plugged into a itouch radio.  When I take it out, it goes blank.  Why can I do?

    My Ipod touch will only work when plugged into an Itouch radio.  When I take it out of the charger, it goes blank.  The battery shows fully charged.  It appears that the battery is no longer charging.  What should I do?

    Try a reset: Hold the home and power buttons at the same time until the Apple boot logo appears. No data will be lost. If that fails, the battery may have gone kaput.

  • When syncing ipod touch with mac, where are my contacts and notes stored on the computer?

    I lost all the notes on my ipod touch..
    When syncing the ipod touch with mac, where are these files stored.
    i.e. contacts and notes?

    It's all stored here.
    User > Library > Application Support > MobileSync > Backup
    Basic troubleshooting steps  
    17" 2.2GHz i7 Quad-Core MacBook Pro  8G RAM  750G HD + OCZ Vertex 3 SSD Boot HD 
    Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101
     In Memory of Steve Jobs 

  • My computer will not recognize my ipod touch anymore. When I plug it in it says the USB device attached to this computer has malfunctioned and windows doesn not recognize it.

    My computer (PC) will not recognize my ipod touch anymore. When I plug it in, it says the USB device attached to this computer has malfunctioned and windows does not recognize it. I have tried attaching the same cord and ipod to a different computer and it is recognized by our mac. I have tried restarting the ipod, downloading all updates on my pc, restarting the pc, etc. Nothing has worked. Please advise.

    See:
    iOS: Device not recognized in iTunes for Windows
    I would start with
    Removing and reinstalling iTunes, QuickTime, and other software components for Windows Vista or Windows 7

  • I recently repaired disk permissions on my mac HD and now my on-board speakers wont work, the icon is greyed out and only works when my headphones are plugged in.

    I recently repaired disk permissions on my mac HD and now my on-board speakers wont work, the icon is greyed out and only works when my headphones are plugged in

    Try to put your headphones several times in and out from your connection, might be the switch is stuck. Normally it should work again while trying to plug the headphones in and out!

Maybe you are looking for

  • Open multi page pdf specific page in Illustrator CS4 with apple script

    I need to open multi page pdf specific page in Illustrator CS4 with apple script. Is it something like this: activate  (open file theTargetFolder as PDF with options -). Thank you.

  • Purchase Requistion,Purchase Enquiry, Sales Enquiry,Capacity Planning & Sch

    Hi All, I am working in SAP business One for quiet long time as Functional Consultant and i am very much aware with its design. And Now SAP is bringing SAP HANA also for Mid Size Company or you can say in SAP Business One. BUT ............... In any

  • Safari 5.0.6 keeps crashing. Here is the report:

    Process:         Safari [1606] Path:            /Applications/Safari.app/Contents/MacOS/Safari Identifier:      com.apple.Safari Version:         5.0.6 (5533.22.3) Build Info:      WebBrowser-75332203~3 Code Type:       X86 (Native) Parent Process: 

  • Integration repository/directory not opening

    I am new to XI, I have DPI box installed, after launching integration builder (SXMB_IFR) and click on Integration repository link I get a message “Do you want to open or save this file” Name: repository.jnlp Type: Unkown File type From: cor-str-app37

  • How to download and install Photoshop Elements 10?

    Hi, I bought the Elements 10 Software about 1 or 2 months ago. I installed it (with the CD) on my old laptop, but I recently got a new one that does not have a CD drive. After uninstalling it on my old laptop, I wanted to download the software to my