My ipad has gone to black and not turning on

my ipad was working ok. then screen when black with red and blue lines now unable to do anything can anyone help

Troubleshooting: My computer won't turn on
BTW, this is the Mac Pro desktop forum

Similar Messages

  • My iPad 3 screen has gone completely black and does not respond

    MY iPad 3 screen has gone completely blank (blacked out) and does not respond to either of the power buttons.
    ANy suggestions?

    If the battery is not flat, try a reset.
    Hold the Sleep and Home button down for about 10 seconds until you see the Apple logo. Ignore the red slider.

  • IPad has gone completely black, any suggestions

    I was using my iPad and it stalled in an application so I pushed the round center button on front . It went black and will not function at all. I tried plugging in charger although I recall it having at least 60% but nothing happens when I try to turn it on, just black.... Anyone else have this happen & how was it solved?

    Try reset iPad
    Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
    Note: Data will not be affected.

  • IPad screen has gone blue/green and will not work

    My iPad 1 screen has gone to black when it is turned on and willl not work. Screen stays blue/green for about 30 seconds and then turns off. Unit is charged fully and has been updated to current operating software. Gerry

    Have you tried a reset ? Press and hold both the sleep and home buttons for about 10 to 15 seconds (ignore the red slider if it appears), after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.
    If that doesn't work then you could see if you can get it into recovery mode and restore it to your last backup : http://support.apple.com/kb/ht1808
    But you might need to contact Apple.

  • Ipad screen has gone stripey grey and black lines .

    Hi my iPad has gone stripey with black and grey lines ,and non responsive .Can anyone advise please.

    Hi kon and kathy,
    Welcome to Apple Support Communities.
    The article linked below provides a lot of great information and troubleshooting tips that can help you resolve the display issue with your iPad.
    Get help with the screen on your iPhone, iPad, or iPod touch - Apple Support
    If you see lines, missing sections, discoloration, or poor image quality
    Try to restart your device. If you can't restart, reset your device.
    If restarting or resetting doesn’t fix the issue, restore your device.
    If you still see the issue after you restore, contact Apple Support.
    So long,
    -Jason

  • My iPad screen has gone gray/black. I have tried both reset and restore, to no avail. Suggestions?

    My iPad screen has gone gray/black. I have tried both reset and restore, to no avail. Suggestions?

    Take it to an Apple Store for evaluation. It sounds like a hardware problem.

  • My ipad has gone black with only the Apple showing  after I tried resetting , now nothing happens. Please help.

    M y ipad has gone black with only the Apple logo showing afte I tried to reset. How can I restart.

    First try a Reset  ( No Data will be Lost )
    Press and hold the Sleep/Wake button and the Home button at the same time for at least Ten seconds... (But can take Longer)... until the Apple logo appears. Release the Buttons
    If no joy... Try a Restore...
    1: Connect the device to Your computer and open iTunes.
    2: If the device appears in iTunes, select and click Restore on the Summary pane.
    3: If the device doesn't appear in iTunes, try using the Steps in this article to force the device into Recovery Mode.
    From Here
    http://support.apple.com/kb/TS3281
    Make sure you have the Latest Version of iTunes (v11) Installed on your computer
    iTunes free download from www.itunes.com/download
    Note on Recovery Mode.
    You may need to try this More than Once... Be sure to Follow ALL the Steps...
    Once you have Recovered your Device...
    Re-Sync your Content or Restore from the most Recent Backup...
    Restore from Backup  >  http://support.apple.com/kb/ht1766

  • My ipad has gone in lost mode by mistake and now i have it and i enter the password and i cant enter my ipad how can i enter or restart the ipad and start back over new

    my ipad has gone in lost mode by mistake and now i have it and i enter the password and i cant enter my ipad how can i enter or restart the ipad and start back over new

    FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. You must follow step 1 to step 4 VERY CLOSELY.
    3. Repeat the process if necessary.

  • I downloaded iOS8 and my iPad has gone bonkers.

    Apple. What have you done to my iPad? I downloaded ios8 and my iPad has gone bonkers.
    I Cannot download stuff, I am having problems with posting photos, and some of my apps will not open.
    please sort out ios8 with a bug fix ASAP.
    <Re-Titled By Host>

    Malcolm76 wrote:
    Apple. What have you done to my iPad? I downloaded ios8 and my iPad has gone bonkers.
    I Cannot download stuff, I am having problems with posting photos, and some of my apps will not open.
    please sort out ios8 with a bug fix ASAP.
    <Re-Titled By Host>
    Please tell me that it has NEVER been jailbroke.  If it has not been jailbroke, here are some standard repair procedures:
    First, try a system reset.  It cures many ills and it's quick, easy and harmless...
    Hold down the on/off switch and the Home button simultaneously until you see the Apple logo.  Ignore the "Slide to power off" text if it appears.  You will not lose any apps, data, music, movies, settings, etc.
    If the Reset doesn't work, try a Restore.  Note that it's nowhere near as quick as a Reset.  It could take well over an hour!  Connect via cable to the computer that you use for sync.  From iTunes, select the iPad/iPod and then select the Summary tab.  Follow the on-screen directions for Restore and be sure to say "yes" to the backup.  You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod.  Again, say "yes."
    At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod.  As before, say "yes."  Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time.  If that happens, only the apps that are part of the IOS will appear on your device.  Corrective action is simple -  choose manual "Sync" from the bottom right of iTunes.
    If you're unable to do the Restore (or it doesn't help), go into Recovery Mode per the instructions here.  You WILL lose all of your data (game scores, etc,) but, for the most part, you can redownload apps and music without being charged again.  Also, read this.

  • HT1430 my ipad has gone dead.   I tried holding the sleep/wake button down until the red slider appears but it never does.  By the way this a refurbished unit I purchased from Apple and just received it yesterday.

    My ipad has gone dead.   I tried holding the sleep/wake button down until the red slider appears but it never does.  By the way this a refurbished unit I purchased from Apple and just received it yesterday

    Try reset all settings
    Settings>General>Reset>Reset All Settings
    Note: Data will not be affected but settings will be reset.

  • HT201412 My ipad has a software problem and does not work, request that it is loaded the software and there is no way that the operating system loads, is not restored. WHAT SHOULD I DO?

    My ipad has a software problem and does not work, request that it is loaded the software and there is no way that the operating system loads, is not restored. WHAT SHOULD I DO?

    This is an iPad user to user forum, so you are not addressing Apple. Depending on how many user helpers are on-line, it may take several hours, or longer, to get a response.
    Try this  - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.) No data/files will be erased.
    Frozen or unresponsive iPad
    Resolve these most common issues:
        •    Display remains black or blank
        •    Touch screen not responding
        •    Application unexpectedly closes or freezes
    http://www.apple.com/support/ipad/assistant/ipad/
    iPad Frozen, not responding, how to fix
    http://appletoolbox.com/2012/07/ipad-frozen-not-responding-how-to-fix/
    iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
    http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
    Black or Blank Screen on iPad or iPhone
    http://appletoolbox.com/2012/10/black-or-blank-screen-on-ipad-or-iphone/
    What to Do When Your iPad Won't Turn On
    http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    Home button not working or unresponsive, fix
    http://appletoolbox.com/2013/04/home-button-not-working-or-unresponsive-fix/
    Fixing an iPad Home Button
    http://tinyurl.com/om6rd6u
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
     Cheers, Tom

  • We have iPhone 4 and I plugged phone into after market hardwired plug in car (that we have used successfully for two years) and the screens has gone black and wont turn on.  Phone is charged. We have tried force quit- home screen and top button. help pls

    We have iPhone 4 and I plugged phone into after market hardwired plug in car (that we have used successfully for two years). The screen has gone black and wont turn on.  Phone was charged. I have tried force quit- home screen and top button. iTunes is not recognizing phone when I plug into computer.  help pls

    FIRST charge with an Apple charger for at least 15 minutes. Then hold the HOME and SLEEP buttons at the same time until an Apple logo appears. Hold for up to 30 seconds. If nothing happens the phone hardware has failed.

  • Just updated itunes now menu bar has dissapeared no black and white box at top left and ctr b does not bring anything up. i need file view etc please help driving me crazy

    just updated itunes now menu bar has dissapeared no black and white box at top left and ctr b does not bring anything up. i need file view etc please help driving me crazy

    Is the iTunes window in FullScreen mode?
    If so, press esc key.

  • Pro15-inch with a lion at the bottom of the system, my computer is not always closed machine, has been a black and white, seems to read the disks that thing has been turning away, how do ah (do not want to reload) to help solve it

    pro15-inch with a lion at the bottom of the system, my computer is not always closedmachine, has been a black and white, seems to read the disks that thing has beenturning away, how do ah (do not want to reload) to help solve it

    What are you talking about?

  • My screen on my iPad has gone weird flickering colour and negative look about it

    My screen on my iPad has gone weird flickering colour and negative look about it any ideas

    Settings>General>Accessibility>Invert Colors>Off

Maybe you are looking for

  • "Failed to Export PDF"

    Dear Friends, when trying to export a document in Indesign CS4 as PDF-file, I get an error message: Adobe InDesign Failed to Export PDF. OK   After dismissing this dialog, the export-process quits and no PDF-file is created. There aren't any further

  • F4 Help for a standard field in transaction FD32

    Hello Expert, i need to create a list selection for the standard field "KNKK-DBPAY" in the transaction FD32, program "SAPMF02C" dynpro 1090, is it possible ? if yes can you show me how to do? thank you in advance that will be very helpful.

  • Float - string

    I have float BMIndex and I would like to display the number in a panel. I think the only way I can do this is to copy float BMIndex to string BMIstring, but I can't figure out how. There doesn't seem to be a parse method in string, and the few things

  • Varray Solution help

    Please help, i am trying to understand VARRAY, but cant around working through this question. Not to sure of the syntax Trying to create datatype: a Varray of 7 Numbers to hold Exam marks . Create a table with Customer ID, Name and marks. Any data ty

  • Stuck on "Rendering Standard Previews"

    After importing images, Lightroom (2.4) is getting stuck in the "Rendering Standard Previews" process.  I have been sitting here for over an hour while Lightroom is stuck at 6 of 117.  This happened on an earlier import as well, and I ended up cancel