My apple tv connections is not working.

my apple tv connects than it will not show on the tv.  When I try to connect again it says that the apple tv is already connected.  When trying to connect it will show the same connect number over and over again but also say that it is already connected.
The apple tv will not turn off even if I hold down the play button.  Should it stay on?

it's unclear what you are saying
are you trying to airplay mirror to the appletv?
are you just operating the appletv but if so how can it inform you that it's connected if it does not show on the tv?
provide more info

Similar Messages

  • HT3917 My apple wireless keyboard is not working after new batteries installed

    My apple wireless keyboard is not working after new batteries installed.

    Do you get a steady green light to say there is a connection.    If not, are the batteries the right way round.   Do you have a monitor to tell the batteries strength. Is there a reading.   Are the batteries good quality ones, Duracell, Energiser or Apple rechargeables.

  • Since the last update to iTunes 11.0.3 (42) the airplay connection is not working properly , keeping breaking up

    since the last update to iTunes 11.0.3 (42) the airplay connection is not working properly , keeping breaking up, while the airplay works fine with my iPad and iPhone. Anyone has experienced the same? any fix available?

    Hi Erdelestre,
    Thanks for visiting Apple Support Communities!
    See this article for some tips about troubleshooting AirPlay:
    Troubleshooting AirPlay and AirPlay Mirroring
    http://support.apple.com/kb/ts4215
    Troubleshooting performance issues with AirPlay or AirPlay Mirroring
    If you are experiencing intermittent playback or significant network lag with AirPlay or AirPlay Mirroring, it could be due to a weak Wi-Fi connection, interference, or the distance between the Wi-Fi router and your iOS device, Apple TV or AirPort Express. Try the following suggestions:
    Ensure that other devices are not trying to stream to the same Apple TV at the same time.
    Turn off Bluetooth on your iOS device by tapping Settings > General > Bluetooth.
    Ensure that your Wi-Fi router is set up with the recommended settings for the best performance.
    Certain external devices, such as microwave ovens and baby monitors, may interfere with a Wi-Fi network. Try moving or disabling these devices.
    If possible, try to locate your Wi-Fi router in the same room as your Apple TV and iPhone/iPad.
    If your wireless and wired networks are the same, try connecting your Apple TV to the router via Ethernet instead of Wi-Fi.
    If the Wi-Fi router has an external antenna, check to see that is it connected properly and in good condition.
    Use the Wi-Fi network troubleshooting guide to resolve interference and other issues.
    Best,
    Jeremy

  • I have updating my Apple TV and now not working

    HI I have updating my Apple TV but now not working.
    what can i do?

    I also had the same issue - Apple TV is pointing to connect to iTunes - when I did it iTunes did not recognize the AppleTv - not sure what is the trouble here.

  • Why does my camera connection kit not work with my ipad 1 after updating on ios 5?

    Why does my camera connection kit not work with my ipad 1 after updating on ios 5? What can I do to make it work again?

    It should. It will only respond if there's something on the card for it to respond to, so do you have pics on the card?
    And if it's messing up; try giving the iPad a restart. Hold down the sleep and home keys, past when you see hte red power down slider and until you see the silver apple. Let it reboot and try again. That can clear up any glitches on the device itself.

  • Internet connection does not work when Macbook wakes up from sleep

    I recently installed MAC OSX LION. After that whenever the macbook pro wakes up from sleep, the internet connection does not work. I get a message 'DNS lookup failed'. I have to Turn off the WIFI and turn it back on every time. Has anyone come across this?

    Same problem here. But I am afraid it has nothing to do with Safari because I don't even have Safari open. When it wakes from sleep, it has no internet connection and i cannot get me mail unless I shut wifi off and then back on. This happened back at the start of Snow Leopard too and it was something Apple eventually fixed.

  • I have a iphone 5 and I can login with my apple id to purchase music. However, when I try to login into icloud using the very same username and password that I use in the apple store it does not work to enter icloud, so what what gives???

    I have a iphone 5 and I can login with my apple id to purchase music. However, when I try to login into icloud using the very same username and password that I use in the apple store it does not work to enter icloud, so what what gives???

    I could do that, however when I select the icloud button (or whatever the heck it is) I am asked to enter the apple id and password. So if you are suppose to create another one for icloud you'd think it would give you the option at this point which would be logical.

  • Bug (?) with Corporate Connectivity is (not) Working check

    Noticed something odd.  In situations where:
    Direct Access client is offsite
    their Internet access is via WiFi
    they first have to enter their access credentials through a web-based captive portal before access is granted
    then the Corporate Connectivity Check process malfunctions.  Have seen cases where, after accessing the captive portal and being authenticated, Internet access works on the client.  Direct Access then connects successfully.  This is confirmed
    on the server console, showing the client connected and the user credentials used.  The client is able to access internal resources just fine (e.g. network drives on file servers).
    But on the client itself, it still says Corporate Connectivity is Not Working.  The WiFi icon is showing an exclamation mark.  My belief is that this is caused by the client's inability to access Microsoft NCSI servers in a timely fashion.
    So it looks like the corporate connectivity checks are dependent on Microsoft NCSI checks.
    Can someone at Microsoft please look into this, as it is confusing our users (not to mention us guys in IT who have only just discovered this odd behaviour!).

    Hi Steven !
    Thanks a lot for your guidance !
    After I followed the steps, I found that the time out occurs when trying to resolve the internal domain name.
    The Windows Firewall was enabled on all profiles ( active on the public )
    There were no IPsec sessions established in the Security associations tab, so I enabled the audit policy of the IPsec as per your instructions.
    There is reoccurring error in the Security log :
    Date:          10/8/2014 10:08:49 AM
    Event ID:      4653
    Task Category: IPsec Main Mode
    Level:         Information
    Keywords:      Audit Failure
    User:          N/A
    Computer:      MyW8Client
    Description:
    An IPsec main mode negotiation failed.
    Local Endpoint:
     Local Principal Name: -
     Network Address: MyW8Client_Ipv6 address
     Keying Module Port: 500
    Remote Endpoint:
     Principal Name:  -
     Network Address: MY_DA_Servert Ipv6 address
     Keying Module Port: 500
    Additional Information:
     Keying Module Name: AuthIP
     Authentication Method: Unknown authentication
     Role:   Initiator
     Impersonation State: Not enabled
     Main Mode Filter ID: 180987
    Failure Information:
     Failure Point:  Local computer
     Failure Reason:  Negotiation timed out
     State:   Sent first (SA) payload
     Initiator Cookie:  9e636863e513b367
     Responder Cookie: 0000000000000000
    As far as I understand - the connection can not be established due to certificate error, which in my case is strange since my DA configuration is set to not use computer certificates, only Kerberos.
    I will keep digging but any additional tip/advice will be appreciated!
    Thanks again, Steven!
    P.S. Just noticed that the Event ID 4653 produce two types of "Failure Reason" - apart from "Negotiation timed out" I also get "No policy configured"

  • My 3G connection is not working after updating to iOS 6.1. I have tried all possible solutions like resetting the network, restarting the iPad

    My 3G connection is not working after updating to iOS 6.1. I have tried all possible solutions like resetting the network , restarting iPad , ...

    The same story. No 3G after updating to 6.1.  Told my daughter temporarily not to do an update on her iPad with 6.01. We've exchanged SIMs. I inserted her SIM in my iPad - 3G appeared immediately. And my SIM in her iPad with ios 6.01 also WORKS FINE. We use the same provider - Megafon Moscow. After attempting to revert SIMs to original configuration, 3G disappeared on my iPad again. Don't know what's going on with SIM during the update to 6.1

  • Why does iTunes keep giving me bogus error messages.  "Your internet connection is not working, check your connection and try again."  My internet is working fine.  iTunes is not working and will not allow me to download tunes.

    why does iTunes keep giving me bogus error messages.  "Your internet connection is not working, check your connection and try again."  My internet is working fine.  iTunes is not working and will not allow me to download tunes.

    This my sound too simple, but I just kept clikning on the arrow next to the selected music and it finally "Kicked" in.
    I live in Europe ,So Be persistent and don't give up !  Aug. 2013

  • My Apple TV remote is not working.

    My Apple TV remote is not working. It was fine this morning, but now ATV is not responding to it.  It still access iTunes on my Mac so I don't think it's a battery issue. The white light flashes on ATV, but nothing happens.  I have restarted ATV several times from the mains, but no change.  Please help!

    Hey Punkmonk1,
    Thanks for the question. I understand that you are experiencing issues with your Apple TV remote. The following resource may provide a solution:
    Apple TV (2nd and 3rd generation): Resolve issues with Apple Remote
    http://support.apple.com/kb/TS5157
    Thanks,
    Matt M.

  • HT5622 Why is my Apple ID or password not working anymore after I reset my password?

    Why is my Apple ID or password not working anymore after I reset my password?
    It keep asking my password... I have reset it, then, when I enter the new password, it's not accepted...

    Perform a Reset... Try again...
    Reset  ( No Data will be Lost )
    Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
    Wait for the Apple logo to Appear...
    Usually takes about 15 - 20 Seconds... ( But can take Longer...)
    Release the Buttons...

  • Apple av adapter does not work after updating ios 5,01

    apple av adapter does not work after ios 5,01. no video on vga monitor. sound goes out on iphone 4 also.

    Thank you for your interest. Last night i tried again. It worked. there is still problem, so i could find out it that monitor is going to power saving mode then voice goes out and no view on monitor. I changed the power saving settings. And worked well. Thnx again.

  • There is a problem with my apple watch.it is not working well .There is a problem in its charging .The repairers says that contact to your company and ask them to provide you its software. Please help me.

    There is a problem with my apple watch.it is not working well .There is a problem in its charging .The repairers says that contact to your company and ask them to provide you its software.
    Please help me.

    Please be aware that you are not communicating with Apple when you post in these forums. These are user-to-user support forums, so in almost all cases the only people who will reply to your posts are, like me, your fellow users.
    As to your issue, Apple does not and never has made a wristwatch as such. The only thing close to a watch that they have made was the 6th-generation iPod nano:
    http://support.apple.com/kb/ht1353#iPod_Nano_6G
    which has a clock feature and which some people have worn as a wristwatch. Is that what you mean?
    Message was edited by: varjak paw

  • I have a Comcast system and am going through a Bose amp for sound.  The comcast box has an HDMI port which I've used for the Apple TV connection.  Nothing works! Help.

    have a Comcast system and am going through a Bose amp for sound.  The comcast box has an HDMI port which I've used for the Apple TV connection.  Nothing works! Help.

    Thanks.  Thought that would be the solution but for my wall mounted TV it's going to be a problem but many thanks for your reply.....

Maybe you are looking for