My auto location service is not working on iphone 4s after updating to ios 8.1.3

Hi every one
i have recently facing a problem my compass and other apps which require location service are not working on my Iphone 4s, after i have upgrade my iphone ios to 8.1.3. Settings are correct i.e. location service is 'ON' and apps require location service are allowed to use my location.
is anyone facing the same issue. Need your valuable suggestions and advices.
Regards
Muhammad Shahbaz
Pakistan

Greetings Biyase, 
Thanks for contributing to the Apple Support Communities. 
It sounds like the Outlook app is not launching after you updated iOS. In this case, I recommend the troubleshooting steps found at this link:
If an app you installed unexpectedly quits, stops responding, or won’t open - Apple Support
Sincerely,
Jeremy 

Similar Messages

  • Itunes Match not working on Iphone 4 after update to IOS 5.1

    Hello,
    Itunes Match has never been an issue for me in the past.  After I updated to IOS 5.1, I accessed my music app and noticed that Itunes Match was only showing artists that started with the letter "A" And "B".  So I turned match off, turned it back on and now itunes match shows a picture of a cloud and a progress bar.  the bar takes hours to move about half way, and then the app will just tell me that I don't have any music and I can dowloand music from itunes. 
    My wife is not having any issues with match on her iphone 4 and my ipad 2 running IOS 5.1 is also not having any issues.
    I have tried signing in and out of the Itunes store, turning on and off Itunes match, doing a hard reboot of the phone, I have rest and deleted everything on my phone and restored from a icloud back up.  I even tried to see if I could delete the music app data by going under settings/general/usage.....but the music app says it has "no data".
    This is Very frustrating for me, and I can't figure out what i can do to make my phone load my music match library again.  I thank you for any suggestions/help that you may have in advance!

    Exactly the same ting has happened to me over te past few days with my ipad2... I too resorted to setting my ipad2 up as a new device again to get match working... There is definitely something screwy happening on 5.1 I think... It was fine till I updated

  • Receiver (ear speaker) not working on iPhone 5 after updating to iOS 7

    Since upgrading to iOS 7 (or 7.0.2) the receiver on my iPhone seems to have stopped working.
    I don't make / receive many voice calls - so not sure exactly when problem started.
    Every call I have received in the last 2 days has been silent, where the person calling me can hear my voice, but I cannot hear them.
    Also there is no sound when I make a call.
    Prior to this most recent calls have been silent at first, with the sound only kicking in after 5-10 seconds.
    I can turn speakerphone on - which works.
    I have performed the folowing to try to fix the problem:
    1) Restarted phone
    2) Reset all settings
    3) Restored from backup
    I've checked mute switch, tried volume buttons and ensured airplay is set to iPhone.
    I managed to make the receiver work again by wiping all settings and content, then setting up as a new phone.
    However I do not want to lose all the content, settings, app data saved on my phone, so this is not really an option.

    Yes I have done this 4 times, I am sorry I should've been more clear in the information I provided but thanks for replying

  • Why AirPrint is not working on my ipad4 after updating to IOS 8.1?

    WWhy AirPrint is still not working on my ipad4 after updating to IOS 8.1

    Hello mmpreston,
    Thanks for using Apple Support Communities.
    To troubleshoot issues with AirPrint on your iPad please follow the directions outlined below.
    Check these things if you are unable to print, or if you see the message "No AirPrint Printers Found."
    Make sure your printer has paper, and enough ink or toner installed.
    Make sure your printer is connected to the same Wi-Fi network as your iOS device.
    Make sure your printer has power and is turned on. Try turning your printer off and then back on again to see if it resolves your issue.
    Check to see if your printer has any error lights or indicators displayed on the printer's control panel. Check the documentation that came with your printer to clear any errors displayed.
    Check with your printer's manufacturer to see if any firmware updates are available for your printer. Check your printer's documentation or contact the printer vendor for more information. A firmware update may be available, even if you just bought your printer.
    About AirPrint
    Take care,
    Alex H.

  • Outgoing calls not working on iphone 4S after upgrading to ios 6.0.1

    outgoing calls not working on iphone 4S after upgrading to ios 6.0.1.
    It always says call back ...
    incoming is working
    i tried number of sim cards from different networks but same issue
    tries resetting network settings but it also didnt worked

    Just counter-check the following settings.
    1. Settings>General>Set Side Swith To: Rotation Lock
    2. Make sure side switch is not in lock position
    3. If necessary do a reset a few more times

  • TS1363 i could not activate my iphone 3G after updating to ios 6.0.1

    i could not activate my iphone 3G after updating to ios 6.0.1

    Generally this is a sign that the iPhone had previously been
    hacked/modified/jailbroken and the update relocked it to the
    original wireless carrier. If this is the case, only that wireless
    carrier can unlock your iPhone. You must contact them to see
    if they offer unlocking and if you qualify.
    If the iPhone was advertised as unlocked and you are still within
    the return period, start a claim with eBay to get your money back.
    What wireless carrier did you use before this problem?
    Does the app Cydia appear on your iPhone?
    What does it say when you look at Settings=>General=>
    About=>Carrier?

  • Wifi doesnt work on iphone 4s after updating to ios 8.02. How do i fix this?

    The wifi doesn't work on my iphone 4s after updating to ios 8.02. How do i fix this?

    Did you already try to reset the phone by holding the sleep and home button for about 10sec, until the Apple logo comes back again? You will not lose data by resetting.
    If this did not work, and to rule out a software issue, setting it up as new device would be the next step:
    iOS: How to back up your data and set up your device as a new device
    If still no luck, this might be a hardware problem and the phone has to be checked by an Authorized Apple Service Provider or Apple:
    iPhone - Contact Support - Apple Support

  • Safari not work for iPad mini after updated to ios 6.1.3

    After updated to ios 6.1.3, Safari just not response. I cannot input any web address. Do anyone has this problem? Do anyone know how to solve it?

    First, try a system reset.  It cures many ills and it's quick, easy and harmless...
    Hold down the on/off switch and the Home button simultaneously until you see the Apple logo.  Ignore the "Slide to power off" text if it appears.  You will not lose any apps, data, music, movies, settings, etc.
    If the Reset doesn't work, try a Restore.  Note that it's nowhere near as quick as a Reset.  It could take well over an hour!  Connect via cable to the computer that you use for sync.  From iTunes, select the iPad/iPod and then select the Summary tab.  Follow directions for Restore and be sure to say "yes" to the backup.  You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod.  Again, say "yes."
    At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod.  As before, say "yes."  Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time.  If that happens, only the apps that are part of the IOS will appear on your device.  Corrective action is simple -  choose manual "Sync" from the bottom right of iTunes.
    If you're unable to do the Restore, go into Recovery Mode per the instructions here.

  • 3G (4G) doesn't work on iPhone 4S after updating to iOS 5.1

    If you are facing the problem described by the subject, my solution is resetting the Network by tapping Settings>General>Reset>Reset Networking Settings.
    Warning: by doing above you will lose all your Wifi information, i.e. the phone will lose all its login data of all Wifi hotspots it associated to previously.

    This saved my ***!

  • IPhone 6 location services/gps not working

    Anyone else have an issue with iPhone 6 location services/gps not working? I have had it happen to me twice where it stopped working for good 7 or 8 hours and then all of sudden it starts working again. For example, directions don't work, every time I open Apple Maps it will say "Cannot determine location", then when I press the location icon on the bottom left, it will try to search again and have an approximate location but not exact, where as the iPad that I have right next to it is able to pin point the exact location. Sometimes the location circle is pulsing blue sometimes its gray. If I am driving and have tracking on it won't track, and so on.  I have tried to setup the phone as new without restoring the backup, when it stopped working with no luck, it still didn't work. I went and restore it back from backup and few hours later it started to work again. This has happened twice now since I got the phone last Friday.

    Check your "Privacy" settings on your iPhone see what apps are using your location.

  • Since updating the recent OS on my iPad my location services do not work.  Maps "Cannot determine location"  and "Find Me" is running in circles.  How can I delete the update on my iPad???

    Since updating the recent OS on my iPad my location services do not work.  Maps "Cannot determine location"  and "Find Me" is running in circles.  How can I delete the update on my iPad???

    You can't delete the update and your problem probably is not in the Update.
    Check to see if Location Services is turned ON. (Settings > Privacy > Location Services)
    What model iPad Mini do you have? WiFi or WiFi + Cellular
    Have you recently changed WiFi routers?

  • TS3274 Location service  is not working on iPad retina

    Location service is not working I tried everything
    Is it hardware of software problem

    Your Wi-Fi only iPad do not have GPS.
    It gets it position from Apple's router data base. Your location may not be in the data base.

  • Bought a new router location services will not work hooked up old router location services came right back on

    bought a new linksys router location services will not work on i-pad hooked old router back up and it started working again linksys was no help

    WiFi iPads determine location through a database of router locations. Your new one is not in the database, give it some time and it will be added.

  • My cellular network is not working on my iphone 5 after updating to ios 8.1.2 !! It was working fine on ios 8.1.1and it was not jillbreak or hacked to unlock. I need help, what can I do?

    My cellular network is not working on my iphone 5 after updating to ios 8.1.2 !! It was working fine on ios 8.1.1
    my phone was not jillbreak or hacked to unlock. i need help, what can I do?

    Did you do the Reset Network Settings as I described above?
    There is no way to go back. You can try reseating your nanoSIM or replacing it. Or call your cell provider and have them check the provisioning on your phone.
    Or Restore your iPhone from your backup in iTunes.

  • My cellular network is not working on my iphone 5 after updating to ios 8.1.2 !! It was working fine on ios 8.1.1 i need help, what can I do?

    My cellular network is not working on my iphone 5 after updating to ios 8.1.2 !!
    It was working fine on ios 8.1.1 i need help, what can I do?

    I have this problem too - and it is on a BRAND new iPhone 6 - I have definitively tracked the issue to the moment I upgraded to iOS 8.1.2 - and am beyond frustrated. No fix to tell you about, sorry…but you can read my post here if you are into the whole "misery loves company" thing: iOS 8.1.2 Cellular data problem (Definitive - maybe)

Maybe you are looking for

  • Mini Display to VGA issue

    I've been using a MiniDVi to VGA adapter on my mid-2009 Macbook Pro for well over a year with no problems. Then, about a week ago, when I went to connect it to my 720p LCD television, the Mac's screen turned blue and came back as if nothing happened.

  • Error in deploying cardemo.war in JWSDP?

    To run cardemo example i copy cardemo.war to webapps folder in my jwsdp home, but the example can run. I see the log file jwsdp_log.2003-03-13.txt, the following is the error message about loading cardemo.war: 2003-03-13 12:14:49 HostConfig[localhost

  • Activty release should be possible only after WBS release

    Hi Gurus My customer wants release of activity only after release of WBS element. Is there any user exit available for that or can i write some validation for the same. Thanks in advance Regards Abhijit Sen

  • When i use function module to create additive costs using KKPI_BDC_ADD_ON_C

    Hi, When i use function module KKPI_BDC_ADD_ON_COSTS_CREATE to create additive costs it shows an error. The error is 'THE OBJECT IS LOCKED BY THE USER SARKARD'  the transaction it uses is CK74 for creating. I have also read about KKP4_ADD_ON_COSTS_CR

  • Link to open microsoft communicator

    Hello, I am trying to make a hyperlink that opens a communicator window with a certain user. I have tried sip:[email protected] and im:<sip:[email protected]> but nothing works. If i copy and paste sip:[email protected] into the search bar for IE it