It won't restore after Updating to IOS 6

After updating to IOS 6 my ipod shows the following message constantly "itunes has detected an ipod in recovery mode you must restore this ipod", I need HELP!

Try:
- iOS: Not responding or does not turn on
- If not successful and you can't fully turn the iPod fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.

Similar Messages

  • IPhone 4 won't restore after updating to ios 5!!!

    After restoring iphone 4 with ios 5, itunes is stuck in "set up your iphone" mode asking me to restore from backup however whenever i do restore it goes back to the same screen asking me to do it again, all my contacts photos and other info syncs but no apps and cant use phone on itunes because it keeps telling me to restore from backup.. please help!!

    So  I went to the apple store today since I was having the same problems, they reset it back to factory settings.  Plugged in Iphone to laptop and the same two options came up: 1. set as new Iphone or 2. restore.    So I restored thinking it would then synch...nope.
    They told me if I didn't work to bring back my Iphone and laptop, it might be a problem with Itunes. 

  • IPhone won't restore after update to iOS 5

    I recently tried to upgrade to iOS 5 on my iPhone 4 but whenever I do, I receive the message: "iTunes was interrupted while restoring the contents of the iPhone “Thundercracker”. Would you like to restore this iPhone again now?" I've tried several times, with no interruptions, and can not get the iPhone 4 to restore from backup. The last backup was made immediately before the update and the iPhone was pretty full before upgrading.
    Anyone else having this problem? Any ideas on how to get my information back?

    When I tried to update to ios5 it gave me an error as well and stayed on the iTunes screen saying the device is in recovery mode along with an error number. Now,I had gone to apple store previously with this issue when tryin to restore my iPhone only. They said that sometimes the software might be crashing because of an app. The solution is to restore it as a New Phone. Then Put everything back manually. So when I was on the process of installing the new iOS 5 the error seemed to be similar and apple gives you all the troubleshooting codes and fixes. I had to put a command before proceeding. I did that and it seemed to work for one of the iPhones, I was updating 2 iPhones at the time. Then for the other one when it stayed on the iTunes screen I just disconnected and connected the USB cable again and instead of doin update I did restore first and then update and that solved the problem. After restoring it will automatically update and put the information you had before the update back to your iPhone .
    http://support.apple.com/kb/ts1275
    http://support.apple.com/kb/HT1808
    Hope this helps

  • My iphone won`t activate after updating to ios 5.1 plz help

    my iphone 3gs won`t activate after updating to ios 5.1 plz help

    I got mine sorted. Turns out because i got it unlocked the first time getting updates via itunes causes it to restart again. Had to get it unlocked at managed to get eveything back after restoring it from itunes. Very happy cause the guy in the apple shop told me i had to call apple and pay 35euro just to talk to them! I manged to get it unlocked for only 20 and its just like it was.
    hope you're able to get yours sorted

  • Iphone 4s won't charge after updated to ios 6.1.3

    iphone 4s won't charge after updated to ios 6.1.3
    Different adapters and usbs have been tried, and now power has been drained.
    Apple support says there is nothing they can do about it, and they surggested me to pay 199 for a new iphone.
    Is there anybody having the same problem?

    I'm having the same issue with iphone 4.
    Seems to work ok after i connect it to itunes but then the next day i have to do it again.

  • TS1717 my iphone 4s won't activate after updating to ios 7?

    my iphone 4s won't activate after updating to ios 7?

    Same here. I heard of some way to bypass the activation but it was patched .

  • Ipad 2 wont restore after updating to ios 7

    ipad 2 wont restore after updating to ios 7

    Hello pinky03,
    I would be be concerned too if I was not able to restore my iPad.  If you have not resolved the issue, I recommend following the steps in this article for an issue like this:
    iOS: Unable to update or restore
    http://support.apple.com/kb/ht1808
    Thank you for using Apple Support Communities.
    Best,
    Sheila M.

  • ITunes won't work after updating to iOS 8.3

    After updating to iOS 8.3 my iTunes App on my iPhone 6 Plus and iPad Air now both don't work.
    If I go to play an sample of a song, the little square box with the cover on spins around and then spins back around and no music will play.  I'm all so unable to play any music that I've already purchased via iTunes on my iOS devices.
    Any comments on what could be causing this?
    All so, on another note.  My friend has just updated to IOS 8.3 and he just noticed that he no longer even has the iTunes App on his iPhone 5.
    Thanks.

    After posting this, I've since found out that my iOS iTunes App on my iPhone 6 Plus works all OK when on WiFi, it just won't work when on the data/3/4G connection.
    Anybody else having this same issue since updating to iOS 8.3?

  • My iPad Won't Rotate after updating to iOS 6.

    After updating to iOS 6, my iPad2 won't auto rotate. I already checked if the rotation was locked, so this isn't the case. I tried restarting it and rebooting it. The only possible way to rotate the screen is to turn off the iPad, rotate the iPad, then turn on the iPad again. Please help me, I don't know how to fix this problem.

    I had same problem post upgrade to iOS 6.1.3
    I went to
      [Setting] [General] and set the
      [Use_Side_Switch_To] option from [Rotation ...]  to [Mute]
    Checked switch by manually flipping the button on iPad cover (next to volume) back and forth and seeing images of mute actions appear sceen centre
    But on checking further not all apps rotated automatically  ... so ...
    Manually closed all open apps by:
      Screen button x2 in quick succession bottom bar appears with all active apps
      Touch and hold on of these apps in this bar untill the x appears on them and the wobble
      Close each one down by touching x
    Then
      Rebooted ( ... just like a Microsoft machine :-)
    Now all working working ... boy you really miss that feature when its not functioning ...
    Dont know if all steps relevant but this is what worked for me ...
    ... best of luck
    Message was edited by: citizenpips

  • Ipad 3 won't charge after updating to ios 6. even with apple charger

    ipad 3 won't charge after updating to IOS6. even with apple charger. just say "not charging" next to the battery symbol

    Hi,
    I did this after reading the forums and it made no difference. it has actually charged from 14% to 67% but thats taken over 12 hours.
    Will monitor it and if no joy will go to a apple store
    Thanks

  • Ipad won't start after updating to ios 8.1.3

    My iPad was working without issue prior to updating to IOS 8.1.3 yesterday. After updating, not only would the ipad not start, it produced intermittent tones. The tone heard when device is plugged into an outlet for charging.
    I attempted to turn the device off but it would not respond. Afterwards, a reboot was attempted numerous times by holding the home and sleep buttons down simultaneously. Once the Apple logo appeared the buttons were released, the logo disappeared but the device remained dormant.
    While connected to iTunes and emitting the connection tones, periodically the splash screen would appear momentarily then turn off. I was able to swipe the screen on one of these occasions. The device worked properly until it was turned off after use at which time it would not turn on again and remains unable to turn on. It does not respond to attempts to turn it off or rebooting.
    Prior to the update I did backup the device in case something like this would occur. Since I appear to have exhausted all my options to get the device to work, I feel the only remaining option is to restore it to factory default. I would appreciate advice from anyone who may either have experienced this same issue and found a resolution, or can provide thoughts on how I should proceed please.
    If I proceed with a restore to factory default followed by a restore of the most recent backup, will I lose any data during this process? This will be my first time to erase a device so any thoughts would be greatly appreciated. I would, of course, prefer an alternative resolution. Thanks in advance for your help.
    tony

    Hello, Tony.  
    Thank you for visiting Apple Support Communities.  
    I understand that your iPad no long starts after an update and you have a backup for your iPad.  It sounds like you will need to restore the device to factory and then will have the option to access your backup after the restore complete.  The only information that should be missing would be after the backup was completed until the device is restored.  I have included the steps for going through this process in the articles below.    
    If you can't update or restore your iPhone, iPad, or iPod touch
    Back up and restore your iPhone, iPad, or iPod touch using iCloud or iTunes
    -Jason H.  

  • Certain apps on iPad won't run after updating to iOS 7

    Apps like iPhoto, AVPlayerHD and Modern Combat 4 are shadowed and say "installing" after pressing on them. They don't run. I tried to delete them and sync them again over iTunes, turned restrictions off, but nothing seems to work. It all happened after i updated to iOS 7 and ran the backup. Help pls?

    Reset the device:
    Press and hold the Sleep/Wake button and the Home button together for at least ten seconds, until the Apple logo appears.
    If that doesn't help, tap Settings > General > Reset > Reset All Settings

  • TS4268 iMessages won't send after updating to iOS 7?

    I have updated to iOS 7.0.2 and I can receive iMessages but cannot send them. I have tried the trick of turning it off and then resetting network settings but this hasn't worked. Does anyone have any other solutions?

    I have an iPhone4 and upgraded to iOS 7.1. 
    Since then imessage does not work properly on the iPhone4. 
    iMessage is working on my iPad normally.
    I have reset network settings after turning iMessage off.
    Turned iMessage back on.
    iMessage is activiating and after doing the above.
    I have also turned the phone off (Held home and power buttons for 10 seconds etc)
    Other devices cannot reach the phone using iMessage.
    My local Brisbane Apple store said last Friday evening it was most likely not the device and there was a problem in the 'cloud' side of iMessage out of my control.
    This does not seem to be the case as I search for the thousands of people this would most likely affect.
    I had a brief period where it appeared to work normally a few days ago.
    Inerestingly when addressing a message in the 'To:' screen iMessage capable names come up blue as if they are about to be addressed and sent as an imessage.  Once selecting the name however it turns green as if to say this will be sent as a text.
    I am at a loss at what to do.  The phone was working perfectly well under iOS6x
    Thanks

  • My iphone 4s won't vibrate after updated to iOS 7?

    Since the update to iOS 7 my phone can't vibrate anymore, I already try to change between vibration patterns, "do not disturb" was off, some said 7.0.2 fixed it but still no luck for me, iphone 4s fellows, does anyone successfully troubleshoot this ?

    Same here. I heard of some way to bypass the activation but it was patched .

  • Iphone 3 won't activate after updating to IOS 5.0.1

    I updated my itunes to the IOS 5 last night and now i cannot activate my phone. I get as far as activating the phone itself and after it tries to activate it tells me it cannot do it as 'the activation server is temporarily unavailable'. It also tells me to try to connect it to Itunes and when i do itunes tells i do not have a SIM inserted when i do. I was told by a man who worked in a phone shop that it the software may have crashed and caused it and i should send it away but that will cost 180euro. I am going into the apple shop 2mo to see if they can do anything but would like to know if anyone else has experienced this and if so what did they do?
    Please help! I need this for college and it has everything on it! If i lose all my stuff i'm in serious trouble!
    Thanks.

    I got mine sorted. Turns out because i got it unlocked the first time getting updates via itunes causes it to restart again. Had to get it unlocked at managed to get eveything back after restoring it from itunes. Very happy cause the guy in the apple shop told me i had to call apple and pay 35euro just to talk to them! I manged to get it unlocked for only 20 and its just like it was.
    hope you're able to get yours sorted

Maybe you are looking for

  • What the data type of this variant? (in the following)

    What's the datatype of the following variant (use probe and indicator): value -> 1356.00 I want to tranfer it to numerical data. When I tranfer it using "variant to data" function (the datatype used is string or numerical), An error occured:  ERROR 9

  • Trying to build the best system for Final Cut

    IWhat screen would be best suitable to work on Final Cut Pro? 1 screen or 2? 24 or 30 inch? I'm using MacPro (SAS DRIVES).Primarily I am a musician, and my end product is for music and video clip, mostly 3d and abstract art in motion. I'd be collabor

  • Update GLT0, KNC1 and LFC1

    Hi, I have 100+ documents in one company code with two diff fiscal years. My requirement is to merge them in to one calendar year variant. Previously it was APR2MAR, now we came to know that need to maintain with JAN2DEC. All the documents we have in

  • How Weblogic used in Integration using J2EE Connector architecture??? need more info

              Hi xperts,           Would like to know more about weblogic integration in EAI zone using J2EE           I checked on           http://java.sun.com/j2ee/connector/           http://java.sun.com/j2ee/white/connector.html           Can anyone

  • Changing a jar's icon.

    Is it possible to change the icon of a Jar file through code or Manifest? I know executables can have their own icon for the exe, can Jar files?