MTP and CFB of call manager not registered

dears,
some thing strange is going on which i never face in my life. by default the mtp and cfb are registered but they are not registered while all other media ann and moh are registered
that's only for pub but sub all are working fine

is the run flag for MTP & CFB under "Cisco IP Voice Media Streaming" service parameter set to True?
can you try changing the device pool and reset it once please?

Similar Messages

I took my card to top up and was told it is not registered what do I do now

i took my card to the shop to top up and was told it is not registered .What do i do now

Hi ,
You can get this done as below:
Call 150 and follow the instructions, or
Send a text to 150. Start your text with ETU, followed by a space and then your 13-digit top up card number e.g. ETU 1234567891234
Hope this helps you out
Thanks.

After update to IOS 4.3.5 my Iphone incoming and out going calls is not working properly and I have to remove the SIM regulerly to conduct or receive a call

after update to IOS 4.3.5 my Iphone incoming and out going calls is not working properly and I have to remove the SIM regulerly to conduct or receive a call
It is not practicale to do this always any one faces the same problem

There may be a problem with the SIM card. Get a new SIM card from your carrier - there should be no charge for a replacement.
If no change with a new SIM card, the standard troubleshooting steps in order are:
Power your iPhone off and on.
An iPhone reset, which is done by pressing and holding the home button and the sleep/wake or on/off button simultaneously until you see the Apple logo and then release.
Restore your iPhone with iTunes from your iPhone's backup.
Restore your iPhone with iTunes as a new iPhone or not from your iPhone's backup.
If no change after any of these steps in order, your iPhone has a hardware problem.

HT201436 I have good reception and can make calls but not receive any, it's going straight to voicemail?

Hello, I have good reception and can make calls but not able to receive calls, it's going straight to voice mail?

What did your carrier say when you contacted them?

Remove device and profile from call manager

Is there any documentation on how to remove phones and EM, RDP, CSF profiles from call manager in order to free up some licensing??

EM does not take any licenses, but the way you want to do this (assuming all associations are correct and dependencies would prevent you from doing it anyway):
delete UDP
delete CSF device
delete RDP
delete desk phone

I am trying to reset my apple id unmation onder icloud account infor the original pc that I signed in with...my phone is connected to the pc and I have made the change in email address and password but it will not register on my phone.

I am trying to reset my apple id under icloud account information on the original pc that I set the account up. I have changed email addresses now and would like to change to new address. I have gone through the steps on changing apple id and password and have my phone hooked up to pc but it will not change over to the new address and password thus I can not order any apps or use icloud. Help!

Go to Settings, and then turn iMessage and FaceTime on if they are off. If they are on, then turn them both off, restart the phone, then turn them back on.
Go back to Settings > iCloud. Whether the current or old email address is displayed there, try your current password.

Call Manager - Phone register & unregister

How can we be informed if a phone unregisters from call manager? Can we see it in the Real Time Monitoring Tool or snmp ?
Thanks

Wrong, there is still app log in any linux appliance.
You access it thru RTMT
HTH
java
if this helps, please rate

Charging me over and over but calls do not connect...

You are charging me over and over with out even making the connection or getting dial tone! THAT'S ILLEGAL YOU HAVE NO CUSTOMER SUPPORT AND YOUR SUPPORT PAGE IS NOT EVEN RESPONSIVE SO I CAN'T EVEN MAKE A COMPLAIN! Your fraudulent activity is a disgrace!!!!!!!! I want you to reimburse me for all the times you don't connect me and charge me for it over and over
Posts transferred to create new topic;
subject/title edited for clarity.

Hello
Checking for you.
TIME ZONE - US EASTERN. LOCATION - PHILADELPHIA, PA, USA.
I recommend that you always run the latest Skype version: Windows & Mac
If my advice helped to fix your issue please mark it as a solution to help others.
Please note that I generally don't respond to unsolicited Private Messages. Thank you.

I restored the iPhone 5 out of a backup and now missed calls are not showed in the notification center

When I restore the iPhone as a new one, then it works. So the backup is senseless otherwise you're not able to see your missed calls in the NC.

In the forum I found that switching notification off and back on helped.
Worth a try, I would think.

Re: Charging me over and over but calls do not con...

I did not call the phone number area code. 971...... How you charge me many times for that .please credit to my account thanks

I just got charged for 2 calls that did not connect even Richard Turpin wore a mask Thats terible

My ipod was stuck on shuffle and a new battery will not register more than half charged.

another forum suggested I reset the ipod and it might fix both problems,
Knowing I had the entire 6 gigs of my library in itunes I, though the reset will
clear my ipod but I would restore from I tunes, after the reset all but a few songs
were gone...i've searched my drive with no success where is my music?

i had a similar problem with some songs... one thing i notices is that if you are using "priated" mp3's that have a bit rate anylower then 220kbps and dont have the Attributes listed as A (rightclick on mp3->properties->details)wont work on the ipods.. they will read but only up to a point an then they stop or skip to the next song... if you really like the song i would just pay the $1 for it on itunes...or try downloading from sites like Filestube.com where it takes it links to sites that have good quailty file onsite...
i know its not very techy and probilly not much of help but its a way around the issue......

How do i get my serial number? - i can't find the packaging of my students edition and unfortunately deleted the e-mail i received. And also is my product not registered in my adobe account, for the registration in my products i need the serial number wit

help

For the link below click the Still Need Help? option in the blue area at the bottom and choose the chat option...
Serial number and activation chat support (non-CC)
http://helpx.adobe.com/x-productkb/global/service1.html ( http://adobe.ly/1aYjbSC )

Adding DNS server and Domain to Call Manager 9.1.1

I am removing this Post, Thanks to all the replies

The name pretty much says it all, cluster reboot, start by your PUB, wait until it comes up, next TFTP(s) wait until fully up, next SUB1, wait until fully up, and repeat until you've rebooted all servers in your cluster.
HTH
java
if this helps, please rate
www.cisco.com/go/pdihelpdesk

Cisco Call Manager and MGCP Question

Hello,
I appreciate if somebody can help.
Scenario:
Site 1 PSTN E1----VG----Call Manager----VG--- PABX---Site 2 PSTN1 E1
I have configured a dialing pattern on Cisco call manager 6.xxxxxx to Send to VG on Site1
Both VG routers are using MGCP with call Manager.
The problem if from Site 2 tries to call 6xxxxxx the call manager is not routing the call to the VG in site 1.
I did debug ccapi inout and on Site 2 VG the call response was the number unassigned. This means that the call Manager is searching the directory for the destination but it is not searching the route patterns.
Any ideas to override this and ask the call manager to check it's destination pattern?
Thanks,

Problem solved. The VG in Site 2 was in a CSS that is not allowed to dial PSTN.
Regards,

Just got a new iPad but can't get it to do the text messaging. Every time I put in a "To" address it shows a red exclamation point and says the name/number is not registered. How do I register the people I want to text?

I just bought a new iPad and can't get the text messaging to work. When I try to address the message a red exclamation point appears and says the person is not registered. How do I register them? They are already in my contacts list & they all are active in my iPhone text messaging.

Please Get the iPad User Manual for iOS 5.

MTP and CFB of call manager not registered

Similar Messages

Maybe you are looking for