MacBook Pro turns off when mega-safe adapter is removed

Question

Hello,
I just installed a new battery, however, battey health condition seems normal but my macbook pro turns off whenever  i remove the mega-safe adapter. I also noticed that even though the battery says 100% charged, the fully-charged green indicator does not come on. Below is the system information.
HELP!!!
Battery Information:
  Model Information:
  Serial Number:    W0*****3LC
  Manufacturer:    SMP
  Device Name:    bq20z451
  Pack Lot Code:    0
  PCB Lot Code:    0
  Firmware Version:    201
  Hardware Revision:    000a
  Cell Revision:    165
  Charge Information:
  Charge Remaining (mAh):    5568
  Fully Charged:    Yes
  Charging:    No
  Full Charge Capacity (mAh):    5568
  Health Information:
  Cycle Count:    3
  Condition:    Normal
  Battery Installed:    Yes
  Amperage (mA):    8
  Voltage (mV):    12580
System Power Settings:
  AC Power:
  System Sleep Timer (Minutes):    10
  Disk Sleep Timer (Minutes):    10
  Display Sleep Timer (Minutes):    10
  Wake on AC Change:    No
  Wake on Clamshell Open:    Yes
  Wake on LAN:    Yes
  AutoPowerOff Delay:    14400
  AutoPowerOff Enabled:    1
  Current Power Source:    Yes
  Display Sleep Uses Dim:    Yes
  PrioritizeNetworkReachabilityOverSleep:    0
  Standby Delay:    4200
  Standby Enabled:    0
  Battery Power:
  System Sleep Timer (Minutes):    15
  Disk Sleep Timer (Minutes):    10
  Display Sleep Timer (Minutes):    15
  Wake on AC Change:    No
  Wake on Clamshell Open:    Yes
  AutoPowerOff Delay:    14400
  AutoPowerOff Enabled:    1
  Display Sleep Uses Dim:    Yes
  Reduce Brightness:    Yes
  Standby Delay:    4200
  Standby Enabled:    0
Hardware Configuration:
  UPS Installed:    No
AC Charger Information:
  Connected:    Yes
  ID:    0x0100
  Wattage (W):    60
  Revision:    0x0000
  Family:    0x00ba
  Serial Number:    0x00eee1de
  Charging:    No
<Edited by Host>

Answer 1

olacurrency wrote:
error code: 4SNS/40000000: IPBR-9.165
This is a current sensor on the power bus. This seems consistent with your symptoms.
A faulty sensor on the logic board means  the board has to be replaced,  take in for repair:
Genius reservation http://www.apple.com/retail/geniusbar/
on-line https://getsupport.apple.com/GetproductgroupList.action
check warranty https://selfsolve.apple.com/agreementWarrantyDynamic.do