Just built the computer and the sound doesn't work.
So, I have just built my computer today. Had a few hiccups, but so far so good. However, I've come to a bit of snag. I can't get the audio to work, no matter what I try.
MOBO: MSI z87-g45 gaming series
I've installed the drivers, I've double checked the plugs, but I can't get anything to come from my headphones, no matter if they're in the back or the front. Could anyone give me some help? If you need more information, I'll give it to you.
have you tried to >>Clear CMOS Guide<< with power cord removed and to load bios defaults?
have you tried to boot with barabone setup with mainboard out of pc case placed over wooden table?
Else you can flash to latest BIOS 1.7:
http://www.msi.com/product/mb/Z87G45_GAMING.html#download
and to see how its goes
Similar Messages
-
My Ipod touch 8gb will not turn back on no matter what i do i have tried just the power button, the power button and home button, and connecting it to the computer and the battery wasn't close to being dead non of them work what do i do?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My computer won't let me run the setup.exe file. I am an admin I've run as admin and I've downloaded many times. I just reformatted my computer and now it won't work.
Try this - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.) No data/files will be erased. http://support.apple.com/kb/ht1430http://support.apple.com/kb/ht1430
If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808http://support.apple.com/kb/ht1808
Cheers, Tom -
I just installed Photoshop and want to use it as the external editor in iPhoto. I also have PS Elements on the computer and the only external editor I can get iPhoto to recognize is PSE. Any help in changing the external editor to PS would be appreciated!
Welcome. I am using Photoshop CS5 and this works fine for me. Possibly Adobe has changed this in CS6. Hopefully, LarryHN will have further suggestions. Best.
-
I updated photoshop cc but I cannot see the updates when I launch photoshop? I have restarted the computer and that still doesn't help.
Installing the "Update" installs a totally new version. The old version of Photoshop CC is still installed. It is likely you are running the old version.
-
After a power outage Apple TV can't find date and time - just keeps spinning on that screen. Tried powering off Apple TV, the computer, and the router. Tried to restart Apple TV. Tried to restore Apple TV, but it got stuck again setting time/date.
Welcome to the Apple Community.
Along with the things you have tried, some have had success setting the location to the US. -
How do i copy content from one hard rive to another through my macbook air? the copy and paste option doesn't work
It's because of the extension of the hard drive is a Windows extension ( most likely MSDOS or Ex-FAT), meaning you can only read but not write. If there are no important files (or you can copy the whole thing to your computer/mac) you can just reformat the hard drive and change the extension to NTFS (readable and writable on both windows and mac) or Mac OS Extended (readable and writable on Mac, readable on windows).
Go to DISK UTILITY
Choose the Hard Disk you intended
ERASE
You can choose either
(I personally prefer this one, you know just in case) -
you are running the latest version of iTunes, have no other USB devices attached, have no security software installed, and are directly connected to your ISP source, simply restarting the computer and the iOS device can clear up certain issues that could prevent you from restoring. After restarting the computer and iOS device, attempt to restore again.
How big is your library? I would recommend the following troubleshooting steps:
- Backup your library. Always a good idea before messing with things.
- Create a new library. Refer to this article for details: http://support.apple.com/kb/HT1589. This won't delete your old library, you're just creating a new empty one. Also refer to this article to get back to your old library later.
- Add a few albums into this new library. Not everything, just a small sampling, as a test.
- Activate Match on this new library. You shouldn't have to re-pay, it should just say "Add Computer" or similar.
- At this point, Match should run again. With just a few albums it should complete in just a few minutes.
If iTunes doesn't crash at this point, then likely there's something about your original library that Match doesn't like - what that is I don't know, but at least you'll know it's not your PC. If iTunes still crashes, then if could be a number of other things, but probably not your library. My next suggestion (if you haven't already done this) is to uninstall / reinstall iTunes. If that doesn't work, then my next ideas you won't like. -
my new macbook pro is giving me hardtime. even apple team is not being to solve it. they replace the motherboard first it didn't work. second time they formatted the computer and that also didn't work. every time my mac showing different problems.
At first my computer had issues. Once it go to sleep it will not back again. I dropped my laptop at apple store to fix it. After 10 days they returned my laptop saying they were no able to fix the problem so they replaced motherboard aiming if that might help. Acttually that didn't help.I had same issue again. I visited apple store again. This time they said they could fix, if I will allow them to format the harddrive. I said ok. They formatted it. It was working fine for few daysAfter few days compter is taking.even more than 15 min to shutdown. Now computer has another problem. It is being hang frequently like every 20'to.30 min.
I don't know what to do? I still have one month left on first year warranty. I have requested couple times to apple associates either to fix or replace or refund. They are showing me rude behavior. They are not understanding my situation. I am a student. I need to do lot of home work. Since last three month my mac book and apple associates giving me hard time. Any suggestions are welcome.Contact Apple Customer Care - not Apple Care - Customer Support. Have your receipts handy and/or case numbers. Be patient, be calm, and tell your story just as you have here. I get the sense you are not in the US and don't have access to an Apple Store but are going to an independent shop. This makes using Customer Support all the more important. If phoning isn't viable, use registered mail.
Since time is running short, be prepared to purchase AppleCare to exennd your warranty 2 more years. Yes, you shouldn't have to do this, but it gives you added protection and more opportunities over the next 2 years to claim a replacement computer if you don't get one immediately. After dealing with a similar unhappy situation with a Mac in the late 1990s I finally got a replacement computer and reimbursed for the AppleCare policy. -
I purchased my Macbook (17") through a certified apple tecnition in August 2012, it was refurbished and the motherboard was completely replaced. I do a lot of photo editing, but I have been unable to do so because of the red vibrating lines that interrupt my screen. The issue disappears temporarily when I tap on the computer, and the problem does not occur when I use external display or try to screen capture the problem. I brought the computer back to the technition I purchased it from and he said that it was a problem with my fan, so I have two new fans but the issue is still occuring. He says he doesnt know whats wrong. Does anyone have any information on this issue?
Here is an image of the issue
http://www.flickr.com/photos/67839707@N08/8884847081/I recommend having your Mac serviced by someone competent. A force sufficient to "blow apart" the fans was clearly excessive and may have damaged the display cable, as well as any number of other problems.
Dust is properly cleaned with a vacuum, preferably one designed for computer service, and they are not cheap.
Compressed air should never be used. It just blows dust everywhere, often into places where it can no longer be removed. -
my ipod is workingfine till i plugged it into the computer and the i tunes logo stays on . wan t to open and go back to regular setting .how could i do it?
Sounds like you are in recovery mode. Try using RecBoot to kick it out of recovery. If that does not work, you may need to restore.
Basic troubleshooting steps
17" 2.2GHz i7 Quad-Core MacBook Pro 8G RAM 750G HD + OCZ Vertex 3 SSD Boot HD
Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101
In Memory of Steve Jobs -
I have burned CDs before from 2gb to 7gb using different types of discs. Now I get this error message Apple error The disc can't be burned because communication between the computer and the disc drive failed (error code 0x80020022). What should I do
Reset the SMC, as per > Resetting the System Management Controller (SMC)
1. Shut down the computer.
2. Unplug the computer's power cord.
3. Wait fifteen seconds.
4. Attach the computer's power cord.
5. Wait five seconds, then press the power button to turn on the computer.
Then zap the PRAM/NVRAM as per > About NVRAM and PRAM
1. Shut down the computer.
2. Locate the following keys on the keyboard: Command, Option, P, and R. You will need to hold these keys down simultaneously in step 4.
3. Turn on the computer.
4. Press and hold the Command-Option-P-R keys. You must press this key combination before the gray screen appears.
5. Hold the keys down until the computer restarts and you hear the startup sound for the second time.
6. Release the keys.
Then retry the Disc Drive. -
Communication between the computer and the disc drive failed
The disc can’t be burned because because communication between the computer and the disc drive failed (error code 0x80020022). This computer has been out of the box for less than a month and this has been a growing problem.
My problem was FIXED at the apple store..... there was something wrong in the system preferences and the genius deleted something that recreated it's self. Surely enough we we're able to burn a 600 mb dmg of nothing onto a few test disks. For anyone having this issue...it's NOT The media, it's some configuration issue within the computer's preferences. I'm telling you all to take your machine to the nearest apple store and have them fix it, if your machine is still under warranty the fix is free. There was no hardware issue, so the optical drive was not replaced.
-
my iphone is able to charge when i connect it to my computor, but no matter what i do, will not show up on itunes. i have tried resetting both the computer and the iphone and nothing is working.
Type "ipad not recognized in itunes" or similar into the search bar at the top of this page by "Support".
-
I have a Iphone and I want to downloa a game but it's over 50MB so it says you must connect to wifi or download from a computer so I downloaded it from the computer and the computer says the downloads done but the app bar is empty and says "waiting.."
Need to Resume download to complete the ongoing Process.
Last Resort, put the iPhone in DFU mode (Google How to do that). Connect in iTunes. Follow on-screen prompts to Restore. All Data would be lost, if not backed up earlier.
To save the photographs you may have to use third party software. Google is your friend. -
please help me on this, what happened was that i connected my ipad to the computer and the itunes library was empty although a week ago i had 48 apps on the itunes library
see my main ques was that i have an ipad 2 in which i have 48 apps and i hv made an itunes account in my computer in which i can backup my purchased apps and i had backed up36 of them so that i can delete them from my ipad if the memory is full but recently when i opened my itunes account in the computer it tells that you dont have any app on this account whereas on my ipad i still do have them, so cant i get all my backed up apps on the itunes account on my computer again?
Maybe you are looking for
-
Addition of 0MAT_PLANT to a cube
Hi, I have the following requirement. I need to create a report on a cube where I need to display a field called Import Code of a material This Characteristic is an attribute of 0MAT_PLANT InfoObject. The cube has 0MATERIAL and 0PLANT. But it does no
-
Error while creating Journal Template
Dear Experts I am in process of re-creating Journal Template and got below error (I have upgraded to BPC 7 NE SP8 - before this I was using the Journal!!!!) Step1_Init : An error occured while parsing EntityName, Line 1, Position 2069 and then Journa
-
I've tried everything and still no response on Ipod
My duaghter has a Ipod mini, Pink in color. I plug it in and it says go to apple.com/ support for help. Did that ordered new battery and put it in and still ends up showing me a frown face and a battery that is not charging on the screen when I plug
-
Using getDistanceFrom function in CLLocation
I would like to calculate the distance between the two coordinates, so I created two CLLocation objects as follow: CLLocation *loc1 = [[CLLocation alloc] initWithLatitude:40.443561 longitude:-79.945592]; CLLocation *loc2 = [[CLLocation alloc] initWit
-
Mail is completely missing from settings.
The Mail icon suddenly disappeared from my Ipad Mini. The Mail Settings category is completely missing within the General Setting screen as well. How don't I restore the settings?