My computer doesn't recognize my ipod. Help.

I have an ipod 3 and an HP Windows Vista computer. 5 months ago my USB cable was starting to break and sometimes not work, so I desided to buy a new one. I went to Mexico for a family visit (where I'm from) and desided to buy one there while I was at it. But the brand was not apple. When I came back home I used the new USB cable and it worked fine, better than fine, actually, for two months at least, two weeks ago whenever I connected my ipod to the computer many different things started to happened each time:
My computer would send me a message saying "USB Device Not Regognized. 'One of the USB devices conected to this computer has malfunctioned and windows does not recognize it'" (The most common. Happens 5 of every 6 times I conect my ipod) Also I have my ipod set to download all the images from the ipod to computer whenever I saved images in my ipod with "windows Photo Gallery" and even if my computer recognizes the ipod, windows gallery recognizes it too but it doesn't dowload the images because it says there's an error.
For some miracle the computer recognized the ipod but when itunes opens it freezes
If Itunes works for some other miracle itunes tells me the ipod could not be recognized because there was an error from the iphone (when it's not even a iphone)
So I'd really need your help. Is it my computer, my ipod or itunes? Or just what's going on? 'Cause it had all been working fine for me before and this issue started out of nowhere. PLEASE and thank you.

Could be the iPod, the computer or the cable.  Can you borrow a know good cable?  Also see:
iTunes for Windows Vista or Windows 7: Troubleshooting unexpected quits, freezes, or launch issues

Similar Messages

  • My Windows 8.1 computer doesn't recognize my iPod nano 7th generation. Why?

    My Windows 8.1 computer doesn't recognize my iPod nano 7th generation. Why?
    When I connect my iPod to my computer, nothing happens. I've read the tips in the section "support" and I noticed that maybe Windows 8 is not one of the operating systems that are compatible with an iPod nano 7th generation. If I'm right, what can I do if my only device is a Windows 8?

    Hi, Grafiti. 
    Thank you for the question.  Below, I have attached a couple troubleshooting articles that will help resolve the device not being recognized by iTunes.
    iPod not recognized in 'My Computer' and in iTunes for Windows
    http://support.apple.com/kb/ts1369
    If the issue still persists after processing these steps, see the section in the article below labeled Verify that the Apple Mobile Device USB Driver is installed > For Windows Vista, Windows 7, and Windows 8.
    Device not recognized in iTunes for Windows
    http://support.apple.com/kb/TS1538
    Cheers,
    Jason H.

  • My computer doesn't recognize my ipod, why?

    My computer doesn't recognize my ipod, why?Can u help?T.you (i'm french)

    http://support.apple.com/kb/ts1369

  • Why is my computer doesn't recognize my Ipod Touch?

    My computer doesn't recognize my Ipod Touch. Any suggestion?

    Here:
    iOS: Device not recognized in iTunes for Windows
    or
    iPhone, iPad, iPod touch: Device not recognized in iTunes for Mac OS X

  • My computer doesn't recognize my ipod

    My computer doesn't recognize my ipod. It is not visible in iTunes or in the computer icon

    Click here --> iOS: Device not recognized in iTunes for Windows

  • My computer doesn't recognize my ipod when I plug it in.

    My computer doesn't recognize my ipod when I plug it in.  This happened after my daughter connected her ipod to my pc.

    Try here:
    iOS: Not responding or does not turn on
    Next make an appointment at the Genius Bar of an Apple store.

  • Computer doesn't recognize that ipod is plugged in

    So I've had this ipod for at least a year now and have been using the same computer for the past 7 months and it's always worked fine. Now all of the sudden my computer doesn't recognize that it is plugged in. It's not even that it doesn't recognize the USB device it's not there period. I tried manually putting it into disk mode but it still didn't recognize it. Please help!!

    http://discussions.apple.com/message.jspa?messageID=11359368#11359368

  • My computer doesn't recognize my ipod nano 2nd gen

    My computer running Windows 7 doesn't recognize my ipod nano 2nd gen.  Also my ipod not seen in my itunes.  I did all the reset stuff and nothing works.  Do you think it is just shot???

    Make sure you have the latest version of iTunes. Are you a Mac or PC user?
    Hm so have you also tried completely erasing your iPod?

  • My computer doesn't recognize my iPod and therefore will not sync my new music

    When I plug my iPod up to my computer, my computer doesn't recognize that the iPod is plugged in. I've tried reinstalling iTunes and this iPod has synced with this computer before.

    Hy there,
    In order for you to solve this problem you have to follow these stept if your running windows:
    1'st step is to go into the device manager
    2 step is to go to portable devices (it is right under network adapters)
    3 step is to right clic apple ipod and click update drivers
    4 step is to brows your drivers from C:\Program Files\Common Files\Apple\Mobile Device Support\Drivers
    After that your itunes will pump up alown and youl see your iphone right there.
    If these doesent work try restarting your device and then see what happens.
    Good luck and sry for my bad righting.
    Andrei

  • My computer doesn't recognize my iPod when hooked up through a USB port?

    I restarted my computer and my iPod, and it doesn't work. The iPod does not recognize being hooked up to a computer, and the computer does not recognize that the iPod is hooked up to it. My iPod's not even charging when connected to my computer. This first occured when I disconnected my iPod from my XBox 360 while the 'Do Not Disconnect' screen was shown. However, the iPod still works with my XBox 360 as well as my AC adapter charger. The iPod also does not show in Device Manager, so it's not recognized by Windows or iTunes. Any help is greatly appreciated, thanks in advance.
    Windows XP   Windows XP   Compaq Presario Intel Pentium 4

    Try here:
    iPhone, iPad, or iPod touch: Device not recognized in iTunes for Windows
    or
    iPhone, iPad, iPod touch: Device not recognized in iTunes for Mac OS X
    Yu need iTunes 10.5 or later

  • My computer doesn't recognize my ipod shuffle anymore

    I have downloaded music before (a while ago actually) on my ipod shuffle (2nd generation). A couple of days ago I bought some music on itunes and when i connected my ipod to my computer it said that it doesn't recognize the usb port.  Can somebody help me ?
    Thanks and merry x-mas
    France007

    Hello France007,
    It sounds like your iPod Shuffle is not being recognized in iTunes in Windows. I found this article for you to help troubleshoot the issue named:
    iPod not recognized in My Computer and in iTunes for Windows
    http://support.apple.com/kb/ts1369
    Here is a general overview of what the troubleshooting will entail:
    1. Start with the iPod Troubleshooting Assistant
    If you haven't already done so, use the iPod Troubleshooting Assistant that applies to your iPod. This will often solve your issue.
    If you're still experiencing the issue after going through each of the steps in the assistant, continue with the steps below in this article. The most likely solutions are listed below (for both USB and FireWire (IEEE 1394) iPod connections). Check each section starting from the top of the list to see if that is what's keeping your iPod from appearing.
    Note: To determine if your iPod syncs via USB or FireWire, check the table in the Additional Information section below.
    2. If your iPod displays an exclamation point folder or sad iPod icon
    3. Charge the iPod and make sure it is getting power
    4. Secure the iPod's connections
    5. Disconnect other USB Devices
    6. Determine whether your iPod's cable functions properly
    7. Place the iPod into Disk Mode
    8. Determine which format the iPod is in
    9. Verify that USB drivers are installed
    10. Determine if Windows confuses iPod with a network drive
    11. Determine if third-party software may be causing conflicts
    12. Reinstall iTunes
    13. Make sure FireWire card is a WHQL-certified IEEE 1394 card
    14. Check for a conflict in the FireWire chain
    15. Determine if there may be an issue with your computer
    16. Your iPod needs service
    Thank you for using Apple Support Communities.
    Take care,
    Sterling

  • My computer doesn't recognize my Ipod and it is disabled

    After not using my ipod touch fro a while, I forgot the password. I used up all the tries, and now it says that it is diabled and i have to connect it to my itunes. When I plug it into my Windows 8 computer, itunes doesn't recgonize my ipod. It is on file for back up, but nothing happens. My itunes is up to date. I don't know what to do. I've tried so many different things.

    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                         
    If recovery mode does not work try DFU mode.                        
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings        
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: Back up and restore your iOS device with iCloud or iTunes
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload most iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store        
    If problem what happens or does not happen and when in the instructions? When you successfully get the iPod in recovery mode and connect to computer iTunes should say it found an iPod in recovery mode.

  • HELP! My Computer doesn't recognize my ipod nano

    so i have one of the older nanos.(the one's that are either white or black and thin). So I go to plug it in and *my ipod doesn't show up on my itunes*! i'm scared because not all of my songs are backed up and I don't want to restore it! please, any help would be much appreciated.
    <3lyndsp<3

    Have you had a chance to look at these troubleshooting pages? They may be of some help:
    iPod shows up in Windows but not in iTunes
    iPod missing in My Computer and in iTunes
    iPod is not recognized properly by computer when USB drivers are not installed properly or are out of date

  • Hey my windows 7 computer doesn't recognize my ipod? and my  ipod is stuck in the connect to itunes screen and is low battery but doesn't want to charge? help

    Plese help?
    First my ipod didnt show it was charging but still turned on(it was dead) so i tried the hold sleep and wake button but my computer(windows 7) wont recognize it so its stuck on the connect to itunes screen.
    PS i took it to get it fixed and they said they changed the battery not sure if that had anything to do with it????
    please help and Thank You.

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar
    - See:
    iPod touch: Hardware troubleshooting
    - Try another cable
    - Try another charging source
    - Inspect the dock connector for bend or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
    - Make an appointment at the Genus Bar of an Apple store.
    Apple Retail Store - Genius Bar

  • Help - My computer doesn't recognize the ipod nano

    I bought a new 4GB nano yesterday. I plugged it in and charged it with the USB. It does not show up on itunes and I can't eject it. My 2GB nano works fine. Am I doing something wrong or is there something wrong with the nano? Thanks.

    I got a new nano 4GB for my son. It shows up on I tunes with a padlock symbol at bottom of screen. I can't do anything with it on I tunes. I have a shuffle and any music from that transfers onto the Nano. He can here music through the Nano but can do nothing on the I tunes page.
    HELP

Maybe you are looking for

  • Imac hard drive replacement

    Incredibly my rarely used 2011 Imac Hard Drive is toast. I saw they have a replacement program but even though it is way too soon for a hard drive OF QUALITY to be going out so soon as mine - mine is not included in the replacement program.  Which I

  • How to replace a MacBook Model# AT181 Logic Board?

    The MacBook Model# AT181 Starts up with no display and the white sleep light is lit and I can't wake it up? Please help me if anyone know of a solution?

  • Can't Delete "StartupManager" or "InputManager" folders after sys reinstall

    I had to do a archive and reinstall awhile back. Everything went fine, and I recently tried to delete the "Previous Systems" folder. Everything in the folder was deleted except for 2 locked folders named StartupManagers and InputManagers, which were

  • Dynamically Convert  to Sales UOM in Sales Order

    Hello, Our customers sometimes send us purchase orders in a Unit of Measure that is different than our Sales Unit of Measure for a material.  Custoemr service would like the system to convert from the Customers UOM on the Purchase order to the Sales

  • Cursor List Property - error 1077

    Hello I'm trying to programatically create cursors in the Waveform Graph. I want to have as many cursors as plots in the graph. See the attached VI. And now the weird thing: when I decrement number of plots, everything is OK - plots are shown, cursor