MBP powering off unexpectedly when running on mains power

I have an early 2006 MBP 15". For the past few weeks it has been powering off unexpectedly while running on mains power. If I take the battery out and continue on mains power there is no problem.
I replaced the battery with a new one but I still have the same problem with running on mains power, battery installed and powering off unexpectedly. This happens about 5 minutes after powering up.
Has anyone got any ideas what might be causing this?
Thanks.

Hello J.C Thanks for your response. I tried resetting the SMC but the problem still occurred. With some further investigation I have narrowed it down to a USB accessory. Either mouse, keyboard or iPhone docking station.
Seems weird that the problem didn't occur when the battery was taken out but still running on mains power.

Similar Messages

  • MBP Powers Off Without warning - on battery

    Similar to earlier post, but happens anywhere after 70%. MBP powers off. No warning or anything.
    Have changed battery. We had the logic board swapped out as well. And it's started to happen again. Any suggestions? He's on 10.5.2 now, only difference from when it didn't happen.

    Quite likely still the battery, depending on when it was replaced. Some users (e.g. Retired Engineer, who you'll see among the Top Users list for this forum) have reported getting four successive battery replacements under the replacement program.
    Hope this helps...

  • MBP shuts down unexpectedly when on battery

    Today my MBP shuts down unexpectedly when on battery. It started at about 50%. I seems to happen if I don't a thing for a short while when I read something or so. I most of the time when using mu MBP have it on the net cord but today I wanted to work the battery.
    Does anyone know what it could be? I have searched in the forum but the answers hasn't been satisfying. I find it weird that I have to use the keyboard or the track pad to keep going.

    Not sure what the cause is but you can try resetting the SMC.
    Intel-based Macs: Resetting the System Management Controller (SMC)
    See: 
    Resetting the System Management Controller (SMC) - Battery information

  • Whilst using my laptop it powered off unexpectedly and won't come back on. Ive tried connecting it to the powere adaptor but it's not charging Nd is still off. Battery was fully charged before it went off

    Whilst using my laptop it powered off unexpectedly and won't come back on. Ive tried connecting it to the powere adaptor but it's not charging Nd is still off. Battery was fully charged before it went off. Please what can I do?

    Try resetting the  SMC http://support.apple.com/kb/ht3964
    Try resetting NVRAM/PRAM http://support.apple.com/kb/ht1379

  • T410 laptop turns off abruptly when running any application

    Hi,
    T410 laptop turns off abruptly when running any application. I contacted the technical support, first they suggested me to run some diagnostics for hard disk which failed and so they sent me a new hard disk. Even then I faced the same problem. Again I contacted them and they told that they will change the system board. Today I received the laptop with new system board/updated BIOS.
    But still I am facing the same problem. I called the technical support again, they told me to use the latop in two modes ( 1. only battery and 2. only ac adapter) and check whether its happening again or ont. In both the cases I am seeing the same problem.  
    Laptop is only 5 months old and bought for  $1400........ 
    SOmebody help me........
     type:  2516 -CTO
    S/N:  xxxxxxx 10/03
    Thanks,
    Kobi
    Moderator Note; s/n edited for members own protection

    Hi and welcome to the forum!
    Tell us something more about your system, like installed memory size, processor speed, graphics card make and size, HDD size and so forth. Because yours is CTO model hence it's not possible to figure out these things without your telling us about them.
    I'm not very expert but I would say it's probably the RAM since system board and HDD have already been replaced or possibly you have got a lemon. But try following suggestions first.
    Do you get any sort of error message or Bluescreen? does Event Viewer report something unusual? Event Viewer can be opened by typing it's name in the search field in Windows 7. If you get Bluecreen you can view it via this program:- http://www.nirsoft.net/utils/blue_screen_view.html and let us know what it says.
    Also, make a bootable CD of mem86 and run the test on your RAM, mem86 can be downloaded free from:- http://www.memtest86.com/
    Lastly, you can burn LiveCD of any Linux distro and boot from it, if applications work fine in Linux environment then probably it's some software problem your thinkpad is having, re-imaging the system to factory state would be great initiative in that case.
    Keep us posted!
    Maliha (I don't work for lenovo)
    ThinkPads:- T400[Win 7], T60[Win 7], IBM 240[Win XP]
    IdeaPad: U350
    Apple:- Macbook Air [Snow Leopard]
    Did someone help you today? Compliment them with a Kudos!
    Was your question answered today? Mark it as an Accepted Solution! 
      Lenovo Deutsche Community     Lenovo Comunidad en Español 
    Visit my YouTube Channel

  • Screen goes dim when processor working - even when plugged to mains power.

    Screen goes dim when processor working - even when plugged to mains power.
    Whether I'm running 3D software or just surfing the net, the screen keeping fading/dimming and then recovering over a few seconds. No USB devices connected, mains power on - NOT IMPRESSED!
    Any ideas - a hardware problem? Back to Mac?

    If you go to System Preferences > Energy Saver, the is a checkbox under the "options" tab that says, "Automatically reduce the brightness of the display before display sleep." On my new MBP (10.5.1), this was "on" by default. Try unchecking it and see if it helps.

  • Satellite A500 - Battery light flashes when connected to mains power

    Win 7 Satellite A500 PSAM3A-03P00E.
    The battery light flashes when connected to mains power (intermittent fault), when I unplug mains and re-connect flashing stops and battery (high capacity) continues to charge.
    Also when battery light flashes the key board back lighting stays on when it should blank out and if the back lighting is off and the battery light starts flashing the key board back lighting doesn't turn on, all other functions seem to work fine.
    The battery charges and holds charge as it should (when light flashes battery doesn't charge).

    Hi
    Did you notice this issue from first day of purchase?
    Theoretically it could be possible that your battery starts to malfunction
    At the other hand an electronic issue might be possible too
    However, try this:
    Remove ac adaptor and battery. Then press and hold power buttons 30 sec long.
    Then insert the battery and connect AC adaptor again does it helps?
    By the way: is BIOS up to date? If not, perform an update.

  • My Macbook pro randomly shut off. When i hit the power button, i can hear it start up, but after a click sound, it stops booting up.  help?

    My Macbook pro randomly shut off. When i hit the power button, i can hear it start up, but after a click sound, it stops booting up.  help?

    Hi..
    Try Resetting the System Management Controller (SMC)
    If that doesn't help, try Troubleshooting MagSafe adapters
    When you post, please tell us which Mac OS X you have installed. Thanks 

  • My iPhone 4 won't switch off. When I press the power button at the top, the phone doesn't respond. Please help!

    My iPhone 4 won't switch off. When I press the power button at the top, the phone doesn't respond. Please help!

    Try a reset

  • MBP shuts down suddenly when running in battery mode

    Hi
    I am from Zaragoza (Spain) and lately (about 2 months ago as I can remember) my mbp shuts down when running in battery mode and without any advice. I see some of you also have this problem.
    I thought it was me not seeing the low battery indicator but last week I realized the battery was above 40%!!
    This problem has been repeating and the battery level was between 40% and 60% when my computer shut down.
    What am I supposed to do? My MBP is still in warranty and I bought it in the online apple store.
    Thanks for the help.

    In the system profiler it says the cycle count to 24. The laptop is from late March 2008.
    The battery info is the following:
    Battery Information:
    Model Information:
    Serial Number: Sony-ASMB012-3841-b0b7
    Manufacturer: Sony
    Device name: ASMB012
    Pack Lot Code: 0000
    PCB Lot Code: 0000
    Firmware Version: 0110
    Hardware Revision: 0500
    Cell Revision: 0303
    Charge Information:
    Charge remaining (mAh): 1718
    Fully charged: No
    Charging: No
    Full charge capacity (mAh): 1875
    Health Information:
    Cycle count: 24
    Condition: Check battery
    Battery Installed: Yes
    Amperage (mA): -2133
    Voltage (mV): 11757
    I did the SMC reset, but I cannot complete the Battery Calibration, the laptop shuts down at half charge battery and does not go to sleep mode.
    Thanks for your help.

  • TS3694 Why does my ipod keeps powering off, and when I turned if on, I have to press down the power button and the screen button at the same time ???

    Why does my ipod keeps powering off, when I have to turn it on ... I have to press on the power button and the screen button at the same time ??? over and over again. I just got this in December 2011 as a gift.

    I am having similar 'freezing' problems with many programs (Mail, Safari, iTunes, etc.). I have done a clean install of Lion instead of an upgrade when it came out. Perhaps something went wrong with my install? I'm thinking about wiping and reinstalling.

  • IPhone 4S only powers up, works, when connected to wall power

    Brand new iPhone 4S, arrived two days ago on the model's launch day.  Few glitches, expected w/ new phone, not a big deal, worked through them, initially did restore-type installation to transfer all info from old AT&T iPhone 3GS, still w/ AT&T.  It was working fine.
    Then, connected to wall charger last night.  This morning, before disconnected from wall charger, charge showed 87%, then disconnected and screen went black.
    Phone did not, and does not, respond when unconnected.
    Connected iPhone to MacBook Pro, result is same as when unconnected, no response.
    However, when iPhone connects to wallpower, it works fine.  Powers up, all functions seem to be normal, but noted that charge now shows only 84% and it's not going up, as it should.
    I have been studying these boards today before typing this post.  Have tried the reset procedure (hold down sleep/wake + home buttons simultaneously for 30+ seconds) when iPhone is unconnected and when iPhone is connected to computer, still unresponsive.  Also tried reset procedure when connected to wall power, it eventually goes into reset mode and it eventually got to the point that it said connect to iTunes, but when I disconnect from wall power and connect to computer, it is again unresponsive.  After doing that, connected to wall power, and it powers up normally.
    With iTunes open and running, the iPhone does not appear therein when connected.  Left iPhone connected to computer all morning, no changes in nonresponsiveness.  Before last night, this was not a problem.
    Before I even starting using this iPhone, I'd put it in a nice, new OtterBox case.  It has not been dropped or mishandled or gotten wet.
    My conclusion is that there's a hardware problem that I cannot fix, and even if I had a clue what to do, I'd probably void the warranty.
    Looking for suggestions as to what to do short of calling AppleCare.  Any help will be most appreciated.

    Called AppleCare this morning, confirmed that this is a hardware problem. Getting replacement.

  • Hizzing / bad sound when running from battery power (Ups)?:

    Why is my computer (Imac) emitting a hizzing sound when running from the UPS (battery)? I am testing a offline UPS type: POWERWARE Eaton Protection Station UPS 500VA 250W. My Imac is suppose to use max 200 watts of electrity (Imac 24 inch. intel 2.8 Ghz, 4 GB memory). When running from AC there is no sound. When testing (pulling out the cord on the UPS the Imac starts emitting a disturbing hizz / sound)???

    I solved it my self. It was OK (no buzz and fuzz) when it was plugged in (when the electicity line was down once and I was running on the UPS battery).....

  • 160gb classic, only working when attached to mains power outlet

    In last 24 hrs my classic has decided to only switch on when plugged into mains outlet. Screen flickers when attached to laptop, had to restart computer to get it to switch on and sync. I have tried restoring to factorysettings before synching tunes back to it. Anyone out there who to can resolve this before I have to pay for repairs?

    Take it to somebody with more experience fixing iPods.

  • PowerBook crashes when running on battery power

    Having problem with a 17" powerbook.
    computer runs fine with AC plug in, but when running without AC, it will freeze or kernal panic when launch any application. Ran disk utility and everything seems to be fine, even with MacTestCD... everything passed (Memory and HDD all passed).
    I did permission repair & diskwarrior... it still crashes without AC...

    MacTestCD? How old is that?
    Never heard of MacTestCD. Who makes it? You should only use a utility made for the operating system in question. Otherwise kernel panics could happen if they attempt to repair things they don't understand.
    Is your data backed up?

Maybe you are looking for

  • How can we change the message type?

    Hello all We use SRM server 5.5 with classic scenario. When we create shopping cart, we implemented the Change Badi to assign the purchasing group from R/3 material master. We implemented the following logic. If material master in R/3 has no purch. G

  • Baseline applications in BPC 7.0 NW version...

    Somewhere in the forum thread I was reading (a response from Jeffrey Holdeman I think) that the initial content of APSHELL has legal application delivered with it. I don't see it in my installation. Is there a way to get access to the Legal Applicati

  • How to export mail to pst ?

    Hi, I would like to know the best way to export my mail from a Mac os X to a pst in order to add to an Outlook on a pc ?

  • Starting BW in 2004s

    In SAP Netweaver Administrator, I went to Deploy and Change tab. There I selected 'Create BW system' - Install It is asking for 1. Http port for ABAP server. 2. ABAP Client. 3. Logon Group. 4. Http port of message server. From where do I get these de

  • Some AAC files won't play in iTunes 10.5

    I am experiencing two problems with some of my AAC files in iTunes: 1. Every time I sync my iPod with my Mac running iTunes 10.5 the following message appears: "Some of the items in the iTunes library, including Revelation, were not copied to the iPo