LASER JET 1022N NOT PRINTING SINCE SWITCH OFF

Question

THERE WAS A LARGE PRINT RUN SET UP IN ERROR AND THE PRINTER WAS SWITCHED OFF TO STOP THE PRINTING AS THE REQUEST HAD CLEARED THE COMPUTOR CONTROLS IN PRINT. NOW THE RED LIGHT FLASHES AND NO PRINT, I HAVE BEEN UNABLE TO CLEAR THE MEMORY. THE PLUG AND NETWORK CABLE HAS BEEN DISCONECTED, COMPUTORS HAVE BEEN REBOOTED BUT IT MAKES NO DIFFERENCE. OTHER PRINT REQUESTS DO NOT TRIGGER OFF A RESPONSE. THE RED LIGHT STILL FLASHES.
HELP WOULD BE APPRECIATED
JOHN
3 SEPT 09

Answer 1

Let's set a static IP address for the printer:
- Print a Network Config Page from the front of the printer. Note the printer's IP address.
- Type that IP address into a browser to reveal the printer's internal settings.
- Choose the Networking tab, then Wireless along the left side, then the IPv4 tab.
- On this screen you want to set a Manual IP. You need to set an IP address outside the range that the router automatically sets (called the DHCP range). You can find the DHCP range of the router using its internal settings page or in its manual. Use the CD that came with your router or type the router's IP address (ends in .1) into a browser.
- Use 255.255.255.0 for the subnet (unless you know it is different, if so, use that)
- Enter your router's IP (on the Network Config Page) for the gateway and first DNS. Leave the second one blank.
- Click 'Apply'.
Now, shut down the router and printer, start the router, wait, then start the printer.
After this you may need to redo 'Add a Printer' using the new IP address.
Say thanks by clicking "Kudos" "thumbs up" in the post that helped you.
I am employed by HP