Laptop screen has a light white square with an orange dot.

I just installed a new screen to replace a cracked one.  When the systems first turns on and powers down a faint 2"x2" white square with a 1/4" orange dot appears.  It's most visible with the lights off.  This has happened with 2 replacement screens and am now wondering if the problem is within the laptop itself.  I've added a screenshot of it with  a circle around the orange dot.  Any thoughts would be much appreciated.
John

Hi
Do a hard reset first
Try downloading & Installing the updated BIOS and graphics drivers from your HP product site to rule out software display problems.
thanks,
++Please click KUDOS / White thumb to say thanks
++Please click ACCEPT AS SOLUTION to help others, find this solution faster
**I'm a Volunteer, I do not work for HP**

Similar Messages

  • Macbook pro screen has black and white squares

    I have an older 2007 15" MacBook Pro. I turned it on one day and, although the computer made the same sounds it always does when it is booting up, the screen showed these very depressing black and white squares, and the rest of the pixes around these blocks (half black, half white)  were very scrambled.  A few days later the computer booted up completely normally, but now it is back to the crazy screen.
    Does anyone know what this problem may be? I am currently in Thailand and am wondering if someone can help me figure out what problem this most likely is so I can decide how much an appropriate repair should cost.
    Thanks so much!

    Hi if the device is a Macbook pro 15 inch mid 2010 model then there might be a chance of replacement of MLB for NVDIA graphic problem, please contact an apple authorised service provider for more details about this issue and you may get a free replacement programme for this MLB also all the best.....

  • Pavilion dv5 -1000us laptop screen has a blinking white transparen​t horizontal lines

    i was using my laptop last night but suddenly the screen start to show blinking white  covering almost 98% of the screen.
    my 5 years old laptop have never been under  repair it has battery issue but i just ignored it. i usually plug it in with the powersource.   what test or remedy can i do save money.please help . thank you in advance bros/sis!

    Does it happen now right after start up?
    Did you run a virus scan?
    Can you test an external monitor?
    *** Say 'Thanks' with Kudos ***

  • This is the third time my screen has a light white line

    Hello,
    I've a macbook air 2011 on Mevericks. And today i used an Black Wallpaper and saw that there are some white spot lines on my display. This is the third time i'm facing this kind of problem i
    m tired of sending my device to the service station.
    Please anyone help me out here.

    fault at the display feed cable that runs thru the hinge.
    slowly move your display and see if the lines flicker off and on.
    display assy. feeds or fault of same at junction with logic board.
    Contact Apple for appt for in shop diagnostics

  • Have a MacBook Pro. the computer will not boot up, the screen has black and white stripes and multi color bands as well.

    Have a MacBookPro. The computer will not boot up. the screen has black and white bands with multi color bands as well.

    Yeah it's dead. Take it to an Apple Genius Bar and have it checked out. Then buy a new one.

  • Why is my ipad screen has a ghoshtly white screen color?

    WHy is my ipad screen has a ghostly white color?

    FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. You must follow step 1 to step 4 VERY CLOSELY.

  • HT1553 my laptop screen has gone blank, probably graphic card problem. i want to back it up. please help

    my laptop screen has gone blank probably due to graphic card problem.i need to back up my content as i have bought a new mac and do not intend on repairing the old one. please help

    Try a Target disk:
    http://support.apple.com/kb/HT4889
    http://support.apple.com/kb/HT1661
    http://support.apple.com/kb/HT4413
    If you are buying a new mac, Apple will do the migration for you, I would let them do it.
    If you have an external monitor, I would try to do a data backup before doing anything.
    Could also be your drive has already failed, or logic card.  Again I would take it the  Apple store, and have them deal with it since you bought a new Mac, they would do this for free, and the shoulder the responsibility.
    Hoe this helps.

  • I reinstalled my windows xp now the firefox icon on my desktop is now a white square with the firefox inside

    I reinstalled my windows xp now the firefox icon on my desktop is now a white square with the firefox inside how do I fix it

    Did you try to change that icon in the Properties via the right-click context menu?

  • Live tracing a jpg gave me a white square with a few vectors

    I used the 3D Revolve effect to create a sphere. I then "expanded appearance" to try and "subtract from shape area" a portion of the sphere. It ended badly. So I copied and pasted the sphere into Photoshop, removed the portions I wanted gone and placed it into Illustrator in hopes "live trace" would save my bacon. It didn't. When I select the graphic and choose expand "live trace", it gives me a white square with a few vector points in it. What am I doing wrong?
    Thanks in advance!

    Go to Live Trace Trace Options so you can change the setup to color then choose 4 or 5 or 6 colors and check ignore white you get this.
    You have to change the option to color or convert to grayscale and choose grayscale the default is b&w which is not what you want.

  • My Mac book pro screen has a constant white mark on it.

    Hi,
    My Mac book pro screen has a constant white mark on it, i have no idea why, its like its inside the screen, its never been dropped or had anything fall on it and the mark is starting to get bigger. Has anyone else had the same problem? i've inserted a pic of it, hopefully you can make it out.
    Thank You

    I see a multitude of white marks on your display.  Your best option is to make an appointment at an Apple store genius bar and have the technicians examine the MBP.  Hardware problems such as this cannot be solved via these forums.
    Ciao.

  • My ipod touch screen has turned white. the screen has turned bright white. it is not going by reseting also. when  i  shift screens then it leaves a trail and i dont know what to do. please help.

    my ipod touch screen has turned bright white. the things are visible but partially and when shift the screen it leaves trails behind. i dont know what to do help please.

    Try:                                               
    - iOS: Not responding or does not turn on           
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable       
    - Try on another computer                                                       
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar                                     

  • Phone screen has too much white on it.

    I've had my blackberry torch for almost two years now and I've either had to have it replaced or get it repaired about 7 times now. Now, the issue it that the screen has white lines going down it. They begun only ONE WEEK after I had gotten my phone back from repair after having the whole screen gone white, making it unuseable. But then white lines begun coming up on the right hand side, but as I need my phone for work, I couldn't deal with having my phone in repair for another week, but now it's gotten really bad and takes up about 70% of the screen. So I was wondering if there was anything I could do to fix it? My contract runs out in about a month so I'm not bothering with repairing it, I just want something I can actually use for emails etc until then....
    Thanks!

    Hello,
    What you describe sounds like hardware, for which no amount of internet-distance diagnostics nor OS/software level "fixes" can be of any use.
    Good luck!
    Occam's Razor nearly always applies when troubleshooting technology issues!
    If anyone has been helpful to you, please show your appreciation by clicking the button inside of their post. Please click here and read, along with the threads to which it links, for helpful information to guide you as you proceed. I always recommend that you treat your BlackBerry like any other computing device, including using a regular backup schedule...click here for an article with instructions.
    Join our BBM Channels
    BSCF General Channel
    PIN: C0001B7B4   Display/Scan Bar Code
    Knowledge Base Updates
    PIN: C0005A9AA   Display/Scan Bar Code

  • My Laptop screen has gone Dark

    I have a Lenovo Ideapad Z500, Intel I7, 3612QM, 6GB Ram with an Nvidia GT740M Graphic Card.
    My display was absolutely fine, till I installed Windows 8.1. After a few minutes of working properly, the laptop screen went dark.
    I have installed all available updates for Windows, and have also updated the drivers for the graphics card, however the screen is still dark.
    Kindly suggest a way to fix this

    You should read this
    http://download.lenovo.com/lenovo/content/windows8-1/upgrade/ideapad/index_en.html
    It is not recommended to upgrade the following models to Windows® 8.1 because some VGA related issues cannot be solved by the vendor, currently.
    U310, U410, U510, U410 Touch, U310 Touch;
    Z500 Touch,
    Z500, Z400, Z400 Touch, Z380, Z480, Z580, Z485, Z585;
    S300, S400, S400u, S400 Touch, S405, S206, G485, G585, N480.

  • Small white square with a plus sign in it right in the middle of page!

    I am ready to print my document, I used a template to create a great document...the only problem is that right in the middle is a tiny white square box with a plus sign in it, and I can't figure out how to make it go away! Please help me!!!

    Nevermind. I finally figured it out. I had text boxes overlapping. Ugh. Time to take a break!

  • TS1382 Screen has horizontal solid white lines

    Screen has horizontal solid lines, unreadeable items

    You can work through the five 5 R's of troubleshooting.
    http://www.apple.com/support/ipod/five_rs/
    It might also be a good idea to let the iPod's battery fully drain. Then charge it back up and restore it once more in iTunes.
    Otherwise, it's likely a hardware issue with the iPod's LCD display, meaning you'll need to take or send your iPod in for service either via Apple or a third party repair service. Here is Apple's repair pricing.
    http://www.apple.com/support/ipod/service/prices/
    Note that they don't actually repair the device, but exchange it for one of the same generation, model, and capacity.  A third party service will actually replace the damaged part for a little less.  Google "iPod screen repair" and you should get a number of results to work with.
    B-rock

Maybe you are looking for

  • All Content Not Viewing In Layout View

    I just installed InCopy CS3 on a user's recent IBM ThinkPad and for some reason when viewing a document in layout view SOME pages are not displaying content. All text content displays fine in galley and story view? This is a fresh install. Any ideas?

  • How do you get your text messages to not show on the screen when they come in

    How do you get your text messages to show on the screen when then come in?  My iphone 3s would just say the persons name and text message.  This says the persons name and the whole message

  • Vendor Master Field Status

    Hi All I Want *Contact person feild as optional field* in Vendor master dara General Data tab. field status for the said field is optional in all the levels i.e Vendor account group  and also in screen layout per activity. Still  while creating vendo

  • Contract validity periods triggering

    Hi Gurus, I came to know that the contract validity periods price will trigger based on PO document creation date... In our case Market price is changed every quarter, and there is no way we have to wait until the new validity period to come to creat

  • 9i and 10g Installation

    Have oracle 9ir2 installed first and I then installed 10g, but 10g DB can't start. Installation was succeessful. When I try to open the database I get the following errors Listener refused the connection with the following error: ORA-12500, TNS:liste