Iuns has detected an iphone in recovery mode. you must restore this iphone before it can be used / iphone cant be restores error ocurred 1611.
I reboot the computer, deleted and restart itunes, change computer, change cable, check ping, check connection. need help
Step by step
6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
7. iPad Recovery Mode on computer screen
8. Select "Restore iPad"...
9. Select "Restore and Update"
10. Extracting Software.
11. Preparing iPad for restore.
12. Waiting for iPad.
13. Verifying iPad restore...
14.Restoring iPad software.
15. Verifying iPad software.
16. Verifying iPad Restore...
17. Restoring iPad firmware...
18. Your iPad is restored to factory settings; keep iPad connected to computer
19. Activate iPad
20. Enter Apple ID and Password
21. Continue
22. Welcome to Your New iPad
Similar Messages
-
when i pluged my ipod classic 5g to PC then it shows “iTunes has detected an iPod in recovery mode. you must restore this iPod before it can be used with iTunes”?then after restoring the PIOD when IPod restarted then Itunes again detect the same ERROR.
If you are using XP, and you went through the procedure at the bottom of the previously linked document to change the iPod's assigned drive letter, and you also tried putting it into Disk Mode...
If you have not already, try shutting down your computer and disconnecting all USB devices, including hub. Start up with only standard keyboard and mouse connected. Just to be safe, put the iPod into Disk Mode again
http://support.apple.com/kb/HT1363
Run iTunes. Connect iPod to a direct USB port on computer. iTunes may prompt you about "recovery" and ask you to do a Restore. Try to do a Restore again. -
Ipod nano 2nd generation: I cant restore, says, itunes has detected an ipod in recovery mode, you must restore this ipod before it can be used with itunes
What do you mean you can't restore? It's asking you to restore...
B-rock -
I was updating my Ipads software when it just shut off. I turned on the i pad and it gave me this picture of the wire plugging in to itunes. i plugged it into i tunes and i got this message on itunes saying itunes has detected an ipad in recovery mode. you must restore this i pad before it can be used with i tunes. pleasssse help
iOS Recovery Mode -
iOS: Unable to update or restore
http://support.apple.com/kb/ht1808 -
iTunes gives me the message that it has detected an iPod in recovery mode and that I need to restore the factory settings. When I click the "restore" button iTunes downloads the software. This is a 30 minute process. Once the download completes, I get the same message "iTunes detects an iPod in recovery mode....". I'm running Windows Vista and ZoneAlarm security software.
I've tried this restore function multiple times and still get the same results.
I've also tried resetting the iPod by holding the wake/sleep button and the Home button at the same time. The iPod turns on but shows the icons of a usb cable connecting to iTunes.
Any help would be greatly appreciated.This maybe yuor problem:
Restore loop (being prompted to restore again after a restore successfully completes)
Troubleshoot your USB connection. If the issue persists, out-of-date or incorrectly configured third-party security software may be causing this issue. Please follow Troubleshooting security software issues. . -
ok, so i finally found my ipod. I pick it up and it asks me if i would like to download the latest ios6 software so i did. Then moments later it died, ran out of battery. So i pluged it into my computer via apple usb cord. Then this is what itunes says "iTunes has detected an iPod in recovery mode.You must restore this iPod before it can be used with iTunes". All i want is to get my notes from the utilites section there so important to
If i restore it will my notes still be there, i dont want to restore original settings or something like that .
please help me what do i do?You have to restore the iPod, no ifs, ands, or buts...
After iOS is installed you will be asked if you what to set it up as a new iPod or if you want to restore from a backup.
If you have a good backup you can restore that and you're good to go.
If you don't have a good backup, then you end up with a "clean" iPod.... -
Went on a Vegas trip on Sept
11th. My iPad worked fine
before getting on the plane. In the hotel about 48hrs later I opened my iPad it
read the message: “iPad is disabled,
connect to iTunes.”
To my knowledge myself, nor anyone else has tried to access my device or
entered the password incorrectly 3 or more times.
I started by updating my iTunes account on my computer to the latest version.
Then multiple times I attempted
the “Use recovery mode”
steps.
e.g.
1. Turn off your device and leave it off.
2. Plug in your device's USB cable to a computer with iTunes.
3. Hold down the Home button on your device as you connect the USB
cable. Keep holding down the Home button until you see the Connect to iTunes
screen.
I received the message on my computer saying “iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes.”
I click the “Restore iPad” button.
During which time the progress bar on my computer’s iTunes
screen was moving very slowly and other times seemed like it wasn’t moving at
all. I would leave my two devices and attached by the cable and upon returning
I would find that the process would have ended before it had completed.
Initially I thought it was a connections issue because I was in remote
locations with slow internet servers. Since being home I have re-attempted the
process and have been able to fully complete the forced recovery but I will
receive a message saying:
“The iPad could not be restored. The disk you are attempting to use is full.
Removing files and emptying the recycle bin will free up additional space.”
What recycle bin is the message referring to? Obviously I CANNOT access any
data on the iPad itself. Just for the **** of it, I did empty my computers
recycle bin and re-attempted the forced recovery process but as I suspected it
did nothing for the iPad and I still received the same message: “The iPad
could not be restored. The disk you are attempting to …”
Please helpHere's a couple of Apple Support articles ...
Resolve iOS update and restore errors
If you can't update or restore your iPhone, iPad, or iPod touch -
I have windows 8 enterprise OS and iTunes ver. 10.5.0.142. I was upgrading my iPad to IOS 6.1.3. After finishing the upgrade my iPad Reboot and currently stucked-up in a plug-in screen and iTunes Logo. When I try to connect it to the iTunes pop-up message appear saying " iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes." In short, I push the restore button then another pop-up message appear saying " The iPad software update server could not be contacted. Make sure your network settings are correct and your network connection is active, or try again later." I tried many ways but still no luck. I repeatedly reboot the iPad and open the iTunes still the same problem. I try also to uninstall the iTunes and installed the lower version but still the same problem, I even check the firewall if the ITunes was block or My privileges is administrator to run the iTunes or even reset my winsock but the problem still remain. PLEASE HELP! Thank you in advance!!!
Turn off your firewall and antivirus software.
-
I updated my Ipod touch 4th gen (IO6 or whatever its called) And it has the picture that says to connect my ipod to Itunes, and I did, now it says "ITunes has detected an Ipod in recovery mode. You must restore this Ipod before it can be used with ITunes." I just updated it and now I have to restore it??! I don't wanna lose all my things on my ipod just for a stupid update! Please someone help!
Once the Device is asking to be Restored with iTunes... it is too late to save anything... and you must continue with the Recovery...
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... Be sure to Follow ALL the Steps...
Take your time... Pay particular attention to Steps 3 and 4.
After you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766
Note:
Make sure you have the Current Version of iTunes Installed on your computer
iTunes free download from www.itunes.com/download -
I try to update IOS 6 to my ipad 2/ wf/3g and after about half of the procedure stopped ... then I try to reconnected to the itunes and say "iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes". Can everyone help please. In the screen of iPad appears the itunes Logo and the cable of connectios. Can't do nothing!!!
Click restore in itunes.
-
I had some new albums I bogut from Itunes and wanted to put them on my Ipod Touch. Went to do that, ITunes said there was an update. I downloaded the update and then I couldn't see anything in my Ipod nor listen to anything. The screen of my Ipod shows a USB cable pointing to Itunes and when I plug it into ITunes again I get the message "iTunes has detected an iPod in recovery mode. You must restore this iPod before it can be used with iTunes." And the ONLY option it gives me is to restore my IPod to factory settings. I looked online for answers but all I see are people having problems with this because they bricked their phone, which I haven't ever done or even know how to do. Would appreciate some help, planned on spending my day off listening to my new albums.
If you are in the USA you can redown
If the music is not in your iTunes library (it is not in the backup that iTunes makes), you can redownload it if you are in the USA.
Downloading past purchases from the App Store, iBookstore, and iTunes Store
Are you in the USA?
What do you not understand? -
I am getting a message that states "iTunes has detected an iPod in recovery mode. You must restore this iPod before it can be used with iTunes." How or where do I go to restore it? As well, it's makes a crankling sound of some sort. Can someone, please assist. Thank you.
You restore it via iTunes on your Mac.
Restoring iPod to factory settings
B-rock -
I downloaded the update because why not. I then turned my iPad on and get the iTunes logo and a lightning cable picture. I plugged the ipad into my computer and opened iTunes.
The I got:
"iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes"
When I click restore it then says:
"Are you sure you want to restore the iPad "iPad" to its factory settings? All your media and other data will be erased, and the newest version of the iPad software will be installed.
iTunes will verify the resotre with Apple. After this process is complete, you will have the option to restore your contacts, calendars, messages and other settings."
I don't want to lose my media. I was never told to make a back up, I was never told the update would be this difficult.
Can I just revert back to how it was before?I downloaded the update because why not. I then turned my iPad on and get the iTunes logo and a lightning cable picture. I plugged the ipad into my computer and opened iTunes.
Then I got:
"iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes"
When I click restore it then says:
"Are you sure you want to restore the iPad "iPad" to its factory settings? All your media and other data will be erased, and the newest version of the iPad software will be installed.
iTunes will verify the resore with Apple. After this process is complete, you will have the option to restore your contacts, calendars, messages and other settings."
I thought okay, I'll just erase everything then. I get error 3004 when I try to restore.
I've tried disabling my security software, updating iTunes, replacing my hosts file and using a third party software recovery tool. Nothing works. I never thought Apple would break my iPad with an update but they managed to.
Any solutions?
Thank you. -
in attempting to reset my ipad2 thru itunes it states .iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes. when i hit restore it does not reset
Step by step
6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
7. iPad Recovery Mode on computer screen
8. Select "Restore iPad"...
9. Select "Restore and Update"
10. Extracting Software.
11. Preparing iPad for restore.
12. Waiting for iPad.
13. Verifying iPad restore...
14.Restoring iPad software.
15. Verifying iPad software.
16. Verifying iPad Restore...
17. Restoring iPad firmware...
18. Your iPad is restored to factory settings; keep iPad connected to computer
19. Activate iPad
20. Enter Apple ID and Password
21. Continue
22. Welcome to Your New iPad -
I'm having the same loop message appear when trying to sync my new Ipod Shuffle "Itunes has detected a device in recovery mode. You must restore this device before it can be used w/ Itunes".
I've restored several times but it keeps looping back to the same message. Turns out this message appeared with my last shuffle and I thought possibly the shuffle battery was depleted and it was time to get a new one.
any suggestions?If you restore from backup.
You should have made sure that everything was on your computer bef ore updating anyway. Did you fail to do that?
All pics taken with iphone should be imported to your computer regularly as you would with any digital camera, most especially before any update/restore/etc. Did you fail to do that?
Maybe you are looking for
-
Language changed and I can't change it back
-
I have been editing and saving a project to the adobe cloud when I tried to send it via the link all material was lost and has so far not been recovered
-
The Paypal integration guide says that I need to install SUn Java JRE 1.3.1_02. I have done that and updated the CF administrator JVM path to point to it, but COld FUsion will not start. ANy ideas? I also tried installing 1.4_15 and it wont start wit
-
Here is where I am at - Im not good with this stuff so treat me like I am 6 and I should be able to figure it out. I updated my iphone to Ios 7.0.4 via the phones update option under settings. Once downloaded, my phone keeps saying I have to connect
-
X doesn't start - Segmentation fault
Hi all, after latest upgrades of the system, X doesn't start anymore. The error is: [ 1193.133] (II) AIGLX: Screen 0 is not DRI2 capable [ 1193.133] drmOpenDevice: node name is /dev/dri/card0 [ 1193.133] drmOpenDevice: open result is 11, (OK) [ 1193.