MOVED: z97 gaming 7 motherboard

This topic has been moved to MSI Intel boards.
https://forum-en.msi.com/index.php?topic=250756.0

For back panel audio ports, you can connect Direct Audio Power and turn on the AUD_SW1 switch to get better audio quality 
and the back panel audio jack
the top(or left) three are mic / Line-out / Line-in, if you plug in your headphone realtek manager will also show the the function of which port you plug in...

Similar Messages

  • MOVED: How to use 3tb hhd on Z97 gaming 3 motherboard

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=249337.0

    Hi Philip,
    It’s also a win7 limitation, UEFI GPT supports much higher than 2T
    As the MBR only locates a HD for a maximum range of 2T, the maximum partition and the starting position of last partition should be less than 2T.
    For example, a 4T HD (3.7 available usually), you can divide it as
    1.9 + 1.8T or 1T+0.8T+1.9T.
    It is NG to do 1.3 + 1.2 + 1.2 , because the position of last part begins from
    2.5 T.
    For your consideration

  • MOVED: Z97 Gaming 5 - Updated drivers with MSI live update, crashed - nothing works

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=255291.0

    sounds like along with drivers, you also flashed your BIOS and this failed and caused this issue
    Quote
    I tried to put the MSI Z97 BIOS on a flash drive and reboot with that, but nothing happens. There are no beeps, just the harddrives booting up and then nothing more..
    place your old BIOS version on the USB key not renamed and place the USB key in rear USB ports
    then see if BIOS can be recovered
    else you have to RMA it as there is no dual BIOS solution on it

  • Can a Z97 Gaming 7 motherboard do 0 rpm fans on its BIOS fan curve ?

    Z97 Gaming 7
    Can the CPU and case fan curves be set as low as 0 rpm ?
    I have 0rpm mode PSU & graphics cards.  The dual tower cooler is enough at idle for the CPU.  It would be great to turn the system on without any fans turning on at all until needed.

    Quote from: Nichrome on 11-December-14, 18:30:31
    Nope, 0% is not possible. Even with aftermarket fan controllers, user's manual states that disabling the fan (0%) is possible but at user's responsibility.
    Thanks for the reply.
    1)
    What is the lowest % you can go?
    2)
    Where on the board is the motherboard temp sensor?
    3)
    The manual (page 3-29)  shows a graph of deg C 0-100 and RPM 0 - 7000.  However on the right your markers are displayed as temp/fan % .  My guess is you set the 4 fan markers from the percentages on the right and the 0-7000rpm Y axis scale is purely for the readout of the current fan speed and not related to the markers.  Is this correct?

  • MOVED: Z97 Gaming 7 isn't booting under BIOS A

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=256341.0

    to what bios version live update update it?
    have you done >>Clear CMOS Guide<< with power cord removed?
    can you list full system specs see >>Posting Guide<<
    about bios recovery, boot with working bios, and go to bios setup, then select m-flash, switch your bios chips
    and proceed with recovery

  • MOVED: Z97 Gaming 7 keyboard freezes at BIOs

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=184251.0

    Try to remove OC with >>Clear CMOS Guide<< and see if it works fine then

  • MOVED: Z97 Gaming 7 - bios 1.6 , random SATA drives disappearing

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=183874.0

    Quote from: pandaz on 07-October-14, 16:57:17
    To Kuba..
    1. Could you state clearly what is the original boot sequence of your HDD shown in the bios?
    you mentioned that after you reset from Windows or from DOS then the sequence will changed??   how often will this symptoms happened.
    2. If you only use the Intel SSD 520 + the Normal HDD (remove DVD and the Samsung SSD) , will you see the boot sequence lost issue?
    3. What do you mean by the below??  you can't flash bios 1.5 in DOS mode???  please help explain in details
    BIOS 1.5 from the support site (no matter eu or global) won't run on Windows 8.1. the file downloaded by msi live update runs normally. Can somebody help and share BIOS 1.5 installer?
    Regards
    Orginal boot sequence:
    1: SSD Intel 520 (system)
    2: SSD Samsung 840
    3: HDD
    Mobo was traing to set Samsung at first place, but after disconnecting this drive, it put HDD on fist place. So i disconnected all other drives, and mobo shows only question marks in Intel SSD field.
    I never had any problems with this intel SSD, it works perfect, samsung behaves the same way, it disappears randomly.
    Sometimes all works correct, some times some drive is missing, it does not matter the restart is made on windows, dos, or on bios. Totally random.
    When i switch to second bios (1.3) all works fine, only on 1.6 freaking out.
    When i what start bios package from msi-support site windows shows "this app. can't be run on this system", thats all (there are 3 files i archive). File downloaded by msi-update starts normally (and this is only one exe file), unzip and run dos-mode update.  Unfortunately, I removed the file with 1.5 downloaded by msi live update.
    Maybe the bios package is dedicated to installing from usb-drive through m-flash ?
    And on the windows can update only through msi-live update? I really do not know, I'm confused.

  • MOVED: Z97 Gaming 5 boot loop

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=254983.0

    Hi
    Try single RAM stick
    Also try to boot when motherboard is on non conductive surface like wooden table or motherboard box
    Try clearing CMOS with power cord removed >>Clear CMOS Guide<<
    Maybe battery replacement will help
    If above fails, disconnect everything, remove CPU and inspect CPU socket with magnifying glass and bright light.
    Edit: with single RAM stick, make sure to test each RAM stick at the time, each time in different slot.

  • MOVED: Z97 Gaming 5 - SATA not present??

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=251803.0

    The thing is: cheap PSU that you've used in old build is most likely not support Haswell (Refresh) so that might be causing different issues too. And personally: yes I will defend it til the death. Cheap PSU can kill anything instantly, and the fact it works with old system... well. It's OLD system and so is PSU.
    Also you're mixing RAM. This motherboard will work perfectly with either 1, 2 or 4 RAM sticks, never 3.
    I think you should speak to the reseller OR MSI, since you think that motherboard killed all the drives (I wonder how... mobo is connected to them only through SATA cables which deliver NO power to them)..
    >>How to contact MSI.<<

  • MOVED: Z97 Gaming 7 won't post. debug LEDs at 41-43. MSI LED is off.

    This topic has been moved to GAMING Motherboards.
    https://forum-en.msi.com/index.php?topic=256760.0

    I'm using a Corsair CS650m.
    I've noticed the CPU support issue after I encountered my problem and was surprised to see this, my understanding that the gaming boards did support the new Haswells, at least with a recent BIOS. In fact, there are some references online to BIOS update issues for this CPU.
    Let me ask a crazy question: Is it possible that I've somehow POSTed correctly and what I'm seeing now is the CPU term? I'm wondering because the numbers (42-44) fluctuate a bit.  I know that POST and POST2 can be used for CPU temp, but I'm not sure how one distinguishes between that and a debug code.

  • How to use 3tb hhd on Z97 gaming 3 motherboard

    Hi All,
    I am using Win7 64 bit, and z97 gaming 3 mb, but the Windows can only use 2.2 GB size with MBR mode.
    Google found MSI has 3tb+ infinity function, how to apply to my PC?
    Many Thanks.
    Philip

    Hi Philip,
    It’s also a win7 limitation, UEFI GPT supports much higher than 2T
    As the MBR only locates a HD for a maximum range of 2T, the maximum partition and the starting position of last partition should be less than 2T.
    For example, a 4T HD (3.7 available usually), you can divide it as
    1.9 + 1.8T or 1T+0.8T+1.9T.
    It is NG to do 1.3 + 1.2 + 1.2 , because the position of last part begins from
    2.5 T.
    For your consideration

  • Z97 Gaming 7 Motherboard with FiiO E10K AMP

    I recently purchased the Sennheiser G4ME One headset and found out today that I could have gotten the Sennheiser G4ME Zero headset, with closed headphones for better noise cancelling, and it has better audio with an amp. I want to know if the motherboard in the subject will be fine with the amp I want to buy with it. I'm not very knowledgeable about this sort of stuff, so i'm looking for some help. Also, I know this isn't the best place to ask because it's not an MSI product, but could someone who replies maybe direct me somewhere to find out what I would need to buy along with the E10K amp? Does it come with everything I would need to set it up in accordance with my Sennheiser G4ME Zero headset? 

    For back panel audio ports, you can connect Direct Audio Power and turn on the AUD_SW1 switch to get better audio quality 
    and the back panel audio jack
    the top(or left) three are mic / Line-out / Line-in, if you plug in your headphone realtek manager will also show the the function of which port you plug in...

  • MOVED: Z97 Gaming 3 Overclocking

    This topic has been moved to Overclocking, Undervolting.
    https://forum-en.msi.com/index.php?topic=256088.0

    Quote from: Marksussman1974 on 31-May-15, 01:25:40
    I'm just curious, did you update your mobo bios to latest release? Also, what speed do you usually keep your cpu at?
    I have updated my BIOS to latest version only because I though I had BIOS problem -> https://forum-en.msi.com/index.php?topic=252562.msg1451633#msg1451633
    Turned out it wasn't, but no one replied at the time.
    I keep ,y CPU as high as temperatures allows,. I run 3 Prime95 threads 24/7 + 1 more at night time, and I prefer CPU package temps to be at low 60s.
    Currently @ 4HGz 1.16v under load (tad above default 1.15v)

  • MOVED: z97 gaming 9 + 4790k 5.0ghz QQQ???

    This topic has been moved to Overclocking, Undervolting.
    https://forum-en.msi.com/index.php?topic=181813.0

    ok just wanted to update , well had to reload everything, it lost half the registry and changed everything to .lnk extensions, so im pretty sure the bsod  was caused my issues because I didn't reload the OS fresh, and the bios was using a 1.0 flash , now since reload everything is all happy, im currently running a 4.7 Oc with 1.31 v on the cpu, 1.6v on the ram and 1.91 on vccin, and so far its stable and holding, so lesson learned "reload os when adding new mb and cpu" and make sure the bios is up to date.  after everthing is reinstalled I may try a 5.0 OC cause I kinda made that y goal currently I think its entirely possible considering its dl,ng multiple filesgames and checking my raid 5 volume, and the temp is37-41c so so far so good, if anyone wants to throw so suggestions feel free but so far I am thinking 4.7 is the magic number hmmm

  • MOVED: Z97 Gaming 5 Cashback

    This topic has been moved to Anything Under The Sun.
    https://forum-en.msi.com/index.php?topic=181185.0

    Contact MSI directly to have a ask about it, >>How to contact MSI.<<

Maybe you are looking for