My iPad screen is blue and doesn't let me do anything, what should I do?

My iPad 2 screen is blue and it's frozen. doesn't let me do nothing, what should I do?

Try reset iPad
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected.

Similar Messages

  • HT201177 My Mac book pro won't re-start. The apple sign stays on for a while, that little circle keeps spinning and nothing happens. After 10 minutes rebooting  the screen turned blue and nothing was on besides the cursor. what should I do? Thanks.

    My Mac book pro won't re-start. The apple sign stays on for a while, that little circle keeps spinning and nothing happens. After 10 minutes rebooting  the screen turned blue and nothing was on. now I just re-tried and lots of pixels came up. what should I do? Thanks anyone.

    My Mac book pro won't re-start. The apple sign stays on for a while, that little circle keeps spinning and nothing happens. After 10 minutes rebooting  the screen turned blue and nothing was on. now I just re-tried and lots of pixels came up. what should I do? Thanks anyone.

  • My iPad screen is blue and blank. It will not respond to restarting

    My iPad screen is blue and blank. It will not respond to restarting. The apple logo does not appear. The screen switches from a dark blue (as if it's on) to black (as if it's off). But will not reset and will not turn off. Any advice?

    Because you forgot the passcode?
    You have to restore the device using iTunes. You want to use the same computer that you always sync with so that you can restore your app data and settings. You can restore with any other computer, but you will lose everything on the iPad.
    Instructions can be found here.
    http://support.apple.com/kb/ht1212
    You may need to restore using Recovery Mode. You can read about it here.
    http://support.apple.com/kb/ht4097
    Recovery Mode Instructions
    Disconnect the USB cable from the iPad, but leave the other end of the cable connected to your computer's USB port.
    Turn off iPad: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for iPad to turn off.
    If you cannot turn off iPad using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the iPad turns off, release the Sleep/Wake and Home buttons.
    While pressing and holding the Home button, reconnect the USB cable to iPad. When you reconnect the USB cable, iPad should power on.
    Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears you can release the Home button.
    If necessary, open iTunes. You should see the recovery mode alert that iTunes has detected an iPad in recovery mode.
    Use iTunes to restore iPad.
    But ...if you are saying that the slide to unlock bar is not working and this has nothing to do with the iPad being disabled .... Reboot your iPad.
    Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.

  • On my ipod touch i bought some music but when i go to download it on my pc it just comes up as downloaded and doesn't let me do anything with it

    On my ipod touch i bought some music but when i go to download it on my pc it just comes up as downloaded and doesn't let me do anything with it.As in it w'ont let me download it or anything like that.

    Make sure you have signed-in your iTunes and authorized the computer.
    Go to iTunes menu EDIT > PREFERENCES > DEVICES tab and check the Box "Prevent iPods, iPhones and iPads from syncing automatically then OK.
    As long as you don't sync your devices, iTunes will not wipe out music from your iPod.  Now connect your iPod and do the Purchase transfer only.

  • My iphone has stopped working it had 80% of charging but the screen got black and now i cant switch it on, what should i do?

    my iphone has stopped working it had 80% of charging but the screen got black and now i cant switch it on, what should i do?
    help me ASAP please

    Hello sameen shah,
    The following article would be a great place to start for information that can help get your iPhone working again.
    iPhone: Hardware troubleshooting
    http://support.apple.com/kb/TS2802
    Cheers,
    Allen

  • HT1766 After unplugging my phone from being charged all night, the screen went black and will not let me do anything!

    After unplugging my phone from being charged all night, the screen went black and will not let me do anything including turning it off. please Advise. Thanks

    press and hold the home and power buttons until the Apple icon is displayed, then let go.

  • I have signed in to my mail on my ipod but it keeps saying 'the connection to the server failed' and i cannot receive or send anything what should i do?

    i have signed in to my mail on my ipod but it keeps saying 'the connection to the server failed' and i cannot receive or send anything what should i do?

    Did it work on the iPod before?
    Can you access that mail account on other devices?
    Have you looked at the previous discussions listed on the right side of this page under the heading "More Like This"?

  • Upon updating my ipod touch to iOS 6.1.3, the screen turned gray and would not let me do anything, and now the screen is blue?

    I was updating my ipod and after it finished the screen turned gray, then blue and now has just recently
    turned white, what do I do?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • When I turn 3G ipad is turned off and turned on only when charging. What should I do?

    When I turn 3G i-pad is turned off and turned on only when charging! What should I do?

    Not too sure of what you are saying but try a Reset [Hold the Home and Sleep/Wake buttons down together for 10 seconds or so (until the Apple logo appears) and then release. When the screen goes blank then power ON again in the normal way.] It is 'appsolutely' safe!

  • HT1977 My Computer crashed so I have had to download iTunes all over again. The problem is now I can't sync my Apps to my iTunes. It doesn't let me arrange them or anything when plugging my iPad in. The screen is greylike and won't let me select anything

    Hi Guys,
    My computer crashed and I lost everything. I got a new one and downloaded itunes all over again. When I plug my ipad in even after authorising my computer it will still not let me edit anything on the ipad. The screen is grey like on the ipad section and i cant select an app or anything. I have transfered purchase apps but all it does is take movies and tv shows accross. It wont transfer the apps into itunes. Please help

    As far as I know, iTunes will still not change anything until you click on Apply in the lower right corner. I fiddle with my settings all the time - just so I can get a sense if what to expect should I make any changes - and I have never seen anything happen to my configuration unless I click on Apply in the lower right corner of iTunes. Not only that - you have turned off auto sync so as far as I know you still have to click on sync or apply in order for the iPad to sync with iTunes.
    That doesn't mean it will not happen, I've never seen it happen - is all that I'm saying. I'm sorry but I'm not sure what will happen, but the only reason that I can of why the apps will not transfer is because of the manual manage setting. I could be wrong about that as well.
    Look at this discussion - which I have referred quite a few users to read. I know this process has worked for a number of people that have read it and used the instructions in it. Maybe we are missing something - what that would be - I'm not quite sure, but take a look.
    https://discussions.apple.com/thread/3305461

  • I have a problem with my macbook after i pressed the power button the screen turns blue and nothing is happening with it! What can I do? Pls helps and thx btw

    I have a problem with my MacBook Pro, I pressed the power button and after that the apple noise came and the screen turned blue. What can I do and what happened? pls help & thx btw

    You may find this helpful:
    http://support.apple.com/kb/PH14061
    Ciao.

  • My iPad has a large and noticeable dent down the middle. What should I do??!!

    So my iPad 2 that I just recently got has a very noticeable dent on the bottom of it going up(almost in half) in landscape mode. The dent won't let third party hard cases slide on it, and the screen is bleeding extra, and there is a white dot on the screen in the general area of the dent on the back.
    What should I do, that isnt too expensive.
    I do think this dent was caused by me but I am not sure, I have never really looked from the side of it before...
    Thanks.

    Take it to an apple store for repair.  It will cost you but it will be cheaper than buying a new one.

  • TS2771 I dropped my iPod touch in the ground and the screen turned blue and now it won't turn on what do I do

    I was walking and I dropped my iPod and I picked it up and it was blue so I tried turning it back on and it wouldn't what do I do any help

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer          
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar              

  • My iphone has just got the itunes symbol and a usb cable showing on the screen it wont turn on or let me do anything what can i do???

    i was updating my iphone 3gs software on my pc and it came up with an error and since then i have just had the itunes symbol and a usb cable on my screen. i cant do anything with it what can i do?

    The only thing you can do is what the picture is telling you to do: plug it into iTunes and restore it.

  • HT4859 we have a iPod touch 4th gen and the screen is locked and it will let us restore it what now

    we have an ipod touch 4th gen and the screen is locked up and it will not back up or restore. I have removed iTunes and reloaded also iCloud the same we are needing help

    A reset may help. Tap and hold the Home button and the On/Off button at the same time for approximately 10-15 seconds, until the Apple logo reappears. When the logo appears, release both buttons and await restart. No content will be affected.

Maybe you are looking for

  • Using the optical drive of a MacBook Pro from new iMac for iTunes

    Can I connect my macbook pro to my new iMac (no optical drive) with ethernet cable and use the optical drive of the macbook pro to upload CDs to iTunes on the new iMac? 

  • Block MRP for Sale order

    HI friends, My client has following requirement. we are using MTO scenario.after creation of sale order these SO is checked by senior sale manager then he approved the sales order after that it is possible to start run MRP.How I can achieve this ? RE

  • Rollback all steps in a mapping if an error occurs

    We have a mapping with some different steps (pre-mapping procedure, some operators and post mapping procedure) and we want to commit or to rollback the entire mapping transaction. So we have that all is OK or all is not refreshed in this mapping. Whi

  • MS 2007 ACCESS

    Does Star Office provide a means of importing Access tables, queries and reports?

  • Unable to add a new line item to a sales document when hitting save

    Dear All, When ever the end user save the sales quotation document, a new line item has to add automatically with a default item with some quantity. I am trying to solve this issue with user exit USEREXIT_SAVE_DOCUMENT_PREPARE in SAPMV45A. But it is