Is there anything that can't be defined with annotations?
HI,
Is there anything that can't be defined with annotations and can only be defined in the faces-config.xml?
Thanks.
A few more things that cannot be defined in faces-config.xml are:
- Localization information
- ELResolver
- Application Factories
- Renderers
- Validators etc.
Similar Messages
-
My system keeps shutting off unexpectedly after updating it to OS X 10.8.2 (12C60). is there anything that can be done to correct this?
Please read this whole message before doing anything.
This procedure is a diagnostic test. It’s unlikely to solve your problem. Don’t be disappointed when you find that nothing has changed after you complete it.
The purpose of the test is to determine whether the problem is caused by third-party software that loads automatically at startup or login, or by a peripheral device.
Disconnect all wired peripherals except those needed for the test, and remove all aftermarket expansion cards. Boot in safe mode and log in to the account with the problem. Note: If FileVault is enabled, or if a firmware password is set, or if the boot volume is a software RAID, you can’t do this. Ask for further instructions.
Safe mode is much slower to boot and run than normal, and some things won’t work at all, including sound output andWi-Fi on certain iMacs. The next normal boot may also be somewhat slow.
The login screen appears even if you usually log in automatically. You must know your login password in order to log in. If you’ve forgotten the password, you will need to reset it before you begin. Test while in safe mode. Same problem? After testing, reboot as usual (i.e., not in safe mode) and verify that you still have the problem. Post the results of the test. -
My track pad has not been working properly for awhile and my disc drive it damaged. I went to update my macbook pro to maveric and it is now frozen and not allowing me to click anything. Is there anything that can be done to fix this without buying a new one? Its from early 2009
ShelbyMackenzieLynne,
when you say that your disc drive is damaged, do you mean your MacBook Pro’s hard disk drive, or do you mean its SuperDrive (the CD/DVD drive)?
When you’d updated your MacBook Pro to Mavericks, did the installation succeed, and subsequently freeze up? Or did it freeze up during the Mavericks installation?
Which version of OS X was installed on your MacBook Pro before you’d installed Mavericks?
Are you currently able to boot into the Mavericks recovery partition? To see if you can do so, hold down a Command key and the R key while starting up your MacBook Pro. -
i have tried all of these troubleshooting techniques, have taken it to an apple shop and had my ipod restarted and wiped but still no luck, is there software that can reunite my ipod with my laptop?
What do you mean by "reunite". Are you experiencing connectivity issues between your iPod Nano and your iTunes on your PC? If yes, in what do these issues consist? Are there any error messages you are being returned?
-
Is there anything that can be done to tune this query?
DB version:10gR2
From AWR report, we have determined that the following SQL is taking most CPU Time. Is there anything that we can do to improve the performance of this query.
We have an index on (stat_code,create_date_time) columns of ext_replenish table.
SELECT EXT_REPLENISH.EXT_REPLENISH_ID, EXT_REPLENISH.EVENT_ID, EXT_REPLENISH.EVENT_KEY, EXT_REPLENISH.WHSE, EXT_REPLENISH.VALIDATE_KEY, EXT_REPLENISH.NBR_OF_RETRY, EXT_REPLENISH.STAT_CODE, EXT_REPLENISH.ERROR_SEQ_NBR, EXT_REPLENISH.CREATE_DATE_TIME, EXT_REPLENISH.MOD_DATE_TIME, EXT_REPLENISH.USER_ID, EXT_REPLENISH.CL_MESSAGE_ID, EXT_REPLENISH.SCHEMA_ID, EXT_REPLENISH.ELS_ACTVTY_CODE, EXT_REPLENISH.CD_MASTER_ID FROM EXT_REPLENISH WHERE ( ( ( ( ( EXT_REPLENISH.STAT_CODE = :1 ) OR ( EXT_REPLENISH.STAT_CODE = :2 ) ) OR ( ( ( EXT_REPLENISH.STAT_CODE = :3 ) AND ( EXT_REPLENISH.ERROR_SEQ_NBR >= :4 ) ) AND ( EXT_REPLENISH.ERROR_SEQ_NBR < :5 ) ) ) AND ( EXT_REPLENISH.MOD_DATE_TIME <= :6 ) ) AND ( EXT_REPLENISH.NBR_OF_RETRY < :7 ) ) AND ROWNUM <= 1 ORDER BY EXT_REPLENISH.STAT_CODE ASC, EXT_REPLENISH.CREATE_DATE_TIME ASC FOR UPDATE
Is there anyway i could tune this query?
note: Ignore the unnecessary brackets. They are system created(apparently by hibernate)
Message was edited by:
Nichols
Taking off the pre tags due to readability issue(all words appear in single line )
Message was edited by:
NicholsFrom just blindly looking at this particular query, there doesn't seem any obvious reason why an index couldn't be extended to cover all the columns specified in the where clause.
It might not help too much -> explain plan is required first really before blindly guessing.
Obviously, there's no point having an order by and a rownum (unless you wanted to do the order by before the rownum in an outer select) - I assume this is just a Hibernatism. -
Please help me figure this out......having NO MUSIC is like ripping off a part of me and throwing it away : ( Just devastating.
If you have iTunes 10.3 or later and you are a resident of the U.S. you can re download past iTunes purchases for free.
Click Purchased under Quick Links right side of the iTunes Store window.
Downloading past purchases from the App Store, iBookstore, and iTunes Store -
I recently got my moms friends old iphone5 that he had for like a month. Everything is fine with it but it wont let me update any of my apps because it asks for his apple ID password. Is there anything i can do to change/fix that?
sabrinabriii wrote:
I recently got my moms friends old iphone5 that he had for like a month. Everything is fine with it but it wont let me update any of my apps because it asks for his apple ID password. Is there anything i can do to change/fix that?
You should remove his AppleID and restore it as new. -
I tried to update my iPhone 4S but I now keep getting an error saying I need to restore my phone before it can be used because it's in recovery mode! But if I restore it I lose all my media and data and I don't want to do that! Is there anything I can do?? Somone please help, i'm freaking out over here!
Anything that was on the phone is already gone. You have no choice but to restore. If you were backing up and syncing the phone on a regular basis, you should be able to restore your backup with minimal data loss.
-
Hello! I bought an iPod touch 3rd gen at a pawn shop and when i tried to set it up, it would not connect to my iTunes OR Wifi so that I could finish set up. Is there anything I can do to fix this before i take it back and get my money back?
Take it back for a refund.
-
Hi! I bought a song on itunes, and now it won't play on my computer or iPod. Itunes on my computer keeps telling me that I'm not authorized to play the song on my computer, even after reauthorizing it. Is there anything I can do to play the song?
Hello
Thanks for using Apple Support Communities.
For more information on this, take a look at:
iTunes repeatedly prompts to authorize computer to play iTunes Store purchases
http://support.apple.com/kb/ts1389
Best of luck,
Mario -
I was using my notes earlier today and now for some reason they are all gone. How does this happen and is there anything I can do to get them back, the new ones also that haven't been synced.
See Recover your iTunes library from your iPod or iOS device.
tt2 -
I am running Mac OS X Lion on a brand new Mini. Every now and then, my keyboard goes "dead." The mouse still works but I can't type. If I restart, everything is fine again. Is there anything that will fix this problem?
Also, I am trying to connect my Mini from the mini-Displayport to the Displayport of my Dell U2410 monitor. The image is very grainy,even though it is set to the correct resolution: 1920 X 1200 at 60Hz. If I use HDMI to VGA input, the image is much clearer. Is there a way to get the Displayport to work?I'm having exactly the same keyboard issue. Certainly nothing has ever enhanced my concentration while coding like suddenly becoming unable to type.
I'm seeing a great many devicemgr and rake errors in my system log. I don't know if they're related. How 'bout you?
If you're unfamiliar with the system log…
Open /Applications/Utilities/Console.
If necessary, choose View > Show Log List.
system.log is at the top of the FILES section.
Try searching it for hot words like DEBUG, FATAL, and aborted.
I've found some discussions that would tend to indicate my errors are postGres related – I'm running OS X server.
-Bryan -
My iPod Touch is stuck. I can't get it to power off. All that comes up on the screen is the Apple Logo. Is there anything I can do to fix this problem?
You may need to hold the sleep/wake button and the home button until the apple logo appears. Or anther thing you can try is draining the battery until the battery is dead. That's what i tried and worked. You may need to do those things more than 2 times. OH anther thing is you can try connecting you ipod to your computer and see if it appears on itunes. If those don't work you can send it to apple. So that's what helped me I hope I answered your question.
-
Hi Anybody
I seemed to have picked something on my MacBook Pro that hits me with a survey that involves winning a new iPhone 5 or iPad. Is there anything you can advise to get rid of whatever it is? Bear in mind I am a greenhorn with regard to computers!
Computer: 2.8 GHz intel core 2 Duo MacBook Pro computer with Mac OS X Lion 10.7.5
I did download clamXav software as someone on line recommended it which duly scanned my computer and located some infected files. However, I don't know how to select these files to delete them. Does anyone know an idiot's guide for this software?
Regards Art4Quit Safari.
Hold the shift key down and relaunch Safari.
Reset Safari.
Click Safari in the menu bar.
From the drop down select "Reset Safari".
Uncheck the box next to " Remove saved names and passwords".
Click "Reset".
Empty Caches
Safari > Preference > Advanced
Checkmark the box for "Show Develop menu in menu bar".
Develop menu will appear in the Safari menu bar.
Click Develop and select "Empty Caches" from the dropdown.
Turn off Extensions if any, and launch Safari.
Safari > Preferences > Extensions -
Pages for iPad is not recognizing the password I assigned to a document. I included a hint, and I know I am entering the password associated with the hint. Is there anything I can do to access my document? i quite the Pages app and restarted it. Now I guess I'll reset the iPad and see if that helps. Thanks!
Rhonda Fogel wrote:
Interesting that one does not need the password to delete using Finder.
The Pages password protects the contents of the document. If there were a Finder password, it would protect what you might think of as the "file wrapper" ... the stuff around the file content.
Glad it's not vital. I have to say I only pasword protect those Pages documents that are, in fact, vital.
Best of luck.
Maybe you are looking for
-
Could not connect Nokia 6303i via USB cable to Win...
Hello guys in this forum Hello driver development group This is not a question for help, but more a question for sharing experiences. I recently bought a new Nokia 6303i, worked a little bit with it and finally I wanted to connect it to the PC to ent
-
Why doesn't my flash player work?
I installed the Flash Player from Adobe, the message said it was successful. When it went to the Adobe page, it went black. I checked the control panel and it showed it as installed. When I tried it on Jib Jab, I could not see the video. It works on
-
How to migrate Mail & Contacts from backup disk of old PPC iMac (10.3.9) to new iMac (10.8.1)? The Firewire disk is connected and have been able to copy across document folders etc, but Migration Assistant doesn't find the disk so that method no goo
-
I supposedly downloaded a textbook I need for school on firefox. Supposedly. In calling, I was told it would be downloaded but to call back if it did not. I cannot even seem to get to "my bookshelf" so I can check, though meanwhile, I am still paying
-
How can we unregister OID from R12 when OID has crashed
Our R12 Oracle Apps was registered with OID 10g. Somehow our OID has crashed. Now we have installed a new OID 10g from same installer. Now we want our R12 instance to deregister from old OID instance and register with new OID. How can I deregister ol