My computer doesn't recognize my SD card! what can I do?
When I insert my SD card from my camera, the computer doesn't recognizes it. What can I do?
thnx
try a diff. SD card. What then? Tried an SD card to USB reader to verify if the SD card slot is bad?
Similar Messages
-
Hi, The computer in my MacBook Pro 10.6.8 isn't showing up in Skype (the indicator light doesn't show and it doesn't show in Skype preferences). Also Photo Booth doesn't recognize a camera. What can I check for please?
Hi Lee again..
Please do not startup duplicate topics. I responded to you here > Hi, The camera in my MacBook Pro 10.6.8...: Apple Support Communities
Sometimes navigating the forums can be difficult.. we understand that. -
I restored my iphone 4s and now doesn't recognise the sim card what can i do?
i restored my iphone 4s and now doesn't recognise the sim card what can i do?
Was your iPhone hacked/jailbroken to be unlocked?
If so, installing an iOS update on an iPhone that was hacked to be unlocked or restoring such an iPhone with iTunes re-locks the iPhone to the carrier the iPhone was sold as carrier locked with.
What is the exact error message - the SIM card is not supported? -
Solaris 9 x86 doesn't recognize my lan card and can't get the drivers
Hi guys! I have a problem with my solaris os.. It doesn't recognize my realtek 8029 lan card and this means that i can't download the drivers from the internet.. Anyway i got the drivers using my other installed OS ( slackware linux 9 ) from the www but there's a problem it seems that i cant mount the harddrive where the driverz are..neither linux->mount solaris hd disk nor solaris->mount linux hd disk do the trick..(+ i don't have a floppy drive ) Any ideaz how to transfer the drivers from the hd disk where the linux is installed to the solaris disk..?
I have the same NIC (RTL 8029 chip), and.. the solution 4 you. :) I made this quick guide for me, so I can add netwotk support to my system, very easily. Happy to see that another person needs that info.
Follow these steps:
1. Download the file from the link below, put it at /, and unzip it.
ftp://sun.drydog.com/pub/solaris/nei-i86pc-solaris5.7.zip
2. Run (from command line) the command:
add_drv /kernel/drv/nei; devlinks
3. Create the file /kernel/drv/nei.conf and write
name="nei" parent="isa" reg=1,0xe800,0x1f interrupts=5;
(this is the hardware address for my card, you should find your's).
4. Create the file /etc/hostname.nei0, whick will contain the line
192.168.0.1
(this is the IP addr. I use for my internal network, change that to any other reserved addr. you like, like 10.0.0.1)
5. If you use IPv6, create /etc/hostname6.nei0 ,too, with the same contents as hostname.nei0
192.168.0.1
6. Edit /etc/hosts and add the line:
192.168.0.1 myname.mydomain
7. Edit /etc/inet/hosts and make the file look like this:
127.0.0.1 localhost
192.168.0.1 myname.mydomain loghost
8. Edit /etc/inet/netmasks and put:
192.168.0.1 255.255.255.0
9. Run from command line mode or from a terminal:
/usr/sbin/drvconfig -i nei
10. Run from command line mode or from a terminal:
touch /reconfigure; /usr/sbin/reboot
11. After rebooting, type "ifconfig nei0 plumb" to make sure the device was recognized.
It should show up in the output from typing "prtconf"
Normally, now you can use your RTL8029 card.
I hope I help a little bit mate. :) -
My iphoto doesn't recognize my iCloud account. what can I do?
I am trying to email pictures from iPhoto and it won't recognize my iCloud account. What can I do?
Welcome to the Apple Community.
For the avoidance of doubt, have you added the account in iPhoto preferences. -
I can't use it anymore! Please help me, I can't live without my iphone!
There should have been an error message with an error number. Knowing that number is all-important in identifying the problem. See: http://support.apple.com/kb/TS1275 and http://support.apple.com/kb/TS1538
-
When I try to synchronize the music library from i tunes to my i pod, i tunes says that ther is no i pod connected, what can I do in order to reset the conection, the I pod its connected to the USB port # 1 and the library for i tunes and the aplication (program) are instaled in an external hard disc drive connected to the USB port # 2
IBM thinkpad T43 Windows XP portatilhas anyone helped you with this?
-
My computer doesn't recognize my ipod, why?
My computer doesn't recognize my ipod, why?Can u help?T.you (i'm french)
http://support.apple.com/kb/ts1369
-
Need help with iphone 4. tried to download new software and it zorked sim card and phone. Only get a blinking apple icon. Computer doesn't recognize iphone so I can't restore
Hello henry lfrommiami,
Thanks for using Apple Support Communities.
To troubleshoot this issue where your iPhone gives you the message "No SIM Card installed" please follow the steps below.
Update your iPhone to the latest version of iOS.
Turn airplane mode on and then off again.
Restart your iPhone.
Check for a carrier settings update. Go to Settings > General > About. Install any available update.
Remove the SIM card and make sure that it's a valid SIM that your carrier provided. Also make sure that it's not damaged, worn, or modified. Then reinsert it.
A SIM tray that comes with one iPhone model won't necessarily work with a different iPhone model. When you insert the correct SIM tray, the SIM tray should be flush with the device.
If you have another SIM card, insert it. You can use a SIM card from any phone with the same format as your iPhone SIM card. If your iPhone works with that SIM card, contact the carrier that issued your original SIM card.
Restore the iPhone.
If you still see the issue, contact Apple support.
If you see 'No SIM' alert on iPhone
Cheers,
Alex H. -
My computer doesn't recognize my ipod shuffle anymore
I have downloaded music before (a while ago actually) on my ipod shuffle (2nd generation). A couple of days ago I bought some music on itunes and when i connected my ipod to my computer it said that it doesn't recognize the usb port. Can somebody help me ?
Thanks and merry x-mas
France007Hello France007,
It sounds like your iPod Shuffle is not being recognized in iTunes in Windows. I found this article for you to help troubleshoot the issue named:
iPod not recognized in My Computer and in iTunes for Windows
http://support.apple.com/kb/ts1369
Here is a general overview of what the troubleshooting will entail:
1. Start with the iPod Troubleshooting Assistant
If you haven't already done so, use the iPod Troubleshooting Assistant that applies to your iPod. This will often solve your issue.
If you're still experiencing the issue after going through each of the steps in the assistant, continue with the steps below in this article. The most likely solutions are listed below (for both USB and FireWire (IEEE 1394) iPod connections). Check each section starting from the top of the list to see if that is what's keeping your iPod from appearing.
Note: To determine if your iPod syncs via USB or FireWire, check the table in the Additional Information section below.
2. If your iPod displays an exclamation point folder or sad iPod icon
3. Charge the iPod and make sure it is getting power
4. Secure the iPod's connections
5. Disconnect other USB Devices
6. Determine whether your iPod's cable functions properly
7. Place the iPod into Disk Mode
8. Determine which format the iPod is in
9. Verify that USB drivers are installed
10. Determine if Windows confuses iPod with a network drive
11. Determine if third-party software may be causing conflicts
12. Reinstall iTunes
13. Make sure FireWire card is a WHQL-certified IEEE 1394 card
14. Check for a conflict in the FireWire chain
15. Determine if there may be an issue with your computer
16. Your iPod needs service
Thank you for using Apple Support Communities.
Take care,
Sterling -
My ipod touch (4gen) won't turn on or charge. My computer doesn't recognize when I plug the ipon in. What can I do?
same problem over here
-
My Windows 8.1 computer doesn't recognize my iPod nano 7th generation. Why?
My Windows 8.1 computer doesn't recognize my iPod nano 7th generation. Why?
When I connect my iPod to my computer, nothing happens. I've read the tips in the section "support" and I noticed that maybe Windows 8 is not one of the operating systems that are compatible with an iPod nano 7th generation. If I'm right, what can I do if my only device is a Windows 8?Hi, Grafiti.
Thank you for the question. Below, I have attached a couple troubleshooting articles that will help resolve the device not being recognized by iTunes.
iPod not recognized in 'My Computer' and in iTunes for Windows
http://support.apple.com/kb/ts1369
If the issue still persists after processing these steps, see the section in the article below labeled Verify that the Apple Mobile Device USB Driver is installed > For Windows Vista, Windows 7, and Windows 8.
Device not recognized in iTunes for Windows
http://support.apple.com/kb/TS1538
Cheers,
Jason H. -
I have an 11" MacBook Air. When I plug in my VGA adapter to my Thunderbolt port, the computer doesn't recognize it ... unless I reboot the computer. Is there another way to get the computer to recognize the adapter? (It works with my MacBook Pro)
Thanks for the useful feedback, Knucklesmac. I agree. I must have blown something on the logic board -- because I had a faulty old KVM switch that would not switch between computers without some nasty hot-plugging/unplugging the VGA video cables. (wince!). It's like when Dizzy Dean ruined his arm because a line drive hit him in the foot and he readjusted his mechanics around the injury. I take the blame because this has been a great computer, and does not deserve any blame.
If it will help anyone else reading this thread, C2G (née Cables to Go) has some interesting ideas for still getting external video out of this computer:
-USB-to-VGA
http://www.cablestogo.com/product/30545
-Convert s-video or composite video signals to high resolution VGA
http://www.cablestogo.com/product/40971
The price range is $75-$85, which doesn't make horse sense to me for such an old computer -- which has a lot of life in it anyway, because its own 15" monitor is not chopped liver.
el7 -
Computer doesn't recognize my printer since upgrade
my computer doesn't recognize my printer since upgrade to yosemite
Hi ..
Try a reset > Mac OS X: How to reset the printing system
If a reset doesn't help, visit the website for your printer manufacture then search for v10.10 Yosemite drivers to download and install. -
Computer doesn't recognize administrator password. How to override or reset?
Computer doesn't recognize administrator password. How to override or reset?
You cannot override but you can chage it, the approach depends on the Mac OS X you are using.
Maybe you are looking for
-
How do you remove an apple id from find m iphone if you are unable to contact previous owner
i bought a phone from someone 4 months ago on craigslist and never went to activate it until now and saw that it wont let me passed the activation screen and im not able to contact the seller because i don't have their information how can i get it re
-
IE 11 zoom default 125% based on display settings in control panel.
Using Windows 7 Enterprise with 2 displays I have my display settings set to increase windows objects and text by 125%. IE 11 appears to compound this by defaulting to 125% zoom on startup default. If I set the display control back to 100 the defau
-
As a trainer i would like to train others how to work with either of these tools - the ipad or the Mac Air. Starting out in the world of Mac as i embark on this journey i want to ensure the path i choose will work. in other words, based on the experi
-
Need advise setting up bootcamp please
Hi I am new to setting up partitions and bootcamp. Please can you advise me: 1. How do I know how much space I will need? I'm installing MS Money, TurboLister (ebay), Windows, Office. If I setup Bootcamp, can I increase the partition if I decide to i
-
Commercial & Excise invoice no Should be same.
Hi, i want that my commercial invoice & Excise invoice no should be same. How to achieve this? any negative effects of this? Regards, Amol