Itunes wont launch due to audio configuration problem

Itunes won't launch saying there is a audio configuation problem, this started all the sudden no new software added no updates, no configuration changes. I've tried uninstalling and reinstalling without improvement and all other audio programs work fine. any ideas?

This is usually a Quicktime problem, see this article:
http://docs.info.apple.com/article.html?artnum=304424

Similar Messages

ITunes wont open due to audio configuration.

Hopefully someone can help me, when I click to open iTunes, a message pops up saying "iTunes cannot run because it has detected a problem with your audio configuration." I have windows vista and dont know what I need to change or where I change it. Please help!
Nicole.

Perhaps this Apple KnowledgeBase article will help:
iTunes 7 for Windows: iTunes had detected an audio configuration problem
Good luck.
Forum Tip: Since you're new here, you've probably not discovered the Search feature available on every Discussions page, but next time, it might save you time (and everyone else from having to answer the same question multiple times) if you search a couple of ways for a topic, both in the relevant forums, in the User Tips Library and in the Apple Knowledge Base before you post a question.
Regards.

Itunes starts but fails to open due to audio configuration problem

Hi
I have been running itunes 7.1 quite successfully until today. Running on windows xp/toshiba laptop.
Problem occurs when i select itunes on desktop, itunes appears on task bar below, after a number of seconds the following error message appears "itunes cannot run because it has detected a problem with your audio configuration", once I click ok on this message itunes terminates.
No changes have been made to my audio configuration (to the best of my knowledge), i can run Windows Media Player and that works fine, so too real player.
I reinstalled itunes, but this did not resolve the problem. I also ran itunes from another logon on my laptop and that presented the same error. I checked all my audio settings in the control panel and also ran the diagnostics on each device and all appears to be fine.
Has anybody faced the same issue, and could anybody advise on any diagnistic tool that could assist in pinpointing the configuration problem?.
Thanks
Toshiba Satellite Windows XP Pro

Hi
Got it resolved, thanks for the prompt responses all!.
Resolved by removal current version of Quicktime thru the control panel (add/remove programs), and then reinstalled from the website.
Phew!
Toshiba Satellite Windows XP Pro

Itunes cannot open due to audio configuratoin problem

Will someone tell me what this means?

that's typically caused by a problem with your QuickTime. (itunes uses QuickTime for audio and video playback.)
the following document may be of some assistance:
iTunes 7 for Windows: iTunes has detected an audio configuration problem

ITunes wont open somehting about audio configuration

okay i updated to 7.2 and it was working fine then yesterday i try and open it and it says this
"iTunes cannot run becasue it has detected a problem with your audio configuration"
any ideas or suggestions?
thx for reading

Have you had a chance to look at this troubleshooting page? It may be of some help: iTunes 7 for Windows: iTunes has detected an audio configuration problem

Itunes cant open due to Audio Configurations

I was Messing with my sound settings because of an over the internet Voice program called Ventrillo I don't think that the Program has anything to do with the error but I don't know how to get either itunes to open or how to get my sound settings back to default

Does this help?
iTunes has detected an audio configuration problem

Itunes can't run bc of audio configuration problem

Well I've been using itunes for about 2 years now and just recently i installed the newer version. It was working fine until today when my computer told me ther was some kind of computer error and that i should do a system restore. So i did a restore to about 2 weeks ago which was before i updated my itunes. And then i was getting the message that my itunes was missing files and could not run. So i ran a repair on it and still got the same error. Then I deleted it adn reinstalled and I got the error "Itunes cannot run because it has detected a problem with your audio configuration.
So then I undid the system restore and tried itunes to see if it would work. And I was still getting the same message that itunes cannot run because it has detected a problem with your audio configuration. So then I uninstalled it and reinstalled it and still getting the same message.
Can someone help me out? What problem would it be with my audio configuration? I haven't changed anything. Is there something i can adjust to fix the problem? I'm clueless....

the message is typically produced by a problem with your QuickTime. (itunes uses QuickTime for audio and video playback.)
perhaps let's start with the following document:
iTunes 7 for Windows: iTunes had detected an audio configuration problem
... but if no joy there, try this alternate technique for swapping out your QuickTime:
head into your Add/Remove programs. uninstall QuickTime.
Next, we’ll manually remove any leftover program files and folders.
1. On the Start menu, click My Computer (or double-click My Computer on the Desktop).
2. In My Computer, open Local Disk.
3. Open Program Files.
4. Right-click on the QuickTime folder and click Delete from the shortcut menu.
5. Navigate to C:\Windows\system32\.
6. Remove the files QuickTime.qts and QuicktimeVR.qtx.
7. Restart your computer.
next, we'll get a fresh copy of QuickTime into your PC by doing a repair install of itunes.
switch off antivirus and antispyware applications prior to the repair install.
go into Add/Remove and select itunes. click "Change" and then click "Repair".
if the repair install goes through okay, restart the PC and try launching itunes again. does it launch properly now?

Audio configuration problem in iTunes

I am running iTunes 7.1.1.5 (WinXP). When opening iTunes, I get an error message that there "are problems with your audio configuration." In iTunes support, I followed instructions to remove Quicktime then reinstall as standalone (without iTunes). Same problem persists. I will add that same problem occurred about a month ago, but that time the same steps of removing Quicktime, then reinstalling as standalone corrected the problem. Unfortunately, it recurred.

See if this helps:
iTunes 7 for Windows: iTunes has detected an audio configuration problem
http://docs.info.apple.com/article.html?artnum=304424

Audio Configuration problem detected after install

During the download of the new ITunes version I had a major power failure. I went back and completed the download and after the installation I got an error message that ITunes could not be opened due to an audio configuration problem detected. I went to the Apple site and downloaded a new version from scratch and after the install I got the same audio error. Any Suggestions?

Perhaps this Apple KnowledgeBase article will help:
iTunes 7 for Windows: iTunes has detected an audio configuration problem
Hope that helps.
Forum Tip: Since you're new here, you've probably not discovered the Search feature available on every Discussions page, but next time, it might save you time (and everyone else from having to answer the same question multiple times) if you search a couple of ways for a topic, both in the relevant forums, in the User Tips Library and in the Apple Knowledge Base before you post a question.
Regards.

ITunes wont open due to Quicktime HELP PLEASE!!!!!

everytime i try to open itunes i get an error message saying..
'QuickTime version 7.1 installed, iTunes requires QuickTime version 7.1.3 or later.
Please reinstall iTunes.'
ive tried deleting itunes and reinstalling it numerous times as well as trying to download QuickTime version 7.1.3 and im still getting the same error.. PLEASE HELP!!
Windows XP

Perhaps this Apple KnowledgeBase article will help:
iTunes 7 for Windows: iTunes had detected an audio configuration problem
Good luck.
Forum Tip: Since you're new here, you've probably not discovered the Search feature available on every Discussions page, but next time, it might save you time (and everyone else from having to answer the same question multiple times) if you search a couple of ways for a topic, both in the relevant forums, in the User Tips Library and in the Apple Knowledge Base before you post a question.
Regards.

My itunes wont open,because of audio configeration?

when i try to open my itunes,i get a pop up saying my audio configeration is wrong,i've tried restoring to an earlyer time but get the same responce,havent had a computor long and i'm over 50 so someone help,before I put an axe through my computer,cheers,druby

Since iTunes uses QuickTime to play audio/video content in iTunes, that error message most likely indicates that there's a problem with Quicktime installation.
See if this article helps with that:
iTunes 7 for Windows: iTunes has detected an audio configuration problem
-Kylene

Itunes wont launch, no error message, no blue screens, just wont open

itunes wont launch, i get no error message, no blue screen, it just wont open. I've tried to delete and reinstall, but once i close itunes i still have same issue. it wont open again.

I have same problem on my XP lap top and Windows 7 PC. Apple have been investigating this problem for me for a week now without success so far. Understand it 's ongoing with other customers as well.
It is caused by an bit of program called APSDaemon supplied by Apple in latest i-Tunes. Your quick fix to enable you to open i-Tunes again is as follows:- open Task Manager (right click bottom toolbar), click on Task Manager, select Processes. Find APSDaemon, highlight and press END PROCESS. I-tunes will now re-open ok. You have to repeat this every time you want i-Tunes re-opened until you switchoff or restart.
A pain I know, but lets you keep going until Apple repair and release an update for i-Tunes

My iTunes wont launch I get the following message: This version of iTunes has not been correctly localized for this language. Please ru the English version. I click OK and nothing happens

my itunes wont launch
I get this message
This version of iTunes has not been correctly localized for the language, please run the english version.
I click OK and nothing happens

Hi there Scottielongdrive,
You may want to try removing and reinstalling iTunes as an initial troubleshooting step. Take a look at the article below for more information.
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
http://support.apple.com/kb/ht1923
-Griff W.

ITunes wont launch - just upgraded but running OS10.6.8 on my powerbook that I use for iTunes

alias for discussions: lolobacsi
iTunes wont launch now that I have upgraded it a short time ago. I am running OS10.6.8 on an older MacBookPro I use primarily for iTunes

What happens when you try? Error messages? Try re-installing it.
iTunes 11.2.2

Could not start the app due to a configuration problem

Hi Gurus,
I have an issue to be resolved asap, need your assistance.
I have implemented SAP Fiori apps (Approve Purchase Order, Approve Purchase Contract, My Leave Request and Approve Leave Request)
We have only one Gateway system and 3 back end ECC systems.
Gateway Client 220 is integrated with ECC Dev and performed all the configurations and tested successfully.
We have created a new client 320 with a copy of client 220, Integrated 320 client to ECC quality system and performed necessary configurations and while testing Approve Purchase order and Approve Purchase Contract tiles are loading the count from ECC Quality system but when I click on the tile it throws an error "could not start the app due to a configuration problem" and when I click the error ot is being redirected to Client 220.
From the inspect element I found below error
2015-04-13 12:22:13 INTEROP service's ResolveLink operation returned 2 targets for hash '#PurchaseOrder-approve', first one is used. - used target: {"id":"PurchaseOrder-approve~652","shellType":"FLP","postParameters":"","text":"Approve Purchase Orders","applicationData":"SAPUI5.Component=ui.s2p.mm.purchorder.approve","applicationAlias":"ApprovePurchaseOrders","applicationType":"URL","url":"/sap/bc/ui5_ui5/sap/mm_po_apv"}
ignored target: {"id":"PurchaseOrder-approve~65k","shellType":"FLP","postParameters":"","text":"Approve Purchase Orders","applicationData":"SAPUI5.Component=ui.s2p.mm.purchorder.approve","applicationAlias":"ApprovePurchaseOrders","applicationType":"URL","url":"/sap/bc/ui5_ui5/sap/mm_po_apv"} sap.ushell_abap.adapters.abap.NavTargetResolutionAdapter
I did not found any duplicate # key entries in table USOBHASH.
Any response is highly appreciated, thanks in advance
Regards,
Srujan

Hi Michael,
Thanks for that, I have raised an OSS message to SAP, to seek their assistance on the solution I followed to fix the issue. I have reverted back the changes and reproduced the issue for SAP guys to investigate further, at last they concluded me there is an external alias defined for /sap/bc/ui5_ui5/sap in transaction SICF in GP1/320, which contains a hard-coded client 220.
This is responsible for the fact that the services are redirected/opened in client 220
After removing the client hard-coded in system alaises under /sap/bc/ui5_ui5/ in transaction SICF, I have reverted back the change from "Alternative Logon Procedure" to "standard" in logon procedure of each service and tested, now the issue got resolved.
This could help someone to resolve the similar issue.
Thanks everyone
Regards,
Srujan

Itunes wont launch due to audio configuration problem

Similar Messages

Maybe you are looking for