My I pad 3 will not come on no matter what I do and it was working until I plugged it into the charger.
I've tried plugging and unplugging the charger, holding both buttons in for ten seconds. Even took it to cell phone repair and they couldn't get it to come alive. Any ideas?
Try reset iPad
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected.
Similar Messages
-
I was just listening to my iPod shuffle and it stopped working. I plugged it into the computer to sync it and it won't sync. The little light don't come on on my nano. I've turned it off and on, pushed the play/pause and nothing. Can anyone help me out here?
How long have you left the iPod to charge? It can take up to 30 minutes before it shows any signs of life. Did you use the instructions in this article to properly reset the Shuffle?
Resetting iPod shuffle
B-rock -
my ipad will not come on. i tried to restore and get error message 1603, dont know how to take out itsw which it tells me to do.
Error 1603
Follow the steps listed below for Error 1604. Also, discard the .ipsw file, open iTunes and attempt to download the update again. See the steps under Advanced Steps > Rename, move, or delete the iOS software file (.ipsw) below for file locations. If you do not want to remove the IPSW in the original user, try restoring in a new administrator user. If the issue remains, Eliminate third-party security software conflicts.
Error 1604
This error is often related to USB timing. Try changing USB ports, using a different dock connector to USB cable, and other available USB troubleshooting steps (troubleshooting USB connections. If you are using a dock, bypass it and connect directly to the white Apple USB dock connector cable. If the issue persists on a known-good computer, the device may need service.
If the issue is not resolved by USB isolation troubleshooting, and another computer is not available, try these steps to resolve the issue:
Connect the device to iTunes, confirm that the device is in Recovery Mode. If it's not in Recovery Mode, put it into Recovery Mode.
Restore and wait for the error.
When prompted, click OK.
Close and reopen iTunes while the device remains connected.
The device should now be recognized in Recovery Mode again.
Try to restore again.
If the steps above do not resolve the issue, try restoring using a known-good USB cable, computer, and network connection.
The above is from the 2nd link below.
Update and restore alert messages on iPhone, iPad, and iPod touch
http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
iOS: Resolving update and restore alert messages
http://support.apple.com/kb/TS1275
iPad: Unable to update or restore
http://support.apple.com/kb/ht4097
Cheers, Tom -
My iPhone4 will not come on. When i plug it into the charger, it only says connect to iTunes. When I tried restoring it, it said my iPhone4 could not be restored.
Try this
http://support.apple.com/kb/HT1808 -
Ever since I downloaded the new Firefox, when I right-click on a link to open it in a different tab, the tab will open but will not load anything, no matter what link I try. The tab will show the website destination in the navigation bar, but will not automatically load it; I have to press the load button in the navigation bar instead of it instantly loading.
== This happened ==
Every time Firefox opened
== The newest version, 3.6.6, of Firefox was downloadedIt's not specific sites. I can middle-click on the same link 50 times and it will open it in a new tab 45 times and 5 of those times, it will randomly open it in an entirely new window. I don't know what's causing this.
It happens so randomly that I don't know how to pin-point what it could be. -
Why is my location city changed by Firefox to a town I don't live in? I put in my zip code in the weather info and it will not hold it no matter what I do. This is very frustrating and never a problem in the past. IE doesn't have the problem. Can anyone help?
1) Is it a video clip? Something you recognize? To be clear, it's displaying at a point in your exported movie but doesn't appear at all in the sequence?
2) What are your sequence settings? Right-click your sequence and choose "Item Properties" to verify. -
My camera is very dark and will not get lighter no matter what light i am in, how do i fix it?
my camera on my mac is very dark and will not brighten up no matter what lighting i am in, how do i fix it?
what brand
-
What do i do my iphone will NOT turn on it is like stuck its fine it hasnt been dropped kicked or thrown or hurt in any way its just i plug it into the wall in the charger it will not turn on its a black screen and also i hold the ON Button and its still not working I tryed plugging it into the Computer and still Nothing...What do i do?!?
What do i do my iphone will NOT turn on it is like stuck its fine it hasnt been dropped kicked or thrown or hurt in any way its just i plug it into the wall in the charger it will not turn on its a black screen and also i hold the ON Button and its still not working I tryed plugging it into the Computer and still Nothing...What do i do?!?
-
My ipod froze so I restarted it, but then it happened again, so I restarted it again, and it was fine but then it ran out of battery. Now when I plug it into the charger it, the Apple sign comes up for 5 seconds then disappears, it doesn't turn on or come up with the charging sign. Is it not going to work again, or is ther something I can do? Please help.
I have the same problem, and my Ipod turned off (when I held the home and power button)
but then when I held down the home button (after turned off) nothing happened, the screen is still black.
Do you know what I should maybe do?
Thanks is advance -
Hello I am using Ipad 4 and its charger is not working while I was using it few days before and it was working properly now it says that the cable does not support this Ipad Please Help me out.
Try a reset:
- Hold the home button and sleep/wake button down at the same time. When the Apple logo appears release both buttons then try and charge again.
If issue persists try:
- Another known working cable
- Check the charging port for any damage or debris
- You could also use a dry soft bristle toothbrush and gently brush it on the port to clean it of any debris that could be in there -
My ipad will not allow me to delete my Facebook account. I went to settings an tried to delete my account will not let me. I even entered my password an it said it was incorrect. I also uninstalled my Facebook app an tried to reinstall it am it still will not log out or let me delete my account. PLEASE HELP ME.
Can you log into Facebook from Safari (just to make sure you're entering the right password)?
-
My iPhone 4 started to blackout out of nowhere and it wont work only until I plugged my phone into the charger. It has been going on for several times in a day, where it just randomly blacks out. Do anyone know what is the problem and how do I exactly fix this? thanks
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
What does it mean when your screen just goes black and will not turn back on? I can connect it to computer to charge and it recognizes it and charges it but no picture on screen.
Hey Krkirst10,
Thanks for the question. It sounds like you may have a hardware issue with your device, however let's try to isolate as much as possible to determine if that is so. To isolate the issue, follow the regular troubleshooting steps for power issues:
Will not turn on, will not turn on unless connected to power, or unexpected power off
1. Verify that the Sleep/Wake button functions. If it does not function, inspect it for signs of damage. If the button is damaged or is not functioning when pressed, seek service.
2. Check if a Liquid Contact Indicator (LCI) is activated or there are signs of corrosion.
Learn about LCIs and corrosion.
3. Connect the iPhone to the iPhone's USB power adapter and let it charge for at least ten minutes.
4. After at least 30 minutes, if:
- The home screen appears: The iPhone should be working. Update to the latest version of iOS if necessary. Continue charging it until it is completely charged and you see this battery icon in the upper-right corner of the screen. Then unplug the phone from power. If it immediately turns off, seek service.
- The low-battery image appears, even after the phone has charged for at least 20 minutes: See "iPhone displays the low-battery image and is unresponsive" symptom in this article.
- Something other than the Home screen or Low Battery image appears, continue with this article for further troubleshooting steps.
5. If the iPhone did not turn on, reset it while connected to the iPhone USB power adapter.
- If the display turns on, go to step 4.
- If the display remains black, go to next step.
6. Connect the iPhone to a computer and open iTunes. If iTunes recognizes the iPhone and indicates that it is in recovery mode, attempt to restore the iPhone. If the iPhone doesn't appear in iTunes or if you have difficulties in restoring the iPhone, see this article for further assistance.
7. If restoring the iPhone resolved the issue, go to step 4. If restoring the iPhone did not solve the issue, seek service.
My issue is still not resolved. What do I do next?
Contact Apple Support.
For additional information, see this article:
iPhone: Hardware troubleshooting
http://support.apple.com/kb/TS2802
Thanks,
Matt M. -
My phone was working fine, then just went completely blank, and now is totally unresponsive
Plug it in to mains power for at least 15 minutes. If it doesn't automatically come on, try a Reset... press the home and sleep/lock buttons until you see the Apple logo, ignoring the slider. Takes about 5-15 secs of button holding and you won't lose any data or settings.
-
Keyboard lights will not stay off no matter what I do on my MacBook Pro. Why??
I've got a MacBook Pro 2.4 GHz Core 2 Duo.
I have ALWAYS left the keyboard lights off for the 4 years I have had it.
But lately, no matter what settings I change or what I try, I cannot PREVENT the keyboard lights from coming on when I've been away from the computer for a long period of time.
Automatically illuminate keyboard in low light is NOT checked in System Prefs. I have reset the PRAM, and left the laptop off with the battery off for hours in hopes of resetting it.
Nothing will work. Almost every time I am away from my computer for hours, I come back and the keyboard lights are on. And when I tap the keyboard light brightness buttons, it just gives me the buster symbol (white circle with a line through it) on screen below the keyboard light brightness indicator for a few seconds. Somehow continuing to tap those buttons eventually makes the lights just turn off. Or holding my hands over the whole keyboard to trigger the sensor can suddenly allow me to control the on/off brightness with those buttons again. In which case I try turning the lights off completely or turning the brightness so low that it goes off.
But once again, when I wake up in the morning, I find the keyboard lights on.
Now the ONLY thing that has changed since this started happening is that I added a new User account. BUT that should asbolutely not cause this problem. I have checked to see if the System Preferences for the keyboard lights in the new user account were causing a conflict, but no, they are exactly the same as my main account.
I have not tried deleting the user account yet because I actually want it and would find it very hard to believe that was the culprit. It's just the only thing I can think of that changed shortly before this started happening.
Is there anything else I can do!?! Is there some preference file that controls the lights somewhere that could be corrupt that I need to trash?
Thank you for any help anyone can provide. This one has stumped me good.From reading up of other forums with the same problem i have come up with two reasons why it is doing that.
first try doing a smc reset
if that does not work then it is a hardware error. Many people have had the problem and they have not been able to fix it so good luck
Maybe you are looking for
-
Occasionally, I will close my Macbook Pro when I'm not using it, and when I reopen it my wireless network shows as being connected, but the internet will not function whatsoever. I tried disabling the WIFI and re-enabling it but the problem persiste
-
I have a JComboBox, when i navigate between the various items inside the Combobox, it gets highlighted by some color. I want to know how to get that color object, i want to use the same color for something else. What would be the RGB combination for
-
I installed new version 4. Whenever I double click on any htm or html document it will not open with firefox it gives a message window saying "Windows can not file path please type correctly" (not extact these words) .. It was working when old firefo
-
How can I register a Event for TAB???
Hi, my problem is, that i search for an solution to register an Event for Tabulator (Tab Key). If i klick to tab, than it must be trigger the event!! I have found in forum following: http://webcache.googleusercontent.com/search?q=cache:fk2pfn0bhiwj:w
-
Sales order Copying Requirement
Dear Experts, I went to transaction VOFM to maintain the Copying Requirement for the Sales Order. When I create a new Routine number, I found out that some has the importing parameter BY_SUBRC in the Subroutine and some do not, I want to ask when th