Making a vlan for all wireless devices on network
Hello,
We connected 4 wireless access points (AP541N-E-K9) to an SG300-10P switch.
We want to be sure that no wireless clients can alter settings to the network by connecting to any of the networking devices. We also want that no wireless devices (except a few) can connect to computers that are on the wired network.
I'm new to configuring networking devices so I would appreciate a step by step guidance to set up the switch for this.
We already added all the MAC-adresses of all the wireless devices (that are allowed to use the wireless network) to the access points.
Thanks already for your reply.
Wim
Wim,
Look in the administration guide and their are step by step on how to create vlans -page 178
http://www.cisco.com/en/US/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/78-19308-01.pdf
After attempting to configure the switch and run into problems you can give us a call @ 1-866-606-1866 and open a support case
Jasbrayn
Similar Messages
-
My Ipad 1, for no apparent reason, no longer connects to the Internet. Our home wireless connection is working for all other devices.Any clues?
You can also try to reset your network settings on the iPad. Go to Setings>General>Reset>Reset Network Settings.
Good Luck! -
I have an Airport Extreme as my router and am using time capsule to extend the network in my new house. My ISP is only providing me 4-5 ip addresses and wants me to set up my router to issue out new ip addresses for all my devices.How do I fix this?Help.
They said I need to change my settings to NAT settings. I haven't been able to figure out or find anything. I have also spoken to Apple Support on the phone for hours without being able to figure out how to do this ( i don't think he knew much either lol.) Please help me because I've got about 15-20 devices in my house that require to be connected to the internet and this is just making things ridiculously slow and painful for me.
Thanks!It is on DHCP & NAT under router mode yet my isp is still the one issuing ip addresses to my devices instead of the router issuing them
-
Helpful Tips for all iOS Devices!
Here's the link for helpful stuff, including news and tips for all iOS devices!
El LINKOThank you,
Then, when you have to create an iphone+ipad app joined, have you only possibility to create Multifolio app type?
Then, can you only see some multifolio options like the Android app (next link)?
http://wwwimages.adobe.com/www.adobe.com/content/dam/Adobe/en/devnet/digitalpublishingsuit e/articles/making-and-deploying-android-dps-viewers/fig03.jpg
So, with iPad+iPhone apps, the iPad version would be multifolio app too, that is right?
And are these apps (iPad+iPhone) multifolio (next link)?
http://wwwimages.adobe.com/www.adobe.com/content/dam/Adobe/en/devnet/digitalpublishingsuit e/articles/making-and-deploying-android-dps-viewers/fig10.jpg
can I only create single folio for iPads when I have iPad app alone?
Thanks a lot for you information, -
i have 3 different itunes accounts and would like to combine them into just one for all my devices, a macbook pro, an iphone 4S, an older IPOD, and a ver sion one Ipad. how can i do this on all devices ?
i had one for a long time, then when i got the ipad i didn't realize they would all still work under one so i set up the second one on that
then when i got the new iphone i put in the info for the first and main one from my mac pro and it would not work at all, and i knew it was right, then it asked me to create a new one or i couldnt finish the setup
hence why i have 3 now
hard to believe you cannot combine into one
oh well, i will just make them all accessible for all 3
thanks -
I have 2 iphones, 1 personal and 1 business. I thought I was supposed to have 2 separate itunes accounts. I now have a work ipad and want to only have 1 itunes account that I can use for all 3 devices. How do I cancel 1 account or just combine the 2?
I want to be able to transfer my apps from my original itunes account that I have on my personal iphone 3 and work ipad 3 to my work iphone 4S ,as well as purchase more more apps for the work iphone with the original itunes account. Plus I need to sync all 3 of them with my work tower computer. I really appreciate you're trying to help me out.
-
I use the same apple ID for all my devices, 2 iphones, 2 itouch, 1 macbook pro, 2 ipads. Becuse I have small children, can I change that and still, have control, and don´t need to buy the same things serveral times.
It is something I would avoid if possible. I would want to educate my children to think possessively and therefore of security. Yes, I know you are all family but at the end of the day you wouldn't want your children to be blaming each other for any problems that arise. Well, that's how I see it, for what it is worth.
-
For home sharing do you have to use one apple ID? Im trying to make my own new account for all my devices (iphone, ipad, mac) , but i still want the music from my dads account.
For home sharing do you have to use one apple ID? Im trying to make my own new account for all my devices (iphone, ipad, mac) , but i still want the music from my dads account.
-
Greetings: I have multiple iPads and iPhones. I want all to be able to be able to stream to our Apple TV. All of the docs I see say you must have the same Apple ID for all the devices, but we each have our own Apple ID. Is this just a doc short coming?
You can each have your own ID for your own iTunes accounts, but in order for a device to stream via AirPlay to the same Apple TV, everything must use the same homesharing ID. This is not the same as your iTunes account ID (although it can be for one of the devices)
-
My IPad 2 external speaker does not work and the original headphones have popping sound when used. This all occurred at the same time as my IPhone and IPod headphones only plays mono (and no, the "mono" option is not on) with the original headphones, as well as, other headphones tested. How can there be audio issue for all these devices at the same time?
As you may have noted from the list of Apple devices I own, I believed in the Apple and the products it was producing; but it is hard to believe from my experience and the other voices within the Apple Community that we are all experiencing the same hardware issues. Especially since I recently, I upgraded to an IPhone 4g (no, my faith in IPhone 5 series is very little) and is experiencing the same audio problem as described above. So now, I am off to the Apple store again to be told that it’s a hardware problem on new IPhone. Really? Apple, what happen to the pride in the product you were producing?Everyone does things a little differently. I love to "jam " along with iTunes ( or old Lp's) . Always have. That's where/how I've learned to play .
I'm sure leonieDF is giving a proper way to jam along on a keyboard with an iTune. He blows my mind all the time with what he knows. Nuff respects to him !
What I do is make a GB project I call "Jam With". I'll make several new tracks that are blank. Just has a few instruments named in the blank tracks. You can change those per song ...
Because I'm not concerned about changing the pitch / key.... of the iTune or the tempo ... I can simply play along with it.
Peace,
P. Dreadie -
I just set up the airport wireless modem - with a comcast internet router - all wireless device connect seemlessly (3 Iphones, Mac Air, and a Sony Laptop) but my IPAD 1 no longer connects. It tries to but never connects. I have reset it and have airprot utility app downloaded on my IPAD - it shows the modem and the internet no connected?
Do you mean an Airport Extreme Base Station connected to a Comcast Modem?
-
I have different icloud and iTunes id's and I want to do homesharing for all my devices. I'm trying to set up a new iMac but homesharing is not working. Should it be the itunes or iCloud id?
Welcome to the Apple Community.
Preferably your iTunes account, but it shouldn't really matter for getting homesharing turned on, as long as it's a valid ID. -
trying to hook up preowned airpoirt extreme. asking for password for selected wireless device. would there be a password from previous owner?
A "hard reset" will do the same thing.
Make sure that the AirPort Extreme is powered on
Hold in the reset button for a few seconds and the amber light will begin to blink more quickly. Keep holding the reset button when you see this for another 4-5 seconds and release
Allow 25-30 seconds for the AirPort Extreme to restart to a slow, blinking amber light
Open Macintosh HD > Applications > Utilities > AirPort Utility and click Continue to follow the guided setup -
Download drivers for all the devices
I have installed Win 2008 R2 using Bootcamp, I found the windows device manager showing generic microsoft drivers been used for display and also there are unrecognized devices.
I am using iMac 27".
Where can I download device drivers for all the devices? I assume Windows 7 64bit drivers must be compatible for Win 2008.
Thanks.I am not an expert on all devices but I can tell you that while you can use a single username/password to access all devices you can't have a "generic" set of rules. AAA services operate different based on the model/platform. For example, the ASAs, WLCs and Nexus devices are completely different when compared to the standard IOS routers and switches. For this this situation (read-only ASDM) you should check this useful post:
https://supportforums.cisco.com/message/853437
Thank you for rating! -
If I buy iWork, will that include Pages, Numbers and Keynote for all my Devices?
If I buy iWork, will that include Pages, Numbers and Keynote for all my Devices?
It seems like purchasing Pages, Numbers and Keynote Seperately for my Mac Computers and then again for my iOS 5 Devices ads up to about $100, though iWork costs more as a whole, what would be the key advantages in purchasing iWork not from the app store?
If i do purchase iWork not from the app store, will it still be available on all my Devices?
-iPhone
-iPad
-MacbookElliotDG wrote:
my question was whether buying iWork from the apple store would defuse this restriction and make it available on all my devices
No.
Maybe you are looking for
-
Receiver determination Condition. XPATH suggestion
Hi All, I got a condition to put in receiver determination like.. Condition 1 --> System_A //ZORDER03/IDOC/E1EDKA1(PARVW='LF')/ILNNR = SA AND //ZORDER03/IDOC/E1EDKA1(PARVW='LF')/PARTN = 0000050570 AND //ZORDER03/IDOC/E1EDKA1(PARVW='WE')/LI
-
What is the best way to import a series of still images?
I'm trying to import a series of 300 PNG images into an existing FCP project. I've gotten the stills imported into FCP but when I place them into the timeline they are setup to be 10 seconds long and then if I change them all to 1 frame they are spre
-
Formatting pivot tables (obiee 11g)
Hi, I'm trying to find good ways to format pivot table results in 11g. Can someone help answer the following questions? Note that I'm putting the "measures" label into the row position, which allows me to format measures differently from each other.
-
Just need some simple stats :)
I've been using Microsoft's "Excel Lite" program for a few years. I don't even know what it's called, but its performance is more limited than Excel, which I've never used. I've never used a mathematical formula in a spreadsheet. All I do is insert d
-
How to configure third party outlook in outlook
Dear Experts, I am trying to integrate Outlook into my portal. ihave been through many of the documents and they refer to url as below: http://<server_hostname>:<port>/Exchange/<User.UserID>/Calendar/?cmd=contents but my client is using third party O