Macbook pro mid2012 turns on when magsafe get unplugged. anyone else with same issue?
as stated above, when I unplug the magsafe, macbook wakes up from sleep. Anyone having that issue as well?
I have confirmed that this is definitely related to the Firmware Update 2.0.
I performed an erase and install of Mountain Lion 10.8.2 then applied all updates EXCEPT the firmware update 2.0.
I then restored all of my content and tested.
My MBP no longer wakes from sleep when the AC adaptor is disconnected or connected. I'll be logging it with Apple support shortly.
Similar Messages
-
My macbook pro shuts down unexpectedly when battery gets to 20% and is not plugged in
Why does my macbook pro keep shutting down when it gets to 20% without warning?
here is my battery information:
Battery Information:
Model Information:
Serial Number: SMP-ASMB014-3774-64a
Manufacturer: SMP
Device name: ASMB014
Pack Lot Code: 0002
PCB Lot Code: 0000
Firmware Version: 0110
Hardware Revision: 0500
Cell Revision: 0102
Charge Information:
Charge remaining (mAh): 3395
Fully charged: No
Charging: No
Full charge capacity (mAh): 3677
Health Information:
Cycle count: 1148
Condition: Fair
Battery Installed: Yes
Amperage (mA): 385
Voltage (mV): 12442
System Power Settings:
AC Power:
System Sleep Timer (Minutes): 10
Disk Sleep Timer (Minutes): 10
Display Sleep Timer (Minutes): 5
Automatic Restart On Power Loss: No
Wake On AC Change: No
Wake On Clamshell Open: Yes
Wake On LAN: Yes
Display Sleep Uses Dim: Yes
Battery Power:
System Sleep Timer (Minutes): 10
Disk Sleep Timer (Minutes): 10
Display Sleep Timer (Minutes): 2
Wake On AC Change: No
Wake On Clamshell Open: Yes
Display Sleep Uses Dim: Yes
Reduce Brightness: Yes
Hardware Configuration:
UPS Installed: No
AC Charger Information:
Connected: Yes
Charging: No
WHAT DOES IT ALL MEAN??That many cycles is amazing service. A battery that consistently shuts down at about the same charge level percentage every time probably has a bad cell (that info came form an Apple technician) and needs to be replaced.
It's given you far longer service than many of us get, and may be a new record around here for cycle count! -
my macbook pro will not boot. It gets the grey screen with the apple until the bar is half way across and then shuts down. The only screen I can get to is in safe mode and I don't know what to do with that
Mac OS X: Gray screen appears during startup - Apple Support
-
Radeon HD 5770 graphics card works perfectly with my MAC Pro 1,1 and Adobe CS6. However, I upgraded to Adobe CC and Photoshop CC disabled some filters and 3D functionality. The preference panel for Performance/Graphics Card in Photoshop CC is greyed out and inaccessible and shows this message -
"Photoshop detected an error in your display driver. Update or reinstall the driver and check Use Graphics Processor to retry."
I still have Photoshop CS6 installed and it still works perfectly. Anyone else with this issue? Is there a driver update for this compatable with my setup?
OS 10.7.5
Mac Pro 1,1
20gb ram
ATI Radeon HD 5770 Graphics Card
30" Apple Cinema HD displayafter going round with this Adobe was able to find the fix....opened the "show content" folder for the application Photoshop CC (control click on the application folder) and navigate to the sniffer file and rename it by putting a tilda ~ in front of the name..." ~sniffer ", close and open PhotoshopCC...and voila, problem solved... Thankyou Adobe support
-
Macbook pro 17 turns off when switching to high performance mode
Hi guys!
My 2009 Macbook pro 17 turns off and goes dead when switching to "high performance" graphics in the energy saver controll panel.
This happens also when the battery is 100% charged. i must reconnect powersupply to reboot.
The battery is new, from june this year.Aardal87 wrote:
I have just re installed the system. and the problem continues.
I guess ur solution isnt worth trying on a fresh system install?
It will not do any harm trying it but you are probably correct in these circumstances.
If the symptoms are consistent, then a savvy technician at an Apple store genius bar should be able to define the problem.
Ciao. -
My computer MacBook pro want turn on it started when input the lion ultimate versión it straus in the white screen with the Apple and the circle ten it goes off
Try starting your computer by holding down the command + R keys, then run disk utility on your hard drive to verify/repair it. Take a look at his link, http://support.apple.com/kb/HT1782
-
Phone won't charge when I plug it in. Anyone else with this issue?
Not sure if this has anything to do with the new download, but Thursday I downloaded the '08 updates (yeah...I am slow getting to it), anyway... while I was downloading the updates, my phone of course was charging from the computer. After the download was finished I turned my phone off and plugged the phone into the wall charger. Charged fine... well last night (Saturday) I had to recharge my phone, but once I connected my phone to the wall charger it would not respond and/or start charging. Tried to plug it into the computer and it said my USB port was overloaded. I was ticked... needless to say I tried again this morning with no luck. Left my phone off for a few hours still nothing. Called tech. support and the guy asked me to try it again on the computer and read what the error said to him.....low and behold it started charging... on the pc and then on the wall charger. I have no idea why it started to work. I was happy it did, but has anyone else had this issue?
Odd problem, but there are all kinds of problems with the wall chargers. If you want a new one, make an appointment with your local Genius Bar at the apple store, bring in your misfunctioning one, and they will swap it out for a new one. They do this routinely for charging bricks, sync cords, and headphones.
-
My MacBook Pro screen turns off when I open the lid!
This has been driving me nuts, and also apparently Apple as well.
When my MacBook Pro is connected to a power adapter, if I close the lid it sleeps like a good little Mac. When I open the lid, the display comes on instantly. Then after about a second, it goes black. The LED backlight turns off. I can get it to come on using either of two ways: 1) touch either of the brightness buttons, or 2) remove and replace the power connector.
Now, here is the weird part: it only seems to do it when I am logged in as me. If I login as guest, it doesn't happen. That would seem to imply it is something about my profile that causes it to happen. So I whacked ~/Library/Preferences and it still happened. So where is this particular bit of nastiness hiding?OK, so I think I solved my issue. It was caused by the system not going to sleep (The screensaver thing was a dead end).
When I ran the console app pmset, I got something like this:
➜ ~ pmset -g assertions
12-06-29 9:11:06 AM EDT
Assertion status system-wide:
PreventUserIdleDisplaySleep 0
CPUBoundAssertion 0
DisableInflow 0
ChargeInhibit 0
PreventSystemSleep 1
PreventUserIdleSystemSleep 0
ExternalMedia 0
DisableLowPowerBatteryWarnings 0
EnableIdleSleep 1
NoRealPowerSources_debug 0
UserIsActive 0
ApplePushServiceTask 0
The process that was causing PreventSystemSleep to be 1 was "org.cups.cupsd" which is the print service. So I checked all my printers, one of them was "In Use". When I opened it, there weren't any jobs listed. I went through the options and selected Jobs > Show Everyone's Jobs and sure enough there was a job there. I deleted it and everything seems to work now.
The odd thing is that print job was probably from my other account which didn't seem to have this screen problem. Anyway, I hope this helps anyone out there.... -
I just purchased a Macbook Pro. When I sign into Netflix and open a movie I get a Digital Rights Management Error (error N8151) screen. restarting the browser does not solve the problem.
Shootist007 It has to do with the first reply to the OP's question, and Joseph Albanese2, that referenced article has to do with "hackintosh's". scratch66 - what web browser are you using?
-
My 2 year old 13" MacbookPro suddenly turned off, presumably when the screen automatically dimmed (or went to sleep?) and now it won't turn back on. It was at 96% charge and now when I use the battery checker on the side, nothing shows up. No lights or anything. The charger doesn't seem to work either even after trying it on different outlets. This has never happened before but it has been harder to wake it from sleep in the last 6 months or so. I would have to push the On/Off button for a sec and the screen would turn back on. Also when I turn it on, the password screen is sometimes off-centered..weird.
I'm using Yosemite, the latest version..not sure what it is and can't check right now...I had to go use a PC to ask this question >_<Try a SMC reset:
http://support.apple.com/en-us/HT201295
If no success, make an appointment at an Apple store genius bar for a FREE evaluation.
Ciao -
My macbook pro doesnt turn on when i push the power button
I was working on my mac the other day and as usual shut it down when i was done. A couple hours later i wanted to turn it on again to check my emails and it didnt start up when i pushed the power buttin. i light on the lid lock bottun lights up but it does nothing else. Battery is fully charged so i don't understand why it refuses to turn on... HELP please?
Portables that will not Power on.
http://support.apple.com/kb/TS1365
Go step by step.
Note: Steps 5 and 6
Step5
Reset SMC. http://support.apple.com/kb/HT3964
Choose the method for:
"Resetting SMC on portables with a battery you should not remove on your own".
Reset SMC, hold the keys down for 20 seconds or more.
Keep it charging for 2 hours or more.
Best. -
I did a clean reinstall on my Mac Book Pro and in the process I lost my Espon print drivers. I went to th eEspon site and downloaded what was needed. I installed per instructions. I was told to reboot, but all I got was a blank blue screen. I shut down the computer again all got was a blank blue screen. What should I do> How can circumvent the usual satrtup procedure.
Tom AckerlyStart up in Safe Mode.
http://support.apple.com/kb/HT1455
Best. -
Getting intermittent connection, anyone else experiencing same issue?
I am getting intermittent connection with my 3gs where i can get speed of up to 800 kps then nothing. I have soft reset the phone already, put a new sim card.
I never had that problem with my previous 3g iphone.
I am around philadelphia area.I would ring ATT and check for network problems. Sounds like it's a network problem. Not phone or sim. > paulkhon wrote:
I am getting intermittent connection with my 3gs where i can get speed of up to 800 kps then nothing. I have soft reset the phone already, put a new sim card.
I never had that problem with my previous 3g iphone.
I am around philadelphia area. -
How do I get a newly purchased Macbook Pro to turn on - all I get is a blinking folder with "?" on a gray screen?
Take it back where it was purchased. Include all packaging and take your dated receipt. You can request an exchange or your money back within the first 14 days from date of purchase. Don't delay.
-
My 13" macbook pro 2011 overheating anyone with same issue?
my 13" macbook pro 2011 turn hot when i open windows (boot camp) and also using microsoft word on mac os x, why this issue happen? anyone with same issue?
try smcfancontrol.its a good program controling the temp of computer if you set the speed of fan to a high value.
you know,the temp increases a lot when you are watching movies or doing work like data base or office work,due to high usage of processor.
Maybe you are looking for
-
Is it wise to keep the Nikon camera files "DSC's" after downloading them and converting to DNG files via Adobe converter for lightroom use. In other words do the DNG files have all the raw data I would ever need in processing or should I save the ca
-
I'm hoping that some kind soul will take pity on me before I tear the last remaining strands of hair from my head. I've read lots of posts on this very helpful forum and have tried various things, but am now so confused that I think I need to try and
-
Listing Employee Education and Language Information.
I'm writing a web application that uses PS to modify employee information, specifically their education and language information. Basically, I'm using a JpmPersonProfile object to get a JpmPersonProfileJpmJpCatTypeJpmJpCritmVwCollection object. Unles
-
I have a 5508 deployed, what I'm trying to do is configure it so that it can be accessed with AD credentials, I'm not talking about accessing the wifi network, I'm talking about logging onto the controller itself for management purposes. We havea fe
-
Best settings for Flash output PREL 8
Hi all, I apologize if this is a repeat question, but I've spent a couple of hours already today trying to find the answer and to no avail. Here's what's happening: once completed, my creative agency sends me the file (mov format...details below) and