ITunes will not run on 1 of my 2 computers

On my older and slower computer, no problem. On my laptop (IBM T42 notebook, running XP Pro), the disclainer page shows for a couple of seconds and then disappears. Any suggestions?

make sure older versions are properly uninstalled and use task manager -> processes to shut down any non essential tasks that may conflict. hope this helps.

Similar Messages

  • Itunes will not run on my pc after update: see error messageProblem Event Name:     BEX

    Itunes will not run on my pc after update, i get this error message:
    Problem Event Name:          BEX
    Application Name:               itunes.exe
    Aplication Version               10.7.0.21
    Application Time Stamp          504d85d9
    Fault mode Name:               Quicktime.qts_unloaded
    Any Ideas on a fix??

    Fault mode Name:               Quicktime.qts_unloaded
    Try updating your QuickTime Player to the most recent version. Does that clear up the launch errors?

  • I just put itunes upeate 11 on and now itunes will not run. I get an error that sys iTunes has stopped and windows is sutting it down. I reinstalled 10.7 and it will not run eather now.

    I just put itunes upeate 11 on and now itunes will not run. I get an error that sys iTunes has stopped and windows is sutting it down. I reinstalled 10.7 and it will not run eather now.

    C Mawle wrote:
    Thanks.  I have followed all the instructions as recommended and nothing has worked so it looks like the restore/update may have been interrupted - would loss of internet connection do this?
    Yes it would, possibly even brick it.
    Have successfully connected my ipod nano with iTunes so looks like the device driver is working.
    Can I use my ipod nano USB connector to check?
    It is not much help to you, since the device that you need still not recognized.
    Anyway looks like I may have to swallow the loss of data.  Have set-up a call for tomorrow with Apple support so will wait until after this before doing the factory restore!
    Good luck, but if you expect miracle from that call good luck again.

  • I just finished installing 11.3 and now iTunes will not run.

    I just finished installing 11.3 and now iTunes will not run. I have uninstalled itunes and resinstalled several times. Now when I attempt to start iTunes i get the following two error dialogues:“The procedure entry point ADiAdID_AcquireMatchSlotIfNecessary could not be located in the dynamic link library iAdCore.dll. and was not installed correctly. Please reinstall iTunes. Error 7 (Windows error 127)

    Hi Greybeard1955,
    Welcome to the Apple Support Communities! I understand that iTunes is not opening after uninstalling and re-installing it. When iTunes is uninstalled on a Windows computer, all of its components must be removed as well and they must be removed in a specific order. Below is the article for uninstalling on Windows 7. I recommend uninstalling iTunes and all components in order and reinstalling fresh.
    Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
    http://support.apple.com/kb/ht1923
    1. Remove iTunes and related components from the Control Panel
    Use the Control Panel to uninstall iTunes and related software components in the following order and then restart your computer:
    iTunes
    Apple Software Update
    Apple Mobile Device Support
    Bonjour
    Apple Application Support (iTunes 9 or later)
    I hope this helps,  
    -Joe

  • When upgrading quicktime, I get an error code: -3, and itunes will not run.

    when upgrading quicktime, I get an error code: -3, and itunes will not run. How do I fix?

    i 'm very interest because on 3 PC , i have the same problem and i work at tv producer...

  • HT1349 I don't have a MAC, I have a PC and itunes will not run because I had an update and now it says msvcr80.dll isn't working or not installed and wont let me run itunes help me fix it.

    I don't have a MAC, I have a PC and itunes will not run because I had an update and now it says msvcr80.dll isn't working or not installed and won't me install or run itunes anymore help me fix it.

    MSVCR80.dll missing, cannot install iTunes - https://discussions.apple.com/message/24618776

  • Itunes will not run unless I disable bonjour

    itunes only runs when I disable the "bonjour" service and thus cannot sync with my itouch, as, from what I learnt it's the bonjour service that allows the sync to happen. If I disable it itunes will not launch, I enable it, I cannot sync my ipod touch, it doesn't see it! Please help if you know how to fix this.
    Thanks

    The only sign that its had any activity was last night when I tried to shut down my computer I got a "Not responding" window about itunes store...
    Hmmm. with that one, perhaps try the following document:
    Apple software on Windows: May see performance issues and blank iTunes Store
    (A LSP issue in theory could affect an iTunes launch via the Bonjour Service, although the symptom isn't mentioned in the document.)

  • Itunes error 45075, itunes will not run help

    from a system clean up and deletion of restore points!! iTunes ill not run I have tied reinstalling, repairing, uninstalling following with an install and still it will not run! I have obviously deleted something relatively important and now the computer has no restore point which will resolve my issue.
    Help is greatly appreciated.

    The 2096 erro may be associated with running in compatabilty mode, see:
    http://docs.info.apple.com/article.html?artnum=305212
    None of the tick boxes on the compatability tab should be checked.
    It is also worth checking iTunes.exe in c:Program Files\iTunes.

  • Itunes will not run after update. Windows 8.1

    I have windows 8.1 and just downloaded the latest update. The icon has disappeared from the desktop and the program will not run. Can I uninstall and reinstall without losing my library? Please help. Can't live without my music!!

    For general advice see Troubleshooting issues with iTunes for Windows updates.
    The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down page in case one of them applies.
    Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
    tt2

  • After downloading iTunes will not run, after downloading iTunes will not run

    after downloading iTunes it will not run on my pc in order for me to install it.

    mike.t007 wrote:
    No errors it just stops running.  Even if I download to save, it doesn't save anything in my folder.
    Are you able to successfully download an installer if you use Firefox instead of IE or vice versa? (Firefox handles network/internet connections differently from other browsers, so an issue in IE can sometimes be overcome by using Firefox or vice versa.)

  • Am getting error message missing MSVCR80.dll and itunes will not run

    am getting error message missing MSVCR80.dll itunes will not run

    Solving the iTunes Installation Problems in Windows
    1. Apple has posted their solution here: iTunes 11.1.4 for Windows- Unable to install or open - MSVCR80 issue.
    2. If the Apple article does not fully resolve the problem for you, then try Troubleshooting issues with iTunes for Windows updates - MSVCR80.

  • ITunes will not run on my computer since I tried to upgrade the software

    I performed an upgrade a while back to my iTunes software. Every since then it will not open even though it says it is running in my task manager. I tried uninstalling and reinstalling a hundred times with no luck so far. I recently went to the iTunes support page and found a thread that I thought would solve my problem (http://docs.info.apple.com/article.html?artnum=302386). I followed the steps and deleted the file with no success. I have tried to start it without my firewall and Norton completely shut down and this did not work either. I am really frustrated and could use some help.

    I know it sounds nuts, but it has helped probably 30 or more pple in the last day or two alone.
    There is a version of malware going around causing iTunes to not open. It started showing up sometime in October. Its a bear, but Ewido seems to be removing it for pple to open iTunes

  • Newest version of Itunes will not run it says its missing a file called MCVCR80 Windows was not installed correctly error 126

    Itunes will no take the update. I tried to completly reinstall it still gave me errors. This application failed to start because MSVCR80.dll was not found. Error 126 please reinstall windows . I tried this and it still wont reinstall.

    Entshuldigen aber mein Deutsch ist ganz schlect. was is 'datei'?
    Ich habe 3 stunden mehr ausgaben mit Adobe Support . noch ein problem! Und er war uberhaupt ein dumbkopft.
    Peter
    Sent from my iPad Air

  • TS2363 latest version of itunes will not run in windows 8.1 after download

    Just downloaded the latest version of iTunes and it will not open in Windows 8.1.    Error is entry point not found.

    See Troubleshooting issues with iTunes for Windows updates.
    tt2

  • ITunes will not run. Several error codes. Please help

    A couple months ago I tried updating iTunes and received the error "Could not open key:
    UNKNOWN\Components\69413F169B198734FA40BC8B73511DB0\108B43C0CEA676640B35306AE7D2 4051.
    Verify that you have sufficient access to that key, or contact your support personnel." (take note my key is different than the one above thats just for an example.) So I read and read and finally figured out that my problem came down to permissions for that key. I changed the permissions and voila it installed properly! But now I just tried updating again because I want to get iOS5 on my iPhone4. I received the same error again, "Could not open key..." so I thought heck this is an easy fix and I changed the permissions again and this time it did not work. So then I uninstalled Quicktime, iTunes, and all other Apple software from my computer (which is running Windows 7 btw). I tried to reinstall iTunes and then it went through the install and finally comes to a screen that says "iTunes has successfully been installed on your computer." So I closed that window, restarted my computer, clicked on the iTunes icon and I get a completely different error now. This error is a two-part pop up. The first error window that pops up says:
    "The procedure entry point kCMByteStreamNotification_AvailableLengthChanged could not be located in the dynamic link library CoreMedia.dll."
    I click OK.
    Then I get:
    "iTunes was not installed correctly. Please reinstall iTunes. Error 7 (Windows error 127)"
    I've tried reinstalling it again and I get the same error. I tried stuff from this thread ( https://discussions.apple.com/thread/2262389?start=0&tstart=0 ) and it doesnt seem to be working. Can someone please help me work through this. I would appreciate it very much, and please explain everything in computer-illiterate terms as I'm not the greatest with computers these days.
    Thank you,
    Max

    OK, so iTunes opens OK in another account so it is a user specific problem.
    Just to be absolutely clear, have you carried out the all the user specific steps:
    Remobe plugins
    Remove preference files
    Recreate Library
    Check for Content files with issues.
    One of those steps usually solves user specific issues.
    Something else that you could try is to create a new iTunes library elsewhere on your disk.
    Hold down the shift key and start iTunes. Keep holding the shift key until you are prompted to choose or create a library. Select "Create" and create a new library somewhere way from the your music folder eg in Documents - so it is completely separate from your existing iTunes.
    Does iTunes Open like this?
    If so go do Edit>>Preferences>>Advanced and Un-check "Copy to iTunes Music folder when adding to library". This is to stop iTunes copying your music files when you add to you new library.
    Now try adding music from your original iTunes Music folder in stages as in the "Content files with issues" section.
    This approach has worked for someone else although they did not say if they stuck with their test library or if they ever found the problem with the original one.

Maybe you are looking for

  • Dynex LCD seems to have a faulty digital tuner?

    After WOW cable (and other cable companies) switched to the all digital format, my Dynex LCD started flipping out every time I try to use it. We don't have cable boxes or converter boxes, as we only have a basic package of 80-some channels. WOW told

  • FCPX 10.0.7 Won't create alias' to event files

    We recently had a Facilis Terrablock SAN installed along with a CatDV server. The problem we're having is that FCPX won't create alias files on the SAN when importing footage and not moving it to the Events folder, so everything comes up as offline.

  • SAP Cash Flow statement - Direct Method

    Dear Experts We are working on Cash flow statement - Direct method. We observed there is report for cash flow direct method i.e T.Code S_ALR_87012271. In this report we have  changed the form as per the client cash flow format and assign the FSV to t

  • Sorting a community list

    Hello ! I'm building a community list after getting these from a CommunityNavPage by the method GetCurRelCommunities(). This method returns me a ICPListEntryIterator, which is sorted by Community name. I would like to have it sorted by Community ID r

  • SQLPlus login hangs because of "Thread 1 cannot allocate new log"

    Hi to everybody! Could you please give an advice how to overcome the following situation. In my 10GR2 database I have destination for archive logs placed in ASM disk group. When suddenly this disk group becomes overfilled I can not login into the dat