My I phone 4s has stopped working
My I phone 4s has stopped working, as only the cam was working in start but now its fully hanked. Home button is also not working. What should I do?
Hello there Wiljalu,
I found an article about troubleshooting audio issues with the iPhone speakers. Named iPhone: Can't hear through the receiver or speakers found here http://support.apple.com/kb/TS1630. Although the issue is not exactly what you are experiencing, the troubleshooting is valid.
Resolution
Verify that there is nothing plugged in to the headset jack, including headsets, headphones, or adapters.
Make sure the Ring/Silent switch is not switched to silent.
While on the Home screen, adjust the volume buttons. If you see the icon below, indicating that headphones are attached, there may be debris or an object lodged in the headset jack:
Check the headset jack. If there is an object lodged in the headset jack that is not easily removed, have the iPhone serviced to remove object.
For Original iPhone: If there is light debris, such as lint, in the headset jack, try connecting a pair of headphones to the headset jack and then remove the headphones. Repeat this several times to remove the debris.
If you have installed a protective film on the display, either ensure that the receiver is not covered or remove the film completely.
Check the receiver mesh (which is on the top front of the device, above the display). If it appears blocked, use a clean, small, dry, soft-bristled brush to carefully and gently brush away any debris.
If you have paired with a Bluetooth headset that is nearby, either use the headset or turn Bluetooth off (chooseSettings > General > Bluetooth).
Restart the iPhone.
If restarting the iPhone doesn't resolve the issue, try restoring the device.
If the issue persists, go to the Service Answer Center - iPhone for information on service.
Regards,
Sterling
Similar Messages
-
I have an Iphone 5 on contract with T-mobile/EE. The lock button on my Phone 5 has stopped working completely. It just will not work anymore so I have to rely on the auto-lock . Will apple replace my phone or do I ahve to take it back to T-mobile? It is just short of a year into a 24 month contract.
Yes; If it's under the one year hard ware warrnety and it doesn't have any damage on the device you can get it replaced, contact Apple ASAP
-
My i phone 5 has stopped working on both my car stereos
hello all my i phone 5 has just stopped working in both my car stereos. it still charges but won't play. on one i get "error 19" and the other "not supported" they both where working on the 31/12/12 but not now ?? any one any idea why ???
has there been an update of software(iso) over the last few days ???
-
TS1630 I had purchased IPHONE 5S in MAY 2013 and in NOV 2013 my phone ringer has stopped working
i had raised a call earlier also 531814968 and with this id the executive tried everything possible to get my phone work but nothing happened.
and then I was told by the customer care executive that i will have to go to the same vendor from where i purchased it since i was in india and i ahd bought it from Dubai I sent it back but now that vendor is not replacing the phone.
The phone is still under warranty and I am surprised to see this kind of unethical practice.
I need this phone to be replaced. kindly please let me know how do i go about it. I can help with the vendor details.No one here can do anything about it. The warranty is NOT valid outside of the country where the phone was originally sold. Get on a plane and take it back there to an authorized service provider.
-
When I click on any of my movie or TV shows in Itunes I immediately get an error message that says Itunes has stopped working and closes the program. I can sync the movies and shows to my phone okay but I can't watch on Itunes. Can anyone help?
Let's try the following user tip with that one:
iTunes for Windows 10.7.0.21: "iTunes has stopped working" error messages when playing videos, video podcasts, movies and TV shows -
The last several days I have not been able to access the dial pad. When I go to phone a pop up appears that says "unfortunatly contacts has stopped working." To remove the pop up you have to hit 'ok', the it goes back to the home screen. This also happens when I go to contacts.
You migh give resetting your NVRAM a try:
http://support.apple.com/kb/ht1379 -
Hi, Suddenly my iphone 3g phone's touchscreen's middle portion has stopped working.
Hi, Suddenly my iphone 3g phone's touchscreen's middle portion has stopped working. while dialling through keypad or for adding new contact my 789 & Q to P in keypad is not responding my touch (not working). Please help me out in sorting out this problem.
Basic troubleshooting from the User's Guide is reset, restart, restore (first from backup then as new). Try each of these in order until the issue is resolved.
-
When I sync my phone it gets to step 6 the does not complete the sync i get a message that says itunes has stopped working and needs to close anyone else have this issue
The same problem here!... My itunes stucks on "preparing to sync" when sync my ipad 2, and stucks on iphone 4 calendar sync...
Any solution?? Need help, please!!
Macbook pro 13 i7
Iphone 4
Ipad 2
Thanks!!! -
I have a problem with my viber.It has stopped working.I tried reinstalling it again .On the setup option after entering my phone number and continuing ..it either exists or gives no service message .My other applications are working fine ..other applications that require internet too are working fine.
Please get in touch with Viber's customer support.
-
I have changed my account to SIM only and when I put my new SIM Card into my iPhone 4 it just says 'no service' in the top left corner, also iMessage has stopped working too. I can only use my phone on my WiFi at the moment, does anyone have any idea?
I already have, I contacted Orange yesterday and they said I will receive a text to confirm the registrastion for my new SIM Card, they said the text would arrive between 2 and 24 hours and its been over 24 hours with no text recieved
-
Hi
My iphone 4 has stopped working...the lock button IS working...when it stopped working it had a 50% battery remaining...it was working when I last used it and when I returned it had a blank screen....it will now not charge or connect to itunes when plugged into the computer and it will not charge on the plug socket....I think the last iOS op system updated was 5.1.1....please helpTry holding both home and power buttons until apple logo appears (ignore on/ off slider) and then let go. No data will be lost. Wait for phone to restart
-
iphone 4s "slide to unlock & slide to turn off" has stopped working and i cant unlock phone, how can i fix it please ?
when i conect to itunes to restore it tells me "find my iphone must be turned off" but of course i cant unlock my phone to do that.
im stuck please help..How about a hard reset. Hold the top button down along with the home button until the phone turns off.
-
My Wi-fi on/off button in setting has stopped working and I can't even attempt to find anything does anyone know how I can fix it?? I've already reset the phone setting, network and factory settings
can you see the wi-fi address in the about? if it show N/A, your iphone needs to be repaired.
if your ios is 5.1.1 or you can see the wi-fi address,you could try to connect your iphone to the itunes to restore and update. -
The ringer switch on the side of my Iphone 4S has stopped working and the phone is now turning itself on and off silent without me touching any buttons. Will this be covered under warrenty? I have had the phone for less than a year. Although I have had the screen replaced, and wondered if this may void the warrenty?
Yes, the screen replacement (I am assuming by you our a 3rd party) voided your warranty.
-
Thread- unfortunately the process com.android.phone has stopped working
Hello Everyone,
I am Rohit from India but recently moved to new Zealand. I have been fan of lenovo since 2008 when I purchased first laptop Lenovo 3000 Y 410. after that I have recently imporated Lenovo vibeX S960 phone.
It was started and working well initially. but one day the message pop up about upgrade the firmware.
I have updated it to Kitkat 4.4.2. After that I have been constantly getting message " unfortunatly the process com.android.phone has stopped working".
I have tried factory reset few times but the error has not been removed.
I am annoyed by this problem.
Kindly give me solution. plstry this: settings/appsswype to left until you reach ALL tab.scroll down to Phone icontap ittap on clear datatap on force stopreboot your device then try again with SSID code, if it still crash, only a factory reset probably will fix the issue.
Maybe you are looking for
-
Type of a field in select query
i have a query like this: SELECT SINGLE (lwa_mat_attr-zattribute) FROM mara INTO lv_value WHERE matnr = <fs>-matnr. can anyone tell me what would be the type of lv_value. because i have got a dump in the type declar
-
How can I change the color of all folders from light blue to another color?
My computer was just upgraded from Tiger to Leopard, and now all the file folder icons are pale blue on the desktop and elsewhere. My desktop is green and those light blue folders do not look good on a green background. How can I change the color of
-
Ipod Nano 6th Gen damaged Apple won't repair...any options?
I have had my Ipod Nano 6th gen for about 8 months and used it religiously during work outs...unfortunately I sweat a lot and apparently this will damage Ipod Nano to the point that Apple considers this to be outside the guidelines of normal manufact
-
It seems like something has changed with 10.5.6 or so with respect to the ability to use networked drives. I have a PowerMac G5 that I have been using as a server with an second internal (IDE) drive that I have been using for time machine backups fro
-
Message when opening a pdf cannot find HelveticaNeue-Roman. What can I do?
I'm getting a message when openign a pdf in Adobe Reader X that says cannont find HelveticaNeue-Roman. The document opens but is not easy to read. I think this started after an upgrade late last year. How do I correct this?