My ipad is the 1st generation and is unable to turn on. what should i do?
heellpp
First, try a system reset. It cures many ills and it's quick, easy and harmless...
Hold down the on/off switch and the Home button simultaneously until you see the Apple logo. Ignore the "Slide to power off" text if it appears. You will not lose any apps, data, music, movies, settings, etc.
If the Reset doesn't work, try a Restore. Note that it's nowhere near as quick as a Reset. It could take well over an hour! Connect via cable to the computer that you use for sync. From iTunes, select the iPad/iPod and then select the Summary tab. Follow directions for Restore and be sure to say "yes" to the backup. You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod. Again, say "yes."
At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod. As before, say "yes." Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time. If that happens, only the apps that are part of the IOS will appear on your device. Corrective action is simple - choose manual "Sync" from the bottom right of iTunes.
If you're unable to do the Restore, go into Recovery Mode per the instructions here.
Similar Messages
-
I updated the IPAD with the latest update and now when I turned the IPAD on, I get the itunes logo and then nothing else. How can I fix this to let me use my IPAD?
YOU ARE IN RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.
3. Repeat the process if necessary. -
I updated the IPAD with the latest update and now when I turned the IPAD on, I get the itunes logo and then nothing else. How can I fix this to let me use my IPAD?
Hi ....
"I get the itunes logo and then nothing else"
Use Recovery Mode > If you can't update or restore your iPhone, iPad, or iPod touch -
My iPad is locked and has this message "this iPad hasn't been backed up. Backups happen when this iPad is plugged in, locked, and connected to wi fi". What should I do to continue using it please?
Welcome to the Apple Community.
You might try a forced shutdown to begin with, hold down the top and home buttons together until the device shuts down, then restart it. -
I have no profile on iPad, I'm doing presentation and I can't launch applications.what should I do. How I can have a profile in settings-general-profile
Profiles are installed using the Apple IPhone Configuration Utility. See http://manuals.info.apple.com/en_US/Enterprise_Deployment_Guide.pdf
Also read: http://support.apple.com/kb/ht4213 -
I am not able to adjust the hight of one page on my site. I try to move the blue mark on the left side and it doesn't move. What should I do ? Thanks
Hi,
could you please try to find any blank oject like rectangle/textbox, specially at the lower end of the page. Use Edit -> "Select All" to select everything on the page, it will be easier to locate it.
Let me know if that works -
How can I buy a song but always asked the security questions and you don't remember them what should I do
Write down your security questions.......
Here is what you should do if you do not remember the answers to your Apple ID security questions:
Try answering them at least once to see if you can get them right, even if you are not sure you remember the answers to your security questions.
If you are confident you can't remember them, try one of the following:
If you have three security questions and a rescue email addresssign in to My Apple ID and select the Password and Security tab to send an email to your rescue email address to reset your security questions and answers.
If you have one security question and you know your Apple ID passwordsign in to My Apple ID and select the Password and Security tab to reset your security question.
If you have one security question, but don't remember your Apple ID passwordcontact Apple Support for assistance. Learn more about creating a temporary support PIN to help Apple confirm your identity when you contact Apple Support.
Note: If you have forgotten your password and answer your security questions incorrectly too many times in a row, you will be unable to try to answer your security questions for a period of time. During that time you will not be able to reset your password and will not have access to your account.
Cheers,
Alec -
I have updated my facebook application to the latest one and it is not working...i deleted it and reinstalled it and still not working..what shoul i do?Thank you.
cristinar wrote:
I have updated my facebook application to the latest one and it is not working...i deleted it and reinstalled it and still not working..what shoul i do?Thank you.
As suggested try a reset: Simultaneously hold down the Home and On buttons until the iPad shuts down. Ignore the off slider if it appears. Once shut down is complete, if it doesn't restart on it own, turn the iPad back on using the On button. In some cases it also helps to double click the Home button and close all apps from the tray before doing the reset.
Also, it might help if you provide a little more detail on what you mean by "not working" -
ive tried everything from resetting my ipod touch to resseting the network connetion but evertime i put in the password it says unable to connect what should i do
- Did the iPod successfully connect to the network in the past?
- Does the iPod successfully connect to other networks?
- Do other devices successfully connect to the network?
- Power off and then back on your router.
- iOS: Troubleshooting Wi-Fi networks and connections
- iOS: Recommended settings for Wi-Fi routers and access points -
My iPhone 5 microphone is not working and i have tried the brush technique and the microphone still has not recovered .. what should i do?
your phone is still under warranty. Bring it to Apple for evaluation.
-
my ipod wont turn on. i thought it was dead, but i tried putting it in the charger and i let it charge for 4 hours and it still wont turn on. i tried multiple chargers and also tried plugging it in 2 different computers. what should i do?
That symptom is coverd here:
iPod touch: Hardware troubleshooting -
iphone 3g not working because of uncompatible update, what should i do?
There is no way to update a 3G to iOS 4.3.x using approved Apple procedures (meaning using iTunes), so presumably you used a non-approved procedure to do it. You may now have an iBrick, but you can try to restore it to a supported version using iTunes and DFU mode. See: http://support.apple.com/kb/HT1808. If this fails there may still be a way, but you won't find it in this forum. You need to try some iPhone hacking sites.
-
My brand new, fully charged, working for nearly 2 days iPhone 4S suddenly stopped working and will not turn on. I've tried recharging and it's unresponsive. What should I try to do?
I've had a similar thing happen to my new iPhone 4S three times. It gets hot and doesn't respond to either button -- the screen remains completely off. I have to hold down both buttons for awhile until the Apple appears and then everything seems fine... until it happens again. Once it happened overnight, so I missed my alarms. Another time, it was while I was at dinner.
Always it happens when the iPhone is on standby with the screen off and nothing particular happening with it. The iPhone 4S is brand new, hasn't been dropped, hasn't been messed with in any way.
Is there a way I can get a trace of what happened before I reset it? The system log (visible in "System Status" and other apps) starts with the reset, so it doesn't help here. -
My ipad went dead and i put on charge and it still didnt turn on what should i do
Please help
You need to wait about 30 minutes after you plug it in to the wall charger.
Frozen or unresponsive iPad
Resolve these most common issues:
• Display remains black or blank
• Touch screen not responding
• Application unexpectedly closes or freezes
http://www.apple.com/support/ipad/assistant/ipad/
iPad Frozen, not responding, how to fix
http://appletoolbox.com/2012/07/ipad-frozen-not-responding-how-to-fix/
iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
Black or Blank Screen on iPad or iPhone
http://appletoolbox.com/2012/10/black-or-blank-screen-on-ipad-or-iphone/
What to Do When Your iPad Won't Turn On
http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
Home button not working or unresponsive, fix
http://appletoolbox.com/2013/04/home-button-not-working-or-unresponsive-fix/
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Cheers, Tom -
hi i cant restore my i phone 4 please help it is off
They will be gone from the iphone, but you should be syning all contacts to your computer regularly and should be importing all pics to your computer regularly, particularly before any update.
Have you failed to do this?
Maybe you are looking for
-
I got an iPhone 5s today and it won't hook up to iTunes.
I got an iPhone 5s today and when I got home I tried to hook it up to iTunes, but iTunes wouldn't even recognize my phone. I've reset my phone and my computer multiple times, yet my phone still won't hook up to iTunes. Please help.
-
Run a shell script at login?
I would like to run a simple shell script each time a user logs in. Currently, I have it wrapped in an Automator executable that is included in "Login Items", but figured there must be a more elegant way? Thanks. More info: The problem I'm trying to
-
How to maintain the sequence in the custom table
Hi, We have custom table where we will store the standard text name based on different flags and it will be fetched the value according to the condition. Example code SELECT SINGLE field1 field2 INTO ( vaiable1 variabl
-
Applecare ordered with computer....didn't receive it in delivery
I just received my powerbook 15". I ordered a wireless mouse with it along with applecare. The powerbook arrived last friday. The wireless mouse and applecare product was shown in my emails to be shipped from a different location and shipped fed ex g
-
I'm trying to help an elderly friend. She has some pdd files from the days when Photoshop would only allow work files to be saved in .pdd format. Can anyone give me any guidance as to what modern software may be able to read them, or is there anythin