My ipad 3 screen seems to be shifting down!!!!! What can I do?
I purchased an ipad (third gen) last year and noticed that my screen has shifted down a little. This happened about a week ago. I should (can) I do?
Step by Step to fix your Mac
Why is my computer slow?
Most commonly used backup methods
If you get pinwheels when off the Internet, it coudl be a failing boot drive or just a few bad sectors as it has a hard time reading from it.
This is a possible cure, it's a lot of work though.
Reducing bad sectors effect on hard drives
How to erase and install Snow Leopard 10.6
Similar Messages
-
I have Lightroom 4 on a PC and while enhancing photos, the screen seems to keep refreshing. What can be the problem?
Leilani ~ Welcome to the Support Communities. Before posting your question it's worth searching the Communities — here's an Apple tutorial:
Apple Support Communities: Searching
...But since you've already posted, look in the More Like This section to the right of your post. Also: -
ermm mine ipad 2 screen is little bit crack so how can apple help me ..
Unless Apple determines this is a hardware defect or they make an exception if caused by accidental damage, Apple will not help you as in exchanging or repairing the iPad for free.
-
I have a PowerBook G4 17" and need Apple discs to set it up again. Mine lost during move. Screen seems damaged, has vertical lines. Can anyone help. I can call as I have unlimited calling on my iPhone 6 anywhere in North America.
king,
If your Powerbook's serial number (do not post it here) starts with "W8" then the vertical lines are mostly likely due to a defect in the display itself. W8 is a factory code and, during the iMac G5 and PowerBook G4 timespan, that factory shipped thousands of units with the same defect. It cannot be fixed via software.
As all PowerBooks are now classed as "obsolete," an Apple Store will not work on it. They will look at it ands tell you it has vertical lines and that they cannot fix it. This Apple article shows Apple devices they curently considered obsolete:
Vintage and obsolete products - Apple Support
It is possible that some Apple Authorized Service Providers (AASP) will still work on older computes but they cannot get neededparts from Apple. As this issue was so pervassive, it wil be hard for you or an AASP to find a used/pulled display that is not effected with the "W8 Curse."
Although I love the old PowerBooks, I would not even spent the money for disks, much less the US$150-400 it would cost to replace the display, even should one be available.
If you give us a rough idea of where you are in the world, we can suggest repair shops specializing in fixing older Mac notebooks, but be aware those resources may be rather scare outside North America. -
My ipad's screen has gone completely blank. I can't see anything. Have attempted to update and restore it, but to no avail. Does anyone have an idea on how to resolve this issue?
Try Reset iPad
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected. -
I just got a new iMac. was following the onscreen instructions to do migration assistance and I guess it connected to my old iMac via wi fi. It never instructed me to connect via firewire. Now it seems to have stopped. what can I do that won't completely mess it up? how Long will it take to do over wi fi?
Your new iMac does not have a Firewire port so you ned this adapter:
http://store.apple.com/us/product/MD464ZM/A/apple-thunderbolt-to-firewire-adapte r
to connect the two machines together and migrate simply follow the instructions in:
http://support.apple.com/kb/HT4413?viewlocale=en_US&locale=en_US#1 -
Ipad is disabled and forgotten pin number. What can I do??
Ipad is disabled and forgotten pin number. What can I do??
You have to restore the device within iTunes. You want to use the same computer that you always sync with so that you can restore your iTunes content. You can restore with any other computer, but you will lose everything on the iPad.
Instructions can be found here.
http://support.apple.com/kb/ht1212
You will probably need to restore using Recovery Mode. You can read about it here.
http://support.apple.com/kb/ht4097
Or you can follow these Recovery Mode Instructions
Disconnect the USB cable from the iPad, but leave the other end of the cable connected to your computer's USB port.
Turn off iPad: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for iPad to turn off.
If you cannot turn off iPad using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the iPad turns off, release the Sleep/Wake and Home buttons.
While pressing and holding the Home button, reconnect the USB cable to iPad. When you reconnect the USB cable, iPad should power on.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears you can release the Home button.
If necessary, open iTunes. You should see the recovery mode alert that iTunes has detected an iPad in recovery mode.
Use iTunes to restore iPad. -
i have an ipod touch and it is locked and i can't seem to get into it. what can i do to unlock it?
You have to input your Apple ID in the prompt when it pops up
-
i have an iphone 5s and my phone was working perfectly fine then it turn into a blue screen and after that i tried to restore it but when i do the phone does half of the steps and then it turns into a blue screen and it doesnt work again what can i do?
The Basic Troubleshooting Steps are:
Restart... Reset... Restore from Backup... Restore as New...
Malvinfromny wrote:
... i tried to restore it but when i do the phone does half of the steps and then it turns into a blue screen and it doesnt work again what can i do?
If you try all these Steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step... Be sure to make an appointment first... -
My ipad 2 has permanent disabled due to passcode what can I do
My ipad 2 has permanent disabled due to passcode what can I do
If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup).
If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
You may have to force iPad into Recovery Mode
http://support.apple.com/kb/ht1808 -
HT4623 I have da stuck pixel on my screen. On my iphone5. What can I do?
I have da stuck pixel on my screen. On my iphone5. What can I do?
Hi! Sorry for the late reply.
You could go back to Verizon, though it's highly likely they might send it away for repair. If you go into an Apple Retail Store instead they tend to do everything on the spot.
Not entirely sure with Verizon's options (Im in Australia) but can only give it a try -
I am trying to update my ipad. When I start the process, I get the message " there are items bought in itunes that were not transfered. I synchronized my ipad, but still get the same message. What can I do?
I assume that this means items that haven't been transferred from the iPad into iTunes.
Connect the iPad to your PC and launch iTunes. Right click on the iPad name on the left side under "Devices" and select Transfer Purchases from the pop up window. Then sync one more time. Then after that, right click on the iPad name again and select - Backup. After that process completes then you should be OK. -
Hello everyone I touch the screen of my iPod fourth generation what can? I do?
Hello everyone I touch the screen of my iPod fourth generation what can?
Was something lost in the translation? I can touch the screen of my iPod too. That is how you use a touch-screen device like the iPod.
Please clarify your problem -
I lost all of my contacts and notes when attempting to move over music. When I try to restore the backup the day I want to restore to is not present. I do see a copy on my I cloud but I can't seem to retrieve it. What can I do?
Hi bluegrandpanash,
Thanks for visiting Apple Support Communities.
If you backed up your iPhone to iCloud before updating the software, first try the steps under "Restore from an iCloud backup" in this article to recover your data:
iOS: Back up and restore your iOS device with iCloud or iTunes
http://support.apple.com/kb/HT1766
Best Regards,
Jeremy -
my kids entered the passcode several times wrong and now it is disabled and written on it"connect to itunes" , when i did connect it to itunes it said "can not connect to ipad because it is locked with a passcode" what can i do pls?
You may need to put the iPad into recovery mode : http://support.apple.com/kb/ht1808 - you should then be able to reset the iPad and restore/resync your content to it.
If you do it via a different computer that it's not normally synced to then (from here) :
If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
Maybe you are looking for
-
I have a program using JMF which worked fine on XP and Vista but is behaving very oddly on Windows 7. The program displays two mpg files synchronised with each other and I also control the playback speed. This has worked fine for 18 months. On Window
-
PO history not getting updated.
Hi, I have created a purchase order for text material (without material no). And posted inbound delivery without error/warning messages using VL06IG tcode. This inbound del. is creating a confirmation of service, and not a goods receipt. Norm
-
Need help find a solution to a connection error to the internet once connected already and then asked to type in the Password again to connect on the operating system 4.3.5
-
If I plug my ipod into my laptop, itunes no longer opens.
The ipod says "Connected" and charges, but nothing else. When I do the same for my iphone, itunes opens immediately and the iphone charges. Oh, and if I plug my ipod in then unplug the cable, itunes then opens. Help?
-
I am using ISE 1.2. I have to configure automatic device registration through Guest Portal. The issue is that whenever a guest logs in for first time, he needs to enter the device mac address manually. Is there any method so the ise will automatical