Linking by Ethernet to sync, and then, going wireless from then on

Has anyone done their initial sync wired, and then gone wireless? Depending on your setup, B, G, N, or signal strength, going wired would certainly decrease your "upload" / sync time on the first one (40gb). Once the 40gb is synced, then you could go wireless, and hook it up to your tv proper.
Anyone done this? Just curious.

I believe G is theoretically 54 compared to ethernet's 100. So there could effectively be a significant increase in speed. If you plug in the ethernet connection, others have posted that it turns off wireless and configures itself just as it would when using the wireless connection. Once you unplug ethernet, I don't know if you have to re-enter the password for the wireless connection, but I'd think that you wouldn't have to.
One more thing to try wirelessly is to make sure your base station's settings is set to exclude 802.11b connections. Kinda like USB 1 and 2, using a slow device makes the network slow down significantly to compensate. Setting it to G only means you can't use older devices with it, but now it won't slow down either.

Similar Messages

  • TS1373 my  5th generation ipod acts like it is going to sync and then "ejects" itself before even 1 song can be synced. It then doesnt recognize that it has been ejected and keeps the"do not disconnect" icon on the screen even after unplugging. What do I

    my  5th generation ipod acts like it is going to sync and then "ejects" itself before even 1 song can be synced. It then doesnt recognize that it has been ejected and keeps the"do not disconnect" icon on the screen even after unplugging. What do I do?  it also makes a lot of noise while connected to the computer.

    Is the camera damaged? Could be a hardware problem.
    Try:
    Close the Camera app in the multitasking bar, then try again.
    Restart/Reset/Restore your iPod. In that order.

  • Whenever I try to sync my ipod, it'll say that it's syncing and then "waiting for changes to be applied" when it reaches step 5, then it closes and nothing happens. I don't know what to do :(

    Whenever I try to sync my ipod, it'll say that it's syncing and then "waiting for changes to be applied" when it reaches step 5, then it closes and nothing happens. I don't know what to do

    Hi, There
    What do you mean nothing happends? because after step 5/5 the sync is complete and it should go back to the normal top screen of itunes. Is this what is happning? of is it freezing on step 5?
    Message was edited by: Scott\'y

  • I installed Firefox sync and then used iphone app called FireFox Home and I can syncronize history, tabs and bookmarks. But I am NOT able to syncronize passwords from Firefox in my Macbook to FireFox Home on iPhone !

    I installed Firefox sync and then used iphone app called FireFox Home and I can syncronize history, tabs and bookmarks. But I am NOT able to syncronize passwords from Firefox in my Macbook to FireFox Home on iPhone so I am very terrible to input my IDs and Passwords with my hands on FireFox Home when I log into Facebook, Twitter etc... Is it issue or something like that? If you have some solutions to make it clear, can you tell me how to syncronize memorized IDs and Passwords for the webs. Thank you.

    You can look in Tools > Options > Sync
    Menu differences: [http://kb.mozillazine.org/Menu_differences Windows: Tools > Options - Mac: Firefox > Preferences - Linux: Edit > Preferences]
    See also:
    * [[What is Firefox Sync]]
    * [[How to sync Firefox settings between computers]]
    * [[How to sync Firefox between my desktop and mobile]]

  • My ipod nano 6th gen synced and then i go to use it and there isnt any music on it?

    my ipod nano 6th gen synced and then i go to use it and there isnt any music on it? but when i plug it in to itunes it says there's music on it..

    you have to press quite hard to get the headphones in
    dont be afraid it breaks

  • Sometimes when I open a link in a new tab and then switch to the tab, the address bar clears and the website won't open.

    Sometimes when I open a link in a new tab and then switch to the tab, the address bar clears and I'll have to re open the tab and hope that doesn't happen again. Sometimes this happens again and again. Most of the times if I just open the link in a new tab and don't switch to it, this won't happen. But as I switch too the tab, the text would disappear and the link wouldn't open.

    Start Firefox in <u>[[Safe Mode]]</u> to check if one of the extensions is causing the problem (switch to the DEFAULT theme: Firefox (Tools) > Add-ons > Appearance/Themes).
    * Don't make any changes on the Safe mode start window.
    * https://support.mozilla.com/kb/Safe+Mode
    * [[Troubleshooting extensions and themes]]
    In Firefox 4 you can use one of these to start in <u>[[Safe mode]]</u>:
    * Help > Restart with Add-ons Disabled
    * Hold down the Shift key while double clicking the Firefox desktop shortcut (Windows)

  • IPOD recognized during SYNC and then disappears from My Computer

    My IPOD is recognized during the SYNC phase and as soon as the SYNC phase is done the IPOD disappears in My Computer. I have tried restoring my IPOD, uninstalling and reinstalling the drivers, deactivated the save power on the USB hubs and other suggestions. There is no problem with it showing up in itunes or in the Device Manager. When I plug in my flashdrive it shows up fine in My Computer. I can unplug the IPOD from the cable and plug it back in and it will again show up in My Computer until it finishes SYNCing and then again disappears. HELP! I don't know what else to try!

    This list http://www.copytrans.net/helpcopytrans.php#22 of iPod not detected hints might help.

  • "Mark in Sync" and then what?

    I captured a Hi-8 tape with my D-8 camcorder (think 'DV Converter' setup) and the 1:40 master clip has the audio out of sync by about four seconds. It might be that the capture began on blank tape and it took a moment for the video and audio to settle down. I'd like to avoid recapturing the whole tape.
    In the Timeline I locked the video track, dragged the audio into sync, and then picked "Mark in Sync", which got rid of the red complaint boxes. I want the slipped clip to be the new "Master" for the whole capture session. How to I preserve the slip/correction and return the clip to the browser? If I drag it back up there it seems to lose the new sync and the red 'slip' boxes return again. My goal is to 'start over' with the slipped clip and mark the scene changes on it.

    The 'make subclip' command exists in FCE, but the new subclip is out of sync again.
    Exporting the clip to QT movie, even without 'make movie self-contained' checked, works. I may 'print to video' anyway to create a DV backup of the Hi-8 original. Thanks for your suggestions.

  • I downloaded songs on itunes, when I go to sync it to my ipod it "says" its syncing and then it shows up on the capacity bar but there are no songs on my ipod

    I downloaded songs on itunes, when I go to sync it to my ipod it "says" its syncing and then it shows up on the capacity bar but there are no songs on my ipod

    In itune did you play any of the songs downloaded. If so plug your ipod back in an manualy check off to sync all music. If that doesn't work you might have to restore the ipod.

  • Firefox Sync Reset, not syncing and deleting all addons from every device

    I started to notice that some of my addons were being uninstalled randomly so I decided to unlink my three devices, make sure one was a master, set up sync and then sync the other devices. However, something happened and now my quota for addons is 6.0 KB, that doesn't seem like much for addons and when I sync on any other device, replacing the data on that computer with the sync data, all addons get unistalled. I tried changing the recovery key, deleted the account and created a new account with the same email address. I am at a loss. Ideas?

    I tried the suggestions at the links above but they did not work. Every time I sync, all addons are uninstalled. I have to back and undo the uninstall on all of them to keep them.

  • Sync and Create project operation from DTR is taking more than one hour

    Hi All.
    Recently basis team has implemented the track for  ESS/MSS application.So When we import the track to NWDS its showing 500 Dcs.
    I have successfully done the Sync and create project operation from DTR for 150 DCS and its take 5 min per Dcs.
    However after that when i am trying to sync Dc or create project DC from DTR the operation is taking more than 3 hour per DC.Which should not be the case because for rest 150 DC that i ahve done Sync operation adn Create project operation from DTR it hardly takes 5 min per Dc.As this operataion is taking so much time finally i have close the NWDS to stop this operation.
    I am using NWDS 2.0.15 and EP7.0 portal SP15 and NWDI is 7.0
    Can any body tell how to solve this issue so that i can Sync and Create project from DTR for a DC within 5 min?
    Thanks
    Susmita

    Hi Susmita,
    If the DCs are fine in CBS build, then I feel there is no need to test all of them locally in NWDS.
    You can verify some certain applications in these DCs, then you sync & create project for these DCs & test run these applications.
    As I get you only need to check ( no changes will be done ), yes you can verify them in small groups (say 20-25 DCs/group) in different workspaces so that no workspace is overloaded.
    But why do you want to keep a copy of them locally as you are not making any changes, you can Unsync & Remove these projects once verified & use the same workspace to work on the next set of DCs.
    Hope this clarifies your concerns.
    Kind Regards,
    Nitin
    Edited by: Nitin Jain on Apr 23, 2009 1:55 PM

  • Had to reinstall Lion.  Backed up music to external hard drive.  When I plug in iPod msg says it's synced w/another iTunes library.  Do i "erase and sync" and re-add music from the hard drive?

    Had to reinstall Lion.  Backed up my music to an external hard drive.  When I plug in my iPod a prompt msg says it's synced w/another iTunes library and asks if I want to "erase and sync" (to what is now an empty library) or "Transfer purchases".  Do i "erase and sync" and re-add music from the hard drive once that's done?

    You just need to tell iTunes where the library is located. If you want it back on your internal drive, copy the entite iTunes folder. Follow the instructions below.
    iTunes: How to move your music to a new computer (Mac or Windows):
      http://support.apple.com/kb/HT4527

  • My computer crashed and i had to reinstall itunes is there a way to sync and upload my music from my ipod back to my itunes

    My computer crashed and I had to reinstall itunes, is there a way to sync and upload my music from my ipod back into my itunes?

    what do you mean crashed?
    did you reinstall windows as well? or it just shut off and now your library is missing?

  • IPOD freezes while SYNCING - and then gets file error

    Hello all,
    i have a standard 40gb click wheel ipod, quite old, it works, but limited. The ipod just freezes while syncing now, it has been restored numerous times, but 2 not much avail, i can get one or two albums on there, then everytime i try and sync the ipod just freezes, and has to be reset. Every TIme i plug the ipod into my vista laptop it says, the says. SCAN AND FIX, ( because i couldnt get anything else to work i tried this ) and this is what vista told me
    http://img155.imageshack.us/img155/9118/vistafixesipodlu5.png
    i was like woah, so i proceded to restore the ipod then it seemed to work, for a day. then went back to the freezing while syncing, then next time i plugged in the ipod, windows said the disk needs to be formated before it could be used, so i tried that ( cos itunes was doing sweet **** ALL ) and windows couldnt format it, and neither cos HP USB FORMAT Tool. so i reset the ipod, plug it back into vista, and behold, SCAN AND FIX COMES UP, so i click it, it fixes it, but only loads 1 album before it freezes while syncing again, i have the screenshots,it took 11 screenshots, to get the FULL MESSAGE, that vista chkdsk gave me, there was thousands of these "BAD LINKS IN LOST CHAIN at CLUSTER XXXXX Corrected" messages
    im currently listening to Three Days Grace on the ipod, works GREAT, except if i try and put more then this ONE album on it, it freezes while syncing, and gives me the unknown file error. SO any ideas if this ipod can be fixed, cos itunes cant do anything, im assuming there is physical unrepairable damage to the HDD of the ipod and will need replacing if this ipod wants to be in full working order again.
    The ipod is NOT under warranty either, so does any1 know where in Australia, it be fitted with a new HDD? Thanks
    kind Regards,
    Hayden
    Message was edited by: FittyyeN

    your an idiot stardock, format doesnt work, fails to format -
    stardockofthedead ( aussie css joke lol )

  • My itunes stops working everytime i plug up my phone and it tries to sync and then closes. Help!!

    Everytime I plug in my iphone 3gs and my itunes tries to sync itunes stops working and shuts down. I tried to uninstall and reinstall but it didnt work. Can anyone help?

    Are you seeing any error messages?
    Check this thread out -> itunes has stopped working...here are the problem reports:
    Try unchecking the Include videos option in iTunes, under Photos. You'll click the iPhone on the left side of iTunes, then click Photos across the top of iTunes to see the option.
    If you still want to sync the videos, you can add them to iTunes as movies and then sync them. You may have to right click and convert the videos in iTunes before syncing to the iPad (depending on how the videos were created).

Maybe you are looking for