Line-In doesn't appear in the mixer (Audig

The Line-In is dead, and I suppose it's because this source doesn't appear in the mixer.
Because of this, I'm cannot enable the soucre. And then I get no soud.
If I choose "SB Audigy 2 AZS Audio" as default for recording, I'm missing the option to choose Line-In in standard Windows mixer. (The slider isn't there.)If I choose "C-Media Wava Device" as default for recording, I can choose Line-In in standard Windows mixer, but I don't get any signal.
I have installed the last drivers.
Hope you can help me!

OK, sound some better.
Can you run the Creative diagnostic tool without errors?
If you do not find next programs mentioned, you have to install them
(Creative CD bundled with cadr).
Have you AudioHQ on System Control Panel.
- Is speakers set to be muted when using headphones. Uncheck this.
- options : is SB Audigy xxxxx selectedt as sound device?
Control Panel:Sounds & Multimedia
- Audio : is Sound Play Back devic selected to be SB Audigy xxxx
- is all behind Volume (button) set not muted
Check if mic and midi settings are like you want.
- is all behind Advanced (button) set like it shoul be
Hardware : Creative audigy xxx - properties : Creative xxxx (WDM)
- is use this audio device selected
- is do not map through this device selected
Creative Surround Mixer
Speaker settings
- set same settings as above (and select syncronization with control panel)
- unselect digital output only
Rec settings (red portion with slider)
- select AnalogMixer as source
- check if record without monitoring is not checked
- disable unneeded inputs (mic, aux, ...) - wave, volume, linein should be ON
- set input and recording levels
EAX -panel
- switch off all effects if you do not need them
This come into mind now ... hope it helps ...
.jtpMessage Edited by jutapa on 04-07-2005 02:47 AM

Similar Messages

Maybe you are looking for