My iMac does not move beyond the white screen with apple logo?

When the iMac turns on it does not advance it's start up beyond the 'White Screen' with the apple logo at the center.

the following article addresses the mac booting to gray screen issue you described:
http://support.apple.com/kb/TS2570
you should get resolution from this, good luck!

Similar Messages

My Imac will not move beyond the Grey Screen with the spirl spinning any ideas

Recently I rebooted my IMac, it now will not move past the grey screen with the spinning spirl.
Please help

Turn off your machine, then power on whilst holding down cmd+alt+p+r until the screen goes off and you hear the chime again.
Also, what iMac do you have/how old?

Imac wont boot - i get a white screen with apple logo, and it loads to about 10%, then screen goes black

imac wont boot - i get a white screen with apple logo, and it loads to about 10%, then screen goes black

Hey there mtriest,
It sounds like you are unable to boot the iMac successfully as it keeps shutting down when you try to boot. I suggest the troubleshooting from the following article named:
Mac OS X: Gray screen appears during startup
http://support.apple.com/kb/ts2570
Disconnect, test peripheral devices and network cables
Note: "Peripheral devices" refers to external devices other than what came with your Mac, such as hard drives, printers, or hubs that you connect via a USB or FireWire cable.
Shut down your Mac. If necessary, hold your Mac's power button for several seconds to force it to power down.
Disconnect all peripheral devices such as external hard drives or printers (leave only the display, a keyboard, and mouse connected).
Disconnect any Ethernet cables.
Start up your Mac.
If you can start up this way, one or more of your peripheral devices (or installed software related to the device) is probably causing the gray screen issue. Connect one device, then restart your Mac to test for the issue. Repeat the process until you locate the device at issue. Make sure the device is powered if it needs to be to operate correctly. Check with the manufacturer of the device for support or possible software driver or firmware updates that may be available for the device. Try a different cable with the device if possible (such as a different USB or FireWire cable).
Note: If you have multiple peripheral devices and the issue only occurs when they are all connected, but not when each device is the only peripheral connected, see the Additional Information section below.
If you are using a desktop Mac with a third-party keyboard and/or mouse device, and the issue still occurs, try starting up with an Apple keyboard and mouse connected instead. Try starting with no keyboard and mouse connected, then connect them after start up. Also, try a different USB port on your Mac.
If the gray screen issue persists with no devices connected, go to the next section (with the peripherals still disconnected).
Perform a Safe BootSimply performing a Safe Boot may resolve this issue.
Shut down your Mac. If necessary, hold your Mac's power button for several seconds to force it to power down.
Start your Mac, then immediately hold the Shift key. This performs a Safe Boot. Advanced tip: If you want to see the status of a Safe Boot as it progresses, you can hold Shift-Command-V during start up (instead of just Shift).
Note: A Safe Boot takes longer than a typical start up because it includes a disk check and other operations.
If your Mac starts up as expected, immediately try restarting.
If the Safe Boot does not work, or the restart after a successful Safe Boot does not work, go to the next section.
There is additional information in the article with further troubleshooting if needed.
Thank you for using Apple Support Communities.
Cheers,
Sterling

I bought iphone 5s 2 days ago and suddenly it turn off and start again till the white screen with apple logo and start again

i bought iphone 5s 2 days ago and suddenly it turn off and start again till the white screen with apple logo and start again
please answer me as soon as possible

Hello Ahmedabokamar,
Thanks for the question! I'd recommend taking a look at the following article for troubleshooting steps that can help get your iPhone working again.
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
Cheers,
Allen

ITunes Store wont open. Only thing appears is the white screen with Apple Logo

iTunes Store won't opeen. Only thing appears is white screen with Apple Logo and takes really, really long to load.

Hi Davin12,
I'm sorry to hear you are having issues acessing the iTunes Store from your Windows computer.
The article below may be able to help you with this issue.
Click on the link below to see more details and screenshots.
I've quoted some helpful highlights for you:
iTunes for Windows: iTunes Store connection troubleshooting
Remove pop-up blockers
Some pop-up or ad-blocking programs may interfere with the ability of iTunes to connect to the iTunes Store. Removing them in many cases will resolve the issue.
Flush DNS Setting in Windows
In some cases, the DNS information you computer uses to connect to the Internet needs to be reset. Follow these instructions to flush your Windows DNS information:
Windows XP
On the Start menu, click Run.
In the Open field type cmd and click OK.
In the resulting window, type ipconfig /flushdns and press Return on the keyboard.
You should see a message that the DNS Resolver Cache has been successfully flushed.
Windows Vista and Windows 7
On the Start menu, point to All Programs > Accessories and then right-click Command Prompt and chooseRun as Administrator from the shortcut menu. If Windows needs your permission to continue, click Continue.
In the resulting window, type ipconfig /flushdns and press Return on the keyboard.
You should see a message that the DNS Resolver Cache has been successfully flushed.
Note: If, in the command prompt, you see this message: "The requested operation requires elevation", close the command prompt and repeat steps 1 and 2 above to be sure that Administrator privileges are used to access to Command Prompt.
The article below will help you troubleshoot the issue from your computer or your iPod Touch:
iTunes: Advanced iTunes Store troubleshooting
I hope this information helps ....
Have a great day!
- Judy

Got a iMac upon start up it has white screen with apple logo and loading wheel spinning forever under it, does anybody know how to fix this?

PLEASE HELP!!!!!! EMERGENCY Upon start up normal start up noise occurs, then after white screen with Grey Apple logo, and a spinning loading wheel under it (thee repetitive lines NOT rainbow one) ?!? then thats as far as it goes it stays on that screen forever will not boot up. Any info on how to possibly fix? I've tried several of the Start up shortcuts , it wont even start up in Safe Mode . My fiance' is crushed she is a writer and EVERYTHING SHE HAS WORKED ON is somewhere on that hard drive. Any thoughts, i'm open to any and all LOGICAL responses, thank you very much for ya'lls time ........Its just heartbreaking to see my iMac in this vegistated coma,The whole reason i bought a mac was cause I love them I have Apple EVERYTHING, so once again please help.

Try this: Switch off your iMac wait 10-15 seconds hold down the Option Key (alt) key then press the power botton but keep the option key down. This should show all the available options to boot from. I trust you have a full backup, Good luck.

TS1367 My MacBook Pro will not go past the grey screen with apple logo in the middle

How do I fix this issue is there anything I can do

Hey there Gonzoeg850,
It sounds like you are unable to boot your computer to your desktop or log in screen. I do not know if you have tried these steps from the article you have up there, but that is exactly where I would start:
Troubleshooting: My computer won't turn on
http://support.apple.com/kb/TS1367
Verify you have a good connection from your Mac to the wall outlet by confirming the power cord and adapter if present are securely connected and plugged in. To check if the wall outlet is working, plug in a lamp or other electrical device.
If the wall outlet is working and you continue to have no power try another power cord or adapter if available. If it works you may need a replacement cord or adapter.
Note: See Apple Portables: Troubleshooting MagSafe adapters for further troubleshooting with MagSafe adapters.
Disconnect all accessories that are plugged in to the computer, such as a printer, hub, or other mobile device.
If your Mac supports user-installable memory, solid state drive, or hard drive, and you recently installed any of these, make sure they are installed correctly and are compatible with your computer. If possible, reinstall the original memory or drive into the computer to find out if the behavior persists afterwards.
MacBook Pro: How to remove or install memory
MacBook: How to remove or install memory
Mac Pro: How to remove or install memory
Mac mini: How to remove or install memory
iMac (27-inch, Late 2012): Installing or replacing memory
iMac: How to remove or install memory
Reset the SMC.
If you are still unable to start up your computer after trying each of these steps, visit an Apple Store or Apple Authorized Service Provider (AASP) for further diagnosis. If you plan to visit an Apple Retail Store, make a reservation at the Genius Bar using http://www.apple.com/retail/geniusbar/ (available in some countries only).Note: Diagnostic fees may apply for issues not covered under warranty or the AppleCare Protection Plan (APP).
Thank you for using Apple Support Communities.
All the very best,
Sterling

Imac does not start white screen with apple logo.......

Hi guys, my brand new Imac 21.5 got stuck on the white screen with apple logo and nonstop little wheel, but it never gets out of it....Disconnected everything else restarted but still nothing...stuck at the same screen. Please i need help, the machine is only 3 months old!!!

Hi, do you have AppleCare?
Call AppleHelp in any event 1-800-275-2273
You could try booting from your discs (Disc#1) that came with your Mac -
...L

White screen with Apple logo/ not booting

I recently tried to install the software for the "Flip" video camcorder and upon restarting my computer after installation, my computer is stuck on the white screen with Apple Logo, 'thinking" wheel spinning, and fans going full blast. I tried forcing a stop with turning computer off by holding power button in the back until system powered off. When I started the computer back up, it did the same thing.
What is the likely problem and how do I fix this. I bought the computer used and do not have the OS X software that comes with the computer originally.

You really need those discs. You can either buy a BLACK retail version of Leopard and use that or you can call Apple at 800-767-2775 and for a nominal fee they will send you the proper discs for your model. You will need the serial number, which you can find on the bottom of the foot of your computer. Do not buy any grey discs, they are machine specific and will not work on yours. In the meantime, try starting by resetting the PRAM and the SMU
1. Shut down the computer.
2. Unplug the computer's power cord.
3. Press and hold the power button for 5 seconds.
4. Release the power button.
5. Attach the computers power cable.
6. Press the power button to turn on the computer.
You need to make sure also, that the software that comes with your Flip is compatible with the OS version you are running.
Let us know how you make out,

Mac stuck on white screen with apple logo at startup

It's a few days i have this issue.
When i turn on my macmini (late 2009) it does the startup sound, but when the white screen with apple logo appears it stucks on that screen.
To solve this problem i have to unplug the power connector, when i restart it works normally.
This happens randomly, not at every startup.
I switched from normal HD to ssd HD (brand new one), i have the same problem with both HDs.
Since black outs are not good for computers i woult solve this problem.
Does anybody have my same issue or know what's wrong?
Thanks!!!

Hello, tough to tell what it might br.
Have you done a PRAM reset, CMD+Option+p+r...
http://support.apple.com/kb/HT1379
In fact, do 3 in a row, takes a bit of time.
Intel-based Macs: Resetting the System Management Controller (SMC)...
http://support.apple.com/kb/HT3964

Mac book pro is unable to display desktop ,only white screen with apple logo is appearing

Hi
I have a Mac book pro, since today morning the Mac book pro is not starting. It just displays the white screen with Apple logo and search signal. Despite waiting for a long time desktop is not coming up.
I have tried to restart it several time but the status remains same. Kindly help.
Thank you
Kind regards
satish

Gray, Blue or White screen at boot, w/spinner/progress bar

TS3824 2011 mac mini won't go past white screen with apple logo

My Mac mini won't move past a white screen with apple logo in the center. What should I do?

Hi ..
If you have v10.7 Lion installed, use Lion Recovery to repair the startup disk if necessary, or reinstall the Mac OS X.
If you are running a prior Mac OS X, boot from your install disc, run Disk Utility. The startup disk may need repairing > Using Disk Utility to verify or repair disks
And try Resetting your Mac's PRAM and NVRAM

My imac won't load from the white screen with the logo on? What shall I do?

My imac won't load from the white screen with the apple logo and buffering sign? What shall I do..

Try any of the steps suggested in this article that you haven't already tried:
http://support.apple.com/kb/TS2570?viewlocale=en_US&locale=en_US

I get a white screen with apple logo and progress bar on my imac mavericks

I get a white screen with apple logo and progress bar ,then computer shuts down
when I turn my imac back on same thing happens,every time same thing
pprogress bar only goes half way then computer shut down
is there a solution ?
if not is there a way to at least salvage some files and docs?
i Have the latest imac 27

Thanks I tried it but after I repaired my disk via disk utility at start up, it told me that
my disk can't be repaired and to try to back up my files so I can format it
but is there to back up my files?
also what I get is white screen with the progress bar not grey

My macbook 13' (older version) starts only to white screen with apple logo tried to rebooot by pressing shift at the opening but it didn't finish starting before stopping please help anybody please

is anbody there how does this work never done it before my macbook won't start past white screen with apple logo any ideas ?

Are you using a 10.6 Snow Leopard Install DVD? If yes, you can erase and install following these directions: http://support.apple.com/kb/HT3910
You'll know whether or not it is a hard drive issue when you get to step 8 under "Part One: Erasing the hard drive". If you do not see your hard drive in the list on the left side of the Disk Utility window then you know the Mac isn't seeing it—could be a loose cable, but more likely hard drive failure.
If you can see it on the left, click on it and look at the bottom of the Disk Utility window. If you see something like "S.M.A.R.T status: failing" that is definitely a hard drive issue. Otherwise, you can just follow the directions for an erase and install!
Might be worth fixing depending how much a repair would cost. Genius Bar could at least diagnose it for you and give a repair estimate. I'd look at what a new or refurbished one with your same specs would cost though to see if the price differential is worth it...

My iMac does not move beyond the white screen with apple logo?

Similar Messages

Maybe you are looking for