Is there anyway of speeding up unlock process
can you tell me if its possible to speed up unlocking process. i`ve contacted vodafone and they have sent request.
No. It takes them as long as it takes them. They will send you an SMS when it's ready to plug into iTunes to complete the process.
Similar Messages
-
i'm in vietnam and i have a relative give me a verizon iphone now i can't use it is there anyway to get it unlock from you
Only the carrier can unlock a phone and I am not sure if Verizon is one of those which will.
iPhone, Troubleshooting authorized unlock issues - http://support.apple.com/kb/TS3198
Responses on these forums come from other Apple produce users like yourself. Apple does not respond to posts on this forum. -
Is there anyway to speed up my mac?
When i open applications, it takes a really long time and eventually, the color wheel pops up. Also, applications force quit many times. My startup time is also extremely slow... Is there anyway to speed up my mac?
THANKS!!Have a look here > http://www.thexlab.com/faqs/performance.html
-
Is there anyway to speed up encoding/burn process?
It's been 3 hours and only 13% encoded.
A thuderstorm is moving in and I may have to quit.To give you an idea, I will share a little story:
I was handed a Project, where the client said that the WMV's were the ONLY available source files (not too different from the DivX one, on the machine now). I begged for the originals, and pointed out that the WMV's were heavily compressed, and if we could ONLY go to the originals, all would be much, much better. The client did not want to look around his company, so I was instructed to use the WMV's. In a fit of pique, I just Imported the 4 WMV's, added the Titles, did some simple cuts, and then Exported. This was on my workstation, which is still very fast. It was taking forever. After about an hour into the Export, I loaded up the WMV's onto the laptop, converted them to DV-AVI Type II's, Imported them into a New Project, did the same Titles, the same cuts and then Exported. The one on the laptop, though started much later, and that had the time to convert, finished 3 hours ahead of the WMV's on the workstation. I learned to not break my own rules of "Always Convert," and ended up with a bit of a benchmark.
Whether there will be THAT big a difference with your DivX files, I cannot say. Also, I was Exporting to DV-AVI, so that would be quicker, than MPEG-2, the format/CODEC needed for DVD. Still, there was about a 5 hour difference, considering all that had to be redone in the second version.
Good luck, and hope that the story did not bore you to tears...
Hunt
PS - I was also using PrPro on the workstation, and had to use PrE on the laptop, so as to not violate the EULA of having two instances of PrPro runnng at the same time. PrPro is a tad faster, than PrE, but they are very close. -
Is there anyway that I can unlock a phone that is locked to somoene elses icloud
I bought a phone from a pawn shop.. IPHONE 4S and its locked to someone elses icloud.. I dont know who had the phone etc.. can you help me
No - if you're being asked for an Apple ID that is not your own, there is no way to use the phone. That's Activation Lock, which will remain active unless the original owner of the phone releases it.
Return the phone if you can - it's nothing more than a paperweight to you.
~Lyssa -
Anyway to speed up using a P2P program?
When using a P2P program, the download speeds are incredibly slow.
When downloading files off my browser, I can get around 130 kbs. When using P2P, I'm lucky to get 20 kbs. Is there anyway to speed this up? I'm using a WRT54G router.What router and version is it?
What P2P do you use?
It also depends how many peers you're connected to.... I range anywhere from 5kbs to 500kbs. I assume you have forwarded the correct port? Did you set a speed limit in the P2P program setup? -
I tried to start face time and it said that it would send an email to the address provided but i didn't realize that the email address there was an inactive one and now i cant use face time since i havent verified it yet. I was trying to see if there was a way to restart the process so that i can get that email sent to the corrent email address that i actually use.
If there is no other way around this, is there anyway to completely wipe the phone then??
The Apple store agreed to give me a new iPhone 4 as a warranty replacement for $150 (I travel a lot and I have a factory unlocked phone, so this is still worth it for me). But before I trade it in, I would like to make sure all my data is backed up on the device first.
When I try and restore the phone now on iTunes, it says I have to turn off Find My iPhone on the phone first before I can restore it. Now since I can't use the screen I can't really do that.
So how do I completely wipe the iPhone???
Thanks! -
I changed my ipod password and now when i try to unlock my ipod it says wrong password. Is there anyway i can get into my ipod without restoring it?!?!?!?!?!?!
If You Are Locked Out Or Have Forgotten Your Passcode
iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
iOS- Understanding passcodes
A Complete Guide to Recover Your iDevice if You Forget Your Passcode
If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup). If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. Refer to Updating and restoring iPhone, iPad and iPod touch software.
Try restoring the iOS device if backing up and erasing all content and settings doesn't resolve the issue. Using iTunes to restore iOS devices is part of standard isolation troubleshooting. Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition.
Before restoring your iOS device, Apple recommends that you either sync with iTunes to transfer any purchases you have made, or back up new data (data acquired after your last sync). If you have movie rentals on the device, see iTunes Store movie rental usage rights in the United States before restoring.
Follow these steps to restore your device:
1. Verify that you are using the latest version of iTunes before attempting to update.
2. Connect your device to your computer.
3. Select your iPhone, iPad, or iPod touch when it appears in iTunes under Devices.
4. Select the Summary tab.
5. Select the Restore option.
6. When prompted to back up your settings before restoring, select the Back Up
option (see in the image below). If you have just backed up the device, it is not
necessary to create another.
7. Select the Restore option when iTunes prompts you (as long as you've backed up,
you should not have to worry about restoring your iOS device).
8. When the restore process has completed, the device restarts and displays the Apple
logo while starting up:
After a restore, the iOS device displays the "Connect to iTunes" screen. For updating
to iOS 5 or later, follow the steps in the iOS Setup Assistant. For earlier versions of
iOS, keep your device connected until the "Connect to iTunes" screen goes away or
you see "iPhone is activated."
9. The final step is to restore your device from a previous backup.
If you can not restore your device then you will need to go to recovery mode.
Placing your device into recovery mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the other end
of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the
red slider appears, then slide the slider. Wait for the device to turn off.
If you cannot turn off the device using the slider, press and hold the Sleep/Wake
and Home buttons at the same time. When the device turns off, release the Sleep/Wake
and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the device.
The device should turn on. Note: If you see the screen pictured below, let the device
charge for at least ten minutes to ensure that the battery has some charge, and then
start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button.
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
Downloading an app on to my iPad mini takes 15 minutes or more just for one app is there a way to speed up the process?
Maybe your internet is very slow.
Try reset iPad
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected. -
I just bought a new Mac mini and can't remember my password to get into the computer. Is there anyway I can unlock my computer without loosing all my files, especially all my photos?
Hi Jeff,
Reset Password 10.7, 10.8...
http://reviews.cnet.com/8301-13727_7-20087723-263/how-to-run-the-password-reset- utility-in-os-x-10.7-lion/
Then Reset your Keychain...
http://support.apple.com/kb/TS1544 -
My son can't remember his passcode for his iPod touch and for some reason every time I try to restore it, the software gets updated and it starts processing it then it says there was an error and to try again later. Later, it still does and says the same thing. Is there any other way to unlock it without the passcode?
The only way to clear off the passcode is to restore the device. You could always try the restore process on another computer that has iTunes just to get the iPod working again, then you could plug it back into your comptuer to sync all of his content back on the iPod.
-
I got a used iphone 4s from a pawn shop and I cant activate it because I dont have the past owners icloud info is there anyway to unlock it and put in my information?
Take it back to whomever you purchased it from and ask for a refund. There is no way to get past the "Activation Lock".
-
hello im trying to unlock my ipod and its not letting me do this its saying that i have to connect to itunes and i did that so is there anyway you could help me please?
iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
Please Get the iPod Touch User Manual for iOS 5 -
i tried to update my phone and it ended up going into recovery mode. now my phone is locked bc i dont remember my old apple ID security questions, nor does the email exsist anymore. is there anyway i can unlock my phone myself or do i have to go to apple???? ANYONE SUGGESTIONS PLEASE!!
http://support.apple.com/kb/HT5312
-If you established a rescue email address, there will be a link on the "Passwords & Security" page of id.apple.com. Clicking the link will send the reset to your rescue email address (NOTE: This is not the same address as your Apple ID email)
-If there is no link on the page, then you didn't establish a rescue email address. Contact AppleCare at 800.694.7466 (If you are in the US), and ask for account security. You will need to answer some questions to verify your identity, AND you will need access to a computer to generate a temporary support pin.
-If you are not in the US, click http://support.apple.com/kb/HT5699 - Apple ID: Contacting Apple for help with Apple ID account security
HTH -
Since the update to iOS 5 I've been unable to access the Restrictions section in Settings. I didn't forget since it was the same as my unlock passcode and that works. Is there anyway to reset that without a complete restore?
Hi,
Thanks! I forgot to add, I have debonded and rebonded the bluetooth in car and phone and have carried out 3 restores on the phone in my ITunes. All to no avail. I have also jsut spent £40 on a lead from Ford that has made no difference too! I went to them today to request a software upgrade on my car as I though perhaps the lack of connectivity in the car was down to the car being behind the iOS5 software but was informed there was no need for an upgrade and this problem is purely an apple problem! Is there any way around the downgrade? Or are apple gong to resolve this problem at all??
Maybe you are looking for
-
Why does wireless work for one laptop and not the other?
I have two laptops: 1) MacBook: 10.4.8, Airport Exteme (Firmware 1.0.46) 2) G4: 10.3.9, Airport Extreme (405.1 (3.90.0.p18) I have the two machines sitting right next to each other in my apartment. Machine #1 has full wireless signal strength. Machin
-
AArgh!! New display bug in L9?
Apologies if this is pilot error somehow, but it seems like another bug to me in 9.02 I'm trying to line up a track with the "cue beep" I've placed 2 seconds before the start of my video in Logic. I've done this dozens of times without much trouble o
-
Abap Proxy Sender Configuration
In my test system, (XI 7.0) Client 001 : XI (Integration Engine) Client 500 : Business System (Web AS ABAP) In client 500, I send a message to XI using ABAP Proxy. During the execution Logon Popup message appears and ask me user id and password for c
-
Defining text and integer variables??
I found this in some code: var num = 0, txt = "bo"; I guess it could also have been written as: var num = 0, txt = "bo"; Why is it allowed to define an integer by just using "," and when you define a text variable you use ";"
-
Restore Active Directory on Server 2008 using NTDS.DIT file
hello I have NTDS.DIT file with me and want to restore it on same hardware with same host name and IP Please help