My i4s phone does not ring on incoming calls.  The settings appear to be correct

My i4s phone does not ring on incoming calls.  The settings appear to be correct for the phone to ring.
Also, during a call, when I hit the speaker buttom, I can neither hear nor be heard by the other party
Any suggestions?

Try a factory restore, this might be a software problem so just plug into itunes and go and click the restore button. If this doesnt fix it then its a hardware problem meaning you need to head to an apple store for a replacement.

Similar Messages

  • HT4515 phone does not ring during incomming call

    phone does not ring during incomming call

    Is the phone silenced? Check the button on the side of the phone above the volume buttons if you see an orange line it is silienced, slide it to the front of the phone and it should correct this.  Also ensure the volume is up.  If you've checked these and still nothing are you able to call people? do you have service?

  • I have installed a ringtone but phone does not ring on incoming calls

    I Have an Iphone 4S, it came with vibration set as default ringtone, I changed the ringtone but the phone does not ring on incoming calls, What is wrong?

    Also, you may want to do a reboot, hold both the power and home buttons until the apple logo appears and it restarts, ignoring the red slider if it appers, so that everything is reset.

  • Phone does not ring on incoming calls

    Hi,
    I hope someone can help or advise on my issue - see points 3 and 4.
    1. Tested with 2 analogue phones - 1 phone definetley known to be working at a separate location - and a mobile phone.
    2. All tests conducted twice - at master socket and internal test socket/  ALL other extensions& broadband line connections removed during testing.
    3. Incoming calls do not ring on the analogue phones, but calls can be answered if analogue phone is picked up.
    4. When hanging up on an incoming call, the analogue phones do not kill the open line. I have to terminate the call on the mobile as well.
    5. Outgoing calls can be made and picked up by mobile with no issues.
    6.  Online BT Line Check reports no faults on the line.
    7. Both analogue phones were checked to make sure they are not in silent mode.
    Anyone have any ideas or suggestions?
    Thanks
    Ben

    I had this problem recently - caused by a fault in the BT line box just outside the house.
    3. If you ring your number from a mobile do you hear the phone ringing in the mobile? I my case there was just a short ring heard in the mobile and then silence - picking up analogue phone you could then talk to mobile.
    3. This is normal. Reverse cleardown takes some time - I think it is about 10 mins. I often use this feature when I pick up a call on one phone and want to move to another extension. I just replace the first phone, so no phones are connected, then go to the other extension and pick up the call.
    Peter

  • Phone does not ring with incoming call

    My iPhone 4 is not ringing -- and it's not set to silent or vibrate. I believe this may be a cell reception problem as sometimes my voicemail isn't available either. I tried turning the **** thing off and restarting it but that didn't help. I am ready to ditch the iPhone, which I love, because of its poor reception capabilities. Any other ideas out there? Help!

    That would be fine, razmee, but my carrier AT&T says it is doing the best it can do. I am in a rural area and 1 mi away from 3G service. Sometimes my reception is ok and sometimes not. In the meantime I am trying to find a work-around as I am not sure if 1: the problem is caused by poor service and 2: if it is, are there any solutions.

  • Iphone 4 does not ring on incoming calls

    It rang and vibrated on incoming calls it still vibrates but no ring, I don't think changed anything but im still exploring.

    I have the same issue, the phone does not ring on incoming calls, moreover, when changing the tone I can't hear the new tone, and when I press the keys on the
    keyboard I can't hear the clicks, if I use the headphone I can hear everything.
    I checked the silent switch, it is not silent, and I restrat the phone, no help.
    I have this issue immediatly after purchase and unbox
    the phone is updated to 4.3.3
    note: I use the same computer to sync to ipad.

  • TS2634 My iPhone 4s does not ring for incoming calls. Ring tone is set/settings/sound. It used to ring. I think it has to do with updating to IOS 7.0.4? After updating IOS 7.0.3 my microphone stopped working. Had to clear/reload.

    My iPhone 4s does not ring for incoming calls. Ring tone set and used to ring. I think it has something to do with updating the IOS 7.0.4. When I updated to 7.0.3 the microphone stopped working. Had to call Apple Support and cleared phone and reloaded. ($57 charge). Any suggestions?

    Start with your finger at the bottom of the screen (about even with the home button) and swipe in an upward motion.  There should be a row of icons at the top of a grey field.  if the quarter-moon icon is bright white, tap it.  If it was (and still is) dark, take the iPhone in to be evaluated by a qualified technician.

  • Phone can dial out but does not ring on incoming calls

    We have a strange problem with a 7961G phone. It's configured the same as all of our other phones in CMM, but it can dial out but when dialing in the phone does not ring nor does the call appear to be routed to the phone. I called out from the phone to my cell and it displays the correct Caller ID information. Any ideas???

    I would check the partition that the DN on the called phone is in and the CSS of the calling phone. These are the two fundamental principles that control when a phone can call another phone.
    You might want to change the partition of the called DN to momentarily, to see that the calling phone can call it. All phones can call the partition unless there are explicit blocks put in place.

  • Phone does not ring when people call your number

    A lot of people have complained that when they call my phone I never answer even though the phone rings. However, the iPhone does not show a missed call. Years later I get a voicemail indicator. My phone shows full signal strength and the thing never rings. I have noticed this way too many times so I decided to post this question to see if anyone else has noticed the same thing.

    The most common causes for this behavior:
    1. Bad coverage/roaming (unlikely, since you said you have good AT&T coverage)
    2. Frequent EDGE use (calls will go to voicemail if you are actively using EDGE)
    3. Defective or improperly set ringer (if this were the problem, you'd be registering a lot of "missed calls" in your Recents list, which I assume you are not)
    4. Bad SIM card
    If you have eliminated #1-3, then it is likely #4. You can get your SIM swapped out very quickly at the AT&T store.

  • IPhone 4 does not ring for incoming calls

    I got the iPhone 4 two days ago, and I noticed that when someone calls me, the phone will vibrate, but it will not ring.  The volume on the ringer is set to the highest level.  I downloaded an update for the phone 2 days ago.  What can I do to get my phone to ring?  Do you think the update had anything to do with the problem?
    Thank you in advance for your help!

    Hello Dracheskind,
    Have you corrected the issue with the ringtone volume? If not, make sure the Ring/Silent button above the volume keys is turned on (if off, orange sticker will appear). Then go to settings > sounds > Ringer and Alerts > change the volume to loud. The vibrate options can stay on. If all of these settings are enabled, try changing the ringtone. 
    For additional assistance, go to http://www.apple.com/support/iphone/
    Thank you,

  • HT201401 my phone only vibrates and will not ring on incoming calls.  How do I fix this?

    My phone only vibrates and does not ring on incoming calls.  How do I get the audible ring?  John

    on left side of your phone you have volume controll an right above that is a small button an if you see a orange or red dot you are in silent mode flip the switch up an it will remove silent .

  • HT201401 I have set the ringer for my phone, and it is on according to settings, but does not ring when a call is received.  How can I fix this?

    My phone does not ring when a call is incoming.  How can I fix this?

    You might try restarting your device, your router and your Apple TV.

  • My new iPhone 5S will not ring for incoming calls.  It vibrates. I've tried suggested tips for iPhone 4 but it doesn't work for 5S.  Please help!!

    Can anyone help.  My new iPhone 5S does not ring for incoming calls.  It vibrates.  How can I get ringer to work?

    Hello lyngos,
    Thanks for using Apple Support Communities.
    For more information on this, take a look at:
    iPhone: No sound or distorted sound from speaker
    http://support.apple.com/kb/TS2802
    If an audio issue occurs when using a specific application, try testing other applications to see if the issue persists.
    If the iPhone is paired with a Bluetooth headset or car kit:
    Try turning off Bluetooth.
    If you experience difficulties with the Bluetooth feature, follow these troubleshooting steps.
    Restart the iPhone.
    If restarting doesn't fix the issue, ensure that your iPhone is updated to the latest version of iOS.
    Best of luck,
    Mario

  • Phone does not ring when I get calls

    My phone does not ring when I receive incoming calls since I upgraded software to IOS 7. 

    I tried that just now and it doesn't seem to have fixed it--but it is not a constant problem--just sometimes!  I received a call from a friend when do not disturb was turned off but  also when it was on!  That was really strange!
    Now I am trying to figure out why my camera flash won't work!!
    Yikes crazy stuff going on with my phone since I updated the software!.

  • Phone does not ring after using Bluetooth

    I have an iPhone 5 with IOS 8.1.  My phone does not ring or notify me of incoming texts.  This happens after I connect to Bluetooth.  If I reselect my ringtone, the phone works, until the next time I use Bluetooth.  It seems like a bug in a recent update.

    I had same issue. My phone will not ring or get text sounds when locked. This morning my alarm did not make a sound neither. Thanks to my dog who woke me up. My "do not disturb" was on. It's the moon on your quick menu. I wish the phone will let you know the "do not disturb" is on when you hit the home button to use the phone. I was not aware of this feature on my quick menu.

Maybe you are looking for

  • APEXUTIL.Get_file... need to force a prompt to save, open or cancel

    I'm a newbie to APEX and am using APEX_UTIL.Get_File to open static files (PDF documents).  The requirement specifies that the user must be prompted whether to save or open the file.  We have created a "popup" page with dynamic PS/SQL: DECLARE     l_

  • PowerBook G3 with Mac OS 10.2

    So I got this PowerBook but there are some applications that come with Mac OS 10.2 that are not there. How would I get them back?

  • Clearing a stuck badge

    Badge notification is stuck on 2 whnere there are no unread email in any email account. How can I clear or reset the badge?

  • Session facade vs Command object pattern

    Hello, I am debating using the Command pattern as my primary strategy for implementing my J2EE enterprise app business logic and would like some advice. The general idea is to have only a few types of abstract commands (such as a ReadComand, an Updat

  • Understanding Regex replace method call involving delegate

    Hello, I am trying to understand the $regex.replace static method call below (I came across this code snippet in the cookbook). $replacer = { param($match) $chars = $match.Groups[0].Value.ToCharArray() [Array]::Reverse($chars) $chars -join '' $regex