My Blackberry Z10 stock on the BB logo and it wont boot
My Z10 frost and I turned it off and on again. At this point the Z10 came back on but only showed the blackberry logo but would not boot, then I went to Blackberry link and tried to reload and it star OK and the BB light a green light, but then after about 5 minutes the green light comes off and the process interrupts showing a message unspecific error 0X0000049.
If I turn the BB10 off it comes back on by it self to the blackberry logo so I have to take the battery off.
Could any body help?
I just came from one repair shop and they tried downloading latest BB link to see if they could solve the problem but when the phone is extracting its software and the light is green, it then stops what its doing and gives the 00000049 error.
I received a massege from FozzieBear which i appreciate but been in Venezuela, my service provider would not take the phone to send it to blarck berry for inspection.
Is there another way that i could send my BB Z10 to Black berry for them to see what is wrong with this phone?
Similar Messages
-
My i phone 3gs was hang with the apple logo and its not booting
my i phone 3gs was hang with the apple logo and its not booting can any one say me how to fix this .
my phone is blinking with the apple logo and will not start
-
I updated my ipad to ios 8 and now it just has the apple logo and it w3ont do anything
my ipad asked me to update and i did and now all i havve is the apple logo and it wont do anything else
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.
3. Repeat the process if necessary. -
MORNING HAVING A PROBLEM WITH MY Z10 WHEN SWITCH ON IT SHOWS THE LOADING LOGO AND NEVER COMPLETES THE LOADING PROCESS.YOUR HELP WOULD BE APPRECIATED
Checkout this thread: http://supportforums.blackberry.com/t5/BlackBerry-Z10/Z10-stuck-on-loading-logo-on-starting-up/td-p/2517909
-
I tried updating my iPod 5th gen to iOS 8 but it only shows me a picture of the iTunes logo and a charger at the bottom, I'm not sure what this means or what I need to do. Can someone please help me?
After restoring to factory settings/new iPod you will then have to restore from backup
To restore from backup see:
iOS: Back up and restore your iOS device with iCloud or iTunes
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store -
How do I fix a initializing problem with my macbook pro? I only get to the blank screen with the apple logo and the "processing something" sign... it just doesn't start the system....
Please help
MarceloIf there is no loading bar, it's usually a problem with a third party kext file in OS X itself.
You can press the power button down to force a hardware shutdown, then reboot holding the shift key down on a wired or built in keyboard, this will disable them and you go around and update your third party software.
Gray, Blue or White screen at boot, w/spinner/progress bar
Also take this time to backup your users files off the machine if possible.
Most commonly used backup methods
Sometime that won't work and you need to do more
..Step by Step to fix your Mac -
I was trying to transfer itunes to my macpro from my iphone 4 and the phone froze up with the itunes logo and a usb cord looking like its suppose to plug into the itunes.. Now my phone wont go past that screen and i cant use the phone at all... Help if you can?
Contacts are designed to be synced to a supported application on the computer or a cloud service.
Pictures taken with the device are designed to regularly be copied off the device to a computer as would be done with any digital camera.
If you have failed to use the device as designed it may be too late to recovery anything.
Is the device regularly backed up to a computer via iTunes? If so, the most recent backup (when restored to a replacement iOS device) should contain all contacts and pictures as of when the backup was created. -
My MacBook Pro stated that it needed to be updated. I clicked yes to restart the computer and update but when it restarted it stays on the gray screen with the apple logo and then pops up, stating "unable to find driver for this platform." What do I do?
Boot into Recovery by holding down the key combination command-R at the startup chime. Release the keys when you see a gray screen with a spinning dial.
Note: You need an always-on Ethernet or Wi-Fi connection to the Internet to use Recovery. It won’t work with USB or PPPoE modems, or with networks that require any kind of authentication other than a WPA or WPA2 Personal password.
When the Mac OS X Utilities screen appears, follow the prompts to reinstall the Mac OS. You don't need to erase the boot volume, and you won't need your backup unless something goes wrong. If your Mac didn’t ship with Lion, you’ll need the Apple ID and password you used to upgrade, so make a note of those before you begin.
Don't install the Thunderbolt update -- it's defective. -
My iPhone 3gs has frozen while doing update 5.0.1 I think it was. All it shows is the iTunes logo and the usb cable on the screen. I will not turn on or off. I have tried reconnecting to iTunes but nothing happens. Have held both buttons for 10 seconds etc and nothing is working! What can I do?
Here are Apple Steps: http://support.apple.com/kb/HT1808
-
My iphone is no longer working I have black screen with a picture of the itunes logo and a USB cable. When I try to connect my iphone to itunes the device is not detected, can anyone help me? I desperatley need my phone back
I have had a 3GS for 2+ years. After upgrading to IOS 4 (now 4.3.5) I began having problems. In the past week, my screen went to the itunes logo and USB cable twice -- unprovoked -- just found it sitting there like that! I connected to itunes and it did restore from a backup but it is a major inconvenience. I am also searching for answers, but better back-up regularly!
-
my iphone 5 on the ios 7.1.2 suddenly wont fully turn on...it gets stuck on the apple logo and stays like that for approximately to 90 secs then goes blank but I can see a bit of lighting behind the dark screen....it goes off by itself and comes on by itself trying to boot but still gets stuck on the apple logo after the dim light shows....when I connect to iTunes my phone can only be recognised only in recovery mode thus if I force it into recovery mode. My main worry is I don't have a back up of any of my data...on icloud I have just less than 2GB of my data which is as a result of incomplete back up...HOW CAN I GET THIS PHONE WORKING AGAIN WITHOUT LOSING MY DATA...if I can only just recover my data I would really appreciate it as I really need almost everything on it back...if I can only get retrieve my data and lose the phone I wouldn't mind at all....Anybody know how to resolve this??Kind Regards
Anyone have any suggestions? or is everyone else just as clueless as me !
-
my ipod touch is stuck on the apple logo and after a while a white screen comes up and it restarts and the same thing all over agan. this happened to me before and after a while it turns on but why does it keep on doing this?
Try connecting the iPod Touch to your computer and restore it. http://support.apple.com/kb/HT1414
-
On start up of my new iMac it locks on the grey screen with the apple logo and the progress wheel spins. Boot up in safe and this is where it stopped at "BootCacheControl: Unable to open /var/db/bootcache.playlist: 2 no such file or directory. "
Reinstalling MacOS does NOT fix the problem for me. I'm still searching a solution !
Bernard -
how can I unlock my iphone??? on the screen I only have the apple logo and a thing that looks like if the phone is working but no advance
Hi,
Try a Reset of the Phone... You will Not Lose Any Data...
Turn the Phone Off...
Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
The Apple logo will Appear and then Disappear...
Usually takes about 10 - 15 Seconds...
Turn the Phone On...
If that does not help... See Here:
Backing up, Updating and Restoring
http://support.apple.com/kb/HT1414 -
my phone doesn't want to turn off or on, it gives me the apple logo and doesn't turn on at all, help please??
Do a reset by holding the power and home button until the apple logo appears ignoring the slide to power off (no data loss).
Maybe you are looking for
-
When we try to refresh the XI Data cache of INTEGRATION SERVER, the process gets stuck and the Cache is not refreshed. In the defaultrace I see this: checkReceivedPacket [EXCEPTION] javax.jms.JMSException: Internal error. at com.sap.jms.protocol.noti
-
REST API POST and GET Error--Retriving following sites news feed
i have used below code to retrive the newsfeeds but im getting 403 error.i think url formation for POST and GET is wrong.Kindly anyone worked help mee. var feedManagerEndpoint; // Get the SPAppWebUrl parameter from the query string and build // the
-
hi all pls define the words payload and pipeline Thanks.
-
Hi guys. I've been trying to summarize a bunch of rows, but I'm having a little trouble doing that. I have few nested queries which I show below: SELECT DATA, SAP, SADIG, DIFF FROM (SELECT TMPSAP.DATSAP as DATA, TMPSAP.VALSAP as SAP,
-
Lots of audio pops when recording from mixer
I'm using FCP 5.1.4 on a mac laptop (don't know what type it is, but think it's somewhat recent). I'm recording a stage play's audio. Here's my audio flow: Mixer's 1/4" headphone jack -> 1/4" Stereo audio cable -> 1/8" stereo adapter at other end (ha