Microsoft DHCP Server - Option 43 Setup

Question

I have the scope configured properly as far as the 241 Option with Option 43 and the VCI in it for both the 1130 and 1200 series AP's. However, how do you make this work if your subnet has both 1200 and 1130's in it? Basically if I have two 241 options set, the 1130 comes in first allowing hte 1130's to associate, but not the 1200's. If I remove the 1130 Option 241, the 1200's associate. Basically, how do I get both to work from the scope correctly?
Thanks,
Raun

Answer 1

Hi Raun,
Here is some additional info;
This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP server for use with lightweight access points. For other DHCP server implementations, consult the DHCP server documentation for configuring DHCP Option 43. In Option 43, you should use the IP address of the controller management interface.
****Note DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a separate DHCP pool for each access point type.****
From this doc;
http://www.cisco.com/en/US/docs/wireless/access_point/1200/installation/guide/120h_g.html
DHCP OPTION 43 for Lightweight Cisco Aironet Access Points Configuration Example
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00808714fe.shtml#t1
Hope this helps!
Rob