My iMessage will not use wifi to send messages unless the phone is on Airplane mode

I cannot send or receive texts at home because there is insufficient service at my house so I use iMessage over wifi. The issue is that when I am on wifi and out of service the phone will not send iMessages or texts over wifi unless the phone is in Airplane mode. Does anyone know how to make wifi the default iMessage so that I can send iMessages over wifi without going to Airplane mode? It tries to send them but it acts as if there is no service when I have full wifi and as soon as I switch to Airplane mode and keep wifi connected, all messages send fine.

Do the basic troubleshooting steps, as needed, described in the User Guide, Appemdix B: restart, reset, restore using a backup, restore as new.

Similar Messages

  • My email on my ipod will not allow me to send messages to my phone through my email

    well i tried to send pictures from my ipod to my phone. I went to my camera roll selected the phone then clicked mail i put my phone number in and it wont send somebody please help me!!!!

    You have to mail them to an email address. You can message them vai the iPhone's number.

  • I have an iMac, and have a Verizon DSL account. Recently, my Mac Mail keeps requesting the passwords on my account every few minutes, and will not allow me to send messages using Mac Mail. I cannot edit the outgoing server; how can I send emails?

    I have an iMac, and have a Verizon DSL account (3 email addresses). Recently, my Mac Mail keeps requesting the passwords on my accounts every few minutes, and will not allow me to send messages using Mac Mail (the message says that the outgoing server was rejected. I cannot edit the outgoing server, and the keychain will not save my passwords (the ports are valid). How can I change the outgoing server to send emails, and how can I avoid having Mail request my passwords every 2 minutes? Verizon, as usual, will not provide support to iMacs.

    Is there an email saved in your drafts or outbox folder?  I suspect that Mail is continually trying to send it, and each time Google is rejecting the email message.
    You can open the message and then delete it from your Outbox folder.  Then try removing all @gmail email addresses from it and seeing whether you can send to the other folks.  I suspect that will work.
    With email, if an SMTP server *can* verify email addresses, sometimes it will and it will refuse to send messages.  If a message has to be relayed across servers, no verification is done, and you'll get a bounce if an email address is bad.

  • Just got a new iphone 4s and it will not load yahoo emails. gives message of the connection to the server failed

    new iphone 4s will not load yahoo emails, gives message of the connection to the server failed

    Perhaps you should use this iPhone email setup assistant to re-enter your Yahoo account settings.  If you do that, simply go to Settings > Mail, Contacts, Calendars and delete your current Yahoo account, then use the assistant to re-establish it.
    iPhone Email Setup

  • HT1688 I am having issues get my email in one of my mail accounts so I tried to "DELETE" the whole account.  But my phone will not delete a mail account.  And the phone is getting really hot and battery was full 2 hours ago and now at 25%.

    I am having issues get my email in one of my mail accounts so I tried to "DELETE" the whole account.  But my phone will not delete a mail account.  And the phone is getting really hot and battery was full 2 hours ago and now at 25%.

    Well, you don't say what happens when you try to delete the account. So I don't know what else to recommend. However, if your phone is not charging, is that the mains charger or the computer USB? Also, if it not showing any change to battery percentage, then something is wrong with the software. The next step in user troubleshooting after the reset is a restore from backup. However, considering the condition of the phone right now, I would be more than willing to say your backup is going to be corrupt. But you can try. If that does not fix the device, then you restore as new, not from a backup. If the phone works, then you can try restoring the backup again, but if it messes up, you are going to have to restore as new again. If the restore as new does not work, then you need to make an appointment at the Genius Bar or Authorized Apple Service Provider to get the hardware checked.

  • IPad will not use wifi, prefers 3g

    Lately my iPad seems to have started using the 3G network in preference over the wifi. At home we have terrible mobile coverage and so previously the ipad would use my homw wifi with great success. Now it has to think about every page and every download trying to connect to one bar of network coverage. I have tried turning the cellular data off and it sees the wifi fine but if I open safari it says it cant see the internet despite the fact that the other computers in the house are happily connected to the internet via wifi.When the cellular data is on the wifi symbol does not appear. I hav tried renewing the lease, i have a fixed IP address for the iPad. Any ideas?

    Sounds like you are having problems with your router or its configuration.
    What make, model, and version router do you have? Have you checked that it has the latest firmware installed?
    The fact that you are using a static IP is a bit alarming. Why are you using static IPs? Are you sure that there is not an IP conflict with another one of your devices? Is your static IP outside the DHCP IP allocation range set in your router?
    Try restarting your router by removing power for 30 seconds and restarting to see what affect this has.

  • My new ipad air will not face time or send messages,have tried to reset. but nothing happened

    my new ipad air will not facetime or send messages.  I have tried to reset all settings, changed my password 3 times, but still nothing happens.

    You need to post this in the iPad discussions to get help

  • IPad will not charge after IOS 7 update unless the brightness is dimmed,..Why?

    I recently updated my 4th gen IPad 64Gb to ios7. Previous to the update I loved my iPad and it worked flawlessly. Since updating the iPad now will not charge unless I dim the brightness of the screen, and slowly when it does. Why? Is there a way to remedy this?

    I do not know if it's iOS7 related or not. My 2 is still working. However, my first 2 was returned to best buy after the charging port on it died. So that can happen. ANd it happens with little to no warning. CHarges monday, doesn't on tuesday.
    As far as I know the issues with 'unsigned' lightning devices is just the cable, not the power brick, but there's no official word (nor do I expect one)
    Lightning cables have a little chip in them and if that chip isn't signed by Apple then your device kicks up an error but should still work.
    However since this is an iPad 2, that's not the case since 2's use 30 pin chargers, not lightning.
    Usually when a 2 doesn't charge, common troubleshooting is to swap out the charger, cable and outlet, to confirm or rule those out. Also to do the reset. (the soft reset that's holding down the sleep and home keys until it reboots). Also to look in and blow out the port in case there's some lint or such in there.
    Usually those things fixes it. If not, then it could be the port.

  • IPhone 4S will not start or charge, error message when trying to restore in recovery mode

    So my iPhone 4S shorted out the other night while I was charging it. I did the hard reset and it restarted itself. But later that evening, it turned off and wouldn't restart no matter what and would not charge. When I connect it to my computer (mac) iTunes recognizes it and says it is in recovery mode and needs to be restored. It starts the restore process and the apple logo comes up with a loading bar but then when it gets to the "verifying restore with Apple" it gives an error message (9) and then the phone goes back. Please help!

    Hey rileyec,
    I found this information about error 9:
    Error 9
    This error occurs when the device unexpectedly loses its USB connection with iTunes. This can occur if you manually disconnect the device during the restore process. You can resolve this issue by using USB troubleshooting, using a different Dock Connector or Lightning Connector to USB cable, trying another USB port, restoring on another computer, or by eliminating conflicts from third-party security software.
    via: iTunes: Specific update-and-restore error messages and advanced troubleshooting
    http://support.apple.com/kb/TS3694
    If those steps do not resolve the issue, I would attempt to perform a recovery-mode restore:
    iOS: Unable to update or restore
    http://support.apple.com/kb/HT1808
    Cheers,
    Delgadoh

  • I plug my iphone 4s in to my pc and it will not sync or evan show up in   the phone is there in itunes

    my iphone will not sync in to itunes and up date

    Make sure you have the Latest Version of iTunes (v11) Installed on your computer
    iTunes free download from www.itunes.com/download
    Unable to update... See Here  >  http://support.apple.com/kb/HT1808
    You may need to try this More than Once...  Be sure to Follow ALL the Steps...
    Take your time... Pay particular attention to Steps 3 and 4

  • The light on the back of my phone will not turn off, even when I turn the phone off. Help?

    The light on the back of my iphone 4s will not turn off. Even when I turn the phone off the light stays on.  Can someone help? I did notice that the camera on the back has a little bit of moisture. (I have 3 small kids).

    You will need to have the hold switch replaced.

  • Imessage will ONLY have option to send from email. Phone number is greyed out... Please help

    Hi,
    I have tried all of the tips and tricks for getting my imessage to send from my phone number, not my email but I am not having any luck.
    The option in the message settings has my phone number greyed out and my apple ID has my phone number stored. I am not sure why this is happening and would really appreciate the help.
    All imessages sent to me do not get to my phone because it seems to be disabled.

    Hi Myf!
    I have an article for you here that can help provide you with troubleshooting steps for this issue:
    iOS and OS X: Link your phone number and Apple ID for use with FaceTime and iMessage
    http://support.apple.com/kb/HT5538
    Thanks for coming to the Apple Support Communities!
    Cheers,
    Braden

  • Imessage will not work with some contacts

    Hi there,
    I'm new to iphone and need help with imessage. I can imessage and face time my wife, although it's always a blue bubble wether I'm on wifi or not. My brothers has an iphone which will imessage sometimes but will never connect for face time.
    Is imessage spouse to work only when both phones are in wifi? Is there any way to force it into an imessage rather then SMS? Vodafone nz have told me that every time I turn it off and on again, I am charged. Is that normal?
    I've tried that anyway, I've tried rebooting the phone, it just does what it wants all the time.
    Thanks for the help

    1. Both devices have to be running iOS 5.*
    2. Internet latency can delay iMessage connection.  If you enabled "Send as SMS", the phone will switch to SMS if iMessage doesn't connect quickly.  If you disable Send as SMS, more of your messages will go through as iMessage.

  • Imessage will not activate iOS8

    okay so basically i've brought an iphone 6 on contract (vodafone) i wanted to keep my old number so i used their "keep my number" service online, ever since ive done that my imessage will not go through or any messages for that matter, imessage is stuck on the good old "waiting for activation" any tips? i have tried the reset all network option and i have tried to manually reboot it. nothing

    I'm having the exact same issue but with 3... I don't think it's the network though. Mine were working no problem for me initially (before iOS8.1.1) and now they won't activate. From what I have read, this is a bug within the update and Apple need to fix this ASAP

  • My Droid2 Global will not pair to My Ford SYNC since the latest software update.  Please help!

    Since the latest update, my Droid2 will not pair to my Ford SYNC.  The phone will not find SYNC for me to place in the PIN.  It use to work wonderful before the latest update.  
    I can not drive and talk on my phone without SYNC.  Corporate Car- Corporate Policy.
    Thanks for your help.

    Hello rosalee2340,
    Thank you for sharing your concern as I am more than happy to assist you! Are you able to successfully pair your Droid 2 with another bluetooth device, like an earpiece or a computer? This will help us determine if there is an issue with the bluetooth technology after the software update or is it a compatibility issue. Also, what year and model vehicle do you have? In order to successfully pair with the vehicle, the Droid 2 must be in discovery mode. Below is a link to walk thru placing the Droid 2 into discovery mode.
    http://support.verizonwireless.com/clc/devices/knowledge_base.html?id=34745
    Once the phone is in discovery mode, the next step would be to attempt to pair with SYNC again. Here is a video link with the steps on how to pair a phone with SYNC.
    http://syncsupport.ford.com/servlet/technology/connect-phone-sync
    If the pairing is unsuccessful then you can contact the dealership for assistance with the pairing process and/or for an updated device compatibility list of phone. Let me know how the steps above works out for you.
    Thank you...

Maybe you are looking for

  • How do I separate my Apple ID password from my icloud password?

    How do I separate my Apple ID password from my icloud password? i share my apple ID with my family to share software downloads etc but need to keep some icloud stuff secure from. Any help appreciated! Mikul

  • RSD - really fast repair!!

    My Macbook suffered from the RSD problem. I live in the UK and rang Apple on Thursday. A courier arrived with a box to return it for repair the next day, Friday. The courier also collected it the same day and I received the repaired Macbook today, Tu

  • Compiler error in 9.0.3 when deploying using jdk1.4.1rc

    Hi, I'm trying to deploy an application into iAS9.0.3. The server is started with jdk1.4.1rc. However, I'm getting a compiler error (see below). When compiling with jdk1.3.1 everything is working fine, but I need to use the new API's in 1.4. Can anyo

  • Change field value in mb31

    Hai all, I need to set a value for mseg-erfme in mb31 using BADI. The value is 'ST' in mseg while debugging. But i need to change the value 'ST'  to  'PC'(base unit) using BADI. Can anyone helpme?

  • Dynamic actions in abap-hr?

    What is dynamic action? Why dynamic actions? Give me example for that. Regards, Thrimu