My ipad says it is hooked up to wifi but at top there is no bars
my ipad says it is hooked up to wifi, automatic my wifi is checked
but at top of the ipad has no bars
If Safari and other apps that use the network work
Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Go to Settings>General>Date&Time and make sure it is set to Automatic
- Go to Settings>wifi>the connected network and change the DNS to Google's 8.8.8.8
- Go to Settings>iTunes and App Stores and sign out and sign back in
Similar Messages
-
My iPad says it's connected to the wifi but nothing loads. My xbox and cable box connect and work just fine.
Hey JnastyCL,
Thanks for the question. The following resource outlines the basic troubleshooting steps for Wi-Fi connectivity. I have also included the steps specific to the symptoms you are experiencing:
iOS: Troubleshooting Wi-Fi networks and connections
http://support.apple.com/kb/TS1398
Be sure you're in range of your Wi-Fi router (access point).
Tap Settings > Wi-Fi and turn Wi-Fi off and on. If your W-Fi setting is dimmed, follow these steps.
Confirm that your Wi-Fi router and cable or DSL modem are connected to power, turned on, and connected to the Internet. If not, refer to your network administrator or Internet service provider (ISP) for assistance.
Restart your iOS device.
Tap Settings > Wi-Fi and locate the Wi-Fi network to which you're connected.
Tap and Forget this Network.
Try to connect to your desired Wi-Fi network.
Note: You may need to enter your Wi-Fi password again if your network requires one.
Turn your Wi-Fi router off and on. If your ISP also provides cable or phone service, check with them before attempting this step to avoid interruption of service.
Update your device to the latest version of software.
Update your Wi-Fi router to the latest firmware. For AirPort Base Stations, install updates using the AirPort Utility.
Unable to access the Internet while connected to Wi-Fi
If you're using a public or commercial network, you may need to log in or subscribe.
Check to see if you have a self-assigned IP address:
Tap Settings > Wi-Fi and locate the Wi-Fi network to which you're connected and tap ( i ) .
If your IP address is 169.254.xxx.xxx, you may not be able to access the Internet.
If you do not have a self-assigned IP address, see if other Wi-Fi devices on your network have Internet access.
If they do not, consult with your network administrator or ISP for further assistance.
If they do, reset network settings on your device by tapping Settings > General > Reset > Reset Network Settings. Note: This will reset all network settings including:
previously connected Wi-Fi networks and passwords
recently used Bluetooth accessories
VPN and APN settings
Thanks,
Matt M. -
My ipad says it has 149 photos on it, but I can't find them. Any ideas where they might be?
Did you ever restore your last iCloud backup? That contains you camera roll photos & videos, text messages, app data, settings, etc. It will also redownload your apps and other purchased media.
If you didn't, follow the steps in this article to restore the backup: https://support.apple.com/kb/ph12521. -
im having trouble using bbciplayer on my ipad it says i need to switch to wifi but im already connected can any one help? I ve uninstalled/ reinstalled switched it on and off what next?
Did you try downloading the movie from iTunes on your iPad? I know it takes longer but I'd try that.
Also try to reset all settings.
Settings > General > Reset. Reset all settings. -
HT4623 why does my ipad say its ios is up to date but i havent updated it to ios7
why does my ipad say its ios is up to date but i havent updated it to ios7
First generation iPads cannot be upgraded to iOS 7. Which generation do you have?
-
My iPad says it has to restore to update, but it will not. It is caught in a cycle of not being able to restore but needed to restore. I keep getting error code 3014 but I can not figure out what this means! nor can I do anything about it! So Frutrated!
Also...
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once...
But... if the Device has been Modified... this will Not necessarily work. -
My ipad says the software is my to date but it is only iOS 5.1.1. How do I update it to iOS 6?
If you have the first generation, there is no way to update beyond iOS 5.1.1.
Newer iPads can only update to the latest software, iOS 7.0.4.
Model Identifier Utility -
My iPad doesn't connect to my home WiFi; but my Toshiba Laptop does?
can any one help with my WiFi problem. My iPad doesn't connect to my home WiFi; but my Toshiba Laptop does? and my iPad works in other places but not at home????
Some things to try first:
1. Turn Off your iPad. Then turn Off (disconnect power cord for 30 seconds or longer) the wireless router & then back On. Now boot your iPad. Hopefully it will see the WiFi.
2. Go to Settings>Wi-Fi and turn Off. Then while at Settings>Wi-Fi, turn back On and chose a Network.
3. Change the channel on your wireless router (Auto or Channel 6 is best). Instructions at http://macintoshhowto.com/advanced/how-to-get-a-good-range-on-your-wireless-netw ork.html
4. Go into your router security settings and change from WEP to WPA with AES.
5. Renew IP Address: (especially if you are droping internet connection)
• Launch Settings app
• Tap on Wi-Fi
• Tap on the blue arrow of the Wi-Fi network that you connect to from the list
• In the window that opens, tap on the Renew Lease button
~~~~~~~~~~~~~~~~~~~~~~~~~
iOS 6 Wifi Problems/Fixes
Fix For iOS 6 WiFi Problems?
http://tabletcrunch.com/2012/09/27/fix-ios-6-wifi-problems/
Did iOS 6 Screw Your Wi-Fi? Here’s How to Fix It
http://gizmodo.com/5944761/does-ios-6-have-a-wi+fi-bug
How To Fix Wi-Fi Connectivity Issue After Upgrading To iOS 6
http://www.iphonehacks.com/2012/09/fix-wi-fi-connectivity-issue-after-upgrading- to-ios-6.html
iOS 6 iPad 3 wi-fi "connection fix" for netgear router
http://www.youtube.com/watch?v=XsWS4ha-dn0
Apple's iOS 6 Wi-Fi problems
http://www.zdnet.com/apples-ios-6-wi-fi-problems-linger-on-7000004799/
~~~~~~~~~~~~~~~~~~~~~~~
Look at iOS Troubleshooting Wi-Fi networks and connections http://support.apple.com/kb/TS1398
iPad: Issues connecting to Wi-Fi networks http://support.apple.com/kb/ts3304
WiFi Connecting/Troubleshooting http://www.apple.com/support/ipad/wifi/
How to Fix: My iPad Won't Connect to WiFi
http://ipad.about.com/od/iPad_Troubleshooting/ss/How-To-Fix-My-Ipad-Wont-Connect -To-Wi-Fi.htm
iOS: Connecting to the Internet http://support.apple.com/kb/HT1695
iOS: Recommended settings for Wi-Fi routers and access points http://support.apple.com/kb/HT4199
How to Quickly Fix iPad 3 Wi-Fi Reception Problems
http://osxdaily.com/2012/03/21/fix-new-ipad-3-wi-fi-reception-problems/
iPad Wi-Fi Problems: Comprehensive List of Fixes
http://appletoolbox.com/2010/04/ipad-wi-fi-problems-comprehensive-list-of-fixes/
Fix iPad Wifi Connection and Signal Issues http://www.youtube.com/watch?v=uwWtIG5jUxE
Fix Slow WiFi Issue https://discussions.apple.com/thread/2398063?start=60&tstart=0
How To Fix iPhone, iPad, iPod Touch Wi-Fi Connectivity Issue http://tinyurl.com/7nvxbmz
Unable to Connect After iOS Update - saw this solution on another post.
https://discussions.apple.com/thread/4010130
Note - When troubleshooting wifi connection problems, don't hold your iPad by hand. There have been a few reports that holding the iPad by hand, seems to attenuate the wifi signal.
~~~~~~~~~~~~~~~
If any of the above solutions work, please post back what solved your problem. It will help others with the same problem.
Cheers, Tom -
it would say request timed out so i restored my ipod erased and reset it hoping it would delete the problem but it was still there it says that it is connected to wifi but will not launch safari and will bring up that message request timed out. itunes app store anything that uses internet/wifi will not work. it is not in airplane mode and wifi is on. i also forgot to mention this but it would also sometimes say that it is not connected to the internet even though i have 3 bars of wifi.
The router itself will always be sending a signal to devices connected to it. The router could not even be connected to your modem and it will still show that you have a connection on your device. Check your router config, reset it, and if all fails, contact your internet service provider.
BF -
My PowerBook G4 says that it's connected to wifi, but it still no internet connection. The connection will work for a while, and then I'll have to run diagnostics and it will work again for a few minutes and then stop working again. What's going on??
Basic troubleshooting techniques for any problem
Restart the computer = joy?
Reset the router = joy?
Restart the computer in Safe Mode = joy?
ask yourself "What changed immediately preceding the onset of the problem?" = Anything... hardware, software, cabling, environment (interference source)
ÇÇÇ -
My laptop says it is connected to our wifi but it also says alert: you are not connected to the internet! Does anyone know how I can fix this/has it happened to anyone? Thanks
This usually indicates a problem with your router or cable modem, your ISP's service or cabling outside your house. First thing I'd try is rebooting the router/cable modem (turn it off, wait 1 minute, then turn it back on).
-
My MacBook Air says it in connected to my wifi, but my wifi signal has a "!" sign on it. My computer will not allow internet access, help?
When you see an exclamation point in the Wi-Fi menu, from the menu bar, select
▹ System Preferences... ▹ Network
Click the Assist me button and select Assistant. Follow the prompts. You may get a warning that Wi-Fi is not available, that you're too far from the base station, or that you're using the wrong password.
Assuming that you've ruled out those possibilities, restart the computer and try again. If there's no change, click the lock icon in the lower left corner of the preference pane and authenticate, if necessary. From the Location menu at the top of the window, select Edit Locations. A sheet will drop down. Click the plus-sign button to create a new location. Give it any name you want. In the new location, set up the Wi-Fi service with the same settings you used before. Click Applyand test.
If there's still no connection, and if you have control of the router, compare its settings to Apple's recommendations. Some third-party routers may be incompatible in 802.11b/g/n radio mode. Try setting the mode to 802.11n only. -
We have the itouch hooked up to wifi but can't access email
we have the itouch hooked up to wifi but can't access email or app store - is there a router setting (which is an open system, no passwords or log in needed) we need to address? We can successfully use safari, but anything with a password seemigly is no go. This is using a new iTouch 8G that I bought for my Mom yesterday.
We got our son's working yesterday. It didn't dawn on me until many hours later that I kept giving the router password instead of the Hex key for the I-touch password Entry. We had to supply the Hex Key. We use WEP as a security mode and both password and Hex key are in Hexidecimal format. I hope this helps you and saves you many hours of headaches.
-
My phone says i am hooked up to wireless. but will not load anything.
Do you have a seperate AP providing your wireless or are you using the wireless built into the AT&T router? If seperate, you will need to re-configure the AP to the new equipment AT&T sent you.
Got a new modem today and now my phones will not load anything. Says i am hooked up to wireless. But cant load games,Facebook and well everything.please help.
-
When i bought my iPhone and my iPad they both were on iOS 7.0.2 i updated them shortly after thinking the new iOS 7.0.4 was better. i see its not but they both worked great with iTunes before and after the update. My question is why is my iPhone not connecting to iTunes? it will not connect through USB or wifi and i know that the setting to do that is turned on. my iPad connects through iTunes through wifi but not USB. This isnt making any sense but i wanna know is this a iTunes issue? or is it my phone and iPad??
This can sometimes be the result of a faulty/damaaged USB sync cable. Do you have another cable you could test it out with?
B-rock
Maybe you are looking for
-
How to call methods from within run()
Seems like this must be a common question, but I cannot for the life of me, find the appropriate topic. So apologies ahead of time if this is a repeat. I have code like the following: public class MainClass implements Runnable { public static void ma
-
Ipod connected to car iPod ready deck
I have an iPod that is connected to my car iPod ready stereo. It is connected via an aftermarket product. My question is, is it ok to leave myiPod connected 24x7 in my car? Will it drain the battery faster? Will it damage my ipod?
-
PERFECT/COMPLETE VERTICAL LINE IN SAPSCRIPT?
Hello all, I have to draw vertical lines to make a grid in a SAPscript. But the grid size is not fixed, there a number of records and long texts that are displayed based on certain conditions. Is there a way to draw a perfect/complete veritcal in SAP
-
Tranport Request from Higher version to Lower Version
Hello, Can any One Know how to Transport Requests from Higher Version to Lower Version for Example From Ecc6.0 Ehp1 to->>>>> Ecc6.0. is there is any way or any SAP Note related to this? Ple
-
All Day Events - adjust print settings?
Is it possible to adjust the way all day events print? I need them to wrap text, rather than truncate the text with ellipses. My timed appointments wrap nicely, so is there a setting I'm missing.