My 3rd generation ipad even though my battery is at 100 % the screen goes black after sitting for more than 15 mins. The only way to get it to come is by resetting the ipad. Is there a fix for this. It all started after the last two updates.
my 3rd generation ipad even though my battery is at 100 % the screen goes black after sitting for more than 15 mins. The only way to get it to come is by resetting the ipad. Is there a fix for this. It all started after the last two updates.
Try a Reset...
Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
If no joy... Try a Restore...
1: Connect the device to your computer and open iTunes.
2: If the device appears in iTunes, select and click Restore on the Summary pane.
3: If the device doesn't appear in iTunes, try using the steps in this article to force the device into recovery mode.
From Here
Unresponsive iPad
http://support.apple.com/kb/TS3281
Similar Messages
-
IiPad air2 suddenly freezes, the screen goes black but the sound is still on, I have taken it back to factory settings and it was OK then yesterday it froze again, only plugging it into my IMac got it going again. Anyone else got this problem?
Greetings jupiejupie,
Welcome to the Apple Support Communities!
I understand that your iPad is sporadically becoming unresponsive and the screen is turning black. In this situation, I would recommend reading over and working through the suggested steps in the attached article.
If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support
Cheers,
Joe -
My new iPhone 4s and my iPad 1 have the same problem: While working on one of them, the screen goes black and the right back to home screen. I've tried resetting the iPad with no chages to this problem. Need help, this is anoying.
I just did a reset all settings on both.
Will see where this gets me.
Thank you for your helpfull input. -
I have a iPad, 32g, and for no apparent reason, the screen goes black and whatever app I am using is closed on me. It seems to be happening more and more frequently, especially when loading apps, or trying to watch a YouTube video. I try to open safari or youtube again and it will often crash several times before it may or may not decide to load for me. It is extremely annoying and getting to the point where I can not use it
Standard troubleshooting steps in order are as follows:
Power the iPad off and on.
An iPad reset, which is done by pressing and holding the home button and the sleep/wake or on/off button simultaneously until you see the Apple logo and then release.
Restore your iPad with iTunes from your iPad's backup.
Restore your iPad with iTunes as a new iPad or not from your iPad's backup.
If no change after the last step, your iPad has a hardware problem. -
Just recently my ipod nano 4th generation's battery seems to be messed up? I plug it into the charger and the ipod says it's charged, but when I take it off the charger, the screen goes black. What is going on and how can I fix it? I'm really sad because it happened so suddenly.
Yes. The battery appears to be shot and in need of a replacement. This can either be done by Apple or a third party repair company.
http://www.apple.com/support/ipod/service/prices/
You can Google "iPod battery replacement" for third party service centers.
B-rock -
The video on my iPad 2 is frozen on a tv show, although it will play the tv show until the end. At the end, when I click 'done' the screen goes black so I can't see the other movies that I've downloaded. I've shut down a few times but it reverts to the same thing. How can I re-set the video feature or do what is necessary to get it working again?
Have you tried resetting the iPad:
Reset iPad: Press and hold the On/Off Sleep/Wake button and the Home
button at the same time for at least ten seconds, until the Apple logo appears. -
I haven't been able to find any answers that solve my problem. My Ipad will not leave the Apple logo. I hold both buttons and the screen goes black and then the Apple logo immediately pops back up. I can't get the red slider screen at all. No matter how many times I hold down both buttons the screen goes black and then the Apple logo pops right back on.
Before you do anything else, try charging via a wall outlet for a while, since its off. Then try turning it back on.
When you put the device into recovery mode it allows you to restore the device when no other options work. You do risk losing everything currently strored on the ipad itself. Hopefully you've performed regular backups either via itunes, icloud or both. Evern if you have synced content to either of those, you may not lose everything. All previous purchases have been saved in the itunes and app stores, so you can dowload them again.
while the ipad is off, press and hold the home button and plug the usb cord into the ipad. You should see a message pop up on the itunes window on your compoter screen that state it has discoverd an ipad in recovery mode.
You should now be able to restore -
When I pull the notification screen down after about 5 seconds the screen goes black and then the apple appears for about 30 seconds and then returns to the home screen, this is an iPhone 4 running ios7 , any ideas??
One problem though, the top button on my phone is jammed so i cant power off the phone, anyway of resetting the phone without using the top button ?
-
IPad 2 turns on then after a few seconds the screen goes black
IiPad 2 turns on then after a few seconds the screen goes black.
Hi Tsinker,
I'm sorry to hear you are having issues with your iPad. If your iPad isn't responding or starting up successfully, you may find the troubleshooting steps outlined in the following article helpful:
If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support
Regards,
- Brenden -
When I open my internet and got to say the Macy's website and try to bring up all pages in the handbags dept, the screen goes black and it returns to the screen that has all my icons on it. Why?
Safari is crashing.
Try a reset:
Hold the home and power buttons at the same time until the Apple boot logo appears. No data will be lost. -
I tried replacing the screen with no luck. The same thing happened with the new screen. I replaced the backlight coil and the backlight ic and still have the issue. I don't know what else could be the problem. If the battery is completely dead and I plug it in the "charging battery" symbol shows just fine during the entire time it is charging, but as soon as it starts to boot up the apple logo shows for a split second then the screen goes black. The rest of the phone still boots up just fine. I can use SIRI, press the lock button like I'm about to use my phone and slide my thumb across where the "slide to unlock" would normally be and it will make the unlock noise just no picture display. I am pretty tech savvy when it comes to repairs and all of the connections look fine, replaced backlight coil and ic, replaced LCD/digitizer, tried a restore, tried a DFU restore, multiple hard resets, but I am at a loss as to where to go from here. I had dropped the phone and put a minor crack in the screen but the phone worked just fine for a couple months after before this started to happen. The phone is still under apple warranty but apple won't cover it because Apple is stating that it is "caused by the crack in the screen." But being a repair technician I know that is not the case... Good one apple. So I took it upon myself to try to determine the REAL problem. Anyone with a little more knowledge have any ideas? Any suggestions are appreciated!!
Yes, I understand that. But The screen issue is not a result of user damage. The phone was not dropped when the screen got cracked. My daughter was standing in a chair at the table and dropped one of her toys onto the bottom of the phone and cracked it right by the home button. (Nowhere near the LCD/digitizer flex cables, connections, or logic board components) then a few months later my phone had died, I plugged it in, it showed it was charging, then Apple logo disappeared and screen didn't work. AFTER contacting Apple about the issue and them telling me that it "is a result of the very minimal crack to the sheet of glass that has no relation to the LCD or Digitizer and that the warranty does not cover it I had taken it upon myself to change the LCD/digitizer to no avail, as well as backlight ic and backlight coil to no avail. But how do I go about letting Apple know that it is in fact NOT due to the cracked screen nor is it due to the flex cable connections? I can't. So the lady that works the call center phones trying to "convince" me that she knows what she is talking about and "convince" me that it is from the cracked screen I have to take her word because I can't show Apple that its not because of that without paying them $199 to fix the screen in which case they will just send me a new phone rather than fix the faulty hardware under warranty.
-
While restoring my iPod Touch second generation computer is turned off the screen goes black what do I do?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I have a phone 3g and everytime I go to open facebook or bejewelled blitz it will not load. It crashes and then the screen goes black for a few seconds before going back to the home screen. I have uninstalled this app and reinstalled it on a few occassions but now it will not even go the facebook homepage. It sometimes also happens with other app.
The problem corrected itself,....i tried to delete the post but could not do it.
-
my Mac won't start up and Im using DiscWarrior. When I restart the computer with "c" down, the screen goes black. Is this ok? Do I just wait it out?
Have you just tried repairing with Disk Utility?
Repair the Hard Drive and Permissions - Lion/Mountain Lion
Boot to the Recovery HD:
Restart the computer and after the chime press and hold down the COMMAND and R keys until the menu screen appears. Alternatively, restart the computer and after the chime press and hold down the OPTION key until the boot manager screen appears. Select the Recovery HD and click on the downward pointing arrow button.
Repair
When the recovery menu appears select Disk Utility. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list. In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive. If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported then click on the Repair Permissions button. When the process is completed, then quit DU and return to the main menu. Select Restart from the Apple menu. -
My new macbook pro has gone black on me three days in a row. is this a chronic problem?
The only way to get it back is a hard reset or let the battery die and then plug in the charger. The brightness is up and the power stays on while screen is black.
This is the second macbook pro i have owned in the past two weeks. I am ready to return it for good if this is a chronic issue. Please help if you have had this same issue.Try a SMC reset:
http://support.apple.com/kb/HT3964
Try a NVRAM/PRAM reset:
http://support.apple.com/kb/HT1379
If no joy, take it back, and take full advantage of your warranty!
You also may want to let Apple know about this as well:
http://www.apple.com/feedback//
I wish you the best
Maybe you are looking for
-
Creation of automatic PO for a serive PR
Hi, What are the prerequisities for converting a service PR which uses Service conditions to automatic PO and also wihout service conditions ? How to automate account assignments to those PRs/ POs without manual entry in account assignment tab. Regar
-
Profit Center is not updating in Vendor line item
Hi Experts, For my GL postings in F-43, F-41, F-53 ,F-54 and F-28 the 1st line item corressponds to Vendor or Customer, the profit center is not updaitng the values and shows nill. We have given check in Exit and Substitution but its not updating in
-
Does't sean to work with my TV
I recently got a apple tv but it doesn't appear to work with my TV. The TV is about two years old and I have no idea what the resolution is! I assume it is 480i but I am not sure. When the apple tv is on all I get is distorted Black and white images,
-
How can i pass variables between classes?
Hi. i have three classes and i need use a variable from 'Battleship' and use it in 'BattleWindow', these summaries of the classes, if anyone could give me a solution without editing it too much it would be greatly appreciated public class Ship{ publi
-
Creating Reservations from scanner
Hi, We have requirement is to create Reservations items automatically through scanner like, user will use the scanners and this should create reservations in SAP automatically in background Is that possible in SAP?