Is it ok to consistently use Iphone 5s hotspot?

My Wifi is down for the moment and im wondering if i can use my Iphone 5s USB hot spot for the time being. But currently im worried that this will effect my Iphones battery life. Can someone confirm that this will/ will not damage my iphone in any way? I have unlimited data so the usage factor is no problem.

It will not damage your phone. Whatever gave you that idea?

Similar Messages

  • How to use iphone as hotspot

    How to use iphone as hotspot?

    To use your iPhone as a Hotspot, first make sure you subscribe to a hotspot plan through your provider.
    Depending on your prodiver it may come included in your Data subscription or you may need to pay extra.
    Most carrier will give you instructions on how to set up your hotspot.
    If not try following this: Settings > General > Cellular > Setup Personal Hotspot
    Try this too: http://support.apple.com/kb/HT4517

  • Is there any way of sharing my Macbook Pro's Wifi connection to iPhone 4 (Not Using iPhone as hotspot for laptop the other way around)

    So a nasty smash destroyed both Front & Back of my iPhone 4, and since having them replaced the Wifi signal has been really weak.
    I have seen other posts about screen replacement having to be done by going through the antenna, so something could be missing, or done incorrectly during the screen repair. Will definately be taking it back to the shop and finding out if It was put back together properly.
    In the meantime I was wondering if it is possible to share my Macbook Pro's Wifi (always full signal in my house) directly to my iPhone either using USB cable or through bluetooth. It's not been too much of a problem but it would be nice to use my iPhone in bedroom using the Macbooks good signal.
    Note: The replacement front screen on iPhone has a small gap >1mm between the screen and centre metal casing on the left side just above the Silent/Loud Switch, which can be noticed by light leaking through the gap. The metal casing also still has a small dent between the volume down buttons and silent/loud switch, again nothing drastic 1mm maximum

    Here is the start of the setup:
    Click on the Wi-Fi Options button and provide the needed info:
    Click on the OK button. Now check the Internet Sharing box to turn it all on. If the port box you checked is no longer checked, then uncheck Internet Sharing, check the port box again, then check the Internet Sharing box again.

  • X200 using iPhone personal hotspot failure

    I've got a friend with an X200. He is trying to use his iPhone 4s as a  personal hotspot. The phone is set up correctly because we can connect to it using my laptop (not an X200). My laptop connects using WPA2/AES.
    When we try connecting using Access Connections, the association fails. I tried all four modes WPA/TKIP WPA/AES WPA2/TKIP WPA2/AES. All failed. When I click on the help me fix this button and get the report here's the error and recommended actions:
    Connection status:        Disconnected
    Cause:        Association Failed
    Error code:        011
    Recommended actions:
    Verify that the encryption settings (WEP/TKIP/AES) specified in this profile match those expected by the wireless network.
    Verify that the wireless adapter in your computer has not been restricted from accessing the radio channels being used by the wireless network.
    As I said, we tried all the encryption settings and checked the key several times. The phone is using channel 2.
    This is the Adapter info:
    Adapter Details
    Adapter name        Intel(R) WiFi Link 5100 AGN                                     
    Adapter type        Wireless LAN                                                    
    Adapter speed        150.0 Mbps                                                      
    Driver/Firmware version        12.2.1.2/ N/A                                                   
    Adapter status        Enabled                                                         
    Connection Status        Disconnected                                                    
    Disable unused cards?        No
    The first fix I tried was to update the BIOS and Access Connections (5.85). Still wouldn't work and gave the same errors.
    Any suggestions as to what to try next?
    Thanks
    Solved!
    Go to Solution.

    Apply this patch on AC 5.85. This is for Win 7.
    Attachments:
    iPhonePatchAc5.85.zip ‏829 KB

  • Using iphone as hotspot

    I have an iphone 4s 5.1.1 and a MBP 10.6.8
    If I use my apple usb cable and plug then together the phone charges and updates in itunes and also does all the other usual things but I cannot get it to work as a Personal hotspot.  The Mac says the phone is not connected.  It will work as a wireless connection, so I know I have set things up correctly but with the usb cable only, they cannot see each other to work, even though the cables work in other applications ?

    Using the device as a hotspot for extended periods of time will cause it to heat up for constant use and drain the battery very rapidly.  Buy a dedicated device.
    From a cost/speed perspective, cable modem, DSL, or Satellite are a better value.

  • Use iPhone personal hotspot to connect my iPad with my laptop

    I am living in school residence so I don't have a wireless connection, nor am I allowed to use a router on the school internet.
    I have an iPhone with data plan and personal hotspot. I want to watch movies on my iPad, streaming from my laptop, using some apps like VLC Streamer.
    So my questions are, can I set up a network using my iPhone, and have both my laptop and iPad connect to my personal hotspot? Will that allow me to use VLC Streamer? And will my mobile carrier charge me for the data between my laptop and iPad, which should be considered a local connection?
    Thanks a million!

    Please help me!!!

  • How can I air print from a MG5420 using iphone 6 hotspot?

    I'm attempting to print a doc from ipad to MG5420 utilizing my iphone6 hotspot. Can this be done? MG5420 is not recognizing the hotspot. Help!

    You don't. With the phone disabled, the only way to enter the phone is a restore. That will destroy the data. You did not have to sync the phone while using it as a camera, but you should have been importing the photos from the device as you would a digital camera. That would not have required the phone to be active either. If they were important, you would have been backing them up and/or importing them on a regular basis.
    Unless you can remember the passcode, you will not be able to get into it, and the passcode even disables the ability to get to the photos via Explorer on the computer. I'm sorry.

  • TS3899 "cannot get mail" in iphone5 suddenly. been using iphone to check 2 email accounts for months now, one is gmail and not troubled. the other is thunderbird and i get this error message now. no settings have been changed or anything! ideas?

    hey all, I have been getting the "cannot get mail" error message on my iphone5 suddenly.
    ive been using iphone to check two email accounts for months now, one is gmail and not troubled. the other is mail from thunderbird and i get this error message now saying it is not responding. no settings have been changed or anything, it just suddenly stopped receiving mail on my device as of Tuesday afternoon.
    Does anyone have iny ideas about why? i have yet to update to the new OS7 yet, could that be it?

    'The installer has insufficient privileges to modify this file C:\Program Files (x86)\Common Files\Apple\Apple Application Support\Web kit.resources\inspector\Images\Spinner Inactive Selected.gif.'
    That one's consistent with disk/file damage. The first thing I'd try with that is running a disk check (chkdsk) over your C drive.
    XP instructions in the following document: How to perform disk error checking in Windows XP
    Vista instructions in the following document: Check your hard disk for errors
    Windows 7 instructions in the following document: How to use CHKDSK (Check Disk)
    Select both Automatically fix file system errors and Scan for and attempt recovery of bad sectors, or use chkdsk /r (depending on which way you decide to go about doing this). You'll almost certainly have to schedule the chkdsk to run on startup. The scan should take quite a while ... if it quits after a few minutes or seconds, something's interfering with the scan.
    Does the chkdsk find/repair any damage? If so, can you get an install to go through properly afterwards?

  • How do I use an used iphone with an exsisting AT, How do I use an used iphone with an exsisting AT

    How do I set up an used iphone to an exsisting AT&T account

    Set it up as new by going to Settings>General>Reset>Erase All Content and Settings (which returns it to it's new out of the box condition), put your SIM in it and go through the activation screens.  Be sure this is an AT&T phone though as AT&T phones are locked to only work on the AT&T network.

  • FaceTime and iCloud must be signed in to the same Apple ID to use iPhone Cellular Calls.

    FaceTime and iCloud must be signed in to the same Apple ID to use iPhone Cellular Calls.
    This is the error message I receive when I try to add my phone to my Mac for proximity / FaceTime audio calling.  This feature worked until I changed my Apple ID.  I have updated my Apple ID everywhere I can think of updating it.  I've signed out of Apple ID on my Mac, deleted EVERYTHING (calendars, contacts, etc.), signed back in, etc.  I've done the same with my phone, and even done a power-down / reboot and nada.  I keep getting this message from the Mac.
    I can't figure out where else I should look for my old Apple ID to be logged into anything or creating problems.  I've gone over my iPhone and Mac and I'm at a loss.  As an aside (and yes, wrong forum), have lost the ability to do SMS forwarding since the Mac no longer receives the code from my iPhone to allow this feature to work.  This was lost after signing out of the Apple ID on my Mac this afternoon.
    Bluetooth is turned on for both devices.  Both devices are on the same WiFi network.  Both devices otherwise appear to be working correctly with the exception of the problems I'm having with FaceTime and iCloud being signed into the same Apple ID (which they are).
    Thanks in advance,

    (By the way, I should have pointed out in my earlier posting that I'm running OS X Yosemite 10.10.3 on my Mac). I Just installed latest Yosemite update while my iPhone was switched off, and when my Mac restarted, the 'iPhone Cellular Calls' checkbox in the FaceTime preferences was checked and the problem was therefore solved. Switched on my iPhone, still fine. Relief.

  • My imessanger is not working in ios 6, i m using iphone 4

    i m using iphone 4 its factory unlock and i have updated ios 6 after this i m not able to activate my imessage please assist on this.

    http://support.apple.com/kb/TS4268

  • I have a used Iphone with someone elses email on it for itunes, how do i remove it and put my account there

    I have a used Iphone with someone elses email on it for itunes, how do i remove it and put my account there
    It is an Iphone 4

    If you go to settings- store - click on the ID and sign out. Then you can put in your apple id.

  • I have bought an used Iphone 5. I dont have the password for the existing login id of the old owner. How do i use the phone and change the log in id?

    I have bought an used Iphone 5. I dont have the password for the existing login id of the old owner. How do i use the phone and change the log in id?

    Unfortunatly the only way that you can get it off is to get the old user to input the password.  You may need to contact that old user and see if he can put the old password in.  hope this helps.

  • How do I activate a used iPhone 3 with no SIM card for use as an ipod touch?

    How do I activate a used iPhone 3G with no SIM card for use like an iPod Touch? It was apparently on AT&T previously and I have another iPhone 3 that is active on AT&T if that is helpful. Thanks!

    Copied from the link provided.
    Follow these steps to use your iPhone without a wireless service plan:
    Insert the SIM card from your new, activated iPhone or one that was previously used to activate the original iPhone.
    Connect the iPhone to iTunes on a computer connected to the Internet.
    Once iTunes activates the device, you're free to use the iPhone as if it were an iPod touch.

  • Can't Apple Remote to iTunes when using iPhone as a Personal Hotspot

    My AT&T iPhone 4S is set up to be used as Personal Hotspot.  So I turn HotSpot on and connect my MacBook Pro to my iPhone's internet just fine.
    However, when I open Apple Remote app on the iPhone, it won't connect to iTunes on my MBP. 
    I have set it up at home where both iPhone and MBP are connected to the wireless connection on the Apple Airport.  It worked perfectly in that configuration.
    I'm in a band that plays weddings and corporate events.  During breaks, I use Apple iTunes to DJ tracks.  If I can't use Remote, I'm tethered to the stage constantly.  This is a big problem.  I need the internet connection to buy songs that are requested that I don't already own.  And I need to be able to control iTunes remotely for when I'm in the crowd running microphones from one person to another during speeches and such.
    Is there a setting that I'm missing somewhere?  Or am I just outta luck for this configuration?
    Thx, Patrick

    Hi! This will solve the problem. Connect iphone personal hotspot, on macbook turn on - internet connection sharing - create your network - connect iphone to that network, you will have internet connection and mac with iphone will think that you are on wifi network. From that point will everything work - also remote control and remote sync with itunes. Try it!.

Maybe you are looking for

  • Can I use a for loop to add anonymous ActionListener objects?

    I have a setListener() method that has the following inside: for(int k = 0; k < buttons.length; k++)     buttons[k].addActionListener(new ActionListener()         public void actionPerformed(ActionEvent e)             g2.setColor(colors[k]); }I have

  • Lion and iTunes 10.5 no longer connect to firefly music server on ReadyNAS.

    I installed Lion and iTunes 10.5 on my MacBook Pro (upgraded from Snow Leopard), and the firefly streaming service on my Netgear ReadyNAS NV+ no longer works. My wife's machine, still on Snow Leopard, still connects through the shared library as expe

  • How can i use page break for every 5 records in sap scripts

    on every 5 lines of records i have go for a new page so what is procedure to do this .if possible send me with coding .

  • Need suggestions on loading 5000+ files using sql loader

    Hi Guys, I'm writing a shell script to load more than 5000 files using sql loader. My intention is to load the files in parallel. When I checked the maximum number of sessions in v$parameter, it is around 700. Before starting the data load, programma

  • Entry not found in Table T706V

    Hi, When I simulate a trip I get error message "Entry not found in Table T706V  Argument JSP IN 0022420080901 is missing". Where JS is Trip provision copied from 40 Trip Provision. I am not undersatnding what is 00224. When I try this in IDES , it wo