My ipad 2 won't hold a charge after installing ios 7

I use the authentic Apple charger and my ipad 2 won't hold a charge after installing ios 7. What is the fix for this miserable wasteful upgrade that made all of our iPads unusable ! I Shut off location, turned off  brightness, shut down and  took off apps.  WHAT NOW for my iPad ?

Batteries eventually fail, and it sounds like that's happened with your iPad. You'll need to take or send it Apple to get the battery replaced. See:
http://www.apple.com/support/ipad/repair/battery-power/
Regards.

Similar Messages

  • My iPad won't hold a charge ---any ideas?

    My iPad won't hold a charge.  It even loses battery while it is on the charge. Any ideas???

    Using the battery level meter in this manner is comparable to using your car's fuel gauge to calculate miles per gallon.  The only thing that matters is the total amount of operating time from full charge to auto-shutdown.
    Use the wall-mount charger that came with the iPad and charge overnight.  Admittedly the labeling is hard to read but, if you use a magnifier and squint your eyes, you'll see "Output 5.1V, 2.1A."  The symbol between volts and amps is the symbol for DC.  Do NOT use an iPhone charger.  Do NOT use an iPod charger.  Then, operate it normally until auto shut-down (ignore any low level alerts that may appear).  An irony is that doing that test to determine the total operating time is also the exact procedure necessary to calibrate the battery level meter.
    I'm not claiming that you do not have a problem.  I am stating, however, that we don't yet know whether or not a battery problem exists.
    According to Apple:
    Use Your iPad Regularly
    For proper reporting of the battery’s state of charge, be sure to go through at least one charge cycle per month (charging the battery to 100% and then completely running it down).
    Elsewhere, Apple elaborates and explains that two half-discharges (or four quarter-discharges, etc.) equals one full discharge.

  • IPad won't hold a charge

    iPad will not hold a charge.  Can the battery be replaced?

    Replace battery
    http://www.apple.com/sg/batteries/replacements.html

  • Why does my iPad won't hold a charge and charges slowly?

    Why does my iPad not hold a charge (about a half hour) and take hours to fully charge?

    Charge battery
    http://support.apple.com/kb/HT4060
    http://www.apple.com/batteries/ipad.html

  • TS3274 My ipad won't hold a charge for very long.

    Just recently my ipad quit holding a charge. What used to last me all day has turned into only a couple of hours. Is there a setting or something I can change to regain the charge I once had. My I pad is only a couple of months old.

    Try turning off the following:
    Settings>Mail, Contacts, Calendars>Push>OFF
    Settings>Notifications>Mail>Gmail>Notification Center>OFF
    Settings>Mail, Contacts, Calendars>Fetch New Data>Off

  • HT4623 why won't my ipad won't charge after installing ios 7?

    just installed ios7 and cannot charge or reset my ipad 2.  Any ideas?

    Same issue here. I have 2 ipads killed by IOS7.

  • Plug terminal got wet now my iPad won't hold a charge

    when its plunged in it will be fully charged and functional untill i unplug then it dies. battery reads zero

    Using the battery level meter in this manner is comparable to using your car's fuel gauge to calculate miles per gallon.  The only thing that matters is the total amount of operating time from full charge to auto-shutdown.
    Use the wall-mount charger that came with the iPad and charge overnight.  Admittedly the labeling is hard to read but, if you use a magnifier and squint your eyes, you'll see "Output 5.1V, 2.1A."  The symbol between volts and amps is the symbol for DC.  Do NOT use an iPhone charger.  Do NOT use an iPod charger.  Then, operate it normally until auto shut-down (ignore any low level alerts that may appear).  An irony is that doing that test to determine the total operating time is also the exact procedure necessary to calibrate the battery level meter.
    I'm not claiming that you do not have a problem.  I am stating, however, that we don't yet know whether or not a battery problem exists.
    According to Apple:
    Use Your iPad Regularly
    For proper reporting of the battery’s state of charge, be sure to go through at least one charge cycle per month (charging the battery to 100% and then completely running it down).
    Elsewhere, Apple elaborates and explains that two half-discharges (or four quarter-discharges, etc.) equals one full discharge.

  • My iPhone 4S won't hold a charge after updating to iOS 6.1.1

    Is anyone else experiencing problems with their battery draining after updating to iOS 6.1.1?

    My phone has died.  It does even show the batter low symbol - Taken to Apple Genie, they told me now to pay £139 as its a hardware fault.  Told them Im a true apple fan, but they didnt give 2 sheets!!!!
    If Only I could turn back the clock and NEVER updated the IOS 6.1.1
    Anyone reading this:- If your phone is out of warrenty and was one of the 1st batches of the 4S - DO NOT update this as this will kill your phone as only way to fix is pay apple £139 for a refurbished handset!

  • My iPad won't connect via cell after installing iOS6 and may now think it is an iPhone!?!

    Question pretty much says it all...
    I upgraded to iOS6 and now I cannot connect to anything using cell/3G/4G. Error messages say odd things like 'Your iPhone is not configured properly'.  Odd that an iPad would say this!
    So I CAN use the iPad For now via wifi but when I turn on the cellular data under the main Settings screen, there are no options/buttons to access my AT&T data service, check my account, etc, like would normally be there with iOS5.  The poly options available are to either turn on cellular data and to set SIM PIN..
    When I turn on cellular data, it goes to 'Searching...' in the upper left of the screen as it would normally do if I was out of range of a cell tower or something and just keeps 'searching'.
    So...any thoughts?  I'm unable to find a place to look at my AT&T data account anywhere under settings to verify that it exists and the iPad is 'touching' it. 
    I'd prefer not to wipe clean and start again from last restore but I am at the end of my creative and technical capabilities.
    Ideate away!
    MG

    I have the same problem with iPhone 3GS, it wont connect to cell data after update to iOS 6.
    everytime i want to connect to internet with any apps on my iPhone, i have to connect from a Wifi first.
    this is frustating...
    are there any solution for this?

  • My ipad 2 won't hold a charge anymore. What can I do?

    My ipad 2 won't hold a charge anymore. I'll charge it up, get it to 100%, unplug it and shortly after wards, it's drained down. What can I do?

    Batteries eventually fail, and it sounds like that's happened with your iPad. You'll need to take or send it Apple to get the battery replaced. See:
    http://www.apple.com/support/ipad/repair/battery-power/
    Regards.

  • My iPad 2 won't hold a charge

    My iPad 2 is 4 years and 2 mos. old.  I have noticed lately that it won't hold a charge.  Is it time for a new one?

    Batteries eventually fail, and it sounds like that's happened with your iPad. You'll need to take or send it Apple to get the battery replaced. See:
    http://www.apple.com/support/ipad/repair/battery-power/
    Regards.

  • IPad won't hold charge

    iPad won't hold charge

    A bit more explanation would be good.  That's about the same as phoning your garage and saying "my car doesn't go".  

  • My iPad 1 won't hold a charge for very long and will only fully charge when turned off while plugged in. Will a full reset fix this?

    my iPad 1 won't hold a charge for very long and will only fully charge when turned off while plugged in. Will a full reset fix this?

    maybe but
    most likely no
    if you have many apps running and using data and localization at the same time yes maybe
    but batteries get worse and worse and worse over time until they die a software reset will not change that

  • Why won't my iPhone 4S hold a charge after updating to ios7 ?

    I accidental update my iPhone 4S to IOS 7 and now it won't hold a charge for a day? Why is that. I had no problems before the update ...

    I am having the same problem with my 4S since the last update. It was shutting off at 38% now today it shut off at 50%. It's driving me nutz and is not very reliable. Some one please suggest something to do. I was wondering if I should eliminate some apps that just updated one by one to see if that helped or just go through that nasty reset. I don't really want to do that but if I have to I will.

  • After installing IOS 7.3 my updates stay on the update list and  my iiPad will not fully charge after turning my iPad off and leaving it plugged in all night. It only charges 79%.

    Why do my recent app updates stay on the update page after updating?
    Why won't my iPad take a full charge after installing IOS7.3?

    Having the updated apps stay on the Update page in the App Store app is a new feature. It is especially usefu to those that have auto app update turned on. You then have a record of the recently updated apps, the new features they have and when they were updated.
    Are you charging your iPad with the wall charger that came with it or by some other means. The wall charger is the best way to charge the iPad. If it is failing to fully charge a reset might help. Press and hold the Home and Sleep buttons simultaneously until the Apple logo appears. Let go of the buttons and let the device restart. See if that fixes your problem.

Maybe you are looking for

  • HFR - Tried to create a bottom line / border line on EVERY single page

    Currently deal with this issues - Trying to make my report in HFR to perfect. I have a report created in HFR. It vary, can run from 2, 3, 4 ,5 pages. The PROBLEM: at the bottom of each page, there is no line (go across the page) to close that page. e

  • How to allow user chaning his password in OBIEE 11g weblogic custom LDAP?

    Hi, How to allow user chaning his password in OBIEE 11g weblogic custom LDAP? I need to give user an option to do so, without the intervention of any Administrator. I also do not want to make user a Administrator else he will be able to login in webl

  • High priority issue

    Hi, I have configured the workflow mailer but iam unable to receive the mails and also the workflow notification mailer has stopped with error The Workflow Document Web Services Service,Workflow Mailer Service The Workflow Agent Listener Service, rem

  • Thinkpd yoga: blurry text on some windows, on win 8.1

    Hi folks, Some texts look blurry on some windows. I have attached a picture to show you what I mean. If you see "Device Manager" window, the text is blurry. On the other "System" window, the text is just fine. Please, let me know your opinion on this

  • Routine doesnt get copied

    Hi we have a cube on which there are update rules. Now created a new cube same as the old one and copied update rules from the old cube update rules. After copying the update rules, i deleted few keyfigures from the new cube and activated. So update