Manual Inspection Lot and Material Document

Question

Dear All,
I created a manual inspection lot using inspection type 89. i wanted to make a relationship between my GRN material document and the Manual inspection lot. Is there a way to link these two. Even in the table level is there a relationship between these two?
Regards,
DTD

Answer 1

>
TMDTDSL wrote:
>PO - 470000565
> LI 10 - Material 1000157  Qty - 100 - Sales Order 60156 - Batch X123
> LI 20 - Material 1000157  Qty -   60 - Sales Order 60157 - Batch X123 
>
> If i assign inspection type 01 for the above mentioned material two inspection lots will be created with the same batch number. What i want to do is in RR combine these two and record results for one inspection lot. By using inspection type 89 even though i can create one inspection lot combing those two, SO reference (Mat Doc reference) is not there. What you suggested is good but once i create a manual inspection lot the way you explained how do i keep the relationship to the automatic generated inspection lot. If you could explain little bit further really appreciate.
Your understanding is correct here. For above two lot if you batch number X123 then simply assign this batch number X123 to manually created lot with type 89, this way you can map all three lot with batch number.
If you want to enter SO in manually created lot for information or reference then assign this SO at field short text in QA01 (technical name - QALS-KTEXTLOS)
FYI - For 89 lot you can do RR & UD for record but this lot would be not stock relevant.
Hope this helps.
Thanks!!!