MACFLAP_NOTIF through AIR-AP1310G

Hello guys!
I kindly ask for your help in order to resolve an issue. I have a switch WS-C3650 that is sending a MACFLAP log that come from wireless hosts in three of its interfaces:
Jun 27 14:12:31.519: %SW_MATM-4-MACFLAP_NOTIF: Host 3cd0.f82c.f35c in vlan 27 is flapping between port Gi1/0/10 and port Gi1/1/1
Jun 27 14:19:53.841: %SW_MATM-4-MACFLAP_NOTIF: Host f8f1.b612.ac7d in vlan 27 is flapping between port Gi1/1/1 and port Gi1/0/10
Jun 27 14:30:03.286: %SW_MATM-4-MACFLAP_NOTIF: Host e899.c47f.d55e in vlan 27 is flapping between port Gi1/0/8 and port Gi1/0/10
In Gi1/0/8 and Gi1/0/10 I have 2 AIR-AP1310G with VLAN 27 as data VLAN and NATIVE VLAN at the same time, and they are connected to the switch through an access port. The switch has NATIVE VLAN 99.
The Gi1/1/1 is a trunk port connected to a Core switch.
My question is: is it correct to have the same number in NATIVE VLAN and in DATA VLAN in my Access-Points?
The next config is in both access-points:
interface Dot11Radio0.27
encapsulation dot1Q 27 native
no ip route-cache
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
interface FastEthernet0.27
encapsulation dot1Q 27 native
no ip route-cache
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
Thank you very much!
Best regards!
Iván

To prevent loop issues, we recommend that you do not connect two MAPs to each other over their Ethernet ports, unless they are configured as trunk ports on different native VLANs, and each is connected to a similarly configured switch.

Similar Messages

Can't open/use excel file. Tried sheet to go xls, even through air browser, it just says loading, and never opens.

Tried sheet to go xls, even through air browser, it just says loading, and never opens. The file works fine on my laptop. Am I doing something wrong?
Here is a link where I'm attempting to use the excel files from.
http://residential.climatemaster.com/dealers_area/tools.html
At the bottom of the left hand column there is a few xls. files. I'm attempting to use the pressure drop calculator and sales proposal.
Please let me know if there is a way to use these on my Playbook.
Thanks

Slaes proposal opened for me. The pressure drop one did not open on playbook but did open on my torch 9860
Hope Tuesdays update will allow it to he open.
Click here to Backup the data on your BlackBerry Device! It's important, and FREE!
Click "Accept as Solution" if your problem is solved. To give thanks, click thumbs up
Click to search the Knowledge Base at BTSC and click to Read The Fabulous Manuals
BESAdmin's, please make a signature with your BES environment info.
SIM Free BlackBerry Unlocking FAQ
Follow me on Twitter @knottyrope
Want to thank me? Buy my KnottyRope App here
BES 12 and BES 5.0.4 with Exchange 2010 and SQL 2012 Hyper V

Help me, I am using flash pro cc and air 4.0,i have one problem when publishing apk through air publish settings,choosing the run time option from third party is disabled.can any one help me bcoz i have to publish without air runtime.......

Help me, I am using flash pro cc and air 4.0,i have one problem when publishing apk through air publish settings,choosing the run time option from third party is disabled.
can any one help me bcoz i have to publish without air runtime.......

Hi,
This option is available when your publish target is set to AIR 3.6.
You can download the desired AIR SDK version from Archived Adobe AIR SDK versions
Thanks!
Mohan

Duplicate iPad screen on HDTV through air play

How do I duplicate iPad screen on HDTV through air play?

You need an iPad 2 or 3 (new iPad).
The iPad 1 only allows basic Airplay.
The iPad needs to be on the same network as the AppleTV.
Airplay needs to be enabled (or not disabled) in AppleTV settings.
On iPad, press the Home button twice, swipe to the leftmost screen where if AppleTv is detected you should have an Airplay option and a slider to turn on mirroring. If you have a compatible ipad and don't see this try rebooting all devices and your router.
AC

I start internet sharing through air port but the arrow in the desktop tool bar doesnt show up. doesnt appear

I start internet sharing through air port but the arrow in the desktop tool bar doesnt show up.

i figured it out through another persons post thanks anyway.

HT204291 I only get sound and no picture from my tv when playing sky sports through Air play , any help ?

I only get sound and no picture when playing sky sports through my air play , Help ?

apps can choose to block mirror
try restarting wifi router, ipad and appletv and try again if it still don't work maybe the app is blocking mirror

HT5887 Can you share pictures (or anything really that can be sent through air drop) from one device to another with the same iCloud?

I'm trying to send photos from my laptop (Macbook Pro 13") that aren't in my iphoto, to my iPod Touch 5g via airdrop, but when i know i have the bluetooth and airdrop turned on, neither show up on either device. They're both signed into the same icloud (and apple id). The other solutions I thought of are emailing them... over a hundred, five 1080x1920 (or something like that) pictures per email, and then take the time to save each one, send them through iphoto (which i'm sure costs a few dollars in the app store, or send them through another internet based app (like dropbox).
Are photos (and documents and stuff) able to send through airdrop if the two devices are logged into the same icloud? -thanks

- AirDrop only work between iOS devices and between later Mac omputer, Not between an iOS device and a Mac computer. Do not ask why.
- Transfer them using PhotoStream
http://www.macworld.com/article/2047670/up-and-running-with-photo-stream.html
iCloud: Photo Stream FAQ

How to connect to pioneer vsx42 through air play

Has anyone here used airplay through a pioneer receiver? I just purchased vsx42 Elite and I can't figure out how to get it working. I have both the iPad and the pioneer on the same network. Any thoughts would be appreciated.

you can only connect your iPhone 4S and iPad2 for the purpose of tethering your iPhone's internet connection to the iPad. Any other connection is not supported.

Playing music through Air Tunes using Windows Media Player

Hello to all.
I am planning on buying the Air Port Express so I can play music wirelessly from my Dell. The only problem I have with is that I can't use the keyboard media buttons (play/pause, stop, next, previous) with iTunes. These buttons work with Windows Media Player, so I was hoping that I could use WMP instead of iTunes. Can this work? Or, is there a way to make the buttons work with iTunes?
Thanks a ton.

Don't know about doing this in windows, but on a Mac you can re-map the keys for those commands to different keys on the keyboard. Or perhaps it would be better to say that you can map ADDITIONAL keys to those commands. There should be something to allow you to do the same thing in Windows.
Good luck!
Doc

SMS through air app

Hi,
I am a newbie in Adobe Air and I am trying to develop a desktop application in adobe air for sending sms in India. Would appreciate any help.

You might do better asking in the correct forum. Please see the sticky topic at http://forums.adobe.com/community/robohelp/airhelp
See www.grainge.org for RoboHelp and Authoring tips
@petergrainge

Executing a java app through AIR

Ok, I have command, which when I execute in a CMD, it runs fine:
"jre/bin/java" -DSTOP.PORT=8887 -DSTOP.KEY=worx -Xms256M -Xmx512M -jar lib/start.jar
any ideas on how to execute this in AIR ?
thank you,
Giorgoc

Try giving absolute path for the jre. for e.g. C:/Program Files/Java/jre

Does Mainstage work through Air Play? Can't hear any output through my Apple TV.

I've selected AirPlay as both my system and Mainstage audio outputs but can't hear anything coming through my Apple TV. All other computer audio output works through the ATV, and Mainstage is unmuted and works fine through the Built-In System output. As I soon as I switch to AirPlay in Mainstage, there is no audio coming out, although output IS showing up on the Master out channel in MS.

I had this same problem when I tried it - No output from the AirPlay even though the display was shwing up and the output device was "Apple TV" in fact if I went to the sound preference panel and attempted to increase the volume, the AirPlay did play the beeps that preference panel emitted. I called Apple support and they were unsure ar first that this capability is even supported. They had me try to reproduce the problem with a new user account. In my case MainStage did work with the Apple TV under the new account. So, they recommended that I quit MainStage, then delete the MainStage-related plist file in my home directory's library/preferences/ folder:
/Users/{username}/Library/Preferences/com.apple.mainstage.plist
After deleting this file, I relaunched MainStage and was able to get the Mainstage output on the ausio system attached to the airport. The delay encoundered is excessive - unsuitable for live performance for me, possibly dud to the fact that I am using an 802.11g wireless connection rather the faster 802.11.n connection. It works fine otherwise.

Access serial port through AIR

isnt there any extensions or API buit for accessing serial
port from AIR.
i am designing a vending machile applicaton in which a coin
drop is detected and corresponding images or message is displayed.
MDM Zinc 3.0 allows serial port access but worths more than
what it deserves. does AIR has some similar functionality.
Any help.

I'm not too hot on this subject, but would it not be possible
to use Binary Sockets to connect to another app on the machine that
could connect to a serial port?

Iphone 3 and 4 can't connect with wireless through air port

We purchased a new Time Capsule yesterday to replace one that stopped working. We have been able to get the Air Port/network working for our Mac Books and iPads, but cannot access the wireless network on our iPhones (a 3 and a 4). The wireless connection function on the phones show the network and shows a check mark next to the network, but does not switch to the wireless network from 3G. We tried to 'forget the network' and sign in again, making sure we are on the WPA2. Any other suggestions? Tami

I had this happen to me yesterday. I have a AirPort Extreme and my iPhone was unable to connect to the wireless network.
I tried everything from resetting the network settings on my iPhone, Hardbooting the iPhone, and even changing the wireless password on my Wireless network and restarting the AirPort Extreme. Nothing worked.
However here is my solution:
Hardware restart. I just unplugged the AE waited about 20 seconds and plugged it back in. When it came back up ...My iPhone was able to connect to the network.

HT4623 my iphone 4 needs rebooting after trying to update through air, but i dont have access to itunes. Is there any manual way to do this?

my iphone 4 stop working after trying toupdate, how can i reboot without itunes?

If you mean it's in recovery mode, no. There is no way around it. It must be restored using a computer running iTunes.

MACFLAP_NOTIF through AIR-AP1310G

Similar Messages

Maybe you are looking for